Engineering Commons^™

Vapor Pressure And Evaporation Coefficient Of Cadmium Oxide, R. Tom Coyle Jr.

Masters Theses

"Knudsen effusion experiments were carried out on CdO in fused silica crucibles at temperatures of 918°K, 1008°K with orifice areas from 2.742x10^-3 cm² to 30.52x10^-2 cm². The experiments were made in a molybdenum-wire, resistance-heated vacuum furnace. Several orifice areas were used at each temperature and reciprocal pressure versus orifice area plots were made. These plots yielded an upper limit to the evaporation coefficient of. 4.15x10^-2. An equilibrium constant for the vaporization reaction

CdO(s) = Cd(g) + 1/20₂ (g)

of

log Keq = 11.12 - 1.952x10⁴/T.

was obtained. Second and third …

Molecular Diffusion In Polymer Solutions By A Microinterferometric Method, Surendra V. Desai

Masters Theses

"The object of this investigation of molecular diffusion in aqueous polymer solutions was to study the effect of solute concentration on the differential diffusion coefficient and also to study the effect of polymer concentration on the mean integral diffusion coefficient. For this purpose a microinterferometric method was used. Two non-ionic, water soluble polymers, Carboxymethylcellulose (CMC) and Carboxypolymethylene (Carbopol), were used in the study with D-Glucose as a solute.

The differential diffusion coefficient was found to increase with increases in solute concentration in all cases. For CMC, the integral diffusion coefficient at first decreased with increasing polymer concentration but became constant …

Dynamic Response Of A Simply Supported Beam To An Accelerating Point Load, Joseph Victor Cusumano

Masters Theses

"An analysis based on linear theory is presented for determining the dynamic response of a simply supported beam on an elastic foundation acted upon by a moving time dependent point force with axial forces included. This thesis extends the present theory to include an analysis of a point force accelerating uniformly across the beam. In particular, it is shown that the customary resonance conditions which are prevalent for a point force moving with uniform velocity no longer exist for the case of a point force accelerating uniformly across the beam.

The basic problem and its solution are presented for a …

Gap-Graded Gravel For Asphaltic Paving Mixtures, Ernest Harrington Martin

Masters Theses

"The objective of this investigation was to determine if naturally occurring gap-graded gravel can produce asphaltic mixtures meeting minimum requirements for satisfactory pavement behavior.

Ten gap-graded mixes were blended by eliminating certain intermediate sized fractions or combination of fractions from the gradation of a control mix. The weight of the fractions eliminated was distributed to either the coarser or finer aggregate fractions.

All specimens were prepared and tested in strict accordance with procedures set forth in ASTM Designation D1559, "Resistance to Plastic Flow of Bituminous Mixtures Using Marshall Apparatus."

The physical properties compared and analyzed were (1) unit weight, (2) …

Stresses In A Thick Spherical Shell, David Wayne Moore

Masters Theses

"This thesis reports a method to evaluate the stresses in a segment of a thick spherical shell. In the numerical examples loads due to thermal expansion as the shell is constrained at the free edge and a dead load acting vertically downward were considered for a shell assumed pinned but free to rotate and for a shell assumed completely fixed at the edge. A concrete shell was specifically studied but the method would also apply to a shell of any homogeneous, isotropic material"--Abstract, page i.

Small-Signal Impedance Of A Junction Diode At High Injection Levels, John E. Lundy

Masters Theses

"A mathematical expression for the driving point impedance of a junction diode at high injection levels is developed. To evaluate the impedance versus frequency characteristic of a diode, it is necessary to know the minority carrier lifetime as a function of injection level and doping density in the base (lightly doped) region, the junction area, and the base width. The interesting characteristic of the diode impedance at high injection levels is the inductive reactance displayed by the diode.

The expression is developed by solving the differential equation for charge flow in the base region of a diode assuming space-charge neutrality …

The Realization And Application Of Parallel Linear Feedback Shift Registers, Ross K. Heitzmann

Masters Theses

"Two methods for serial-to-parallel transformation of linear feedback shift registers are briefly discussed. A third method for transformation is rigorously developed using a next-state and output equation representation of the linear feedback shift register. An algorithm is developed for simplifying the parallel machine resulting from serial-to-parallel transformation, where simplification is defined as reduction in the required number of modulo 2 adders. A computer program incorporating serial-to-parallel transformation and the simplification algorithm is provided "--Abstract, page ii.

Convective Heat Transfer In Small Cylindrical Enclosures Heated From Below, Donald Wayne Land

Masters Theses

"Free convection in enclosed air spaces is often of prime importance in the design and analysis of panels utilizing the insulating properties of air and other gases. Previous investigations were performed on very thin air layers.

This thesis presents the results of an experimental investigation to determine the heat transfer by convection and conduction through air layers with relative sizes in terms of length/diameter ratios of one-fourth to one.

Eight cylindrical samples were tested. Four had inside diameters of 2.0 inches, and the others were 2.75 inches in diameter. Heat was transferred across the air layers by both conduction and …

Characteristic Impedance Of Open Microstrip Transmission Lines Having Finite Thickness And Multiple Dielectric, Philip Julian Carter

Masters Theses

"A computer program is provided for determining the characteristic impedance of microstrip transmission lines having finite thickness. Infinite and finite ground planes are incorporated into the program. The programmer need only supply information in the form of a data card. This procedure is clearly outlined.

Graphical solutions of characteristic impedance for multiple dielectric microstrip transmission line problems are obtained using a discrete resistive analogue. Computer network analysis programs are viewed as having several advantages not possessed by the physical resistive analogue"--Abstract, page 2.

Some Aspects Of Transient Flow Behavior In Artesian Aquifers And In Hydrocarbon Reservoirs Surrounded By Artesian Aquifers, Alton John Nute

Masters Theses

"An analysis of the principal theories concerning the transient movement of water in artesian aquifers and from artesian aquifers into hydrocarbon reservoirs is presented. Various analytical methods which can be applied to depict the behavior of these two types of aquifer systems are compared.

Most aquifer studies to date have been based upon the Thesis Non-Equilibrium Formula. This equation has been used to calculate the coefficients of storage and transmissibility for aquifers; to evaluate well performance; and to investigate problems concerning recharge, movement, and discharge of aquifer water. However, one problem which still remains is that of accurately predicting the …

A Multiple-Input Chemical 'Memistor' For Adaptive Circuits, Richard Franklin Crall

Masters Theses

"A modification of Widrow’s "memistor" is made in a form suitable for extension to multiple-input devices. This modified form is extensively investigated using analog field maps, and through experimental testing. The multiple-input device presented exhibits good adaptive characteristics and reduces the number of interconnections required in the external circuitry"--Abstract, page ii.

A Comparison Of Friction And Drum Hoisting Systems On An Energy-Input Basis, Hemendra Nath Kalia

Masters Theses

"The purpose of this thesis is to provide a suitable basis for comparing the relative advantages of the friction and drum hoists under various conditions of operation.

Such comparisons are mainly and necessarily based upon physical characteristics of the mechanisms for lack of appropriate economic data. It is believed, however, that this inadequacy may be alleviated to some extent by substituting comparative theoretical energy requirements of' the two hoisting systems under identical duty conditions over a practical range of mining situations involving various depths and daily productions.

This has been accomplished by adapting a computer to standard mine-hoist design techniques …

The Role Of Mortar Aggregate In The Strength Of Concrete : Technical Paper, Charles F. Scholer

JTRP Technical Reports

No abstract provided.

Automatic Technique For Abstracting Color Descriptions From Aerial Photography : Technical Paper, J. Gourley, Harold Teddy Rib, Robert Douglas Miles

JTRP Technical Reports

No abstract provided.

System Evaluation By The Simplified Proportional Assignment Technique : Progress Report, Hassan A. Ayad

JTRP Technical Reports

No abstract provided.

Some Orthosilicates And Their Hydrates, Larry E. Campbell

JTRP Technical Reports

No abstract provided.

Evaluation Of Safety At Railroad-Grade Crossings: Technical Paper, William D. Berg, Thomas Gordon Schultz, Joseph C. Oppenlander

JTRP Technical Reports

No abstract provided.

Distribution Of Stresses And Displacements Within And Under Long Elastic And Viscoelastic Embankments : Progress Report, George Y. Baladi

JTRP Technical Reports

No abstract provided.

Terrain Analysis By Computer : Technical Paper, A. Keith Turner, Robert Douglas Miles

JTRP Technical Reports

No abstract provided.

The Journey To Work: A Singular Basis For Travel Pattern Surveys : Progress Report, Gordon Shunk

JTRP Technical Reports

No abstract provided.

Stress Distribution Within And Under Long Elastic Embankments: Research Paper, William H. Perloff, George Y. Baladi, Milton Edward Harr

JTRP Technical Reports

No abstract provided.

Correlation Of Design Characteristics And Operational Controls With Accident Rates On Urban Arterials : Technical Paper, Thomas Mulinazzi, Harold L. Michael

JTRP Technical Reports

No abstract provided.

Tordon - 2,4-D Dimethylsulfoxide Combination Herbicides For Use In Roadside Development, D. James Morré

JTRP Technical Reports

No abstract provided.

Stress-Deformation Behavior Of Anisotropic Bituminous Mixtures: Technical Paper, Herbert William Busching, William Harner Goetz, Milton Edward Harr

JTRP Technical Reports

No abstract provided.

Evaluation Of Delays And Accidents At Intersections To Warrant Construction Of A Median Lane : Technical Paper, Robert B. Shaw, Harold L. Michael

JTRP Technical Reports

No abstract provided.

The Journey To Work: A Singular Basis For Travel Pattern Surveys : Technical Paper, Gordon Shunk, William Louise Grecco

JTRP Technical Reports

No abstract provided.

Production And Spectral Determination Of Low-Energy, Flash X Rays, Robert I. Loebman

Electrical and Computer Engineering ETDs

With the rapidly expanding use of X-radiation devices for medical, industrial and military purposes, the need arises for diverse methods of producing and measuring the X-ray portion of the electromagnetic spectrum.

X rays may be purposefully produced by a source in a continuous manner, in short pulses or flashes or in a random manner. X rays are also produced undesirably by devices having extremely high voltages or as a byproduct of some energy-producing device such as a nuclear weapon. In most cases X radiation is produced over a wide spectral range of varying intensities rather than at discrete energy levels …

Hot‐Film Anemometry Measurements Of Turbulence In Pipe Flow: Organic Solvents, Gary Kent Patterson, Jacques L. Zakin

Chemical and Biochemical Engineering Faculty Research & Creative Works

Longitudinal turbulence intensities, autocorrelations, and energy spectra have been measured in the flow of toluene, benzene, and cyclohexane in smooth, round 1‐ and 2‐in. I.D. tubes. These measurements were made with a constant‐temperature hot‐film anemometer and covered radial positions from the center to r/a = 0.85 in the 2‐in. tube and to r/a = 0.75 in the 1‐in. tube. The turbulence intensity data were found to be similar to those obtained for air in a 10‐in. pipe by Laufer. A slight diameter effect was observed, the intensities in the 1‐in. tube being slightly lower than those in the 2‐in. tube …

The Mechanism Of The Electrooxidation Of Acetylene On Gold, James W. Johnson, J. L. Reed, William Joseph James

Chemical and Biochemical Engineering Faculty Research & Creative Works

Acetylene has been oxidized anodically in aqueous solutions at 80 °C on gold electrodes. It was found that the partial oxidation to CO₂ was accompanied by a polymer formation. Effects of potential, acetylene partial pressure, pH, and temperature on the rate (current) were measured. A discontinuity in the Tafel curves was noted that indicated a change in the reaction mechanism with potential. The discontinuity was also pH dependent. A mechanism involving the discharge of H₂O and/or OH− has been proposed that is consistent with the experimental results. © 1967, The Electrochemical Society, Inc. All rights reserved.

Anodic Dissolution Of Zinc In Potassium Nitrate, Martin E. Straumanis, J. L. Reed, William Joseph James

Materials Science and Engineering Faculty Research & Creative Works

The apparent valence of pure zinc dissolving anodically in 3% KNO₃ was determined as a function of current density, temperature, and ultrasonic agitation. The apparent valence of zinc dissolving anodically at 24°C diminishes from 2.01 ± 0.01 at low current densities to 1.86 at about 50 ma and remains fairly constant up to about 80 ma cm−2. This valence is affected to some extent by the preparation, e.g., polishing of the electrode, but is independent of its structure (mono- or polycrystal). Ultrasonic vibrations do not influence the apparent valence at high current densities. In all cases a black film …