Process Control and Systems Commons^™

Optimizing Virus Prefiltration For Biopharmaceutical Manufacturing, Solomon Isu

Graduate Theses and Dissertations

Virus filters are single-use devices that use a size-based separation process. In virus filters, contaminating virus particles are retained while the therapeutic molecules pass through the membrane pores. Virus filters are an essential component of the overall virus clearance strategy. Sections 1 and 2 of this dissertation provide an introduction and extensive review of monoclonal antibody (mAb) process development, where virus filtration is pivotal. In section 3, prefiltration studies were performed with an industrially relevant IgG1 type mAb using adsorptive and size-exclusion-based prefilters with different mechanisms of action. This mAb has an isoelectric point range of 7.1 to 8.0 and …

Microcystin-Lr Removal From Water Via Enzymatic Linearization And Ultrafiltration, Abelline Fionah, Cannon Hackett, Hazim Aljewari, Laura Brady, Faisal Alqhtani, Isabel C. Escobar, Audie K. Thompson

Chemical Engineering Faculty Publications and Presentations

Microcystin-LR (MC-LR) is a toxin produced by cyanobacteria that can bloom in freshwater supplies. This study describes a new strategy for remediation of MC-LR that combines linearization of the toxin using microcystinase A, MlrA, enzyme with rejection of linearized byproducts using membrane filtration. The MlrA enzyme was expressed in Escherichia coli (E. coli) and purified via a His-tag with 95% purity. Additionally, composite membranes made of 95% polysulfone and 5% sulfonated polyether ether ketone (SPEEK) were fabricated and used to filter a solution containing cyclic and linearized MC-LR. Tests were also performed to measure the adsorption and desorption of MC-LR …

Economic Feasibility Of Mixed Plastic Waste Pyrolysis Using Twin Reactor System In Northwest Arkansas, Carol Rogers, Patricia Means, Renato Gonzalez, Kaida Sheets, Hayden Townsend

Chemical Engineering Undergraduate Honors Theses

Plastic waste generation is increasing at an unsustainable rate while recycling solutions remain stagnant. As a chemical means of recycling, mixed plastic waste pyrolysis can generate synthetic oil appropriate for use as fuel in power generation from plastic waste that otherwise accumulates in landfills. With the scaling of a commercial plastic pyrolysis process in Northwest Arkansas (NWA) modeled after an operational sawdust pyrolysis unit in Huntsville, Arkansas, economic analysis resulted in 26.3% internal rate of return. Therefore, construction of a commercial mixed plastic-to-fuel pyrolysis plant is economically justified and should be pursued. To effectively implement the proposed design, NWA must …

Machine Learning Representations For Optimization Of Process Systems, Logan Watts

Chemical Engineering Undergraduate Honors Theses

The optimal operation of chemical processes provides the foundation for optimization problems to determine the most effective way to operate or design a given process. Chemical processes can be represented as nonlinear systems of equations with decision variables, resulting in a problem that can be solved through nonlinear solvers. The downfalls of nonlinear solvers create the need for improved methods of finding globally optimal solutions to the design or operation of a chemical process. The project will seek to evaluate the use of artificial neural networks to approximate nonlinear systems of equations for the purpose of optimizing chemical processes. The …

Development Of An Integrated Salt Cartridge-Reverse Electrodialysis (Red) Device To Increase Electrolyte Concentrations Of Human Blood Flow To Power Biomedical Devices, Caroline Campbell

Chemical Engineering Undergraduate Honors Theses

Emerging technologies in nanotechnology and biomedical sciences have led to an increase in biomedical implantable devices including cardiac pacemakers, artificial organs, drug pumps, and sensors. These devices require continuous stable and reliable power to operate, which creates the demand for the need to find a safe, reliable, and stable power source. A promising avenue for a power source for these devices is a miniaturized reverse electrodialysis (RED) biopower cell design that utilizes the salinity differences between bloodstreams that flow inside the human body. Initial results of the RED system demonstrate that higher gradient salinity differences between streams lead to a …

Peptoid Microsphere Coatings To Improve Performance In Sandwich Elisa Microarrays, Jesse L. Roberts, German R. Perez Bakovic, Shannon L. Servoss

Chemical Engineering Faculty Publications and Presentations

Enzyme-linked immunosorbent assay (ELISA) microarray performance is limited by low assay sensitivity and dynamic range. Increasing the surface area for reagent binding can help to improve performance, but standard techniques such as roughening the surface or adding a polymer coating lead to increased non-specific fluorescence and do not have reproducibly improved performance. Another approach to increase surface area is adding a microsphere coating on the surface. Poly-N-substituted glycine (peptoid) microspheres are ideal for this application due to low immunogenicity, protease-resistance, and biocompatibility. Peptoids are polymers with a backbone similar to peptides, but with the side chains appended to nitrogen rather …

Design And Cost Analysis Of Acrylic Acid Plant, Adam Ferrier

Chemical Engineering Undergraduate Honors Theses

The purpose of this project was to model and design a plant to produce 75,000 tons per year of acrylic acid. Using the design in section B.9 of Richard Turton’s Analysis, Synthesis, and Design of Chemical Processes as a starting point, a plant was designed based around the partial oxidation of propylene to acrylic acid. The final plant design produces about 86,000 tons per year of acrylic acid. Using an interest rate of 10%, the plant has a discounted cash flow rate of return of 32% over 2 years of startup and 10 years of operation. Attached is an executive …

Recovery Of Water And Salt From Hyper-Saline Mine Water Using Freeze Crystallization, Gabrielle Casey

Chemical Engineering Undergraduate Honors Theses

The Freezerbacks researched, designed, and economically evaluated a full-scale freeze crystallization process as well as two alternative full-scale processes: 5 stage multiple effect evaporation and reverse osmosis. All three processes were designed to treat hyper-saline mine water that was sent into evaporation pond systems. These systems were designed for Freeport-McMoRan’s mines that need to treat impacted water.

The Freeport-McMoRan copper mine in Miami, Arizona was visited in order to gain insight about the problem. The mine is no longer actively mining copper and is in the process of reclaiming land used. An essential part of restoring the land is treating …

Desalination: Freeze Crystallization, Ibrahim Guiga

Chemical Engineering Undergraduate Honors Theses

The Freezerbacks researched, designed, and economically evaluated a full-scale freeze crystallization process as well as two alternative full-scale processes: 5 stage multiple effect evaporation and reverse osmosis. All three processes were designed to treat hyper-saline mine water that was sent into evaporation pond systems. These systems were designed for Freeport-McMoRan’s mines that need to treat impacted water.

The Freeport-McMoRan copper mine in Miami, Arizona was visited in order to gain insight about the problem. The mine is no longer actively mining copper and is in the process of reclaiming land used. An essential part of restoring the land is treating …

Experimentation And Modeling Of The Effects Of Along-Wind Dispersion On Cloud Characteristics Of Finite-Duration Contaminant Releases In The Atmosphere, Jessica M. Morris

Graduate Theses and Dissertations

Along-wind dispersion, or stretching of the cloud in the direction of the wind, plays an important role in the concentration and modeling of contaminant releases in the atmosphere. Theoretical and empirical derivations were compared for appropriate parameterization of along-wind dispersion. Available field data were analyzed to evaluate and improve previous parameterizations of the along-wind dispersion coefficient, σ_x. An experimental test program was developed and executed in an ultra-low speed wind tunnel at the Chemical Hazards Research Center to determine the effects of the time distribution coefficient on true finite-duration releases from an original area source. Multiple wind speeds, release durations, …

Pid Algorithm Design For Automation Of Eukaryote Fermentation, Madison Mann

Chemical Engineering Undergraduate Honors Theses

Single celled eukaryotic organisms are advantageous in the production of proteins for use in biopharmaceuticals due to their ease of cultivation and manipulation. Because of high cell density during fermentation and an ability to allow post-translational protein modifications, yeast is particularly well-suited. To maximize the specific formation rate of the desired proteins, an optimum specific growth rate of the yeast should be found and maintained. This rate is dependent upon pH, temperature, dissolved oxygen content, and carbon feed rate. Fermentation can be done in a fed batch reactor system, and it is possible to use a Buglab (online biomss) sensor …

A Proposed Process And Economic Analysis For A Manufacturing Facility For Nylon 6,6, Perry Doles

Chemical Engineering Undergraduate Honors Theses

The global nylon market is a multi-billion-dollar industry that has been thriving in recent years due to advances in the process technology and its flexibility as a material. Nylon 6,6 is a versatile material with uses in many industries because of its ability manipulated into many forms. It is commonly used in applications that require heat resistance, chemical resistance, and high mechanical strength. It is commonly used in luggage, car parts, carpets, and many other plastic products that require the properties that nylon 6,6 exhibits. The versatility and demand for nylon 6,6 make it an attractive process for many potential …

Water System For Developing Countries / Disaster Relief Made With Local Materials, Shumon Hasan

Chemistry & Biochemistry Undergraduate Honors Theses

The objective of this project was to design a water purification system that can be constructed from easily available materials, common to the particular country, and is capable of the complete water purification process.

Developing Process Control Experiments For Undergraduate Chemical Engineering Laboratories, Chase M. Swaffar

Graduate Theses and Dissertations

It is the intent of this work to develop a process control apparatus and series of experiments that will help students visualize the PID (Proportional-Integral-Derivative) control of a process and enhance their understanding of the subject. The apparatus is a computer-controlled PID mixing system that responds quickly to set point changes and process disturbances which are directly observable. The system can easily be simulated with a transfer function model in Matlab's Simulink, so that the controller can be optimized for the desired system response. Four experiments can be conducted with this system including: exploration of system modeling and controller optimization …

Tin Sensitization For Electroless Plating, Xingfei Wei

Graduate Theses and Dissertations

The tin sensitization process has been used in electroless plating since 1940s Brenner and Riddell developed the electroless plating for surface metallization method. It was found to be an interesting topic to study tin sensitization for chemically controlling metal deposition on different substrates, because the tin sensitization process had critical effects on the electroless plated metal thin films. Nowadays electroless plating metal deposition is still an important method for depositing metals. It has a few advantages over the vapor deposition and electrodeposition method, such as work in an ambient condition, on nonconductive substrates, and without extra power input. Applying electroless …

Modeling, Fabrication And Characterization Of Scalable Electroless Gold Plated Nanostructures For Enhanced Surface Plasmon Resonance, Gyoung Gug Jang

Graduate Theses and Dissertations

The scientific and industrial demand for controllable thin gold (Au) film and Au nanostructures is increasing in many fields including opto-electronics, photovoltaics, MEMS devices, diagnostics, bio-molecular sensors, spectro-/microscopic surfaces and probes. In this study, a novel continuous flow electroless (CF-EL) Au plating method is developed to fabricate uniform Au thin films in ambient condition. The enhanced local mass transfer rate and continuous deposition resulting from CF-EL plating improved physical uniformity of deposited Au films and thermally transformed nanoparticles (NPs). Au films and NPs exhibited improved optical photoluminescence (PL) and surface plasmon resonance (SPR), respectively, relative to batch immersion EL (BI-EL) …

Extraction Of Silymarin Compounds From Milk Thistle (Silybum Marianum) Seed Using Hot, Liquid Water As The Solvent, J.F. Alvarez Barreto

Inquiry: The University of Arkansas Undergraduate Research Journal

High value specialty chemicals are usually obtained from natural products by extracting with generally regarded as safe (GRAS) solvents. Because organic solvents are quite often used, high operating and disposal costs often occur. When compared to traditional solvents, water can be viewed as an interesting alternative because of its low operating and disposal costs. Milk thistle contains compounds (taxifolin, silychristin, silydianin, silybinin A and silybinin B) that display hepatoxic protection properties. This paper examines the batch extraction of silymarin compounds from milk thistle seed meal in 50'C, 70'C, 85'C and 100'C water as a function of time. For taxifolin, silychristin, …