Engineering Commons^™

An Investigation Of A Bistable Oscillator Used In A Phase Modulated Control Circuit, Yu-Fang Yen

Masters Theses

"A primary component in the investigation of phase modulated control systems is bistable oscillator which converts a constant oscillation signal to control the system. The oscillator is feedback type that utilizes a feedback capacitance and resistance in each feedback path to change its frequency. The theoretical behavior of bistable oscillator was investigated and the non-dimensional results were set for convenience in determining the oscillation period. The control circuit which based on the oscillator was also presented a form of suitable circuit for direct application to practical control problems"--Abstract, page ii.

Development Of An Elastic-Plastic Finite Element Program With The Initial Strain Approach, Vernon Dale Allen

Masters Theses

"A finite element method is presented for solution of plane stress and axisymmetric elastic-plastic problems employing the method of successive elastic solutions with the initial strain approach. The problem of nonconvergence of the initial strain approach for perfectly plastic problems was eliminated by expressing the Prandtl-Ruess equations entirely in terms of strain. Two examples are presented to demonstrate the validity of the method"--Abstract, page ii.

Analysis Of Factors Affecting Station Capacitor Bank Switching Transients, M. Davarpanah

Masters Theses

"The problem presented here is a study using a computer program which predicts the transient response when energizing a station capacitor bank of a power system. The computer program gives the wave shape and magnitudes of switching surges obtained while energized capacitor banks at one location and showing the effect of switching a bank while adjacent banks are already energized. The over voltages are given in line-to-ground voltages on the line side of the capacitor banks as well as at lower voltage levels down to the customer 120 volts service voltages. The purposes are to obtain the optimum values of …

High Temperature Compressive Creep In Mullite, Peter C. Smith

Masters Theses

"Compressive creep measurements were made on two groups of mullites at temperatures between 1455ºC and 1520ºC. The first group consisted of commercially manufactured mullites. The second group was made up of 7 different mullite compositions spanning the alumina-silica solid solution range from 3Al₂O₃ • 2SiO₂ to 2Al₂O₃ • SiO₂ . Thermal activation energies and stress exponents were calculated for the mullites in the second group. Steady state strain rates taken at 1460ºC under loads of 100 and 110 psi varied between 1.3x10⁻⁴ in/in/hr and 15.4x10⁻⁴ in/in/hr. Activation energies were between 109 Kcal/mole and 204 Kcal/mole. Stress exponents calculated from data …

The Use Of Semiconductor Memories In Drug Dispensing, James John De Largy

Masters Theses

"This paper presents the problems encountered and the methods used during the design of an electronic system to be an integral part of a medical drug dispensing machine. The system has a memory composed of both random access and read only memories to enable it to operate, along with many such machines , from one data input line. The system accepts information such as patient's name, social security number, and drug location number. It also provides signal drive to an attached printer in order to reproduce this information for use on the drug label. Finally, the system electronics accepts input …

A Software System For Interactive Man-Machine Design And Analysis Of Electronic Circuits, Leo William Midden

Masters Theses

"The development of an interactive computer-aided circuit analysis program is presented. A graphics terminal is used as an I/O device while an SCC 650 mini-computer is used as peripheral processor. The central processor is an IBM 360/50.

Formulation, capabilities and use of the system are discussed in detail. Close attention is given to user control, making the system both useful and versatile. Both hard and soft copies of all plots and tabular data are available. Provisions are made for error corrections and changes at each step of the input. Parameter values can be altered before and after each analysis.

Additionally, …

Mechanical Properties Of Low Carbon Martensite, Allen L. Affolter

Masters Theses

"Steels of three different compositions were heat treated and tensile tested in order to determine their mechanical properties after heat treatment. All samples had near 0.20 per cent carbon and two manganese levels 0.90 per cent and 1.35 per cent. One group containing the higher manganese level also had small additions of columbium and vanadium. The specimens were too brittle in the as-quenched condition to be loaded to full strength. Maximum strength and ductility were found after short time tempering at low tempering temperatures -- 2 to 15 minutes at 200º to 300ºF. Higher strengths were found at the low …

Practical Application Of Digital Computer To Distribution Systems, Juan Vincente Saavedra

Masters Theses

"Given a three phase ac power distribution system, a digital computer program is presented which determines a complete steady state solution for a given condition. The network data is processed by the computer into an admittance matrix, and these parameters are stored in a manner that enables the computer program to operate upon them as the coefficient of a simultaneous set of nonlinear equations. This set of equations are solved by the Gauss-Seidel Iterative Process improved by a modification of the relaxation method. Practical experience with the distribution system of the Davenport, Iowa, plant of the Aluminum Company of America …

The Artificial Sedimentation Of Soil, John Richard Wagner

Masters Theses

"Previous investigations concerned with artificially sedimented soils and a review of the literature on soil structure are summarized. These studies show that many of the physical properties of a soil depend upon its structure and that the structure of a sedimented soil depends principally upon the salt content of the pore water. In addition, artificially sedimented soils have been shown to have a "natural" soil structure. An apparatus was developed which will automatically sediment soils in water of controlled salt content. To determine whether or not the apparatus was able to sediment uniform and homogeneous soil samples, moisture content determinations, …

The Effect Of Skip-Grading On Stability Of Soil-Aggregate Mixtures., Asif Faiz

JTRP Technical Reports

No abstract provided.

Practical Optimization Of Steel Highway Bridge Beams., Robert Henry Busek

JTRP Technical Reports

No abstract provided.

Optimization Of The Structural Design Of Asphalt Pavements : Technical Paper, Joseph C. Oppenlander, Salim Said Hejal, L. D. Burns

JTRP Technical Reports

No abstract provided.

An Evaluation Of Traffic Signal Coordination, Conway Edward Cooper

JTRP Technical Reports

No abstract provided.

The Prediction Of Running Speeds On Urban Arterial Streets, Kenneth Alan Shackman

JTRP Technical Reports

No abstract provided.

Travel Time And Accident Benefits Due To Reconstruction Of U.S. 52 Bypass At Lafayette, Indiana : Progress Report, Alexander Edward Mcneil

JTRP Technical Reports

No abstract provided.

Mechanical Methods Of Steel Placement For The Slipform Construction Of Continuously Reinforced Concrete Pavements : Technical Paper, Charles F. Scholer, Olubayo Timothy Olateju

JTRP Technical Reports

No abstract provided.

Water Conservation Handbook, D J. Carder, G. W. Spencer

Natural resources published reports

This handbook is intended as a practical guide in some of the most common aspects of water conservation in the agricultural areas of Western Australia. It deals mainly with water conserved in dams for stock and domestic purposes on the farm.

the farm. The handbook does not attempt to deal with all aspects of handling and using water for agricultural purposes. This is a vast subject which extends into many fields such as engineering, irrigation and land use.

The guide does, however, touch on some important aspects of good management of agricultural land. It should be read in conjunction with …

A Generalized Investigation Of Potentially Poor Soil Support By Regional Geomorphic Units Within The Adjacent 48 States : Preprint, Matthew W. Witczak, C. W. Lovell

JTRP Technical Reports

No abstract provided.

Techniques In Slipform Paving And Continuously Reinforced Concrete Pavement Construction, Olubayo Timothy Olateju

JTRP Technical Reports

No abstract provided.

Driver Information Systems For Highway-Railway Grade Crossings, Thomas Urbanik

JTRP Technical Reports

No abstract provided.

Young Drivers' Severe Automobile Accidents : Progress Report, William Asher, Michelle Shapiro

JTRP Technical Reports

No abstract provided.

Practical Optimization Of Steel Highway Bridge Beams: Technical Paper, Robert Henry Busek, John Thixton Gaunt, A. D. Lewis

JTRP Technical Reports

No abstract provided.

Test 1070: Minneapolis-Moline A4t-1600 Diesel (Also Oliver 1655 Diesel) 10-Speed, Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 1065: Allis-Chalmers Landhandler 210 Diesel, Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Effects Of Low Temperature Reactor Radiation Upon Crystalline Sio2, Sami Fouad M El-Iskandarani

Archived Theses and Dissertations

No abstract provided.

Herbicide-Binding Activity Of The Plasma Membrane From Grass Coleoptiles : Progress Report, Carole A. Lembi, D. James Morré

JTRP Technical Reports

No abstract provided.

An Effect Of 2, 4-D Herbicide On The Cell Surface Membrane Of Onion Stem Explants : Technical Paper, Willliam Jan Vanderwoude, Carole A. Lembi, D. James Morré

JTRP Technical Reports

No abstract provided.

Permeability Scaling In A Numerical Coning Model, V. K. Dutta, Marion D. Arnold

Geosciences and Geological and Petroleum Engineering Faculty Research & Creative Works

A method is described for simulating coning into a wellbore using a numerical simulation model. The method allows the wellbore cells to be considerably larger than the actual wellbore. This makes coning studies feasible using an implicit pressure-explicit saturation type model with a reasonable time step. This capability is achieved by scaling the horizontal-vertical permeability ratios to give the proper vertical potential drop.

Anodic Dissolution Of Beryllium In Anhydrous Media, William Joseph James, Martin E. Straumanis

Chemistry Faculty Research & Creative Works

No abstract provided.

Stored Energy Of Room Temperature Deformed Copper, G. J. Filatovs, Hollis P. Leighly

Materials Science and Engineering Faculty Research & Creative Works

No abstract provided.