Operations and Supply Chain Management Commons^™

Performance Trade-Offs In Layouts For Relief Centers, Ananth Krishnamurthy, Sanket Bhat, Debjit Roy

12th IMHRC Proceedings (Gardanne, France – 2012)

At a disaster affected region, relief centers distribute critical supplies and aid to the affected victims. Unlike traditional distribution centers, relief centers experience significant ‘crowd effects’ due to the sudden influx of victims in a confined space. Using knowledge from studies on pedestrian traffic flow, specialized state dependent queuing models are developed to model the flow of victims along the walkways setup at a relief center. The underlying queuing network model is analyzed to derive expressions for the average times that victims experience before they receive the service at the relief center. The research shows that crowd density effects lead …

A Multi-Objective Optimization Approach For Designing Automated Warehouses, Tone Lerher, Matej Borovinšek, Iztok Potrč, Matjaž Šraml

12th IMHRC Proceedings (Gardanne, France – 2012)

A multi objective optimization of automated warehouses is discussed and evaluated in present paper. Since most of researchers in material handling community had performed optimization of decision variables with single objective function only (usually named with minimum travel time, maximum throughput capacity, minimum cost, etc.), the multi objective optimization (travel time – cost – quality) will be presented. For the optimization of decision variables in objective functions, the method with genetic algorithms is used. To find the Pareto optimal solutions, the NSGA II genetic algorithm was used. The main objective of our contribution is to determine the performance of the …

A Mathematical Model For Driver Balance In Truckload Relay Networks, Sarah Root, Hector A. Vergara

12th IMHRC Proceedings (Gardanne, France – 2012)

Driver retention has been cited as one of the primary motivating factors for the implementation of relay networks for full truckload transportation. The strategic design of such networks considering important operational factors such as limitations on load circuity and equipment balance has been previously studied in the literature, however driver scheduling has not been explicitly considered in routing decisions. We present a prescriptive modeling approach that uses mathematical programming in conjunction with a decomposition-based algorithm to select feasible duties that consider current hours-of-service regulations and assign them to drivers domiciled at relay points in the network to cover truckload demands …

Collaborative Freight Transportation To Improve Efficiency And Sustainability, Kimberly P. Ellis, Steven Roesch, Russell D. Meller

12th IMHRC Proceedings (Gardanne, France – 2012)

Collaborative distribution offers the potential for substantial improvements in freight transportation. As collaboration increases, more loads are available for sharing among transportation service providers, leading to more fully loaded trailers that travel fewer miles and reduce the cost per load on average. In this study, we develop approaches to analyze improvements in key performance measures as collaboration increases in freight transportation. For the data sets analyzed, improvements include a 34% increase in trailer fullness, a 29% reduction in average costs per load, and a 25% decrease in average miles per load. Based on this analysis, collaboration provides substantial improvements for …

Functional Design Of Physical Internet Facilities: A Road-Based Crossdocking Hub, Russell D. Meller, Benoit Montreuil, Collin Thivierge, Zachary Montreuil

12th IMHRC Proceedings (Gardanne, France – 2012)

As part of the 2010 IMHRC, Montreuil, Meller and Ballot proposed a set of facility types that would be necessary to operate a Physical Internet (PI, π), which they termed nodes. This paper is part of a three-paper series for the 2012 IMHRC where the authors provide functional designs of three PI facilities. This paper covers a unimodal road-based crossdocking hub designed specifically to exploit the characteristics of Physical Internet modular containers so as to enable the efficient and sustainable transhipment of each of them from its inbound truck to its outbound truck. The objective of the paper is to …

Dynamic Slotting Optimization Based On Skus Correlations In A Zone-Based Wave-Picking System, Li Yingde, Jeffery S. Smith

12th IMHRC Proceedings (Gardanne, France – 2012)

Many exiting slotting methods ignore the picking correlations between Stock Keeping Units (SKUs). In a previous paper, a mix integer program model for dynamic slotting to minimize the pick-wave makespan among all zones under some load balancing constraints was developed. In this paper, we develop an ant colony optimization with slot-exchange policy (ACO-SE) based on SKU correlation to assign the correlated SKUs to the adjacent slots in the same zone. The ACO-SE deposits pheromones between SKUs, uses local and global pheromone trail updates, and controls pheromone accumulation using the Max-Min rule. The main heuristic information is set to the correlation …

An Extended Double Row Layout Problem, Chase C. Murray, Xingquan Zuo, Alice E. Smith

12th IMHRC Proceedings (Gardanne, France – 2012)

The double row layout problem (DRLP) seeks to determine optimal machine locations on either side of an aisle, where the objective has been defined as the minimization of material ow cost among ma- chines while meeting machine clearance constraints. In this paper, we extend existing DRLP formulations in two respects. First, we consider the minimization of layout area besides the usual material ow cost objective. Second, we present a mixed integer linear programming formulation that permits non-zero aisle widths. This new formulation also includes new constraints that eliminate layout \mirroring," thus reducing the solution space significantly and thus solution times. …

Robust Material Handling System Design Based On The Risk Versus Cost Tradeoff, Marc Goetschalckx, Edward Huang, Pratik Mital

12th IMHRC Proceedings (Gardanne, France – 2012)

The design and planning of major material handling systems belongs to the class of systems design problems under uncertainty. The overall structure of the system is decided during the current design stage, while the values of the future conditions and the future planning decisions are not known with certainty. Typically the future uncertainty is modeled through a number of scenarios and each scenario has an individual timediscounted total system cost. The overall performance of the material handling system is characterized by the distribution of these scenario costs. The central tendency of the cost distribution is almost always computed as the …

Toward Sustainability, High Density And Short Response Time By Live-Cube Storage Systems, Nima Zaerpour, Yugang Yu, René De Koster

12th IMHRC Proceedings (Gardanne, France – 2012)

This paper studies random storage in a live-cube storage system where loads are stored multi-deep. Although such storage systems are still rare, they are increasingly used, for example in automated car parking systems. Each load is accessible individually and can be moved to a lift on every level of the system in x- and y-directions by a shuttle as long as an open slot is available next to it, comparable to Sam Loyd’s sliding puzzles. A lift moves the loads across different levels in z-direction. We derive the expected travel time of a random load from its storage location to …

Process Analysis For Material Flow Systems, Thorsten Schmidt, David Wustmann, Robert Schmaler

12th IMHRC Proceedings (Gardanne, France – 2012)

This paper describes a generic approach for analysis of internal behavior of logistic systems based on event logs. The approach is demonstrated by an example of event data from the simulation model of an automated material handling system (MHS) in a manufacturing company. The purpose of the analysis is the identification of design and operation problems and their causes, prospectively. As a result, the simulation model developer obtains the condensed and ranked information on events. These events describe the internal system behavior with anomalies pointing at either possible problems or capacity reserves.

A Study On Storage Allocation In An Automated Semiconductor Manufacturing Facility, St´Ephane Dauz`Ere-P´Er`Es, Claude Yugma, Ahmed Ben Chaabane, Ahmed Ben Chaabane, Lionel Rulli`Ere, Gilles Lamiable

12th IMHRC Proceedings (Gardanne, France – 2012)

This paper deals with the allocation of storage capacity in the automated material handling environment of a semiconductor wafer manufacturing facility. The impact of the allocation of stokers to machines in semiconductor fabrication facilities (fabs) is very little studied, although it significantly impacts the efficiency of the Automated Material Handling System (AMHS). After motivating and describing the problem of allocating unitary stokers to machines, a first local approach is discussed. We then propose a Mixed Integer linear Programming model to solve the global problem with two objectives: Minimizing the total maximum travel distance of vehicles and balancing the utilization of …

Design & Modeling Of A Single Machine Flow Rack As/Rs, Zaki Sari, Nadir Hakim Bessenouci

12th IMHRC Proceedings (Gardanne, France – 2012)

In this paper, we aim to introduce a new variation of the flow rack automated storage and retrieval system (AS/RS) using a single machine for storage and retrieval operations instead of two machines. Also, analytical expressions are derived for expected single and dual cycle times of the storage and retrieval machine. For that, randomized storage assignment, and Tchebychev travel are assumed. Two dwell point positions are investigated and compared to determine the best one. Finally an experimental validation using simulation is conducted to verify the quality of the developed.

An Mip Approach To The U-Line Balancing Problem With Proportional Worker Throughput, Reyhan Erin, Andres L. Carrano, Moises Sudit

12th IMHRC Proceedings (Gardanne, France – 2012)

One of the major challenges faced by manufacturing companies is to remain competitive in dynamic environments, where fluctuations in customer demand and production rates require systems capable of adapting in a practical and economical way. A U-shaped production cell is considered one of the most flexible designs for adapting the workforce level to varying conditions. However, re-balancing efforts are time consuming and often require a new work allocation and line design. In this paper, a two-stage MIP model to determine the best cell design under varying workforce levels is proposed. The model seeks to maintain proportionality between throughput and the …

A Yard Crane Scheduling Problem With Practical Constraints, Amin Hossein Gharehgozli, Yugang Yu, Rene De Koster, Gilbert Laporte

12th IMHRC Proceedings (Gardanne, France – 2012)

The problem considered in this paper is to locate storage containers while a set of container storage and retrieval requests are sequenced. Two automated cranes stack and retrieve containers in a single block of a yard. The cranes cannot pass each other and must be separated by a safety distance. Storage containers are initially located at the seaside and land side input/output (I/O) points of the block. Each must be stacked in a specific location of the block, selected from a set of open locations suitable for stacking the storage container. Retrieval containers are initially located in the block and …

Modeling The Inventory Requirement And Throughput Performance Of Picking Machine Order-Fulfillment Technology, Jennifer A. Pazour, Russell D. Meller

12th IMHRC Proceedings (Gardanne, France – 2012)

Picking machines, also known as remote-order-picking systems, are an example of a stock-to-picker piece-level order-fulfillment technology that consists of two or more pick stations and a common storage area. An integrated closed-loop conveyor decouples the pick stations from the storage area by transporting the needed totes to and from the storage area and the pick stations. We develop a probabilistic model capable of quantifying the inventory differences between order-fulfillment technologies that pool inventory with technologies that do not pool inventory. To determine the throughput of a picking machine, we develop a methodology that incorporates existing analytical models for the picking …

Ancillary Service Capacity Optimization For Both Electric Power Suppliers And Independent System Operator, Lijian Chen, Dengfeng Sun, Guang Li

MIS/OM/DS Faculty Publications

Ancillary Services (AS) in electric power industry are critical to support the transmission of energy from generators to load demands while maintaining reliable operation of transmission systems in accordance with good utility practice. The ancillary services are procured by the independent system operator (ISO) through a process called the market clearing process which can be modeled by the partial equilibrium from the ends of ISO. There are two capacity optimization problems for both Market participants (MP) and Independent System Operator (ISO). For a market participant, the firm needs to determine the capacity allocation plan for various AS to pursue operating …

Irish Cios’ Influence On Technology Innovation And It-Business Alignment, Harvey Enns, Joseph J. Mcdonagh

MIS/OM/DS Faculty Publications

Technology is the driving force behind many of today’s new products, services, and cost-cutting measures. However, there are gaps in our understanding about how technological innovation is fostered and nurtured in organizations.

Part of the answer is to examine how Chief Information Officers (CIOs) exercise influence regarding technological innovation in organizations. This is particularly important since the CIO is the head of technology in organizations, an important source of technological innovation. This article draws on an established executive influence framework to demonstrate how Irish CIOs are able to solidify Information Technology’s (IT’s) contribution to technological innovation via relational means. Most …

Isscm Graduating Cohort, 2012, Raj Soin College Of Business, Wright State University

ISSCM Master Cohort Posters

Poster congratulating the 2012 Graduating Cohort from the Master of Information Systems and the Master of Science in Logistics and Supply Chain Management Programs.

Ever Expanding Responsibilities: Upstream And Downstream Corporate Social Responsibility, Judith Schrempf-Stirling, Guido Palazzo, Robert A. Phillips

Management Faculty Publications

The debate on corporate social responsibility (CSR) has been on the public and academic agenda for several decades. In general, CSR issues can be divided into production-related issues (along the supply chain - or how things are made) and consumption-related issues (towards the consumer and society at large - or how things are used). Following the terminology of Phillips and Caldweli, Z upstream CSR refers to the CSR debate along the supply chain, and downstream CSR refers to corporate responsibility towards consumers and society at large. The chapter examines current CSR issues, and proposes a social connection model to understand …

Tls Newsletter, Volume 6, Edition 4. January 2012, Unf Transportation And Logistics Society

Transportation & Logistics Society Newsletter

Inside the Newsletter: TLS General Meeting Spring 2012 on January 18th. Upcoming Events. TLS on Tour--UPS Distribution Center Jax. TLS President's Corner. In the Know--Scholarship Season. Get to Know Editor David Sherman. FYI--Spring 2012 Career Day. Professional Spotlight on Propeller Club Networking Social