Materials Science and Engineering Commons^™

The Extraction Of Chromate Salts From Montana Chromite, Server Tasdemiroglu

Bachelors Theses and Reports, 1928 - 1970

In this thesis I have tried to determine the suit­able temperature, time and the amount of soda ash and lime needed for the calcining process. The leaching and purification tests were studied experimentally. The earlier process for making chromate from chromite was not the same as is used today. There­fore I have found it useful to put into this thesis the newest method for making chromate salts and their important uses.

An Experimental Investigation Of The Age Hardening Of Copper With Manganese Silicide, Ali Kozak

Bachelors Theses and Reports, 1928 - 1970

The subject of the thesis was based upon the theory of precipitation or age hardening of the copper by the compound formed by the Manganese and silicon present in the ternary Cu-Mn-Si alloy. The effect of the heat treat­ment to such an alloy was to be studied and the best aging time and temperature was to be determined.

The Electroformation Of Lithium-Lead Alloys From Molten Electrolytes, Thomas Prater

Bachelors Theses and Reports, 1928 - 1970

An attempt was made to make lead-lithium alloys by electrodeposition of lithium using a molten bath and a molten lead cathode.The variables taken into consideration were: composition of the melt, temperature of the melt, and current density. The purpose of changing these factors was to determine what effect each had on the current efficiency.

Ground Water In The Lake Basin Field And Adjacent Area, Herman Neibauer

Bachelors Theses and Reports, 1928 - 1970

This thesis consists of studying the stratigraphic and structural features of the Lake Basin Field and an adjacent area with special emphasis upon the ground water conditions present.

Oil And Gas Production Methods In Montana, Edgar A. Scholz

Bachelors Theses and Reports, 1928 - 1970

Montana's oil and gas industries aggregate a gross income of over 12,000,000 annually to the state. Oil and gas fields have been thoroughly discussed in liter­ature as to geology, location, production and future possibilities. The specific object of this report has been to compile a comprehensive study of the production methods as they occur.

The Geology And Ore Deposits Of The Ermont Mines, James L. Kelly

Bachelors Theses and Reports, 1928 - 1970

The Ermont Mines are located sixteen miles northwest of Dillon, Montana, in section 35 of T.6S., R.11W. This is in the central part of Beaverhead County. They are considered to be in the Argenta min­ing district, the town of Argenta lying three miles to the northeast.

The Concentration Of Scheelite From The Gold Concentrates Of The Jardine Mining Company, John H. Huxley

Bachelors Theses and Reports, 1928 - 1970

The Purpose of this thesis was to investigate the possibility of concentrating scheelite from Wilfley table gold concentrates from the mill of the Jardine Mining Company; and to determine whether such concentration is economically feasible and the product of sufficiently high grade to meet commercial specifications for such a product.

The Testing And Concentration Of Lake Chelan Copper Ore, Thor W. Johnson

Bachelors Theses and Reports, 1928 - 1970

The geologic history of the Holden area and Lake Chelan district is an integral part of the history of the Cascade Mountain Range. The structure is very complex and the rocks, which have been subjected to intense metamorphic action, are portions of a roof pendant and consists of gneisses, schists and quartzites that are often difficult to correlate.

Gas Analysis By Absorption, Albert D. Mcmahon

Bachelors Theses and Reports, 1928 - 1970

There is practically only one method of gas analysis. This was worked out many years ago by Bunsen, Hempel, and Winkler and consists in the successive absorption with different chemicals of the various constituents of the gas. The only improvement to this method is the oxidation and combustion of different components of a mixture followed by absorption.

Relationships Of Manganese Minerals In The Butte District, Charles F. Parent

Bachelors Theses and Reports, 1928 - 1970

The use of manganese in the steel industry as a deoxidizing and desulfidizing agent makes it a necessity in modern industry, while the various alloy steels using manganese for the quality of toughness are also indispensable. Manganese is also used in the manufacture of such various articles as battery cells, paints and glass.

Pegmatites In Southwestern Montana, Ora Rostad

Bachelors Theses and Reports, 1928 - 1970

Little has been written on pegmatites in Montana except in conjunction with reports on mining districts. This subject was chosen as a senior thesis to see what facts could be ascertained re­garding pegmatites alone, and an attempt has been made by the writer to assemble all written material on pegmatites in southwestern Montana, and to study specimens from those that could be reached or from which specimens were available.

A Study Of The Concentration Of A Low-Grade Manganese Ore From The Ennis District, John B. Schuettenhelm

Bachelors Theses and Reports, 1928 - 1970

The purpose of the investigation was to determine the most effective means of concentrating the manganese in the ore. The study was that of identification of the minerals present. This showed the presence of oxides of manganese and iron, and carbonates of calcium and manganese. Methods of investigation were planned to determined whether the ore could be concentrated effectively by gravity concentration methods. ­

Some Causes For Porosity And Leakage In Non-Ferrous Castings, Alfred H. Hesse

Professional Degree Theses

"Non-ferrous copper base alloys find many applications in industry. Among these alloys one finds the tin bronzes rather widely used for many purposes, and by delving still farther one finds pressure castings as one of their important applications. In many foundries the percentage of rejections due to leakage or porosity is quite high. This is obviously very costly since leakage is generally only found after machining. It is with a view to determine the causes for leakage in pressure castings and to devise methods for its prevention that the work described in this thesis was undertaken. It is not intended …

The Effect Of Glaze Fit Upon The Strength Of Missouri Zadock, Karl Emil Krill, Floyd Rolland Elliott

Bachelors Theses

"We know that, in the case of a beam, the really effective part of the cross-sectional area is that part farthest from the neutral axis. The I-beam, with most of the central area eliminated, is just as strong as is the rectangular beam of similar outside dimensions. Why should not the glaze on a piece of ceramic ware play as important a part in the strength of the piece as does the outermost area in a beam? Microscopic cracks in the flanges of an I-beam weaken it appreciably. Might not a parallel case exist in a piece of glazed pottery …

Characteristics Of Pyrometric Cone Equivalent Test Furnaces, Alfred W. Allen, Joseph T. Dusza

Bachelors Theses

"Though the method of determining the pyrometric cone equivalent of various silicate materials used in the refractories industry has been standardized by the American Society for Testing Materials (A.S.T.M. Designation: C24-35) as to the rate of heating, method of preparation of sample, mounting of test cones, and the interpretation of results, there still remains some variation in the results obtained by different operators using different types of P.C.E. furnaces. The three types of furnaces most generally used are: the Fulton-Coursen Granular Resistance Furnace, the Denver Fireclay Furnace developed by the American Refractories Institute using gas, and the General Refractories' Oxy-acetylene …

The Relative Merits Of The Electrolytic Deposit And The Galvanic Nickel Deposit When Used To Produce Enamel Adherence, Marvin Edward Pingel

Bachelors Theses

"The purpose of this paper is to determin sic if nickel deposited electrolytically from a nickel bath at 100ʻF. or less gives the same adherence qualities to enameling steel that nickel deposited galvanically at 160-180ʻF. produces"--Purpose of This Paper, page 1.

Dry Pressing Refractory Insulating Brick, Frank Clarence Steimke

Bachelors Theses

"The expensive process of grinding the insulating brick and the slow production methods of hand forming led to the possibilities of dry pressing the brick. The use of the dry press would increase production, give greater uniformity to the brick and materially reduce grinding if not eliminating it entirely. Since present day combustives were either impractical or else impossible to use, some new material must be found. Three materials presented themselves, napthalene, sulfur, and petroleum coke. The former for its low melting temperature and the latter two for their complete volatility at high temperatures and low if not negligible resiliency. …

Firing Behavior Of Missouri Plastic Fire Clay, William E. Crockett

Bachelors Theses

"There are two districts in Missouri in which plastic fire clay occurs. The oldest and least significant of these deposits is the "Cheltenham", in the St. Louis area. The most prominent area in which plastic fire clay occurs is generally termed the "east central" district. Included in this district are Calloway, Montgomery, Audrain, Warren, Boone, Monroe, Pike and Lincoln Counties. The clay as tested in this report occurs in Boone County, near Columbia. A plastic fire clay does not have as high a P.C.E. (pyrometric cone equivalent) as the ordinary flint and semi-flint clays, but its high plasticity warrants its …

Solubility Of Glass Tank Refractories Using A Small Electrically Heated Furnace, James Vincent Heddell

Bachelors Theses

"This investigation was undertaken to study the refractory blocks used in glass furnaces - their relation with the molten glass. It was decided to employ for this examination a model glass tank, heated by electrical carborundum resistors known as Globars. Experimental glass tanks have been constructed using fuel oil or gas to obtain the required heat to perform melting. These fuels were used mainly to simulate commercial practice and thus to obtain results which could be easily applied to industrial furnaces. The design of a model electric tank is included as part of this investigation"--Purpose of the Investigation, page 4-5.

A Study Of A Carbonaceous Gold Ore, James S. Huckaba

Bachelors Theses and Reports, 1928 - 1970

The presence of graphite in the ore of the Missouri-McKee Mine has made its treatment by the methods now used quite unsatisfactory. The study was undertaken to de­velop a new flow sheet which would give a high recovery and yet be economical enough to handle low grade material.

A Geological Report On An Area Five Miles Southeast Of Renova, Montana, And On An Area Seven Miles South Of Jefferson Island, Montana, Herman Neibauer

Bachelors Theses and Reports, 1928 - 1970

This trip was conducted to give those students working for their respective degrees an excellent opportunity to work under actual field conditions. A total of three weeks was taken to complete the required work. Two weeks were spent in the field gathering data, and making maps, and the last week was spent in the drawing room at the college preparing the final map.

The Age-Hardening Of Aluminum With Mgzn2, Sidney E. Worthen

Bachelors Theses and Reports, 1928 - 1970

The purpose of this thesis is to investigate the age-hardening of aluminum with magnesium and zinc in such proportions as to conform to the compound MgZn₂.

Because of a lack of time and proper equipment, the only property investigated was the hardness as indicated by the Rockwell Superficial Hardness Tester.

The Investigation Of Different Variables In The Assaying Of Silver Cyanide Solution, Warren M. Mahan

Bachelors Theses and Reports, 1928 - 1970

The assaying of gold and silver cyanide solutions is by no means new. The first method of analysis which is given in the literature is an evaporation method by S. B. Christy in 1896. However, the fire assaying of gold and silver dates further back than this. There is a method of fire assaying for gold and silver given in literature as early as 1556 in Georgius, Agricola’s De Re Metallica book.

The Measurement Of Current Efficiency In Zinc Sulphate Electrolytes Containing Antimony And Cobalt By Hydrogen Evolution, Arthur R. Hard

Bachelors Theses and Reports, 1928 - 1970

The measurement of current efficiency by hydrogen evolution is based on the assumption that the portion of the current which deposits no zinc will release hydrogen. This assumption is correct for solutions containing no impurities electropositive to zinc.

The Geology And Mineralogy Of The Independence Mining District, Alan Kuhlman

Bachelors Theses and Reports, 1928 - 1970

From 1888 until 1893 the district was a booming mining camp. Seven stamp mills were running and ore was be­ing mined from the Independence, King Solomon, Poorman, Golden, Hidden Treasure and Crown claims. The town of Independence, which was on the Boulder River at the fork of Basin Creek, boasted a population of 400 people.

A Study Of Metallic Eutectics, Robert P. Corbett

Bachelors Theses and Reports, 1928 - 1970

All of the metals have definite melting points. When a metal is heated above the melting point, it exists as a liquid. Now if the melt is allowed to cool, it will solidify when a temperature corresponding to the melting point is reached.

However, if one metal is added to another metal, both of which are mutually soluble in the liquid state, a certain effect can be noted. The melt will not solid­ify when the melting point of the pure metal is reached, but will freeze at a lower temperature.

Areal Geology Of The Post-Paleozoic Surface Of The Northwest Plains, William M. Broderick

Bachelors Theses and Reports, 1928 - 1970

Probably most of the area included in this report has been ex­amined to some extent by oil geologists, and most, if not all, of the important domes have been discovered and surveyed thoroughly. In parts of the area, the bedrock is covered by glacial drift or alluvium materi­al, but it is reasonable to believe that no new domal structure will be found. This means that surface examination alone will be insufficient in locating new oil fields, so future prospecting will be dependent, to a great extent, on studies of sub-surface stratigraphy.

A Study Of The Concentration Of A Copper-Zinc Ore., Kenneth L. M. Dodd

Bachelors Theses and Reports, 1928 - 1970

The ore under investigation in this thesis is a copper-zinc ore which came from the state of New Mexico. The exact location is unobtainable. The purpose of the investigation was to determine the most effective means of concentration of the valuable min­erals present in the ore.

The Testing And Concentration Of A Low Grade Copper-Nickel Ore., Laurence T. Eck

Bachelors Theses and Reports, 1928 - 1970

The purpose of this thesis is to investigate the possi­bility of concentrating a low grade copper-nickel ore, to determine the most effective method of concentration, and to attempt to draw some conclusions to determine whether or not the concentrates produced would be of sufficient high grade to make the recovery of nickel and copper a profit­able enterprise.

Geology And Ore Deposits Of The Jardine Mining District, Park County, Montana, Douglas M. Dowell

Bachelors Theses and Reports, 1928 - 1970

The Jardine Mining district is in the extreme southern part of Park County, Montana. Jardine is five and one-half miles northeast of Gardiner, Montana, the northern entrance to Yellowstone National Park.