Chemical Engineering Commons^™

Characterization Of Macromolecular Structure Elements From A Green River Oil Shale, Ii. Characterization Of Pyrolysis Products By 13c Nmr, Gc/Ms, And Ftir, Thomas H. Fletcher, Ryan Gillis, Jacob Adams, Trent Hall

Faculty Publications

This paper is Part II of a study of the chemical structural components of the organic matter of oil shale in the Green River formation. Three sections of a well-characterized oil shale core from the Utah Green River formation were demineralized, and the resulting kerogen was pyrolyzed at 10 °C/min in nitrogen at atmospheric pressure at temperatures up to 525 °C. The pyrolysis products (light gas, tar, and char) were analyzed using ¹³C NMR, GC/MS, and (FTIR). Pyrolysis yields of 80% (daf basis) were achieved at these conditions, with 60% daf tar yield at the highest temperature. The solid-state …

Preformed Particle Gel Transport Through Fractures, Hao Zhang

Doctoral Dissertations

"Polymer gel treatment is one of the most cost-effective methods to control water production in mature oil fields. The main objective of gel treatments is to reduce water or gas flow through high-permeability channels or fractures without damaging productive zones. Preformed particle gels (PPGs) have been applied for conformance control because they can overcome some potential drawbacks inherent in an in-situ gelation system.

In this study, lab experiments were performed to quantify PPG propagation through fractures and fracture-like channels by using screen models and open fracture models. The main findings in these experiments can guide the selection of best particle …

Semantic Model And Updated Screening Criteria For Polymer Flooding, Laila Dao Saleh

Doctoral Dissertations

"Enhanced oil recovery (EOR) processes produce oil that conventional methods leave behind, where interfacial forces, heavy oil viscosity, and reservoir heterogeneity make it difficult to produce. Many EOR methods are available but usually cannot be used at the same time for a candidate reservoir. Therefore, it is important to select the most appropriate EOR process from among the possible techniques. EOR screening criteria have been created using EOR datasets and serve as the first step to compare the suitability of each technique for a specific reservoir. Most of these datasets are based on field data collected from EOR surveys published …

Investigating And Modeling Tar-Mats In A Kuwaiti Carbonate Reservoir And Their Role In Understanding Oil Reserves And Recovery Economics, Abdullah Owidah Almansour

Doctoral Dissertations

"Tar-mat columns exist in many carbonate reservoirs in the Middle East. Historically, tar-mats have been thought to impede primary oil extraction, thus necessitating further improved oil recovery (IOR) technology applications. However, this research considers tar-mats as potential sources for unlocking extremely difficult crude oil, less than 5 ⁰API. The main objective of the study was to understand the qualitative physical and chemical properties of extremely viscous tar-mat oil and the quantitative potential of tar-mats to extract difficult oil.

The physical and chemical geneses of the tar-mat oil were analyzed utilizing several experimental geochemical techniques, including rock evaluation pyrolysis, liquid extracts …

Study And Pilot Test On A Novel Eor Method - Coupling Ppg Conformance Control And Surfactant Flooding, Farag Awadh Muhammed

Doctoral Dissertations

"The interest in enhanced oil recovery (EOR) methods has re-emerged in recent years; however, significant challenges remain for the widespread deployment of these methods. One major downside to the successful application of EOR technologies in mature reservoirs is conformance problems (e.g. heterogeneity). To mitigate these problems, a novel EOR method which couple preformed particle gel (PPGs) conformance treatment with traditional surfactant flooding in one process is introduced.

This dissertation provides a comprehensive study for the proposed method. A series of laboratory tests were carried out to understand the chemical interaction between PPGs and surfactants. A new method to evaluate PPGs …

Carbon Dioxide - Heavy Oil Systems: Thermodynamics, Transport And Interfacial Stability, Truynh Quoc My Duy Tran

Doctoral Dissertations

"Conventional oil recovery leaves behind around 67% of original oil in place for light oils and all of it for heavy oils. The carbon dioxide flooding process is the cheapest among the recovery methods for the next stage. The interest here lies in recovering heavy oil. When CO₂ dissolves in oil, it increases the volume of oil, squeezes it out of narrow capillaries and the viscosity of oil drops by up to an order of magnitude. Starting with the available data with and without CO₂ in heavy oil, the free volume theory is used to predict these physical …

Impact Of Slickwater Fracturing Fluid Compositions On The Petrophysical Properties Of Shale And Tightsand, Yongpeng Sun

Doctoral Dissertations

"A tight reservoir always requires hydraulic fracturing before production to increase production rate. The additives in hydraulic fluids are highly considerable for a successful stimulation. A friction reducer is often used to reduce the flowing friction in the wellbore during hydraulic fracturing. Extensive researches have been conducted to examine the extent it can reduce the fluid friction in tubings; however, no research has been reported on its behavior in a reservoir, which is related to the fracture extension. A breaker is also pumped into the formation to degrade the friction reducer. However, it is not clear that what is the …

Evaluation Of Ceramic Coaxial Cable Sensors For Long-Term In-Situ Monitoring Of Geologic Co₂ Injection And Storage, Yurong Li

Masters Theses

"Monitoring is an essential component of CO₂ injection and storage projects in order to manage the injection process, identify leakage risks, provide early failure warnings, determine the movement of CO₂ plume and provide input into reservoir models. In-situ monitoring provides critical and direct data points that can be used to fulfill the above objectives. However, downhole sensors that can withstand the harsh conditions and run over decades of the project life cycle remain unavailable. A new idea of ceramic coaxial cable temperature, pressure and strain sensor has recently been put forward and the sensors are under development.

A high pressure …

Theoretical Analysis Of Shape Separation Of Particles Using Flow Field-Flow Fractionation, Mehrdad Alfi

Masters Theses

"Size separation of spherical and rod-like particles in Flow Field-flow Fractionation was investigated theoretically. The effect of cross flow migration and rod orientation was also investigated as a new mode of study. It has been shown that the rod local orientation makes different diffusivity values in comparison with spherical particles and helps particle separation. Additionally, a new mechanism of lift-hypelayer mode was used for rod-like particles which can be compared with steric mode of spherical particles. This mechanism is said to be due to hydrodynamic interaction of rod-like particle with wall and with other rods.

As a measure of axial …

An Analytical Pressure Model To Guide Downhole Sensor Placement For Carbon Dioxide Sequestration Monitoring, Yilin Mao

Masters Theses

"Injecting CO₂ into saline aquifers is currently the most viable approach to mitigate global greenhouse gas effect. Various monitoring techniques are required to achieve 99% accuracy in determining the location of the injected CO₂ plume. Sensor locations are critical to the monitoring quality necessary to meet this requirement but have scarcely been discussed. The pressure profile needs to be modeled accurately at the initial stage of CO₂ injection to guide sensor locations. The objective of this thesis was to develop an analytical solution for CO₂ sequestration based on time and distance. This will guide the locations of downhole pressure sensors …

Computational Fluid Dynamics (Cfd) Modeling Of Proppant Transport In A Plug-And-Perf Completion With Different Perforation Phasing, Jinlin Zhang

Masters Theses

"Perf-and-plug is a completion technique commonly used in multistage fracturing. Fracture performance modeling assumes that fluid and proppant distributes uniformly among all perforations along the length of the wellbore in a plug and perf completion Crespo et al. (2012) has conducted a limited proppant flow experiment using a 63 foot stage, and three 0.42 inch, zero phased simulated perforations. His work demonstrates proppant does not distribute evenly, but the work is limited to a single perforation scheme.

In this study, Computational Fluid Dynamics (CFD) software has been used to simulate proppant transport and distribution in a single stage of a …

Aspen Simulation Of Furfural And Hydroxymethylfurfural Production From Biomass, Zachary Daniel King

Masters Theses

"Biomass field liquefaction is a concept where green biomass is chemically treated to produce organic liquids using small-scale equipment in the field. If liquefaction occurs as the crop is harvested, the energy requirements for growing the biomass can be charged to the crop as if the biomass were left in the field. The energy in the organic liquid product is available at the expense of the energy required by the process. A simplified process was simulated using ASPEN to assess the energy production feasibility.

Acid catalyzed liquefaction of cellulose and hemicellulose solids produces furfural and hydroxymethylfurfural (HMF). The simulation assumed …

Data Analysis And Summary For Surfactant-Polymer Flooding Based On Oil Field Projects And Laboratory Data, Pratap D. Chauhan

Masters Theses

"Enhanced oil recovery screening is considered as an important first step towards evaluating a potential EOR technique for a candidate reservoir. A vast amount of research is continuously been conducted in EOR. Therefore, it is imperative to update the screening criteria regularly.

This study involves updating the screening criteria for surfactant polymer flooding for field projects dataset and laboratory dataset. Many of the screening criteria for surfactant-polymer flooding in the literature were achieved on the basis of data collected from the EOR surveys published biennially in Oil & Gas Journals. However, these datasets contain problems like missing data and inconsistent …

Influence Of Erosional Unloading On The State Of Stress For Low Amplitude Single-Layer Buckle Folds - Implications For Tensile Fracture Occurrence, Mengke Li

Masters Theses

"The existence of fractures associated to buckle folds is related to the strain distribution of the fold. The erosional unloading process can amplify the remnant strain in the folded layer. Two-dimensional plane strain Finite Element Analysis (FEA) is used to investigate the influence of the erosional unloading step on both the evolution of the state of stress and the associated failure patterns in low amplitude buckle folds. Sensitivity analyses on different input parameters, including viscosity, shortening ratio, and overburden pressure, are performed. Based on the simulation results, tensile stress can be initiated both in the crest and in the limb …

Evaluation Of Prosper For Modeling Long Lateral Gas Well Productivity In Toe Up, Toe Down, Horizontal Well Geometry, Abdussalam Mahmoud Mohamed

Masters Theses

"Most horizontal wells are not truly horizontal and may be drilled 'toe-up' or 'toe-down' to follow geological formations or in an attempt to keep the well from loading up. Challenges in directional drilling may also lead to horizontal gas wells with undulating wellbore profiles. This wellbore profile creates natural traps for heavy fluids in the lows and light fluid in the highs, which may result in chocked production. Hence, there is an interest in determining the best wellbore trajectory - toe-up, horizontal, or toe-down - for well unloading.

This study evaluates the capability of the well productivity software PROSPER to …

Modelling Of Biomass Gasification Integrated With A Solid Oxide Fuel Cell System, Wayne Doherty

Doctoral

Biomass is of major interest as a renewable energy source in the context of climate change and energy security. Traditional biomass conversion technologies achieve low electrical efficiencies. Biomass gasification (BG) coupled with fuel cells offer higher efficiencies. Gasification is a process in which a carbonaceous fuel is converted to a combustible gas. It occurs when a controlled amount of oxidant is reacted at high temperatures with available carbon in a fuel within a gasifier. Two technologies (circulating fluidised bed air gasification and dual fluidised bed steam gasification) were modelled. Solid oxide fuel cells (SOFCs) are well suited to integration with …

Simulation Of The Swelling Of High-Volatile Bituminous Coal During Pyrolysis, He Yang, Sufen Li, Thomas H. Fletcher, Ming Dong

Faculty Publications

In this paper, a model is established to predict the swelling ratio of high-volatile bituminous coal during pyrolysis, based on the assumption that the structure of bubble distribution in the particle at the beginning of the plastic stage is a central bubble surrounded by many surrounding bubbles. The initial number and size of the bubbles when the particles become plastic are calculated by the pressure in the particle. The chemical percolation devolatilization (CPD) model is used to describe pyrolysis. The pyrolysis of eight types of high-volatile bituminous coals is simulated, and the results are compared with experimental results to verify …

Total Safety Management: What Are The Main Concerns In The Integration Of Best Available Methods And Tools, Maria Chiara Leva, Nora Balfe, Tom Kontogiannis, Emmanuel Plot, Micaela De Michela

Articles

“BP released findings from its own internal investigation of the oil spill in the Gulf of Mexico, revealed inefficient Organization interfaces among BP management, the rig crew and well site leader. Also according to the investigation, one important contributor to the accident was inadequate guidelines for critical tests and operations”. (Pires and Mosleh 2011) Over the recent past, the accumulation of major mishaps, crises and accidents have made it clear that organisations must still improve their capabilities to address safety “not as a stand-alone activity that is separate from the main activities and processes of the organization” but as an …

Stereoselective Transformations Of Α-Trifluoromethylated Ketoximes To Optically Active Amines By Enzyme-Nanometal Cocatalysis: Synthesis Of (S)-Inhibitor Of Phenylethanolamine N-Methyltransferase, Guilin Cheng, Qi Wu, Zeyu Shang, Xinhua Liang, Xianfu Lin

Chemical and Biochemical Engineering Faculty Research & Creative Works

One-pot cascade synthesis of optically active α-trifluoro methylated amines directly from ketoximes was accomplished with the use of Candida antarctica lipase B and catalysts prepared by atomic layer deposition (ALD). Compared to the commercial palladium catalyst, the ALD-prepared catalysts showed much higher activity and afforded various α-trifluoro methylated amides in good yields and with high enantioselectivity. One of the enantiopure amides was further hydrolyzed into the corresponding amine, which was treated as a crucial starting material for total synthesis of (S)-inhibitor of phenyl ethanolamine N-methyltransferase without loss of chiral information. © 2014 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.

Effect Of Magnetic Nanoparticle Heating On Cortical Neuron Viability, Christopher J. Rivet, Yuan Yuan, Ryan J. Gilbert, Diana Andra Borca-Tasciuc

Chemical and Biochemical Engineering Faculty Research & Creative Works

Purpose: Superparamagnetic iron oxide nanoparticles are currently approved for use as an adjunctive treatment to glioblastoma multiforme radiotherapy. Radio frequency stimulation of the nanoparticles generates localized hyperthermia, which sensitizes the tumor to the effects of radiotherapy. Clinical trials reported thus far are promising, with an increase in patient survival rate; however, what are left unaddressed are the implications of this technology on the surrounding healthy tissue. Methods and materials: Amino silane-coated iron oxide nanoparticles suspended in culture medium were applied to chick embryonic cortical neuron cultures. Cultures were heated to 37 °C or 45 °C by an induction coil system …