Engineering Commons^™

Land Reclamation, A. E. Lamm

Mining Environmental Conference

No abstract provided.

Operation Green Earth, Alten Grandt

Mining Environmental Conference

No abstract provided.

Voluntary Land Reclamation In The Florida Phosphate Industry, Earl Wells

Mining Environmental Conference

No abstract provided.

The Present Status Of Reclamation In The Sand And Gravel Industry, W. I. Thieme

Mining Environmental Conference

No abstract provided.

Water Problems, Jennings Randolph

Mining Environmental Conference

No abstract provided.

Extent, Sources And Control Of Pollution From Mining Activities, Don L. Warner

Mining Environmental Conference

No abstract provided.

Deep Well Disposal Of Liquid Mine Wastes, Erle C. Donaldson

Mining Environmental Conference

No abstract provided.

Test 1006: Case 1470 Traction King (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

A Digital Dynamic Data Compensation Technique, George Lee Schulz

Mechanical Engineering ETDs

The output of seismic transducers is proportional to the input only for inputs in specific frequency range. This paper presents a method for extending the usable frequency range of seismic transducers through the use of a digital data processing technique. The method is based on the assumptions that a seismic transducer may be represented by a damped single degree of freedom system and that the output of the transducer is proportional to the relative displacement between the seismic mass and the surface on which the transducer is mounted. The computational technique utilizes a new, efficient, and accurate method of numerical …

Test 1005: Allis-Chalmers 180 Gasoline, Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Reflection And Transmission Of Dipole Radiation In Presence Of An Extended Boundary, Rough And Smooth, Byong Ki Park

Electrical and Computer Engineering ETDs

Several different forms of integral solutions exist to the problem of dipole radiation in presence of a half space with plane boundary, all of which can be easily shown to agree with one another by transformation. For the evaluation of these integrals, a number of assumptions are usually made on some parameters in the expressions such as the medium property, the wavelength and so on. Unfortunately, however, even with these simplifying (but meaningful) assump­tions, practically useful results for the dipole radiation problem are still lacking. Also it appears that there is no theory of dipole radiation when the plane boundary …

A Criterion For Dynamic Low-Cycle Shear Fracture, Teh T. Liu

Mechanical Engineering ETDs

The present investigation establishes a cumulative-damage criterion for specimens subjected to reversed cyclic dynamic shear loads. The empirical equation is found to be:

where

= the change in plastic shear strain at each loading.

= the ultimate shear strain at single loading.

= the empirical exponent to be determined.

Specimens of 6061-T6 aluminum alloy were tested under reversed shear loadings from 1 to 22 applications prior to fracture. The amount of shear deformations was measured at the center part of the critical section. The data was analyzed with the aid of a digital computer. The exponent p in the power …

A Study Of Thin-Film Superconducting Junctions, William P. Korink

Electrical & Computer Engineering Theses & Dissertations

The information presented in this paper is the result of research conducted toward the development. of a reproducible thin-film superconducting junction. The results of this experimentation and the equipment and procedures used are provided.

A qualitative explanation is given for the theory used in the derivation of the volt-ampere characteristics of thin-film superconducting junctions of metal-insulator- metal construction. This explanation entails the electron flow through the insulating layer through the use of the Fermi-Dirac and density of states functions.

The theoretical investigation is based on the BCS Theory and results in volt-ampere characteristics that agree very well with published experimental …

Test 1004: John Deere 1520, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 1003: John Deere 2520 Syncro Range, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 1002: John Deere 2520 Power Shift, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

The Irish Plumbing And Heating Engineer, March 1969 (Complete Issue)

Building Services Engineering

No abstract provided.

Analysis Of Traffic Loads On Bridges: Report Ii Characteristics Of Traffic On Ohio River Bridges - 1968, Robert L. Lynch

Kentucky Transportation Center Research Report

The recent bridge disaster at Point Pleasant, West Virginia, has renewed concern about the mechanism of material fatigue as a possible cause of catastrophic failure of bridge structures. A reasonable methodology for evaluating the fatigue condition of the highway bridge requires a knowledge of the distribution of traffic loads utilizing the facility during the analysis period. The accuracy of such an analysis is dependent on the accuracies of the input data -- material fatigue properties and traffic characteristics. The more critical of the above parameters, with respect to accuracy, appears to be traffic characteristics. This is especially true of vehicle …

The Irish Plumbing And Heating Engineer, April 1969 (Complete Issue)

Building Services Engineering

No abstract provided.

Fm 30-16, Technical Intelligence, 28 February 1969., Robert Bolin , Depositor

United States Department of Defense Military Intelligence

This manual defines technical intelligence and explains the technical intelligence process. It briefly discusses the top level Army technical intelligence production organizations, which at that time were Foreign Science and Technology Center, the Missile Intelligence Directorate of the US Army Missile Command, and the Medical Intelligence Office of the Office of the Surgeon General of the Army.

It explains the technical intelligence activities and planning in US Forces in the field.

Considerable attention is given to explaining the proper procedures for recovery and evacuation of foreign equipment and documents.

The appendices contain an extensive list of references, the categories of …

Further Investigation Of Light Gage Steel Forms As Reinforcement For Concrete Slabs, C. E. Ekberg Jr., R. M. Schuster, Max L. Porter

American Iron and Steel Institute (AISI) Specifications, Standards, Manuals and Research Reports (1946 - present)

No abstract provided.

Three-Bolt In-Line Connections With Low Ductility Light-Gage Steel, D. W. Popowich, S. J. Errera, George Winter

CCFSS Library (1939 - present)

INTRODUCTION In order to investigate the influence of ductility on the strength and behavior of bolted connections, Dhallal (1) conducted tests on single bolt lap joints using "low ductility" steels. As part of a separate investigation, Popowich (2) conducted tests on single, double, and triple bolt in-line lap joints using "high ductility" steels. The investigation reported herein was performed in order to compare the performance of 3 bolt in-line connections of high ductility steels (21 to 53% elongation in a 2 inch gage length) with that of similar 3 bolt in-line connections of low ductility steels (nominally 5 and 10% …

Rheological And Ultimate Strength Properties Of Cohesive Soils, Gordon D. Scott

Kentucky Transportation Center Research Report

In recent years, there have been considerable advances made in rheological theory and its application to various materials. There has not been, however, nearly as much work done toward applying rheology to soil mechanics as the successes of others would seem to indicate. For instance, it has been shown that a variety of stress and deflection problems considering the application of a load by means of an elastic plate to an elastic foundation can be extended to include rate effects through the application of linear viscoelastic theory. Before this theory can be applied to foundation design, however, two questions must …

Settlement Of Highway Bridge Approaches And Embankment Foundations, Tommy C. Hopkins

Kentucky Transportation Center Research Report

The nature and causes of the differential settlement between a bridge deck and the adjoining highway pavement have been studied by only a few investigators. Highway engineers often attribute this fault in the riding surface to the settlement of the embankment because of the improper placement and compaction of material in the approach embankment. Although there exists suggestive evidence that this condition produces the bridge approach fault, no conclusive evidence has been presented which shows this to be the primary source of settlement. Jones (1), Bishop (2) and Deen (3) suggest that differential settlement between the bridge deck and approach …

The Irish Plumbing And Heating Engineer, February 1969 (Complete Issue)

Building Services Engineering

No abstract provided.

Computer Specification Of Centrifugal Pump And Motor, Paul David O'Lenick

Theses

The purpose of this thesis is to develop a PORTRAIT computer program for selecting a centrifugal pump and motor driver. This is accomplished by means of generalized data which establishes the speed of the Dump and its power requirement. After selection of the pump, the motor is sized and specified. In addition to determining the pump and motor, the program also sizes the discharge and suction lines and the required control valve. The resulting solution yields the pump design data, motor, line and control valve sizes. From this data utility and relative equipment costs can be estimated.

A Simple Observational Technique For The Investigation Of Boundary Layer Stability And Turbulence, Tony Maxworthy

Symposia on Turbulence in Liquids

A dense suspension of aluminum flakes in a fluid has many advantages as a flow-visualization method, and has been used to study circular Couette flow and Benard instability, among others. In the present contribution the scientific and pedagogical merits of the technique are examined further for three different cases: (a) Stability of Poiseuille flow; (b) Stability of the side-wall boundary layers created when a fluid-filLed, rotating container is suddenly brought to rest; (b) Stability of the boundary layer beneath a concentrated vortex.

The technique is also useful in other cases, especially when fundamentals of fluid flow are to be demonstrated …

Measurements Of Density Fluctuations In Submerged Water Jets, L. N. Wilson, D. W. Prosser

Symposia on Turbulence in Liquids

A remote sensing technique, free from many of the problems associated with Inserting probes into a liquid flow, has been developed to measure turbulent density fluctuations In a low speed, submerged water jet. The technique employs two schlieren optical systems, composed of He-Ne lasers and photo detectors. The optical beams intersect in the flow in a plane perpendicular to the flow direction. Knife edges are aligned such that the systems are sensitive to gradients of refractive index in the flow direction. An analysis is presented which relates the cross-covariance of the two signals to the local two-point refractive-index covariance and …

Effect Of Dilute Polymer Solutions On External Boundary Layers, Brian Latto, J. A. Middleton

Symposia on Turbulence in Liquids

The paper reports an experimental study of the flow of homogeneous aqueous polyacrylamide MRL 402 solution over a thin flat plate. Extensive velocity profile data were obtained, using both cylindrical and conical hot-file probes, and used to obtain local skin friction profiles. Direct drag measurements were made over a period of time for concentrations of 0, 25, 50 and 75 wppm and indicated that there was no appreciable degradation of the polymer. Extensive turbulence intensity data were obtained which were contradictory but indicated that the conical type probe is better than the cylindrical type for turbulence measurements and that the …

Fatigue Testing Of Light Gage Metal Forms, Kenneth W. Mouw

CCFSS Library (1939 - present)

No abstract provided.