Other Engineering Commons^™

Experimental And Numerical Study Of Dynamic Water Control In Naturally Fractured Reservoirs, Younes Ahmed Alblooshi

LSU Doctoral Dissertations

Excessive water production problem is more troubling in naturally fractured reservoirs (NFR) than matrix-only deposits. In NFR, fluid flow through fracture conduits substantially differs from that in the rock matrix. Development of fractured hydrocarbon reservoirs require good understanding of fluid flow in the network of fractures. In NFR with bottom-water drive, mitigation of excessive water is always a challenge.

This dissertation presents an experimental and numerical study of dynamic water control in fractured basements using downhole water sink (DWS) well technology. A DWS well is a dual-completed well with the top completion used for oil production from payzone and a …

Affordability Through The Eyes Of Industry Towards A Better Understanding Of The Rocket Economy, Christopher J. White

Research Horizons Day Posters

No abstract provided.

Use Of Penetrating Asphalt Emulsions To Address High-Void Pavement Areas, Andrew Eicher, Curt Higginbotham

Purdue Road School

Longitudinal joints are high in air voids due to compaction limitations. Lowering the void content of these areas improves the durability of the pavement. Project data indicate that rapid penetrating emulsion (RPE) fills the voids beneath the surface of the pavement, reducing air and water intrusion while maintaining surface texture, whereas traditional emulsions seal the surface only. Lab tests have been developed to quantify the penetrating ability of an emulsion and resistance to water exposure. Join us for a discussion.

Standardisation In Construction Cost Control, Charles Mitchell

Other Resources

Poster presentation submitted as to the School of Surveying and Construction Management Research and Innovation Industry Evening, March 2019.

A Fire Protection Life Safety Analysis Of Permian Oil Plaza, Nick Francis

Fire Protection Engineering: Culminating Experience Project Reports

The Permian Oil Plaza (POP) is a four story building located in Midland, TX. This facility was designed to provide over 200,000 square feet of office space to approximately 500 employees. The building was constructed of unprotected non-combustible (Type II-B) building materials and was completed in late 2015. An assessment of the building’s fire and life safety systems was performed to ensure these systems were designed and installed in a manner that meets, or exceeds, the intent of pertinent building codes and fire safety standards. This assessment included a prescriptive based analysis, as well as a performance-based analysis. The prescriptive …

Design Thinking As A Framework For Teaching Packaging Innovation, Javier De La Fuente, Irene Carbonell, Mary Laporte

Journal of Applied Packaging Research

Students in scientific/technical-oriented disciplines struggle with achieving good levels of innovation when exposed to design problems. Research indicates the need for implementing alternative pedagogical approaches in technical curricula that enhance students’ creative skills. The purpose of this study was to evaluate the implementation of a cross-disciplinary pedagogical approach with a focus on teaching innovation in the field of packaging engineering at a university in the United States. A Design Thinking Project-Based Learning (DTPBL) approach was used to improve the levels of innovation in student work. Its outcomes were compared with those of a Traditional Project-Based Learning (TPBL) approach. The implementation …

Level Of Service And The Transit Neighbourhood: Observations From Dublin City And Surburbs, David O'Connor, Brian Caulfield

Articles

Few studies have looked at the impact Level-of-Service (LOS) might have on the distances people walk to public transport. The relationship, if any, has implications for transit-oriented-development and the viability of different transit modes serving suburban areas. This paper examines pedestrian catchment areas and LOS across a light rail, a metro rail and two bus corridors in Dublin. Public transport users have been surveyed at 17 stops around the city and their trip origin identified. Catchment areas for bus services with high levels of service were found to be comparable and often greater than those for LRT or metro …

Landslides Near Enguri Dam (Caucasus, Georgia) And Possible Seismotectonic Effects, Alessandro Tibaldi, Paolo Oppizzi, John S. Gierke, Thomas Oommen, Nino Tsereteli, Zurab Gogoladze

Department of Geological and Mining Engineering and Sciences Publications

The Enguri dam and water reservoir, nested in the southwestern Caucasus (Republic of Georgia), are surrounded by steep mountain slopes. At a distance of 2.5 km from the dam, a mountain ridge along the reservoir is affected by active deformations with a double vergence. The western slope, directly facing the reservoir, has deformations that affect a subaerial area of 1.2 km². The head scarp affects the Jvari–Khaishi–Mestia main road with offsets of man-made features that indicate slip rates of 2–9 cm yr⁻¹. Static, pseudostatic and Newmark analyses, based on field and seismological data, suggest different unstable …

Smart Proxy Modeling Of Sacroc Co2-Eor, Gholami Vida, Mohaghegh D. Shahab, Maysami Mohammad

Faculty & Staff Scholarship

Large CO2-enhanced oil recovery (EOR) projects usually contain an abundance of geological and good performance data. While this volume of data leads to robust models, it often results in difficult to manage, slow-running numerical flow models. To dramatically reduce the numerical run-times associated with the traditional simulation techniques, this work investigated the feasibility of using artificial intelligence and machine learning technologies to develop a smart proxy model of the Scurry Area Canyon Reef Operators Committee (SACROC) oilfield, located in the Permian Basin, TX, USA. Smart proxy models can be used to facilitate injection-production optimization for CO2-EOR projects. The use of …

Autojack - Hydraulic Powertrain System, Tyce Vu

All Undergraduate Projects

A primary problem for mechanics and automotive enthusiasts is the risk associated with lifting and securing a vehicle with conventional jack stands. Often times, improper jack-stand installation results in the vehicle collapsing unexpectedly, causing injury and/or death. This problem can be minimized through the application of a newly re-designed vehicle lifting system. The conventional method for lifting cars is time consuming and can be unsafe in many circumstances. A better, safer, and more efficient lift design was needed; the AutoJack. The approach of the AutoJack design was entirely focused on the safety of lifting a vehicle. Safety was improved by …

The Role Of Role-Play In Student Awareness Of The Social Dimension Of The Engineering Profession, Diana Adela Martin, Eddie Conlon, Brian Bowe

Articles

The article aims to expand upon traditional case based instruction through role-play and to explore the effectiveness of the approach in raising students’ awareness of the social dimension of the engineering profession. For this purpose, we added a contextual description to the case study Cutting Roadside Trees driven by a macroethical outlook. Our contribution draws on an exercise based on the contextualised case study in which 80 students at Technological University Dublin participated. The results gathered show that role-playing contributed to complex student responses to the scenario and an awareness of the social factors that are part of engineering practice …

The Effect Of Using A Project-Based Learning (Pbl) Approach To Improve Engineering Students' Understanding Of Statistics, Fionnuala Farrell, Michael Carr

Articles

Over the last number of years we have gradually been introducing a project based learning approach to the teaching of engineering mathematics inDublin Institute of Technology. Several projects are now in existence for the teaching of both second-order differential equations and first order differential equations.We intend to incrementally extend this approach acrossmore of the engineering mathematics curriculum. As part of this ongoing process, practical realworld projects in statistics were incorporated into a second year ordinary degree mathematics module. This paper provides an overview of these projects and their implementation. As a means to measure the success of this initiative, we …

Efficient Excitation Of Micro/Nano Resonators And Their Higher Order Modes, N. Jaber, M. A. A. Hafiz, S. N. R. Kazmi, M. H. Hasan, F. Alsaleem, S. Ilyas, M. I. Younis

Durham School of Architectural Engineering and Construction: Faculty Publications

We demonstrate a simple and flexible technique to efficiently activate micro/nano-electromechanical systems (MEMS/NEMS) resonators at their fundamental and higher order vibration modes. The method is based on the utilization of the amplified voltage across an inductor, L, of an LC tank resonant circuit to actuate the MEMS/NEMS resonator. By matching the electrical and mechanical resonances, significant amplitude amplification is reported across the resonators terminals. We show experimentally amplitude amplification up to twelve times, which is demonstrated to efficiently excite several vibration modes of a microplate MEMS resonator and the fundamental mode of a NEMS resonator.

Method Of Monitoring Charge Condition Of Heat Pump System, Fadi M. Alsaleem, Gregg M. Hemmelgarn

Durham School of Architectural Engineering and Construction: Faculty Publications

A heat-pump circuit may include an indoor heat exchanger, an outdoor heat exchanger, a compressor adapted to circulate a working fluid between the indoor and outdoor heat exchangers, and an expansion device disposed between the indoor and outdoor heat exchangers. A monitor for the heat-pump system may include a return-air temperature sensor, a supply-air temperature sensor, and a processor. The return-air temperature sensor may be adapted to measure a first air temperature of air upstream of the indoor heat exchanger. The supply-air temperature sensor may be adapted to measure a second air temperature of air down stream of the indoor …

Sns Optical Fiber Structure Sensor For Direct Detection Of The Phase Transition In C18h38 N-Alkane Material, Wei Han, Marek Rebow, Xiaokang Lian, Dejun Liu, Gerald Farrell, Qiang Wu, Yuliya Semenova

Articles

A singlemode-no-core-singlemode (SNS) fiber structure optical sensor for detecting the solid-liquid phase change in a phase change material: C18H38 n-alkane material (n-octadecane) is proposed and demonstrated. The transmission-type sensor probe consists of a short section of no-core fiber sandwiched between two sections of a singlemode fiber. Phase changes in n-octadecane are accompanied by large step-like variations of its refractive index (RI). Such a large discontinuous change of the n-octadecane’s RI during its phase transition, leads to the corresponding step-like change in the transmitted optical power that can reliably indicate the phase change of the sample in the vicinity of the …

The Expanding Business Of The Entrepreneurial University: Job Creation, Mike Murphy, Michael Dyrenfurth

Books/Book chapters

This chapter explores the role of universities in job creation. It does this by taking two approaches. The first is to look at how the university sees its role as expanding from traditional first and second mission activities to encompass third mission activities including industry engagement and how this supports job creation and economic development. The second approach is to examine how new jobs are created in a geographic region or country, and the role that the university can play in support of this. Typical third mission activities such as incubators, technology transfer, and science parks are also examined; including …

Business In Engineering Education: Issues, Identities, Hybrids, And Limits, Mike Murphy, Pat O'Donnell, John Jameson

Books/Book chapters

This chapter explores how engineering students are broadened in their education through the teaching of non-engineering subjects, such as business subjects, in order to develop critical thinking skills and self-knowledge of what it means to be an engineer. The goal of the chapter is to provide a commentary on the level of interaction, from design of courses to design of curricula, between business faculty and engineering faculty, and the results of that interaction. This chapter sets out to (i) explore whether there appears to be a place in engineering education curricula for reflective critique of assumptions related to business thinking, …

The Adoption Of Collaborative Robots Toward Ubiquitous Diffusion: A Research Agenda, Yuhua (Jake) Liang, Seungcheol Austin Lee

Communication Faculty Articles and Research

This paper proposes a framework to study the adoption of collaborative robots (co-robots or cobots) as an innovation and their diffusion into the larger population. Collaborative robots are only starting to appear in our society, yet challenges such as fear and distrust may impede their further adoption. This paper discusses the foundational work necessary to understand collaborative robot adoption and the core elements to achieve ubiquitous diffusion, with a focus on human users and the communication processes.

Voltage And Deflection Amplification Via Double Resonance Excitation In A Cantilever Microstructure, Mohammad H. Hasan, Fadi Alsaleem, Abdallah Ramini

Durham School of Architectural Engineering and Construction: Faculty Publications

Cantilever electrostatically-actuated resonators show great promise in sensing and actuating applications. However, the electrostatic actuation suffers from high-voltage actuation requirements and high noise low-amplitude signal-outputs which limit its applications. Here, we introduce a mixed-frequency signal for a cantilever-based resonator that triggers its mechanical and electrical resonances simultaneously, to overcome these limitations. A single linear RLC circuit cannot completely capture the response of the resonator under double resonance excitation. Therefore, we develop a coupled mechanical and electrical mathematical linearized model at different operation frequencies and validate this model experimentally. The double-resonance excitation results in a 21 times amplification of the voltage …

Benchmarking Image Processing Algorithms For Unmanned Aerial System-Assisted Crack Detection In Concrete Structures, Sattar Dorafshan, Robert J. Thomas, Marc Maguire

Durham School of Architectural Engineering and Construction: Faculty Publications

This paper summarizes the results of traditional image processing algorithms for detection of defects in concrete using images taken by Unmanned Aerial Systems (UASs). Such algorithms are useful for improving the accuracy of crack detection during autonomous inspection of bridges and other structures, and they have yet to be compared and evaluated on a dataset of concrete images taken by UAS. The authors created a generic image processing algorithm for crack detection, which included the major steps of filter design, edge detection, image enhancement, and segmentation, designed to uniformly compare dierent edge detectors. Edge detection was carried out by six …