Engineering Commons^™

Subcritical Flow Over Various Weir Shapes, M. Leon Hyatt, Gaylord V. Skogerboe, Lloyd H. Austin

Reports

Submerged flow exists for any given structure when a change in flow depth downstream from the structure causes a change in flow depth upstream from the structure for any given constant value of discharge. The two flow depths, normally measured when submerged flow exists, consist of a depth upstream from the structure, which is used also for free flow conditions, and a depth of flow located any place downstream from the structure. The initial studies in which the submerged flow analysis was developed were made on flat-bottomed flumes (Hyatt, 1965; and Skogerboe, Walker, and Robinson, 1965). Later studies verified the …

Evaluation Of Free And Submerged Flow Data For Large Parshall Flumes, M. Leon Hyatt, Gaylord V. Skogerboe

Reports

Because the accurate measurement of water plays such an important part in water management, such structures as weirs, orifices, calibrated gates f and flumes have been developed. These structures provide the means for reasonable measurement of the smaller flows (1: .. 100 cfs), but for the large flows (100-3,000 cfs) the current meter, large Parshall flume, and various other flumes are commonly used. Where a permanent structure is required, the most widely accepted and utilized method for measurement of large flows is probably the Parshall flume. The purpose of this report has been to collect the existing flow data for …

Estimating Evaporation And Evapotranspiration From Climatic Data, Jerald Emmet Christiansen

Reports

No abstract provided.

Mathematical Hydraulics Of Surface Irrigation, Cheng-Lung Chen

Reports

The general hydrodynamic equations for a spatially varied unsteady flow in a prismatic open channel having an arbitrary cross-sectional shape can be derived from the equations of continuity and momentum. The assumptions based on the general concept of hydrodynamics and the theory of shallow water is introduced. The mathematical models in the surface irrigation can be formulated by these equations of motion with the appropriate initial and boundary conditions prescribed at the singularity point (the origin in the x, t-plane) and at x = 0. Therefore, the flow in the surface irrigation must be described by solving the boundary-value problem …

Hydrologic Instrumentation And Telemetering, Duane G. Chadwick

Reports

The following report discusses the various phases of work carried out by the Utah State University under a cooperative agreement contract with the Soil Conservation Service for the period extending from June 1965 to June1966.

The body of the report discusses instrumentation techniques employed for the remote telemetering of total precipitation and water content of snow. Discussion of performance of a new type pressure pillow is also given for measuring the water content of snow. Data taken during system evaluation is presented in the Appendix.

Test 943: Oliver 1550 Diesel, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 934: John Deere 4020 Syncro-Range Lpg, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 935: John Deere 1020 Gas, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 938: John Deere 2020 Diesel, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 942: John Deere 3020 Syncro-Range Lpg, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Measuring Water With Parshall Flumes, Gaylord V. Skogerboe, M. Leon Hyatt, Joe D. England, J. Raymond Johnson

Reports

Preface: As the value of water increases, the extent to which measurement is employed in an irrigation system also increases. Additional flow measurements provide information for improved management of the water supply. Good water management requires accurate measurement. Many devices have been developed for this purpose and are in use. Included among them are weirs, orifices, calibrated gates, Parshall flumes, and current meters. Of these, the Parshall flume is one of the most widely accepted and used. Presented in this publication is a discussion concerning the use of Parshall flumes for measuring water, including the utilization of a new approach …

Proceedings Of A Summer Institute In Water Resources: Volume 4 - General Principles Of Water Resources Planning, Aaron Wiener, P. Zusman, W. R.D. Sewell, Harvey O. Banks

Reports

Foreward: Recognizing the need for training of individuals to meet the rapidly rising problems connected with water resources development, Utah State University, with National Science Foundation support, organized a Summer Institute in Water Resources for college teachers. it was hoped that participants carefully selected from all regions of the country would receive additional insight and stimulation to improve and enlarge water resources training programs at their own institutions. Thus, the accelerated dissemination of such knowledge on a national scale could be facilitated. Realizing further that the key to a successful institute of this nature lay in the excellence of its …

Test 932: Ford 5000 8-Speed (Gasoline), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 936: John Deere 2020 Gas, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 939: John Deere 4020 Syncro-Range Gas, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 943: Oliver 1550 Diesel, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 944: Oliver 1550, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Minimum Cost Data Collection Techniques For Circulation Control At The University Of Missouri At Rolla Library, John Peter Shewchuk Sr.

Masters Theses

"Data collection is beginning to assume increased importance in the field of data processing. This thesis investigates a method for quantitatively selecting a portion of the library to place on an automated circulation control system that uses data collection as an entry into a data processing system.

The circulation function of the library was considered to be an inventory problem. Titles were considered as items of inventory and circulation of that title was considered to be a "sale" of that item. The IMPACT method was used to distribute items (titles) in a sample by age. Various ages were found to …

The Effect Of Moisture On The Compressive And Tensile Strength On A Variety Of Rock Materials, Richard A. Martin

Masters Theses

"The effect of moisture on the strength characteristics of rock materials has been neglected in the study of rock mechanics. This study was undertaken to determine if there was any effect on the compressive and the tensile strength of rock by varying the moisture content from an oven-dried to a saturated condition.
It was found, by testing eight different rock materials that the compressive strength per unit area decreased with an increasing moisture content. The tensile strengths per unit area, with the exception of the quartzite and the porphyry samples, also decreased with an increase in moisture content. The tensile …

Test 933: Ford 5000 Select-O-Speed (Gasoline), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Turbulence Measurements In Polymer Solutions Using Hot-Film Anemometry, Gary Kent Patterson

Doctoral Dissertations

"Hot-film anemometry was used to study the detailed structure of turbulence (intensities, energy spectra, and auto-correlations) in Newtonian solvents, non-drag reducing polymer solutions, and drag reducing polymer solutions. This was done in two smooth wall tubes with diameters of 1.0 inch and 2.0 inches. A probe traversing mechanism was used for measurements at radial positions from the center to as near the wall as possible for both the film probes (r/a=0.85 in the 2-inch tube) and the impact tubes (r/ a=0.98). The impact tubes were used to measure velocities for film probe calibration.

The solvents used in this investigation were …

Planning A Dairy Farm, A W. Hobbs

Journal of the Department of Agriculture, Western Australia, Series 4

THE average dairy farmer makes improvements to his property as opportunity offers, working towards a goal he has formulated in his mind.

This gradual development may eventually lead to his desired layout.

Australian Tractor Test Report No. 41 : The Massey-Ferguson 135, G H. Vasey, F. T. Baillie

Journal of the Department of Agriculture, Western Australia, Series 4

THE Massey-Ferguson MF-135 is a general purpose tractor of 31 drawbar horsepower. It has 14.9 x 24 pneumatic tyres, and a three-speed gear box with a ratio change which, in the standard model, gives six forward and two reverse gears.

The model tested was also fitted with the optional "Multipower" facility, which gives an "on-the-go" shift to a higher speed for each gear, thus providing 12 forward and four reverse gears.

Application Of Electronic Analog Computer To Solution Of Hydrologic And River Basin Planning Problems: Utah Simulation Model Ii, J. Paul Riley, Duane G. Chadwick, Jay M. Bagley

Reports

As demands upon available water supplies increase, there is an accompanying increase in the need to assess the downstream hydrologic system. At Utah State University this problem is being approached by electronic analog simulation of the hydrologic system. Modeling concepts are based upon the development of basic relationships which describe the various hydrologic processes. Within a system, these relationships are linked by the continuity -of-mass principle which requires a hydrologic balance at all points. Once established, the model is applied to any particular geographic unit by determining the appropriate constants of the hydrologic equations. The analog computer is ideally suited …

A Study Of Modified Plug Designs For A Globe Valve, Robert W. Wagner

Masters Theses

"This thesis presents an empirical study of the characteristics of a cylindrical skirted disk valve used as a flow regulating device. Holes were drilled in two separate removable cylinders, which, when respectively attached to the valve plug adapter, provided control of the flow rate. These cylinders could be moved to permit exposure of more or less flow area by means of the valve stem and crank mechanism. At the closed position of the valve no holes were available for flow within the differential pressure zone of the valve, while at the full-open position all the drilled holes were within the …

Approximate Solution Of The Momentum And Energy Equations For Partially Ionized Argon, Sir-Hoi Chen

Masters Theses

"Based on available experimental data, the transport properties of partially ionized argon gas have been determined by solving the integral equations of momentum and energy conservation by an approximate method. The momentum and the energy conservation integral equations are solved simultaneously by an iteration method by assuming both parabolic and cubic velocity and temperature profiles separately. The results are compared with the case of linear velocity and temperature profiles"--Abstract, page iii.

Permeability And Additive Sorption And Extraction In Lubricating Greases, Hsiu-Hsiung Lin

Masters Theses

"An important goal in the study of lubricating greases is the determination of the mechanism of additive action in lubricating greases and the effect of additive concentration on the improvement of particular properties. As a step in this direction, one aim of this investigation was an attempt to determine whether grease additives are sorbed on the thickener surface, or are dissolved in the oil phase, or if a combination of these effects prevails. Exploratory sorption and extraction experiments were run by Tu using greases thickened with lithium hydroxystearate and Baragel and using only one concentration of additive. More detailed studies …

The Development Of A Modified Soil Shear Vane, Vernelle Truman Smith

Masters Theses

"The purpose of this investigation was to determine how the soil shear graph could be modified to measure more accurately values of shear strength of fine-grained, cohesive soils. Several modifications were tried, however, the one that gave the most satisfactory results consisted of a vane and base plate mechanism.

A red clay of high plasticity obtained from a local cave was tested in both the natural or undisturbed state and in the remolded state. The only variable was the moisture content. Compaction effort was the same for all remolded specimens. Tests were conducted on undisturbed samples taken with thin walled …

The Kinetics Of The Reaction Of M-Nitrobenzyl Bromide With Hydroxide Ion In Aqueous-Aprotic Solvent Mixtures, Ramesh Nagindas Sheth

Masters Theses

"The reaction between m-nitrobenzyl bromide and sodium hydroxide in homogeneous aqueous dioxane and aqueous tetrahydrofuran media was studied.

The product of the reaction was identified by infrared, gas chromatography and chemical tests as m-nitrobenzyl alcohol.
The kinetics of the reaction are second order with practically no variation in the rate constants as the % of the organic solvent was changed in the medium. This seems to imply hydrolysis of the organic halide by a process involving both bond-breaking and bond-formation in the transition state.
The activation energy, measured in 50% aqueous dioxane, between 20⁰ and 69.5⁰C at 5 different temperatures, …

Checking Rigid-Framed Structures By Extended Moment-Area Equations, Lucky Li-Chi Chow

Masters Theses

"Using the known moments obtained from the moment distribution solution, the extended moment-area equations are used to check whether or not delta x, delta y, delta theta are truly zero, or are any other quantity they are supposed to be. In order to get a reasonably correct answer, a solution must meet both the elastic checks and the static checks for their equilibrium and compatibility functions. Using the extended moment-area equations, the magnitudes of the slopes and deflections at all of the joints in framed structures can be found easily"--Abstract, page ii.