Electromagnetics and Photonics Commons^™

Fast Response Dual Frequency Liquid Crystal Materials, Qiong Song

Electronic Theses and Dissertations

Dual frequency liquid crystal (DFLC) exhibits a positive dielectric anisotropy at low frequencies and negative dielectric anisotropy at high frequencies. The frequency where dielectric anisotropy is zero is called crossover frequency. DFLC can achieve fast rise time and fast decay time with the assistance of applied voltage. However, one drawback of DFLC is that it has dielectric heating effect when driven at a high frequency. Thus, the first part of this dissertation is to develop low crossover frequency DFLC materials. The dielectric relaxation and physical properties of some single- and double-ester compounds were investigated. Experimental results indicate that the double-ester …

Quantum Dot Based Mode-Locked Semiconductor Lasers And Applications, Jimyung Kim

Electronic Theses and Dissertations

In this dissertation, self-assembled InAs/InGaAs quantum dot Fabry-Perot lasers and mode-locked lasers are investigated. The mode-locked lasers investigated include monolithic and curved two-section devices, and colliding pulse mode-locked diode lasers. Ridge waveguide semiconductor lasers have been designed and fabricated by wet etching processes. Electroluminescence of the quantum dot lasers is studied. Cavity length dependent lasing via ground state and/or excited state transitions is observed from quantum dot lasers and the optical gain from both transitions is measured. Stable optical pulse trains via ground and excited state transitions are generated using a grating coupled external cavity with a curved two-section device. …

Response-Calibration Techniques For Antenna-Coupled Infrared Sensors, Peter Krenz

Electronic Theses and Dissertations

Infrared antennas are employed in sensing applications requiring specific spectral, polarization, and directional properties. Because of their inherently small dimensions, there is significant interaction, both thermal and electromagnetic, between the antenna, the antenna-coupled sensor, and the low-frequency readout structures necessary for signal extraction at the baseband modulation frequency. Validation of design models against measurements requires separation of these effects so that the response of the antenna-coupled sensor alone can be measured in a calibrated manner. Such validations will allow confident extension of design techniques to more complex infrared-antenna configurations. Two general techniques are explored to accomplish this goal. The extraneous …

Accelerating Optical Airy Beams, Georgios Siviloglou

Electronic Theses and Dissertations

Over the years, non-spreading or non-diffracting wave configurations have been systematically investigated in optics. Perhaps the best known example of a diffraction-free optical wave is the so-called Bessel beam, first suggested and observed by Durnin et al. This work sparked considerable theoretical and experimental activity and paved the way toward the discovery of other interesting non-diffracting solutions. In 1979 Berry and Balazs made an important observation within the context of quantum mechanics: they theoretically demonstrated that the Schrodinger equation describing a free particle can exhibit a non-spreading Airy wavepacket solution. This work remained largely unnoticed in the literature-partly because such …

Misalignment Induced Nodal Aberration Fields And Their Use In The Alignment Of Astronomical Telescopes, Tobias Schmid

Electronic Theses and Dissertations

Following the foundation of aberration theory for rotationally symmetric optical systems established by Seidel, Schwarzschild, Burch, Conrady, Buchdahl, and in its most useful form H.H. Hopkins, Shack, Buchroeder, Thompson, and Rogers developed a vectorial form of the wave aberration theory that enables addressing optical systems without symmetry. In this research, a vectorial theory is utilized and extended for the alignment of two- and three-mirror astronomical telescopes, including the effects of pointing changes and astigmatic figure errors. Importantly, it is demonstrated that the vectorial form of aberration theory, also referred to as nodal aberration theory, not only provides valuable insights but …

Electroless Deposition Of Superconducting Magnesium Diboride Thin Films On Various Substrates, Khrupa Saagar Vijayaragavan

Wayne State University Theses

ABSTRACT

ELECTROLESS DEPOSITION OF SUPERCONDUCTING MAGNESIUM DIBORIDE THIN FILMS ON VARIOUS SUBSTRATES

by

KHRUPA SAAGAR VIJAYARAGAVAN

MAY 2010

Advisor: Dr. Susil K Putatunda

Dr. Gavin Lawes

Major: Chemical Engineering

Degree: Masters of Science

Superconducting thin films of magnesium diboride were synthesized by a novel electroless plating process. Electroless plating shares many similarities to electroplating with the major difference being the absence of a continuous bias voltage. Significantly, this work represents the first investigation where electroless deposition has been used to prepare compounds, as opposed to the elemental metals considered in all previous studies. Magnesium Diboride is a recently discovered superconducting …

Ultrathin, Ultrasmooth And Low-Loss Silver Films Via Wetting And Annealing, Weiqiang Chen, Kuo-Ping Chen, Mark Daniel Thoreson, Alexander Kildishev, Vladimir M. Shalaev

Weiqiang Chen

We have demonstrated that a thermal annealing treatment can reduce the optical losses in ultrathin, ultrasmooth, silver films deposited on a Ge wetting layer to values as low as the bulk material value and at the same time maintain an ultrasmooth surface. The annealing effect is sensitive to the annealing temperature and time, both of which should be carefully controlled. This annealing treatment is also effective for Ag–SiO2 multilayer composite films.

Toward Superlensing With Metal-Dielectric Composites And Multilayers, Rasmus Bundgaard Nielsen, Mark Thoreson, Weiqiang Chen, Anders Kristensen, Jørn Hvam, Vladimir M. Shalaev, Alexandra Boltasseva

Weiqiang Chen

We report on the fabrication of two types of adjustable, near-field superlens designs: metal–dielectric composites and metal–dielectric multilayer films. We fabricated a variety of films with different materials, thicknesses and compositions. These samples were characterized physically and optically to determine their film composition, quality, and optical responses. Our results on metal–dielectric composites indicate that although the real part of the effective permittivity generally follows effective medium theory predictions, the imaginary part does not and substantially higher losses are observed. Going forward, it appears that multilayer metal–dielectric designs are more suitable for sub-diffraction imaging applications because they could provide both tunability …

Fabrication And Optical Characterizations Of Smooth Silver-Silica Nanocomposite Films, Weiqiang Chen, Mark Daniel Thoreson, Alexander V. Kildishev, Vladimir Shalaev

Weiqiang Chen

We have studied the surface-smoothing effect of an ultrathin germanium (Ge) layer on silver (Ag)-silica (SiO2) nanocomposite films for superlensing applications. Our experimental results indicate that inserting a thin Ge layer below the silver-silica composite films can reduce the final surface root-mean-squared (RMS) roughness to under 1 nm. Additionally, the metal nanostructure plays a role in both the smoothing effect and the optical properties of the nanocomposite films. Our experimental results show that the Bruggeman effective medium theory (EMT) is not sufficiently accurate to describe some properties of our nanocomposite films. In addition to the constituent materials and their filling …

Application Of Electromagnetic Waves As A Solution To Some Agricultural Problems, B. M. Ida Idayu, Maryam Ashayer Soltani, Amin Enayati, H. Aliakbarian, Hossein Ameri Mahabadi, M. Moghawemi

Hossein Ameri Mahabadi

A review of some applications of electromagnetic waves in agriculture is presented. There are many applications in the literature which are categorized in two sections of post-harvest indoor and pre-harvest outdoor applications. Taking a look at the applications suggested, there are still works to be done to industrialize the method. However, the proposed method is promising in special cases when the cost and hazards of other methods are high.

Growth Of Crystalline Cobalt Ferrite Thin Films At Lower Temperatures Using Pulsed-Laser Deposition Technique, A. Raghunathan, David C. Jiles, Ikenna C. Nlebedim

David C. Jiles

Cobaltferritethin films were grown on SiO2/Si(100) substrates using pulsed-laser deposition technique at substrate temperatures ranging from 250 to 600 °C. Thermal expansion mismatch between the film and substrate appears to have a substantial effect on the magnetic properties of the cobaltferritefilms, due to the large magnetoelastic coupling of cobaltferrite. It was shown in this study, that polycrystalline films with (111)-preferred orientation could be prepared at substrate temperatures as low as 250 °C. The growth of crystalline cobaltferritefilms at such low temperatures indicates the potential to use cobaltferrite for microelectromechanical systemsdevices and sensor applications including integration with a wider range of …

Resistivity Recovery In Gd5si2.09ge1.91 By Annealing, Ravi L. Hadimani, David C. Jiles

David C. Jiles

Irreversible change in resistivity occurs in Gd5(SixGe1−x)4 (with 0.41

On The Interaction Of An Eddy Current Coil With A Right-Angled Conductive Wedge, John R. Bowler, Theodoros Theodoulidis

John R. Bowler

A fundamental problem in eddy-current nondestructive evaluation is one of finding the quasi-static electromagnetic field of a cylindrical coil in the vicinity of the edge of a metal block. Although the field can be calculated numerically, an effective analytical approach can potentially provide a better understanding of the edge fields and form the basis of a procedure for solving a whole class of related edge problems including edge structures that contain corner cracks. One can represent the metal block as a conductive quarter space in an unbounded region. However, it has been found that the analysis is more straightforward if …

Harvesting Single Ferroelectric Domain Stressed Nanoparticles For Optical And Ferroic Applications, Gary Cook, J. L. Barnes, S. A. Basun, Dean R. Evans, Ron F. Ziolo, Arturo Ponce, Victor Yu. Reshetnyak, Anatoliy Glushchenko, Partha P. Banerjee

Electrical and Computer Engineering Faculty Publications

We describe techniques to selectively harvest single ferroelectric domain nanoparticles of BaTiO3 as small as 9 nm from a plethora of nanoparticles produced by mechanical grinding. High resolution transmission electron microscopy imaging shows the unidomain atomic structure of the nanoparticles and reveals compressive and tensile surface strains which are attributed to the preservation of ferroelectric behavior in these particles.

We demonstrate the positive benefits of using harvested nanoparticles in disparate liquid crystal systems.

Plasmon Enhanced Near-Field Interactions In Surface Coupled Nanoparticle Arrays For Integrated Nanophotonic Devices, Amitabh Ghoshal

Electronic Theses and Dissertations

The current thrust towards developing silicon compatible integrated nanophotonic devices is driven by need to overcome critical challenges in electronic circuit technology related to information bandwidth and thermal management. Surface plasmon nanophotonics represents a hybrid technology at the interface of optics and electronics that could address several of the existing challenges. Surface plasmons are electronic charge density waves that can occur at a metal-dielectric interface at optical and infrared frequencies. Numerous plasmon based integrated optical devices such as waveguides, splitters, resonators and multimode interference devices have been developed, however no standard integrated device for coupling light into nanoscale optical circuits …

Electro-Optical And All-Optical Switching In Multimode Interference Waveguides Incorporating Semiconductor Nanostructures, Nathan Bickel

Electronic Theses and Dissertations

The application of epitaxially grown, III-V semiconductor-based nanostructures to the development of electro-optical and all-optical switches is investigated through the fabrication and testing of integrated photonic devices designed using multimode interference (MMI) waveguides. The properties and limitations of the materials are explored with respect to the operation of those devices through electrical carrier injection and optical pumping. MMI waveguide geometry was employed as it offered advantages such as a very compact device footprint, low polarization sensitivity, large bandwidth and relaxed fabrication tolerances when compared with conventional single-mode waveguide formats. The first portion of this dissertation focuses on the characterization of …

12 Bit Charge Redistribution Digital To Analog Converter For The Residence Time Fluxgate Magnetometer, Miguel Angel Alamillo

Open Access Theses & Dissertations

The continuous advances in CMOS VLSI technology have culminated in high speed, low voltage CMOS digital circuits with gate delays below 50 ps at 1.5 V supply. At the same time, high voltage analog signal processing has fallen behind to the high flexibility and high reliability of DSP. However, the main drawback of DSP is the need for high accuracy low distortion data converters and as a consequence of the persistent efforts of reducing size, cost and power of solid-state components the field of CMOS Mixed-Signal circuit design has become of the utmost importance.

The obvious functionality of data converters …

Characterization Of Atmospheric Turbulence Effects Over 149 Km Propagation Path Using Multi-Wavelength Laser Beacons, Mikhail Vorontsov, Gary W. Carhart, Venkata S. Rao Gudimetla, Thomas Weyrauch, Eric Stevenson, Svetlana Lachinova, Leonid A. Beresnev, Jony Jiang Liu, Karl Rehder, Jim F. Riker

Electrical and Computer Engineering Faculty Publications

We describe preliminary results of a set of laser beam propagation experiments performed over a long (149 km) near-horizontal propagation path between Mauna Loa (Hawaii Island) and Haleakala (Island of Maui) mountains in February 2010. The distinctive feature of the experimental campaign referred to here as the Coherent Multi-Beam Atmospheric Transceiver (COMBAT) experiments is that the measurements of the atmospheric-turbulence induced laser beam intensity scintillations at the receiver telescope aperture were obtained simultaneously using three laser sources (laser beacons) with different wavelengths (λ1 = 0.53 μm, λ2 = 1.06 μm, and λ3 = 1.55 μm). The presented experimental results on …

Technological Challenges Of 1-Dimensional Magnetic Photonic Crystals, Mikhail Vasiliev, Kamal Alameh, Dmitry E. Balabanov, Vladimir I. Burkov, V. V. Koledov, Viacheslav A. Kotov, V. G. Shavrov, Anotoly K. Zvezdin

Research outputs pre 2011

Visible-region magnetic photonic crystals (MPC) designed for higher-order bandgap operation have been proposed to overcome the technological restrictions originating from the strong thickness dependency of the individual magnetic layer properties observed in MPC structures.

Optical Control Of Ultrafast Spin -Wave Relaxation By Magnetic Anisotropy In A Ferromagnet, Kevin James Smith

Dissertations, Theses, and Masters Projects

This thesis presents an investigation of the damping of spin waves in ferromagnetic Au(3 nm)/Ni(10 nm)/MgO(001) thin films using the time-resolved Magneto-optical Kerr Effect (TR-MOKE) and ferromagnetic resonance (FMR) techniques. In the optical measurements, a 150 fs, 800 nm laser beam pulse is split into pump and probe components. The pump pulse, containing most of the beam energy, thermally excites coherent spin precession. The weaker probe pulse, time-delayed by a variable beam path, captures the magnetization dynamics via the polar MOKE effect, and oscillations are observed as a function of external field amplitude and direction. The extracted precession frequency is …