Process Control and Systems Commons^™

A Mathematical Model And Simulation Of Natural Circulation Loop Thermalhydraulics, Nihad E. Daidzic

Aviation Department Publications

In this work, a simple, nonlinear, seventh-order mathematical model with lumped parameter analysis of the thermalhydraulic processes in a natural circulation steam boiler loop is presented. Digital simulation has been performed in order to predict open loop transients in severe accidental situations. Parts of the circulation loop such as the steam drum, downcomer, and riser were modelled separately on the basis of the integral balance equations. The two-phase flow in the steam drum and in the riser was modelled with the aid of a homogeneous-equilibrium, two-phase flow model. Special care was taken to ensure the stability of the numerical scheme, …

Investigation On The Use Of Ethyl Acetate As Solvent For Seed Oil Extraction, E. L. Rivera Porras

Tanzania Journal of Engineering and Technology (TJET)

An investigation on the use of ethyl acetate as a solvent for the seedoil industry was carried out. As hexane is the most used solvent in extraction of oil from seeds, the study focuses on the comparison of the two solvents. The parameters studied were: contact time between solvent and seed cake, temperature of the solvent, quantity of solvent used for extraction and type of solvent. The results are presented on a relative basis where hexane is given a factor of 100. From the results obtained it can be seen that ethyl acetate is in general a better solvent than …

A Continuous Distillation Operation At The University Of Tennessee At Chattanooga, David H. Cummins

Honors Theses

This paper describes the work done on the design, construction, monitoring, and control of a distillation column. This work was done as a Departmental Honors Project in the School of Engineering at The University of Tennessee at Chattanooga. The column has been completed and the various tests performed with the column have produced satisfactory results. The column parameters are monitored and controlled by automatic controllers with manually adjusted set points. In addition to this, micro-computer based control for the column has been designed, however implementation of this control has not yet been achieved.

Process Control Of Activated Sludge Treatment, Phase Ii, Richard I. Kermode, Robert W. J. Brett, Joseph D. Pault Jr.

KWRRI Research Reports

Material balances on substrate and microorganisms were derived in conjunction with various mixing configurations thought to accurately describe the activated sludge process. These models include the completely mixed with bypass, plug flow, and plug flow with bypass. Two sets of kinetic mechanisms for substrate utilization and bacterial growth were employed.

A feed forward controller was designed from linear approximations of the material balances derived in the completely mixed with bypass mixing model. Utilizing frequency response methods, the controller was found essentially identical to a completely mixed modeled controller developed in a prior investigation.

Through computer simulation the controller's effectiveness was …