Engineering Commons^™

Conduction Phenomena Of Reduced Titanium Dioxide With An Oxide Surface Layer, Richard Bechtel

Electrical and Computer Engineering ETDs

No abstract provided.

Counter Circuits Using Gaseous Discharge Tubes And Rectifiers, Robert Creveling

Electrical and Computer Engineering ETDs

This thesis pertains to an electric circuit consisting of gaseous discharge tubes and rectifiers arranged to comprise a counting or integrating device for electric impulses impressed on the system. The ideas presented herewith are wholly those of the author and were submitted in the form of a patent application via the New Mexico School of Mines in June 1950. The basic idea for such a circuit was conceived on November 14, 1949.

Compressive And Flexural Strength Of Portland Cement Concrete As Affected By Fractured Particles Of Coarse Aggregate, Russell L. Vesper

Civil Engineering ETDs

Although a great deal of experimental data are available on many of the factors involved in a concrete mix design, a limited amount of work has been done to determine the effect of the surface characteristics of the concrete aggregates. Some research has been done in this connection by the New Mexico Highway Department. Some of the results of this research are included in a later section of this thesis.

Linear Time Base Precision And The Compound Sweep Concept, William W. Steger

Electrical and Computer Engineering ETDs

This paper is a monograph on general precision criteria for feedback linear time base circuits. The linearity and stability performance of these devices is evaluated in terms of deviation from an ideal ramp function.

In its entirety, the paper attempts to provide a complete reference for the most commonly encountered aspects of time base precision. Attention is centered on what could be called the "low frequency" case, which most often is valid in applications requiring a high precision time base.

The subject is developed in a number of progressive, cumulative stages. The end products at each stage of the analysis …

Radial Dislocations In Plane Stress., William J. Sieger

Mechanical Engineering ETDs

The elastic dislocation theory was used to obtain stress potentials for the dual dislocation problem. These solutions give the stress field for an infinite plane region containing a centrally located circular hole with two radial dislocations originating from opposite sides of the hole and extending into the region along a line perpendicular to the axis of applied load. Solutions were obtained for both the case of a linear dislocation relation along the cuts and for a parabolic relation.

Crystal Habit Modification Of Sodium Chlorate, Michael R. Keegan

Bachelors Theses and Reports, 1928 - 1970

All single crystals have a particular habit or morphology. The crystal habit refers to the relative degree of development of crystallographic planes into surfaces which make up the external appearance of the single crystal.

In this paper, NaClO3 is used as a parent crystal. Its simple cubic habit is modified to tetrahedral by the use of impurities of SO4=, S2O3=, Cr2O7=, and NO3-. The degree of habit change is studied as a function of impurity concentration and temperature. The problem and phenomena are explained in terms of surface chemistry and thermodynamics.

Physico-Chemical Principles Of Sixteenth Century Metallurgy, Robert E. Johnson

Bachelors Theses and Reports, 1928 - 1970

Following a review of sixteenth century metallurgical literature and a discussion of Gibbs free energy, this thesis discusses thermodynamic considerations of galena (PbS) reduction by iron from a lead assay of this period. The importance of fluxes in this assay is emphasized. The discussion covers both equilibrium and non-equilibrium conditions at 1100 degrees Celsius. Possible substitutes for iron are also covered.

Information from twenty-one small controlled lead assays is correlated with the thermodynamic discussion to determine the purpose of each constituent in the assay.

A Prototype Transmitter For A Microwave Refractometer, John C. Jordan

Electrical and Computer Engineering ETDs

A study of the design, development and fabrication details of a transmitter for a microwave refractometer is presented. Atmospheric, radio frequency, refractive index is to be measured rapidly and directly up to altitudes of the order of 200,000 feet. Requirements for the transmitter with regard to its weight, volume and environment are indeed stringent since it is proposed to package the transmitter in a ogive configuration and elevate it to these altitudes utilizing a rocket propulsion system.

Complementary Transistor Memory Circuit And Logic Applications, Lee M. Bossart

Electrical and Computer Engineering ETDs

No abstract provided.

The Beneficiation Of Titaniferous-Magnetite Sands, Ronald Lloyd Nordwick

Bachelors Theses and Reports, 1928 - 1970

The purpose of this investigation of beneficiation methods is to develop and study possible economic methods for recovering an iron-titanium concentrate of sufficient purity to meet metallurgical requirements for subsequent direct reduction to pig iron and a high titanium slag.

Handbook Of Facts And Figures On Indiana County Roads—Including Directory Of Indiana County Highway Departments, Jean E. Hittle

Indiana Local Technical Assistance Program (LTAP) Publications

This handbook will assist county road officials in the planning of county road operations. The data and information included in this handbook are either statistical or public information which are already available from the official sources, but which needed to be brought together for convenient distribution and use.

Stress-Corrosion Cracking Of Brass, Paul A. Fossey

Bachelors Theses and Reports, 1928 - 1970

the mechanism of stress-corrosion cracking of brass has been sought for many years. Investigators have proposed many mechanisms, but each of these mechanisms has always had several drawbacks. This paper presents an account of experimental work done in the laboratory on this subject and compares it to the work of previous investigations. It evaluates the mechanisms presented by investigators and shows the failures of these mechanisms. A theory of Nitrogen Embrittlement is presented and an evaluation of this theory with experimental work follows.

Experimental Arc Furnace Smelting Of Titaniferous Iron Sands From The Northern Oregon Coast, Allan P. Herring

Bachelors Theses and Reports, 1928 - 1970

This investigation is an attempt to experimentally smelt titaniferous iron sands from the Northern Oregon Coast in a laboratory arc furnace.

The Effect Of Ph Upon Chelation Reactions In Montmorillonite Clays, Joseph Michael Keane

Bachelors Theses and Reports, 1928 - 1970

The purpose of this thesis is to investigate several chelation reactions and determine the effect of variable pH upon these reactions.

An Investigation Of The Sintering Of Iron-Wire Compacts, George L. Vivian

Bachelors Theses and Reports, 1928 - 1970

A study of the sintering of iron has been made by observing the rate of bonding of iron wires wound on iron spools. The specimens were sintered at a constant temperature of 850c in vacuum furnaces capable of producing pressures of 10-5 to 10-4 mm of mercury, and the growth of the bond between wires was observed as a function of time.

It has been concluded that the volume-diffusion mechanism is strongly operating in the sintering of iron at 850c, but in an evacuated system, the evaporation-condensation mechanism also contributes to the sintering process.

The Aerodynamic Drag Of Spheres, Leon Rouzelle Scott

Theses and Dissertations

A literature survey was conducted to determine the factors which affect aerodynamic drag of spheres. Graphs are presented which show the effect of each variable where such information was available. Equipment was designed and built for the purpose of studying the effects of acceleration on the aerodynamic drag of spheres. Special emphasis was placed on the measurement and control of each of the other variables which can affect the drag. Tests were conducted using large spheres in air and water to show that the method presented can produce a valid determination of the drag coefficients. The numerical values of the …

Comments On: Aasho Interim Guide For The Design Of Rigid Pavement Structures (Aasho Committee On Design, February, 1962), James H. Havens, Ronald D. Hughes

Kentucky Transportation Center Research Report

We have reviewed the AASHO Interim Guide for the Design of Rigid Pavement Structures, and Messrs. Havens and Hughes of our staff have prepared comments on the guide. These comments do not deal entirely with the rigid pavement guide, but rather compare some of the design concepts from the Flexible Pavement Interim Guide.

The Irish Plumber And Heating Contractor, May 1962 (Complete Issue)

Building Services Engineering

No abstract provided.

The Application Of Nuclear Techniques To The Measurement Of Moisture And Density Of Highway Construction Materials, Robert C. Deen, J. D. Shackelford

Kentucky Transportation Center Research Report

In recent years much attention has been directed toward the application of neutron and gamma ray techniques to soil moisture and density measurements. This application of radiological measurements of these characteristics of materials of highway construction, of course, is of great interest to the highway industry since the performance of the total pavement system is highly dependent upon the condition of the embankment, subgrade, and base components of this system. An important measure of the state of condition of unconsolidated earth materials is their unit weights and moisture contents. The highway engineer undoubtedly would welcome any method or technique which …

A Study Of Sprinkler Uniformity Evaluation Methods, Baha Dabbous

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

The use of water in homes, on farms, by factories, and for recreational purposes has been increasing rapidly. Water use has doubled in the last three decades. By 1980, water use is expected to be double the current use. In arid and semi-arid regions, the practice of successful profit-yielding agriculture often depends on irrigation. Irrigation is, in turn, dependent upon a water supply which is limited. The highest possible efficiency should be maintained if maximum utilization of the available water resources for irrigation is desired. Sprinkler irrigation allows, among other things, high water application efficiencies with good distribution uniformities.

An Approach To Azimuth Angle Refraction Corrections, Wallis R. Cramond

Electrical and Computer Engineering ETDs

In the past, analyses of tropospheric reactions of electromagnetic waves propagating in the atmosphere have been based on spherically symmetric medium. However, this applies only to ray bending in a vertical plane (elevation angles). Numerous methods have been developed to correct for elevation angle errors. In 1961, the presentation of a new method for use in a nonsymmetric atmosphere revived interest in horizontal (azimuth angle) bending. In order to use this method to test significance of azimuth angle errors, the spacial distribution of index of refraction must be known.

The primary objective of this paper is to propose a model …

A Theory Of Self-Evaluating Discrete Communication Systems, Samuel D. Sterns

Electrical and Computer Engineering ETDs

No abstract provided.

The Irish Plumber And Heating Contractor, April 1962 (Complete Issue)

Building Services Engineering

No abstract provided.

Plastic Models For The Study Of Thermal Stresses, Carl W. Theisen

Mechanical Engineering ETDs

The purpose of this thesis was to determine and evaluate an experimental method for accurately measuring thermal stresses in structural shapes subjected to large transient thermal gradients, without introducing the problems of high temperature instrumentation, or expensive and elaborate test facilities. Most experimental methods consist of mounting high temperature strain gages on the prototype or model of the metal structure to be evaluated, thermal shocking the structure and then recording the accompanying strains. This method is used quite extensively in the aircraft field, and in others, where the effects of thermal stresses must be considered. However, problems are encountered when …

Radar Back-Scatter Theories For Near-Vertical Incidence And Their Application To An Estimate Of The Lunar Surface Roughness, Harbhajan S. Hayre

Electrical and Computer Engineering ETDs

This work, after the critical examination of the theoretical background on back-scattering from rough surfaces, offers a new approach to its theory. Various back-scatter theories, as well as the statistical models of terrain and moon assumed therein, are critically reviewed and correlated. A new approach which uses a simple statistical model is then presented for the description of scattering of electromagnetic waves from a rough surface. The statistics of a rough surface are discussed in terms of certain parameters which can be easily associated the surface features, and a new expression for the back-scattering radar cross section per unit area …

A System For Recording Electromagnetic Atmospheric Noise In 30-50 Cps Region, James F. White

Electrical and Computer Engineering ETDs

The electromagnetic noise spectrum extends from below 1 cps to above 3,000 mcs. Within this spectrum many phenomena of atmospheric noise have been observed. Those atmospherics which occur in the audio frequency region of the spectrum have been given not only descriptive but also subjective names by many different investigators. As a result, it is often difficult to determine from the literature what aspect of the noise phenomenon is being considered. In addition, references to low frequencies involved in certain experiments are vague. A brief history of atmospherics research is presented here in order to explain the terminology, to show …

A Study Of Gamma-Ray Photoconductivity In Organic Dielectric Materials, Stanley E. Harrison

Electrical and Computer Engineering ETDs

The gamma-ray photoconductivities of polyethylene, polystyrene, polyvinylchloride, polypropylene, Teflon, Nylon, Kel-F, and three thermosetting resins denoted as Epoxy 1478-1, 1478-3, and 1478-22 have been measured. The measurements were made at steady-state gamma-ray intensities ranging from 1.0rad(H₂O)/min to 3.0 x 10⁵ rads(H₂o)/min and at controlled temperatures ranging from 90 degrees Fahrenheit to 140 degrees Fahrenheit. Conductivity changes resulting from the steady-state gamma-ray exposures were measured continuously throughout the exposure and after the exposure. The exposure period was of sufficient duration to allow all samples to achieve an equilibrium conductivity value.

The Development Of A Static Pressure Probe For The Interaction Region Of Shock Waves And Boundary Layers, John Rode

Mechanical Engineering ETDs

The purpose of this investigation was to develop a static pressure probe for measuring static pressures in the region of interaction of a shock wave and a boundary layer. Requirements of such a probe are: small size to permit measurement of pressure variations within the thin boundary layer, pressure coefficient close to unity to permit precise static pressure measurements in regions of unknown and varying velocity and proper response to large pressure gradients.

Pavement Roughness Studies (A Progress Report), Rolands L. Rizenbergs

Kentucky Transportation Center Research Report

Road roughness testing in Kentucky was first reported in 1949 (1). At that time, emphasis was placed on localized irregularities in pavement profiles detectable by a roller-type straight edge. The experience gained then pointed to the necessity for making a fast, continuous recording of characteristics of the road which would be more closely related to riding quality. Subsequent progress reports (2)(3) dealing with the development of triaxial acceleration as applied to the evaluation of pavement riding qualities emphasized riding comfort or discomfort. The accelerations monitored then were evaluated in terms of g's per seconds or "jerk", which is considered by …

Engineering Properties For Soil Series Mapped In Kentucky, Robert C. Deen

Kentucky Transportation Center Research Report

Soil maps, and particularly engineering soil maps, are proving to be desirable in the planning and design stage of many types of structures and land developments. Problems associated with foundations, drainage and soil behavior may be recognized at a very early stage during the preliminary location and site selection through the use of adequate soil maps.