Power and Energy Commons^™

Loss Model For Gallium Nitride Dc-Dc Buck Converter, Rushi Patel, Daniel Costinett

BCoE Publications

In recent years, more research has been done on Enhancement Mode Gallium Nitride (eGaN) converters as the world is moving towards more power efficient converters. The process to make converters more efficient was complicated and slow in the twentieth century. With help of simulation tools such as MATLAB and LTspice, this process has become much faster and reliable in the modern era. In order to make this process even faster, one of the important aspects in power electronics is to evaluate different losses in the converter. A model for estimating power losses for eGaN DC-DC buck converter (12V/1.2V) is illustrated …

Large-Scale Optimization Of Synchronous Reluctance Machines Using Ce-Fea And Differential Evolution, Yi Wang, Dan M. Ionel, Vandana Rallabandi, Minjie Jiang, Steven Stretz

Power and Energy Institute of Kentucky Faculty Publications

A novel automated design optimization procedure based on the application of an ultrafast computationally efficient finite-element analysis (CE-FEA) for current-regulated synchronous reluctance machines supplied from power electronic converters is proposed. The CE-FEA uses only a minimum number of magnetostatic solutions in order to comprehensively evaluate performance, including ripple torque and core losses. The optimization algorithm is based on differential evolution, and uses as independent variables the torque angle and ratios for a generic rotor topology with four flux barriers. Two problems, one with two and the other with three objectives, are studied and results are compared. Global performance indices and …

Wake Character In The Wind Turbine Array: (Dis-)Organization, Spatial And Dynamic Evolution And Low-Dimensional Modeling, Nicholas Michael Hamilton

Dissertations and Theses

To maximize the effectiveness of the rapidly increasing capacity of installed wind energy resources, new models must be developed that are capable of more nuanced control of each wind turbine so that each device is more responsive to inflow events. Models used to plan wind turbine arrays and control behavior of devices within the farm currently make questionable estimates of the incoming atmospheric flow and update turbine configurations infrequently. As a result, wind turbines often operate at diminished capacities, especially in arrays where wind turbine wakes interact and inflow conditions are far from ideal. New turbine control and wake prediction …

Go With The Flow –Thermoelectric Energy, Shawn Bell

Middle School Lesson Plans

In this unit, students will learn how thermal energy be transferred and transformed. They will carry out investigations to gather evidence to support an explanation about direct conversion of heat into electrical energy. They will develop a model that shows the components of the system and changes in the system being investigated, and they will use evidence from the investigation to construct an explanation for how the energy flows.

Simulation, Measurement, And Emulation Of Photovoltaic Modules Using High Frequency And High Power Density Power Electronic Circuits, Yunas Erkaya

Electrical & Computer Engineering Theses & Dissertations

The number of solar photovoltaic (PV) installations is growing exponentially, and to improve the energy yield and the efficiency of PV systems, it is necessary to have correct methods for simulation, measurement, and emulation. PV systems can be simulated using PV models for different configurations and technologies of PV modules. Additionally, different environmental conditions of solar irradiance, temperature, and partial shading can be incorporated in the model to accurately simulate PV systems for any given condition.

The electrical measurement of PV systems both prior to and after making electrical connections is important for attaining high efficiency and reliability. Measuring PV …

Configuration And Optimization Of A Novel Compressed-Air-Assisted Wind Energy Conversion System, Jie Cheng

Department of Electrical and Computer Engineering: Dissertations, Theses, and Student Research

The increasing concerns over the environmental impact of carbon emissions and the unsustainability of conventional fossil fuel power plants are stimulating interest in the implementation of renewable energy in current power systems. Among all of the renewable energies, wind energy holds a prominent place because of its high output and the maturity of the technology. However, like all of the other renewable energies, integration of wind energy into the power grid causes some quality and control issues, such as overvoltage or undervoltage and frequency excursion.

To mitigate these issues and build a robust wind power system, a novel structure referred …

Recent Progress In Solid-State Nmr Study Of Electrode/Electrolyte Materials For Lithium/Sodium Ion Batteries, Gui-Ming Zhong, Zi-Geng Liu, Da-Wei Wang, Qi Li, Ri-Qiang Fu, Yong Yang

Journal of Electrochemistry

Solid state NMR technique is a powerful tool for characterizing the local structure and compositions of solid materials quantitatively. A comprehensive understanding of the structure evolution during the electrochemical reactions of the materials for lithium/sodium ion batteries will be obtained with the combination of solid state NMR, XRD, and XAS methods. Through analyzing solid state NMR spectra, we can obtain the compositions, local structures and ion diffusion dynamics of electrodes, electrolytes and surface layers for lithium/sodium ion batteries, providing an important theoretical support for the design and development of high-performance materials for batteries. In this paper, we review the recent …

Reduced Graphene Oxide (Rgo) Hollow Network Cages For High-Performance Electrochemical Energy Storage, Chi Zhang, Xu-Jun He, Gao-Ren Li

Journal of Electrochemistry

The reduced graphese oxide (RGO) hollow network cages were synthesized via zinc oxide (ZnO) template-assisted electrodeposition. The as-prepared RGO hollow network cages exhibited the multi-level architectures, from nano sheets, porous structures, networks, to 3D microscaled hollow cages, which can simultaneously optimize transport of electroactive species, utilization rate of electrode material, and super capacitive performance. Electrochemical measurements confirmed the superior performance of RGO hollow network cages for supercapacitors (SCs), such as high Csp (393 F⋅g^-1 at 1.0 A⋅g^-1), excellent rate capability (21.2% Csp loss from 1.0 to 20 A⋅g^-1), and superior cycling stability (< 1% Csp loss after 10000 cycles).

Synthesis, Structural Diversity, And Redox Control Of Cyclometalated Monoruthenium Complexes, Zhong-Liang Gong, Jiang-Yang Shao, Yu-Wu Zhong

Journal of Electrochemistry

Cyclometalated ruthenium complexes have received increasing attractions recently due to their excellent redox and photophysical properties. One structural feature of these complexes is that there is a ruthenium-carbon (Ru-C) σ bond presented in the molecule. Three common methods, namely, the “late metalation”, “early metalation”, and “transmetalation” methods, for the synthesis of cyclometalated ruthenium complexes are discussed and summarized. General strategies for the design of cyclometalating ligand and cyclometalated ruthenium complexes are introduced. By using different ancillary ligands, such as pyridine, imidazole, triazole, and pyrimidine, a great number of ruthenium complexes can be prepared. The presence of the Ru-C bond significantly …

3, 4-Ethylenedioxythiophene Monomer As Safety-Enhancing Additive For Lithium Ion Batteries, Wei-Xiao Ji, Feng Wang, Jiang-Feng Qian, Yu-Liang Cao, Xin-Ping Ai, Han-Xi Yang

Journal of Electrochemistry

Safety concern is a major obstacle hindering the wide applications of large-capacity lithium ion batteries (LIBs) in electric vehicles. In this paper, a polymerizable monomer of 3, 4-ethylenedioxythiophene (EDOT) was proposed and tested as an electrolyte additive for enhancing the safety of LIBs. The electro-oxidative polymerization behaviors and influence of PEDOT additive on the thermal behavior of LiCoO₂ cathode, as well as the safety performance and electrochemical properties of LiCoO₂-based LIBs were investigated. The results from cyclic voltammetry (CV) and transmission electron microscope (TEM) characterizations indicated that the monomer additive can be electro-oxidatively polymerized to form a …

Developments Of Photo-Assisted Fuel Cells, Ling-Ling Zhang, Shao-Jun Dong

Journal of Electrochemistry

The exploitation and utilization of fossil fuels have led to serious energy crisis and environmental pollution. In this case, the development of renewable energy is an alternative to traditional energy consumption. Fuel cells (FCs) can convert chemical energy into electricity via the electrochemical reaction, which is green and environment-friendly. Photo-assisted FCs integrate photo-responsive components into FCs, leading to the dual routes of energy conversion including light energy to electricity and chemical energy to electricity, and thus, improving the energy utilization efficiency. The development of photo-assisted FCs is significant for practical application and promising to solve the coming energy crisis. In …

Energy Consumption Prediction With Big Data: Balancing Prediction Accuracy And Computational Resources, Katarina Grolinger, Miriam Am Capretz, Luke Seewald

Electrical and Computer Engineering Publications

In recent years, advances in sensor technologies and expansion of smart meters have resulted in massive growth of energy data sets. These Big Data have created new opportunities for energy prediction, but at the same time, they impose new challenges for traditional technologies. On the other hand, new approaches for handling and processing these Big Data have emerged, such as MapReduce, Spark, Storm, and Oxdata H2O. This paper explores how findings from machine learning with Big Data can benefit energy consumption prediction. An approach based on local learning with support vector regression (SVR) is presented. Although local learning itself is …

Bringing Electricity To Alafiarou: The Solar Microgrid Project, Nicolas Metais, Jacob Leatherberry

Electrical and Computer Engineering Senior Theses

Despite the great technological advancements and discoveries that have been made throughout the last century, 1.2 billion people still live without access to electricity, 95% of which live in Sub-Saharan Africa and developing Asia.1 In this paper, we discuss how we designed and implemented a self-sustaining, affordable and highly replicable solar microgrid in order to accelerate the electrification of rural communities in the most environmentally conscious way possible. Our project focused on developing a microgrid for a small community of 10 households in rural Benin that previously had no access to electricity. We travelled to this village in December of …

A Utility-Scale Deployment Project Of Behind-The-Meter Energy Storage For Use In Ancillary Services, Energy Resiliency, Grid Infrastructure Investment Deferment, And Demand-Response Integration, Joseph Nathanael Wilson

Dissertations and Theses

Electric utilities are increasingly incentivized to integrate new renewable energy generation resources to their systems; however, operations-related issues arise due to the non-dispatchable and stochastic nature of these renewable energy sources. These characteristics lead to a variety of issues for utilities, among which are voltage fluctuations, balancing dispatch against ramping events, short-duration power fluctuations, and the need to invest in peaking generation facilities just to accommodate the renewable energy. A traditional solution to these issues is to employ renewable generation-following techniques using either newly constructed gas peaking plants, or by shifting existing generation resources to this following responsibility. Unfortunately, use …

The Investigation And Optimization Of A Two-Heat-Pump System Incorporating Thermal Storage For Shaping Residential Heating Load, Emily Lord Barrett

Dissertations and Theses

Portland General Electric has proposed coupling one or more water tanks with two heat pumps in order to perform load-shifting in residential customer heating and cooling applications. By using the water tanks as a thermal storage unit, this project attempts to partially decouple energy consumption from generation to provide peak demand reduction and to better facilitate the integration of variable renewable energy resources. A scoping study was performed to evaluate the potential impact of this project if implemented in single family homes in Portland, Oregon. This study revealed that the system could provide meaningful savings in the cost of electricity …

Wireless Mesh Networks For Scada Systems, Zachary Weisman

Computer Engineering

No abstract provided.

Solar Generation's Impact On Fault Current, Kody Heppner

Electrical Engineering

California is paving the road for other states with the capacity of solar installations for residential and commercial entities. The added capacity of solar generation to the state's electric grid has an impact on power flow and fault currents. This project looks at the impact of solar installations on fault currents. Feeders with added residential rooftop solar and larger commercial solar installations may impact the system differently than a large, utility-sized solar installation. This project looks at the impact of both cases on the magnitude of fault current during many different fault types and locations that can occur within a …

Integration Of Sel Relays To Provide Motor, Transmission Line, And Transformer Protection, Christopher Ewing, Bryce Keefer

Electrical Engineering

The objective of this project is to familiarize the performers with the principles of operation of the Schweitzer Engineering Laboratories (SEL) protective relays in both normal and fault conditions. The SEL-587, SEL-311L and SEL-710 microprocessor-based relays are used to provide protection for a system composed of transformers, simulated transmission lines and a 3-phase induction motor. Each of these relays provides protection by sending a trip signal to local breakers upon sensing a fault condition. The SEL-587 provides overcurrent and differential protection for a 3-phase transformer, while the SEL-311L provides differential and distance protection for a transmission line, and negative sequence. …

Micro-Inverter Improvement For The Energy Harvesting From Exercise Machine Project, James Ralston

Electrical Engineering

The Energy Harvesting from Exercise Machines (EHFEM) project at California Polytechnic State University consists of several different projects coming together to add human generated power to the grid. This project focuses on implementing a more efficient micro-inverter. The micro-inverter used to convert DC to AC voltage requires up to 5 minutes before the conversion process begins. This time lag significantly diminishes the power produced from an exercising individual. Research of micro-inverters approved by the CEC introduces desirable micro-inverters, available for use in California, to the EHFEM project. Testing the two most desirable micro-inverters found from research allows for quantifying of …

Rf Power Harvesting Rectenna, Jimmy Tang, Raymond Phu, Tom Geranios, Benjamin Muñoz

Electrical Engineering

Sustainability is one of today's primary engineering objectives. This principle involves system design that minimizes environmentally harmful energy emissions and resource consumption, and maximizes renewable energy practices [1]. Communication antennas transmit wireless signals that can be converted into usable energy. The Rectenna system described in this report, shown in Figure 1, was designed to accomplish this energy conversion, with -5dBm (316µW) minimum power at the rectifier input. Since typical ambient signal power is in the -70dBm (0.1nW) range, the proposed system could only convert passive, relatively high-power microwave band AC signals to DC. The Rectenna system was designed for 1.9GHz …