Engineering Commons^™

The Photolysis Of Chlorobenzene In An Aqueous Environment, Louis John Del Tufo

Theses

Chlorobenzene was chosen as a model system for the study of photochemically induced reactions in an aqueous environment. It was the goal of this research to achieve a reaction system which best approximates conditions existing in the environment. To do this, a basic model system was established, and then the effect on the rate by various parameters was studied. These parameters, which included the presence of oxygen and such inorganic compounds as might be present in receiving waters, (e.g. nitrate, sulfate, and phosphate), were chosen so as to meet the goal of this research.

Kinetic data was obtained for seven …

Stress-Relaxation Of Cross-Linked Polyethylene At Elevated Temperature, Ravio Luik

Theses

Polyethylene because of its excellent chemical, physical, mechanical and electrical properties, as well as its easy adaptability to extrusion, molding and other processes and its low cost has become a very widely used material for hundreds of applications. But, because it is a thermoplastic, it also deforms and flows when temperatures approach or exceed the crystalline melting point. This handicap, however, can be reduced by crosslinking the polymer chains and thereby converting the thermoplastic to a thermoset material. To further expand the possible uses of this popular material and to further improve the properties, fillers and antioxidants may be compounded …

Distillation Design Techniques, Ronald Michael Carlucci

Theses

A design method for binary distillation systems is presented that minimizes the required rigorous calculations. A computer program is developed that finds the number of theoretical stages, and feed stage for a specified separation and reboiler vapor rate. Results for three binary systems are presented.

The design method and computer program are extended to the multicomponent case at the condition of total reflux. Results for one ternary system are presented. The possibility of using the method at other than total reflux is discussed. Usage of the method to search for multicomponent azeotropes and results are also presented.

Analytic equations are …

Antoine Type Equation For Liquid Viscosity Correlations, Edward Goletz Jr.

Theses

A modified Andrade⁴ equation, similar to the Antoine equation for vapor pressure-temperature correlations, was developed for liquid viscosity-temperature correlations. Included in the investigation were the following compounds: n-alkanes (C₂-C₂₀), n-alkenes (C₂-C₂₀), n-alkyl benzenes (C₆-C₁₀), n-alkyl cyclohexanes (C₆-C₂₂), and fifteen polar compounds. Except for propene, errors of less than 5% were obtained. Normal heptadecane was used to compare correlations developed by Andrade⁴, Walther²⁰, and Doolittle⁹, with the modified Andrade equation. The latter was found to give the best …

Automotive Emission Control, Thomas P. Schultz

Graduate Research Papers

Emission control systems required by the federal government to reduce exhaust, crankcase, and fuel system emissions a.re resulting in engines that have a. totally new set of fundamental characteristics. This paper is intended to examine the various emission control systems and attempt to gain insight into their effect on engine performance, economy, service and trouble shooting techniques that will make servicing these engines more effective.

Interfacial Energy And Wettability Of Some Glass-Metal Systems, Mahmoud Yehia Demeri

Archived Theses and Dissertations

No abstract provided.

The Spin--An Accident Analysis, Tim Brady

Publications

An analysis of an accident involving a C-130 Hercules is described. C-130s do spin and the outcome is normally fatal to aircrew members.

Jacksonville Urban Area Transportation Study: Annual Certification And Unified Work Program For The Jacksonville Urban Area, Jacksonville Area Planning Board

Arthur N. Sollee, Sr. Textual Materials

Document contains committee activities, surveillance findings, short range multi-modal implementation program, unified work program and suggested funding sources.

The Theoretical Distribution Of Forces In The Rigid Component Of The Buccal Arch Positioner, Dennis H. Teruya

Loma Linda University Electronic Theses, Dissertations & Projects

The distribution of an applied force to the rigid component of the Buccal Arch Positioner was determined with a theoretically formulated model. The rigid component was assumed to be a free body without the semi-rigid attachments and was evaluated at four points for the force distribution. The summation of the forces and the moments were equated to zero and were utilized to derive equations to solve for the unknown forces. The unknown forces at each point of the rigid component were solved for in terms of the given force applications.

A laterally directed force application at one of the posterior …

A Method Of Analyzing Mandibular Movement, Richard B. Mccoy

Loma Linda University Electronic Theses, Dissertations & Projects

Mandibular movement is considered to be a fundamental factor in the study, analysis, and treatment of occlusion. For many years, dentists have realized that dental health depends upon the compatibility of mandibular movements and occlusion. This realization has led to the development of new methods and techniques for recording accurately and scientifically the movements of the mandible. In order for this data to be of scientific value, it must be stored in a usable form which is easily available for analysis.

The purpose of this research project was to develop a procedure for storing and recalling mandibular-movement information. Before such …

An Intensity-Dependent Filter, James M. Thorne, Thomas R. Loree, George Mccall

Faculty Publications

It is useful in optically driven Kerr-cell shutters and other laser applications to have intense pulses with extremely low light levels between pulses. We describe here a device that accomplishes this objective external to the laser cavity.

Aboveground Fuel Oil Storage Tanks, Lawrence George Palmer

Theses

A review of the American Petroleum Institute Standard 650 and Appendixes points out the advantages of using high strength steel and the variable point design method (Appendix K) to obtain reasonably uniform shell stresses. Design limitations imposed by notch toughness and residual stresses are pointed out.

Design considerations for the installation of an internal floating roof in a standard cone roof tank are discussed. Methods of calculating evaporation losses and an economic justification for a floating roof are included. Budget estimate figures have been compiled as a function of tank capacity for tanks, site preparation and tank ringwall or piled …

Sidestream Tower Fractionation : A Short-Cut Calculation Method, Richard David Prickett

Theses

A short-cut procedure has been developed for making calculations on a complex fractionation tower. A Simplification of the Thiele-Geddes plate-to-plate procedure provided the basis for the short-cut procedure. The application discussed in this paper is for a tower with a liquid sidestream drawoff in the rectifying section.

The tower was broken at the feed point and sidestream drawoff locations into three calculation sections. The fractionation in each tower section can then be represented by a rigorous series solution expressed in terms of absorption or stripping factors. These rigorous equations can then be simplified by the use of average absorption or …

Separation Of Glucose - Fructose - Water Systems Via Thermal Parametric Pumping, Zikri Mostafa Ahmed

Theses

Series of experiments were carried out to determine the effect of different factors on adsorption from aqueous solutions of sugar using fuller's earth ( LW 16-30 Mesh ) as an adsorbent. The equilibrium data were fitted to the Langmuir's equation., and an explanation for the deviation of some of these data has been given.

Systems of glucose-fructose and water mixtures were subjected to semi-continuous and continuous parametric pumping operations using activated carbon (400 Filterasorb) as an adsorbent. The results obtained confirm the equilibrium theory of the parametric pump and essentially fulfill the requirements established by Chen and Hill (6) to …

Diffusion Studies With Novel Plastics, Marion Toohey Conway

Theses

The rates of diffusion through two fluorinated groups and two non-fluorinated groups of laboratory prepared membranes were compared with each other and with commercially available cellulose membranes. The membranes.were evaluated, in particular, for possible use with the artificial kidney. Diffusion experiments were conducted with sodium chloride, urea and uric acid. Experimental results were compared to diffusion coefficients calculated in the literature for cellulose membranes. The results show that the rates of diffusion of all of the solutes tested for the laboratory prepared membranes are comparable to that of the cellulose membranes. The fluorinated group had a slightly higher diffusion coefficient …

Minimum Reflux In Fractionating Columns : A New And Improved Short-Cut Method, Elizabeth Garcia

Theses

A short-cut method is presented for calculating the minimum, reflux rate for multicomponent systems. This new method is best suited for use on the computer and gives a very accurate estimate of this important factor in the design of fractionating columns. It does so without going to the tedious and time-consuming calculations of the rigorous methods.

The calculation approach is based on a simplification of the Thiele and Geddes method for fractionating columns under minimum reflux conditions.

The program is written in Fortran IV language and was used on an IBM 370 computer. Input specifications include the split of the …

An Analysis Of The Geneva Mechanism As A Timing Device, Hubert W. Meyer

Theses

A mathematical analysis of the Geneva mechanism was conducted to determine the potential of this device as a tinting mechanism, and the feasibility of replacing the widely used pallet and starwheel escapement with a Geneva mechanism.

The primary objective of the study was to determine if the Geneva mechanism will attain a terminal velocity, and if so, how much time is required to reach this velocity.

To accomplish this objective, the differential equation of motion for the system was derived using Lagrangian dynatos. The equation was programmed and solved on a digital computer.

The study indicated that the Geneva mechanism …

A Study Into The Feasibility Of Constructing A Pedestrian Mall In Newark Downtown, Stephen Wesley Warren

Theses

Newark's central business district has been suffering steady economic decline for at least a decade. In an attempt to halt this trend, and perhaps even reverse it, a feasibility study has been conducted toward the goal of implementing a pedestrian mall in the area.

This study was accomplished by conducting both field examinations of Halsey Street, the area under consideration, and investigating data from other existing United States pedestrian malls.

The results of this study show that it is feasible to construct a permanent pedestrian mall on Halsey Street and that the benefits of doing so far outweigh the costs …

Kinetic Modeling Study Of Catalytic Hydrogenation Of Codimer, William Mounce

Theses

A kinetic modeling study was made on a gas phase catalytic reaction. The data used was that on the hydrogenation of codimer, collected by Tschernitz, et al, The objective was to determine if non-linear least squares regression offers an advantage over linear least squares regression in discriminating between Langmuir. Hinshelwood kinetic equations.

For the experimental data in question, it was found that neither linear nor non-linear regression could distinguish between the two plausible mechanisms. With the particular mechanistic equations and range of data used in this study, the more laborious non-linear analysis offered no advantage over linear regression in discriminating …

Digital Computer Solution Of Electromagnetic Transients In Large Power Systems, Bijan Navidbakhsh

Dissertations and Theses

This thesis is an introduction to the solution of electromagnetic transients by a combination of the Bergeran method of characteristics and the application of trapezoidal rule of integration.

Three test examples solved by digital computer illustrate the step by step solution and computer programming.

To compare this method with the Laplace transformation technique, a test problem solved by both methods and also digital computer is illustrated. In conclusion, the advantages and disadvantages of both methods are compared.

The Random Sequence Closing Control System, Henri Bernard Joyaux

Dissertations and Theses

This thesis describes a digital control system used by the Network Analog Group of the Bonneville Power Administration. This system, the Random Sequence Closing Control System, provides automatic control for a special purpose analog computer used in the study of switching surge over voltages on power transmission lines. This system, which uses pseudorandom data, has made it feasible to analyze switching surge phenomena on a statistical basis.

Resonant Raman Scattering From Iodine: Spectral Changes With Excitation Frequency, P. F. Williams, D. L. Rousseau

P. F. (Paul Frazer) Williams Publications

We have recorded high-resolution resonant Raman spectra of molecular iodine which show very pronounced systematic spectral band-shape variations with incident laser frequency. This frequency dependence and the presence of the multiple overtones in resonant Raman scattering from iodine may be explained by a theory in which the scattering intensity depends on Franck-Condon overlap integrals. We have obtained semiquantitative agreement between the observed spectra and spectra calculated from this theory.

Current Design Practice For Bridge Superstructures Connected To Flexible Superstructures, Jack H. Emanuel, J. Leroy Hulsey, John Best, Joseph H. Senne, Leroy E. Thompson

CCFSS Library (1939 - present)

No abstract provided.

A College Level Helicopter Curriculum, Eugene B. Krueger

Undergraduate Theses and Senior Projects

No abstract provided.

Tartan Surfacing For An Equestrian Overpass, Donald C. Newberry Jr.

Kentucky Transportation Center Research Report

The location of I 64 in Jefferson County traverses Seneca Park, noted for its scenic beauty and superior recreational facilities. A bridle path in Seneca Park necessitated construction of an overpass for equine traffic. A non-slip and sound-deadening, resilient surface was essential for aesthetics and safety. Tartan, a rubbery mat developed primarily for race course and paddock surfaces, was specified and installed on the overpass.

High-Intensity Reflective Materials For Signs, Rolands L. Rizenbergs

Kentucky Transportation Center Research Report

Field observations and laboratory tests and evaluations were conducted on High-Intensity and Engineering grade materials (Scotchlite), manufactured by the Minnesota Mining and Manufacturing Company, and were compared in regard to reflectivity, durability, and cost.

The High-Intensity type materials were found to have outstanding performance characteristics in comparison to Engineering Grade materials. The material significantly enhances sign legibility under low-beam illumination, and accelerated weathering tests showed superior durability.

Characteristics And Models Of Outdoor Recreational Travel, Jerry G. Pigman, John A. Deacon

Kentucky Transportation Center Research Report

The purpose of this investigation was to examine the characteristics of outdoor recreational travel and to evaluate models of travel flow from population centers throughout the United States to outdoor recreational areas in Kentucky. Data were obtained by means of a license-plate, origin-destination survey at 160 sites within 42 recreational areas and by means of a continuous vehicle counting program at eight of these sites.

Among those characteristics of outdoor recreational travel which were examined in more detail were vehicle occupancies, vehicle classifications, and trip-length distributions. Vehicle occupancy was found to depend on the type of recreational area, distance traveled, …

Engineering Geognosy Of The Western Coal Field, W. Mccann, Tommy C. Hopkins, Robert C. Deen

Kentucky Transportation Center Research Report

Engineering soils and geologic reports are invaluable tools for engineers, industrial leaders, community planners and administrators during preliminary stages of planning and site selection for construction projects. Such information can be used to great advantage by planners in making soil and geologic reconnaissance surveys, in organizing and checking field surveys, in correlating and predicting performances of soil and geologic materials, and in locating construction materials and resource deposits. Recognizing the need for this type of information, the Division of Research, Bureau of Highways, Kentucky Department of Transportation, has undertaken a study to report the engineering geognosy of Kentucky. The report …

Pavement Roughness, Measurement And Evaluation, Rolands L. Rizenbergs, James L. Burchett, Larry E. Davis

Kentucky Transportation Center Research Report

Vertical accelerations of a passenger in an automobile are automatically summed while traveling a section of road at 51.5 mph (23.0 m/s). A roughness index is obtained by dividing this sum by the time elapsed during the test. Continuity in measurements since 1957 has been preserved through correlations among successive vehicles involved and reference pavements.

In general, bituminous construction has yielded smoother-riding surfaces than concrete construction. The smoothness of concrete pavements, however, has improved on those projects where slip-form paving was used. Interstate and parkway (expressway) construction continues to yield smoother pavements than other major construction. The rate of increase …

Long-Term Retention Of Tritium In Man, Chin-Jen Ou

Electronic Theses and Dissertations

[No abstract provided.]