Controls and Control Theory Commons^™

Introduction To Control Engineering, Xiangyu Meng

E-Textbooks

This is an introductory level textbook for control engineering.

Cooperative Deep Q -Learning Framework For Environments Providing Image Feedback, Krishnan Raghavan, Vignesh Narayanan, Sarangapani Jagannathan

Publications

In this article, we address two key challenges in deep reinforcement learning (DRL) setting, sample inefficiency, and slow learning, with a dual-neural network (NN)-driven learning approach. In the proposed approach, we use two deep NNs with independent initialization to robustly approximate the action-value function in the presence of image inputs. In particular, we develop a temporal difference (TD) error-driven learning (EDL) approach, where we introduce a set of linear transformations of the TD error to directly update the parameters of each layer in the deep NN. We demonstrate theoretically that the cost minimized by the EDL regime is an approximation …

Novel Locomotion Methods In Magnetic Actuation And Pipe Inspection, Adam Cox

Mechanical Engineering Research Theses and Dissertations

There is much room for improvement in tube network inspections of jet aircraft. Often, these inspections are incomplete and inconsistent. In this paper, we develop a Modular Robotic Inspection System (MoRIS) for jet aircraft tube networks and a corresponding kinematic model. MoRIS consists of a Base Station for user control and communication, and robotic Vertebrae for accessing and inspecting the network. The presented and tested design of MoRIS can travel up to 9 feet in a tube network. The Vertebrae can navigate in all orientations, including smooth vertical tubes. The design is optimized for nominal 1.5" outside diameter tubes. We …

On-Board Artificial Intelligence For Failure Detection And Safe Trajectory Generation, Eduardo Morillo

Doctoral Dissertations and Master's Theses

The use of autonomous flight vehicles has recently increased due to their versatility and capability of carrying out different type of missions in a wide range of flight conditions. Adequate commanded trajectory generation and modification, as well as high-performance trajectory tracking control laws have been an essential focus of researchers given that integration into the National Air Space (NAS) is becoming a primary need. However, the operational safety of these systems can be easily affected if abnormal flight conditions are present, thereby compromising the nominal bounds of design of the system's flight envelop and trajectory following. This thesis focuses on …

Development Of Directed Randomization For Discussing A Minimal Security Architecture, Henrique Oyama, Dominic Messina, Keshav Kasturi Rangan, Akkarakaran Francis Leonard, Kip Nieman, Helen Durand, Katie Tyrrell, Katrina Hinzman, Michael Williamson

Chemical Engineering and Materials Science Faculty Research Publications

Strategies for mitigating the impacts of cyberattacks on control systems using a control-oriented perspective have become of greater interest in recent years. Our group has contributed to this trend by developing several methods for detecting cyberattacks on process sensors, actuators, or both sensors and actuators simultaneously using an advanced optimization-based control strategy known as Lyapunov-based economic model predictive control (LEMPC). However, each technique comes with benefits and limitations, both with respect to one another and with respect to traditional information technology and computer science-type approaches to cybersecurity. An important question to ask, therefore, is what the goal should be of …

Decentralized Resource Allocation Through Constrained Centroidal Voronoi Tessellations, Bhagyashri Telsang

Doctoral Dissertations

The advancements in the fields of microelectronics facilitate incorporating team elements like coordination into engineering systems through advanced computing power. Such incorporation is useful since many engineering systems can be characterized as a collection of interacting subsystems each having access to local information, making local decisions, interacting with neighbors, and seeking to optimize local objectives that may well conflict with other subsystems, while also trying to optimize certain global objective. In this dissertation, we take advantage of such technological advancements to explore the problem of resource allocation through different aspects of the decentralized architecture like information structure in a team. …

Modeling, Control And Estimation Of Reconfigurable Cable Driven Parallel Robots, Adhiti Raman Thothathri

All Dissertations

The motivation for this thesis was to develop a cable-driven parallel robot (CDPR) as part of a two-part robotic device for concrete 3D printing. This research addresses specific research questions in this domain, chiefly, to present advantages offered by the addition of kinematic redundancies to CDPRs. Due to the natural actuation redundancy present in a fully constrained CDPR, the addition of internal mobility offers complex challenges in modeling and control that are not often encountered in literature.

This work presents a systematic analysis of modeling such kinematic redundancies through the application of reciprocal screw theory (RST) and Lie algebra while …

Multi-Criteria Performance Evaluation And Control In Power And Energy Systems, Payam Ramezani Badr

All Dissertations

The role of intuition and human preferences are often overlooked in autonomous control of power and energy systems. However, the growing operational diversity of many systems such as microgrids, electric/hybrid-electric vehicles and maritime vessels has created a need for more flexible control and optimization methods. In order to develop such flexible control methods, the role of human decision makers and their desired performance metrics must be studied in power and energy systems. This dissertation investigates the concept of multi-criteria decision making as a gateway to integrate human decision makers and their opinions into complex mathematical control laws. There are two …

Nonlinear Observers For Burning Zone Temperatures And Torque Estimation Of The Rotary Cement Kiln., Bhagyashri Aditya Bhagwat

Electronic Theses and Dissertations

Due to consistent expansion in the infrastructure and housing sectors worldwide have given a new way for the rapid growth of global cement market. Increased global demand for the cement production makes the attractive research topic which can lead to the quality and overall efficiency of the product. Measurement of the temperature in the burning zone is vital to maintain product quality and kiln efficiency in the cement industry. Often the BZT is un-measurable due to internal kiln conditions, dusty environment, extreme heat, harshness for example and this leads to kiln not being driven as efficient as possible. Multi-physics tools …

Optical Control System For Atmospheric Turbulence Mitigation, Martyn Lemon

All Theses

Propagation of laser light is distorted in the presence of atmospheric turbulence. This poses an issue for sensing, free-space optical communications, and transmission of power. With an ever-increasing demand for high-speed data communications, particularly between satellites, unmanned vehicles, and other systems that benefit from a point-to-point link, this issue is critical for the field. A variety of methods have been proposed to circumvent this issue. Some major categories include the manipulation of the light’s structure, an adaptive scheme at the optical receiver, scanning mirror systems, or a transmission of simultaneous signals with a goal to improve robustness.

There is an …

Parallel Distributed Compensation-Pid Controller Design For Maximum Power Point Tracking Of Dynamic Loaded Photovoltaic System, Anas Shomer, Helmy El Zoghby, Mohiy E. Bahgat, Soliman Sharaf

Future Engineering Journal

Control issues come from the output voltage of PV installations and systems operating in a range of irradiance and temperature. By using a DC converter, such systems are able to maintain a constant output voltage despite fluctuations in the generated voltage and load. The design of a maximum power point tracking (MPPT) on DC converter controller is presented in this article for a system. Fractional Order-Proportional Integral Derivative (FO-PID) and Parallel Distributed Compensation-Proportional Integral Derivative (PDC-PID) controllers have been implemented to the system converter as a proposed control approach. Particle Swarm Optimization (PSO) is used as optimization technique for determining …

Hypoxic Incubation Chamber, Simone Lisette Helfrich, Makenzie Nicole Jones

Biomedical Engineering: Graduate Reports and Projects

This paper describes the design, manufacturing, and testing of a novel controllable hypoxic incubator with fully functional oxygen gas control and temperature control in a humid environment. On the current market, a majority of the few hypoxic incubators use pre-mixed gas that does not offer precise control over gas concentration. The objective for this project was to create a chamber that allows the user to set the O2 concentration to varying set points of % O2 while maintaining the chamber at a constant body temperature, CO2 level, humidity, and sterility. To start the project, multiple concepts were developed for the …

Multi-Robot Symbolic Task And Motion Planning Leveraging Human Trust Models: Theory And Applications, Huanfei Zheng

All Dissertations

Multi-robot systems (MRS) can accomplish more complex tasks with two or more robots and have produced a broad set of applications. The presence of a human operator in an MRS can guarantee the safety of the task performing, but the human operators can be subject to heavier stress and cognitive workload in collaboration with the MRS than the single robot. It is significant for the MRS to have the provable correct task and motion planning solution for a complex task. That can reduce the human workload during supervising the task and improve the reliability of human-MRS collaboration. This dissertation relies …

Event-Triggered Optimal Adaptive Control Of Partially Unknown Linear Continuous-Time Systems With State Delay, Rohollah Moghadam, Vignesh Narayanan, Sarangapani Jagannathan

Publications

This paper proposes an event-triggered optimal adaptive output feedback control design approach by utilizing integral reinforcement learning (IRL) for linear time-invariant systems with state delay and uncertain internal dynamics. In the proposed approach, the general optimal control problem is formulated into the game-theoretic framework by treating the event-triggering threshold and the optimal control policy as players. A cost function is defined and a value functional, which includes the delayed system output, is considered. First, by using the value functional and applying stationarity conditions using the Hamiltonian function, the output game delay algebraic Riccati equation (OGDARE) and optimal control policy are …

Inculcating Research Culture With An Outcome-Oriented Technical Project Evaluation Framework, Pritish Vibhute, Sumeet Gupta, Muzffarali Sayyad, Snehal Gondkar

Graduate Research in Engineering and Technology (GRET)

The Outcome of the Teaching-Learning Process of any specific subject or course is measured using a standard statistical method, the majority of which relies on the marks obtained by each learner, according to procedures and guidelines defined by numerous national-international consortiums, boards, or councils for Outcome-Based Education (OBE). Rarely has it been linked to documentary evidence demonstrating the attainment of competency expected to emerge following successful completion of the course. At the same time, a significant number of technical institutes across India are in desperate need of good research, which leads to massive publications, IPR, startups, and cash. For the …

Use Of Assignment Mode For Effective Assessment Of Students To Achieve Course Outcomes, Namrata Karandikar, Pradnya Nanavare

Graduate Research in Engineering and Technology (GRET)

To ensure the quality learning of students, course outcome assessment is vital element of outcome based education. To achieve course outcomes, various modes of pedagogy and assessment are essential. There are different modes of assessment for In-semester examination like multiple choice questions, time bound pen and paper, presentations, seminars, assignment etc. This paper explains the use of assignment mode for effective assessment of students. This paper highlights how assignment mode helps students to apply concepts taught in classroom to solve various problems on applications of engineering mathematics. We had done assessment of 610+ F. Y. B. Tech students by giving …

Three-Phase Ac Induction Motor Speed Control Based On Variable Speed Driver, Abdelrahim Ahmed Mohammed Ate, Rihab Gafar, Xiuyun Sun, Tahleel Abozead

Makara Journal of Technology

Massive loss of power is a concern for many countries because of the high power consumption of alternating current (AC) motors. The motor speed should be controlled to alleviate this problem and save more power. This paper proposes a simple simulation for a variable speed driver (VSD) to control the three-phase induction motor speed. The VSD consists of three parts. The converter performs from full bridge diodes to convert single-phase AC voltage into direct current voltage, and then this voltage is filtered by the RL filter and transferred to the last part, which is the inverter. The model was simulated …

Project Khepri: Mining Asteroid Bennu For Water, Erika Frost, Gowtham Boyala, Adam Gremm, Ahmet Gungor, Amirhossein Taghipour, Massimo Biella, Jiawei "Jackson" Qiu, Athip Thirupathi Raj, Arjun Chhabra, Adam Gee, Saanjali Maharaj, Erin Richardson, Julia Empey, Haidar Ali Abdul-Nabi, Lindsay Richards, Ariyaan Talukder, Aaron Groh, Brie Miklaucic, Jd Carlson, Kristina Kim, Maverick Cue

Undergraduate Student Research Internships Conference

Deep space asteroid mining presents the opportunity for the collection of critical resources required to establish a cis-lunar infrastructure. In specific, the Project Khepri team has focused on the collection of water from asteroid Bennu. This water has the potential to provide a source of clean-energy propellant as well as an essential consumable for humans or agriculture on crewed trips to the Moon or Mars. This would avoid the high costs of launching from Earth - making it a highly desirable element for the future of cis-lunar infrastructure. The OSIRIS-REx mission provided a complete survey of asteroid Bennu and is …

Efficient Control Approaches For Guaranteed Frequency Performance In Power Systems, Samaneh Morovati

Doctoral Dissertations

Due to high penetration of renewable energy, converter-interfaced sources are increasing in power systems and degrading the grid frequency response. Synthetic inertia emulation and guaranteed primary frequency response is a challenging task. Still, there is high potential for application of highly controllable converter-interfaced devices to help performance. Renewable energy sources and demand side smart devices also need to be equipped with innovative frequency control approaches that contribute to frequency regulation operations.

First, the wind turbine generator is chosen to represent an example of a converter- interfaced source. An augmented system frequency response model is derived, including the system frequency response …

Protection Of Microgrids: A Scalable And Topology Agnostic Scheme With Self-Healing Dynamic Reconfiguration, Phani Harsha Gadde

All Dissertations

Momentum towards realizing the smart grid will continue to result in high penetration of renewable fed Distributed Energy Resources (DERs) in the Electric Power System (EPS). These DERs will most likely be Inverter Based Resources(IBRs) and will be an integral part of the distribution system in the near future. The drive towards resiliency with these IBRs will enable a modular topology where several microgrids are tied together, operating synchronously to form the future EPS at the distribution level.

Since the microgrids can evolve from existing distribution feeders, they will be unbalanced in load, phases, and feeder impedances. A typical control …