Engineering Commons^™

The Effect Of A Knurled Heat Transfer Surface Upon Pool Nucleate Boiling Of Normal Pentane, Jerry James Carr

Doctoral Dissertations

"The effect of knurling a nucleate boiling heat transfer surface was studied. The knurling utilized produced regular, four-sided, adjacent pyramids with an apex angle of 90 degrees. Four knurling densities were used ranging from 416 to 2591 pyramids per square inch. The transfer surface was gold-plated copper and the heaters used were electrically heated, ten-inch long, horizontal cylinders of one-inch diameter. The liquid boiled was normal pentane at its saturation temperature and a pressure of 760 millimeters mercury.

For some of the knurled surfaces the temperature difference required to produce a given heat flux was found to be less than …

X-Ray And Neutron Diffraction Study Of The Holmium-Iron System, Michael Fred Simmons

Doctoral Dissertations

"Neutron diffraction and x-ray powder studies have been made of holmium-iron intermetallic compounds. The magnetic moments of Ho and Fe are in good agreement with measured spontaneous magnetization assuming a ferrimagnetic model with the Ho moments antiparallel to the Fe moments. The magnetic moments of the Fe atoms are found to be localized and thus independent of the rare earth content in the alloys. In contrast to HoCo₃, (00ℓ) type magnetic peaks in the neutron diffraction patterns are still prevalent at room temperature and gradually decrease as the Curie temperature is approached. This fact indicates that the easy direction of …

A Generalized Investigation Of Potential Aggregate Availability By Regional Geomorphic Units Within The Adjacent 48 States, Matthew W. Witczak, C. W. Lovell

JTRP Technical Reports

No abstract provided.

Preparation Of Metallic Oxide Aerosols By Vaporization And Degradation Of Organic Compounds, Tom B. Larsen

Chemical and Biological Engineering ETDs

Simple, dependable methods for the generation of aerosols are necessary to many forms of research. Specifically inhal­ation research has a requirement for sub-micron sized insoluble particles.

Two different methods for the production of oxide aerosols from vaporizable compounds were tried. The first method, a mod­ification of the Rapaport-Weinstock generator (R3), consisted of nebulization of a solution into a droplet mist. Next the drop­lets were vaporized, and condensation nuclei formed from the nonvaporizable impurities in the solution. The vapor was allowed to condense on the nuclei in a relatively large chamber, then the resulting liquid droplet aerosol was dried and converted …

An Experimental Study On Heat Transfer Coefficient For Carbon Laden Gas, Jacob Chi-Kwong Huang

Chemical and Biological Engineering ETDs

Abstract

A complete carbon black pilot plant was employed in this study. Carbon laden gas was produced in a fur­nace and introduced into the outer pipe of a heat ex­changer. Air, at the same time, was introduced into

the inner pipe of the heat exchanger cocurrently with the carbon laden gas. Thus, heat, with temperature dif­ference as driving force, would transfer from the car­bon laden gas to the air stream. The temperatures along the two streams were measured by iron-constantan ther­mal couples and recorded by a multi-reading temperature

recorder. Air supply and fuel (C3H8) supply were intro­duced into the furnace …

A Comprehensive Investigation Of The Behavior Of Saturated Sands Subjected To Cyclic Triaxial Loadings., James Francis Kanipe

Civil Engineering ETDs

Considerable interest in earthquake engineering has developed during the past decade. Due to the potential hazards involved in foundation failures of nuclear power plants, and because there is an increase in the demand for earth dams throughout the world together with a decrease in desirable sites, it has become imperative that reliable techniques be developed to predict the response of soils to earthquake induced forces. As an integral part of such an endeavor, this research program was directed toward the identification of the various factors which significantly influence the development of pore pressure in saturated sands subjected to cyclic stress …

Diffusion In Wide Grain Boundaries, J. Mimkes, Manfred Wuttig

Materials Science and Engineering Faculty Research & Creative Works

The rigorous solution of the grain-boundary diffusion problem has been approximated by a series expansion method. The calculations show that higher-order terms may be neglected in the bulk adjacent to the grain boundary. Thus, in this region Whipple's and Suzuoka's solutions represent a close approximation to the problem. Inside the grain boundary, however, higher-order approximations have to be taken into account. These approximations gain importance in the case of wide grain boundaries. The solutions obtained for an instantaneous source have been fitted to available grain-boundary diffusion data of Ni2+ in MgO at 1200°C. Numerical calculations give for the bulk diffusion …

Relationship Between Soil Support Value And Kentucky Cbr, Tommy C. Hopkins

Kentucky Transportation Center Research Report

Three slightly different correlations between Kentucky CBR's and the AASHO Road Test soil support values were developed. The first relationship was made by assuming a logarithmic scale between Kentucky CBR's of 5.2 and 100, which corresponded to values on the soil support scale of 3 and 10, respectively. The Kentucky CBR of 5.2 was determined by performing tests on the AASHO road subgrade soils. For practical purposes, the AASHO Road Test crushed stone base material was assumed to be a "100 percent CBR material" (this assumption was based on CBR data previously reported by Shook and Fang). The second correlation …

Statistical Quality Control Of Highway Construction And Materials, J. B. Venable

Kentucky Transportation Center Research Report

The objective of this report is to review existing local practices used in establishing and enforcing highway specifications and construction processes and to compare these practices. With procedures based on statistical quality control concepts. In order that statistical quality control concepts may be properly used where applicable, the first part of this report considers the general theory underlying the use of statistical control methods and the development of different types. Of acceptance plans which may be used in the highway construction industry. The second portion of the report is concerned with analyzing and comparing Kentucky's current specification requirements with typical …

Basic Instrumentation Of A Three-Zone Convection Coater Dryer For Calculation Of Heat And Mass Balances, Byron H. Mckinstry

Masters Theses

No abstract provided.

Continuously Reinforced Concrete Pavement, James H. Havens

Kentucky Transportation Center Research Report

A sampling-type crack survey was made in July 1969; 200 feet in each 1000 feet were sampled. The average interval between cracks was 5.78 feet. Paving was completed in late 1968. The average crack interval in July 1970 was 4.14 feet. The 1970 survey was also a sampling type.

It is apparent that cracking approached maturity or equilibrium during the first year. Apparently, too, most of the cracking occurred during the first few weeks after construction – which suggests curing shrinkage as a contributory cause. A discussion of the significance of time and temperature will follow the presentation of other …

Evaluation Of Cored Specimens From Timber Caisson Beneath Pier No. 2 Of The Us 25 Bridge Over The Ohio River Between Covington And Cincinnati, James H. Havens, Assaf S. Rahal

Kentucky Transportation Center Research Report

Pier No. 2 of the former C&O Bridge at Covington is off-shore from the Kentucky side of the Ohio River. It was built in 1887. In 1927, this pier was extended downstream to support a new railroad bridge. The other three piers remained independent. The original structure was then converted to highway use and was purchased by the Commonwealth of Kentucky in 1937. In 1968, an engineering analysis of the superstructure indicated critical deficiencies in terms of "safety factors", and the bridge was closed to all traffic. Subsequently, various plans for reconstruction came under consideration. Of greatest significance here is …

Thermal Expansion Of Tungsten At Low Temperatures, Jayant S. Shah, Martin E. Straumanis

Materials Science and Engineering Faculty Research & Creative Works

No abstract provided.

Rotating Cylinder Apparatus For Rarefied Gas Flow Studies, Darryl J. Alofs, George S. Springer

Mechanical and Aerospace Engineering Faculty Research & Creative Works

A Rotating Cylinder Type Apparatus is Described, Suitable for Determining Drag in Cylindrical Couette Flow of Rarefied Gases, and for Evaluating Tangential Momentum Accommodation Coefficients at Gas-Solid Boundaries. the Apparatus is Equipped with a Damping Device using Diffusion Pump Oil for Eliminating Undesirable Oscillations in the System. Tangential Momentum Accommodation Coefficients of Argon on Aluminum Were Determined with an Accuracy of ±2.5%. the Results Obtained Indicate that the Apparatus May Be Used over a Wide Pressure Range, Corresponding to Free Molecule and Continuum Flow Conditions. © 1970 the American Institute of Physics.

Manpower And Apprentice Training Program, B. B. Myers

Kentucky's Annual Forum on Transportation

No abstract provided.

Pollution Control For Quarry Operations, J. W. Render

Kentucky's Annual Forum on Transportation

No abstract provided.

Pollution Control Anti-Pollution Construction, C. W. Sigler

Kentucky's Annual Forum on Transportation

No abstract provided.

Anti-Pollution Design, E. B. Gaither Jr.

Kentucky's Annual Forum on Transportation

No abstract provided.

Status Of The Five Year Highway Program, J. R. Harbison

Kentucky's Annual Forum on Transportation

No abstract provided.

Professionalism - The Challenge Of The 70'S, Sammie F. Lee

Kentucky's Annual Forum on Transportation

No abstract provided.

Concrete Slip-Form Paving For Secondary Roads, George D. Timm

Kentucky's Annual Forum on Transportation

No abstract provided.

Maintenance Management, John D. Witt, B. H. Banks

Kentucky's Annual Forum on Transportation

No abstract provided.

Roadside Safety, John A. Deacon

Kentucky's Annual Forum on Transportation

No abstract provided.

Maintenance Levels: What, Why, Where And How, Adrian G. Clary

Kentucky's Annual Forum on Transportation

No abstract provided.

Subaqueous Interstate Highway Tunnel Design And Construction, Earl F. Cecil

Kentucky's Annual Forum on Transportation

No abstract provided.

Quality Control In Structural Fabrication, C. F. Jarrard Jr.

Kentucky's Annual Forum on Transportation

No abstract provided.

The "Topics" Program, H. Milton Heywood

Kentucky's Annual Forum on Transportation

No abstract provided.

Utilities-Highway Location, N. W. Coomes

Kentucky's Annual Forum on Transportation

No abstract provided.

Remarks By John M. Branham, John M. Branham

Kentucky's Annual Forum on Transportation

No abstract provided.

Remarks By Bill E. King, Bill E. King

Kentucky's Annual Forum on Transportation

No abstract provided.