Power and Energy Commons^™

Arc Fault Circuit Interrupter Development For Residential Dc Electricity, Cassidy Alan Aarstad

Master's Theses

The following technical report describes the development and testing of an arc fault circuit interrupter (AFCI) for DC circuits operating primarily at 48 volts. We have identified an effective method for determining when arcing is occurring. Our method is primarily based on comparing the frequency spectrum of current flowing through the circuit during an arcing event to a known characteristic spectrum. Once an arc has been identified, our interrupter is capable of responding adequately to eliminate the arc. Hardware tests show the AFCI developed in this thesis responded, in all test cases, within 2 seconds of an arc fault occurrence. …

Automatic Water Pump Controller, Alam D. Salguero, Kyle Russell Marquez Weeks

Electrical Engineering

In countries including Indonesia, Mexico, Guatemala, and El Salvador, a city water authority supplies the clean water and pumps it into large ground-level storage tanks. A resident’s water pump then pumps the water to a water tank on top of his/her house. When the water level in the ground-level storage tank becomes too low, the pump siphons air and shuts down, requiring a resident to manually prime the water pump to get it running again. Residents struggle to monitor the water level of the tanks effectively and keep the pump running properly. To remedy the issue, the Automatic Water Pump …

Low-Frequency Series Loaded Resonant Inverter Characterization, Alfredo Medina

Master's Theses

Modern power systems require multiple conversions between DC and AC to deliver power from renewable energy sources. Recent growth in DC loads result in increased system costs and reduced efficiency, due to redundant conversions. Advances in DC microgrid systems demonstrate superior performance by reducing conversion stages. The literature reveals practical DC microgrid systems composed of wind and solar power to replace existing fossil fuel technologies for residential consumers. Although higher efficiencies are achieved, some household appliances require AC power; thus, the need for highly efficient DC to AC converters is imperative in establishing DC microgrid systems. Resonant inverter topologies exhibit …

Energy Harvesting From Exercise Machines Buck-Boost Dc Dc Converter With The Lt8705 Controller, Ryan Matteo

Electrical Engineering

In order to increase sustainability and save money, the Energy Harvesting from Exercise Machines (EHFEM) system uses human supplied energy to self-power exercise equipment such as spin bikes, elliptical trainers, ergometers, etc. This document covers the design and implementation of a Buck-Boost DC-DC converter using the LT8705 controller into the EHFEM system. This project improves upon the overall efficiency of the Buck-Boost Converter designed by past groups working on the EHFEM system.

Transformer And Motor Protection Scheme, Bijan Vakilifathi

Electrical Engineering

No abstract provided.

Modelling And Energy Management Optimisation Of Battery Energy Storage System Based Photovoltaic Charging Station (Pv-Cs) For University Campus, Ayda Esfandyari, Brian Norton, Michael Conlon

Conference Papers

As utilization of Photovoltaic Charging Stations (PV-CS) that generate clean electricity from the sun increase, Technological University Dublin (DIT) adopts this application for accommodating the required charge of small campus Battery Electric Vehicles (BEVs). This paper presents the virtual simulation of the 10.5 kW Battery Energy Storage System (BESS) based PV-CS model. Transient System Simulation (TRNSYS) built-in climatic data and modular structure properties were adopted to replicate the experimentally proposed PV-CS, where special attention was paid to the electrical measurments and energy flow signals. The objective was set to model the PV-CS system, formulate an energy managment optimisation and justify …

Event Detection Using Correlation Within Arrays Of Streaming Pmu Data, Jordan Landford

Dissertations and Theses

This thesis provides a synchrophasor data analysis methodology that leverages both statistical correlation techniques and a statistical distribution in order to identify data inconsistencies, as well as power system contingencies. This research utilizes archived Phasor Measurement Unit (PMU) data obtained from the Bonneville Power Administration in order to show that this methodology is not only feasible, but extremely useful for power systems monitoring, decision support, and planning purposes.

By analyzing positive sequence voltage angles between a pair of PMUs at two different substation locations, an historic record of correlation is established. From this record, a Rayleigh distribution of correlation coefficients …

The Effects Of Phosphonic Acids In Dye-Sensitized Solar Cells, Keith Edward James

Dissertations and Theses

Novel methods for the construction of dye-sensitized solar cells (DSSCs) were developed. A thin dense underlayer of TiO₂ was applied on fluorine-doped tin oxide (FTO) glass using as a precursor Tyzor AA-105. Subsequently a mesoporous film of P-25 TiO₂ was applied by spreading a suspension uniformly over the surface of the underlayer and allowing the plate to slowly dry while resting on a level surface. After sintering at 500° C slides were treated with TCPP as a sensitizing dye and assembled into DSSCs. A novel method was used to seal the cells; strips of Parafilm® were used as …

Reflective Efficiencies Of Materials For Applications Of Bifacial Solar Cells, Michael Metter

Senior Theses

The bifacial solar cell is superior to its monofacial predecessor due to its ability to convert both incident light on top and reflected light from below into energy. The scattering of the reflected light is affected by the property of the material on which it is interacting. To date, little work has been contributed to studying the properties of these materials to determine optimal quantities for bifacial solar cells. In the first experiment, reflective efficiencies compared to the angle of reflection were explored for different grit of sandpaper in order to develop an understanding of how surface texture impacts reflectivity. …

Test Plan For Real-Time Modeling & Simulation Of Single Pole Switching Relays, Ram Mohan Sanaboyina

LSU New Orleans Theses and Dissertations

A real-time simulator (RTS) with digital and analog input/output modules is used to conduct hardware-in-the-loop simulations to evaluate performance of power system equipment such as protective relays by exposing the equipment to the simulated realistic operating conditions. This work investigates the use of RTS to test relays with single-pole-switching (SPS) feature. Single-pole switching can cause misoperations due to fault arc during reclosing of the breakers. Through this investigation, a test procedure appropriate for the testing SPS relays has been developed. The test procedure includes power system modeling for real time simulation, relay test setup, and test plan. HYPERSIM real-time simulator …

Utilization Of Distributed Generation In Power System Peak Hour Load Shedding Reduction, Nandu Balachandran

LSU New Orleans Theses and Dissertations

An approach to utilize Distributed Generation (DG) to minimize the total load shedding by analyzing the power system in Transactive energy framework is proposed. An algorithm to optimize power system in forward and spot markets to maximize an electric utility’s profit by optimizing purchase of power from DG is developed. The proposed algorithm is a multi-objective optimization with the main objective to maximize a utility’s profit by minimizing overall cost of production, load shedding, and purchase of power from distributed generators. This work also proposes a method to price power in forward and spot markets using existing LMP techniques. Transactive …

Sensitivity Analysis Of Synchronous Generators For Real-Time Simulation, Sowmya Munukuntla

LSU New Orleans Theses and Dissertations

The purpose of this thesis is to validate generator models for dynamic studies of power systems using PSS/E (Power System Simulator for Engineering), EMTP (ElectroMagnetic Transient Program), and Hypersim. To thoroughly evaluate the behavior of a power system in the three specified software packages, it is necessary to have an accurate model for the power system, especially the generator which is of interest. The effect of generator modeling on system response under normal conditions and under faulted conditions is investigated in this work. A methodology based on sensitivity analysis of generator model parameters is proposed aiming to homogenize the behavior …

Smart Gate Driver Design For Silicon (Si) Igbts And Silicon-Carbide (Sic) Mosfets, Abdulaziz Alghanem

Electrical Engineering Undergraduate Honors Theses

The design of an efficient and smart gate driver for a Si IGBT and SiC MOSFET is addressed in thesis. First, the main IGBT parameters are evaluated thoroughly in order to understand their effects in the design of the gate driver. All known consequences of previously designed gate drivers are studied in order to achieve an optimum gate driver. As a result of this assessment, the designer is able to determine whether adding or removing components from the gate driver circuit are beneficial or not. Then, exhaustive research is done to identify suitable integrated circuits to use for the power …

Design Of Processing Circuitry For An Rf Energy Harvester, Brett Schauwecker

Electrical Engineering Undergraduate Honors Theses

Significant advancements in technology and the use of low power sensors in both commercial and industrial applications have made it essential to develop wireless solutions for low power devices. Once such solution, which has generated attention in university and R&D environments, is radio frequency (RF) energy harvesting. RF energy harvesting seeks to capture ambient RF energy by means of an antenna and convert this energy to useable DC power. The presence of ambient RF energy in the environment is a result of numerous high-frequency technologies including Wi-Fi, cell phones, microwave ovens, and radio broadcasting, as well as many others. The …

Control Design Of A Single-Phase Dc/Ac Inverter For Pv Applications, Haoyan Liu

Graduate Theses and Dissertations

This thesis presents controller designs of a 2 kVA single-phase inverter for photovoltaic (PV) applications. The demand for better controller designs is constantly rising as the renewable energy market continues to rapidly grow. Some background research has been done on solar energy, PV inverter configurations, inverter control design, and hardware component selection. Controllers are designed both for stand-alone and grid-connected modes of operation. For stand-alone inverter control, the outer control loop regulates the filter capacitor voltage. Combining the synchronous frame outer control loop with the capacitor current feedback inner control loop, the system can achieve both zero steady-state error and …

Solar-Powered Hot Tub, Jonathan Peterson, Anthony Zepeda

Electrical Engineering

This paper discusses the design and implementation of a solar-powered hot tub. The concept of this project was to design an independently-operated hot tub powered by a 12V rechargeable battery, charged during the day by a single 400W solar panel. For this purpose, a twenty-year-old name-brand hot tub was purchased, in used condition. The plumbing, AC electrical wiring, and mechanical pumps were all removed and replaced with new components to meet our design specifications. Additionally, a solar water-heater was designed and integrated into the system to directly apply the sun’s heat to water pumped in and out of the tub, …

High Step-Up/Down Transformerless Multilevel Converter For Renewable Energy Applications, Haider Ghazi Mhiesan

Graduate Theses and Dissertations

This thesis focuses on a high step-up/down transformerless dc-dc modular multilevel converter (MMC) that would be applicable to dc power systems. The design achieves high voltage ratios for interfacing renewable energy sources such as photovoltaic and line interactive Uninterruptible Power System (UPS) systems. The circuit topology provides for high step-up/down dc-dc conversion ratios using an MMC approach operating in resonant mode in order to improve overall efficiency. This topology operates to step-up the input voltage with 1:10 or larger conversion ratio. As a bidirectional converter, it also provides step-down capability at the same voltage ratio (10:1 or greater). The MMC …

Use Of Drone And Infrared Camera For A Campus Building Envelope Study, Raheem Taiwo Ariwoola

Electronic Theses and Dissertations

Presently, there are concerns that buildings in the USA under-performs in terms of energy efficiency when compared with the original design specifications. A significant percentage of the energy loss in these buildings is associated with the building’s envelope. This study provides a qualitative and analytical understanding of the R-value, which indicates the thermal performance of the elements that make up a building envelope. Infrared thermography is used as a methodology to assess the thermal performance of envelopes of ten buildings on East Tennessee State University Campus. A Fluke Ti25 infrared hand-held camera and a DJI phantom-2 drone mounted with FLIR …

Special Issue: Electrocatalyst And Electrocatalysis In Fuel Cells Preface, Zi-Dong Wei

Journal of Electrochemistry

/

Recent Progress In Non-Precious Metal Oxygen Reduction Reaction Catalysts With An Encapsulation Structure, Mei-Ling Xiao, Jian-Bing Zhu, Chang-Peng Liu, Jun-Jie Ge, Wei Xing

Journal of Electrochemistry

Platinum-based materials, the state-of-the-art catalysts for fuel cells, suffer from prohibitive costs, limited resources and insufficient durability. Accordingly, tremendous efforts were made in searching for efficient, durable and inexpensive alternatives to precious-metal electrocatalysts for the oxygen reduction reaction (ORR). Transition-metals (Fe, Co)/nitrogen co-doped hybrids, heteroatom (N, P, S, F, et al) doped carbons and composites with transition-metals encapsulated in graphitic layers are reported as the most efficient non-precious metal ORR catalysts. Among the various non-precious metal ORR catalysts, transition-metals encased in graphitic layer catalysts are a novel type of catalysts for ORR with high activity and durability, and thus, the …