Petroleum Engineering Commons^™

Development Of A Framework For Scaling Surfactant Enhanced Co₂ Flooding From Laboratory Scale To Field Implementation, Gbolahan I. Afonja

LSU Doctoral Dissertations

The efficiency of the use of CO2 as a displacement fluid in oil recovery is hampered by the existence of an unfavorable mobility ratio that is caused by the large difference in viscosity between the injected fluid (CO2) and the reservoir fluids. This viscosity contrast results in early CO2 breakthrough, viscous fingering, gas channeling, and consequently, the inability of CO2 to effectively contact much of the reservoir and the oil it contains. Improvement of sweep efficiency and mobility control in CO2 injection require solutions to these problems. The use of surfactants and other chemical means for mobility control has been …

Comparison Of Square Root Of Time Approach And Statistical Approach To Minimize Subjectivity In The Determination Of Minimum In-Situ Stress, Soumitra Bhaskar Nande

Masters Theses

"A formation's minimum in-situ stress is an important parameter to determine for hydraulic fracturing. While minimum in-situ stress, and its orientation, can be measured from triaxial tests on core, it is more common to measure it as closure stress, by performing pressure testing of wells in the field. Closure stress is considered equal to, or a good approximation of the minimum in-situ stress for most cases. The analytical methods applied to such pressure testing include the square root of time plot, G function plot and the G-dP/dG plot. These plots require the engineer to fit tangent lines to the data, …

Coupled Geomechanical Reservoir Simulation, Amin Amirlatifi

Doctoral Dissertations

"Founded by Department Of Energy, the Plains CO₂ Reduction (PCOR) Partnership is investigating the Williston Basin as a candidate for sequestering CO₂ emissions from power plants. The State of Missouri, a member of PCOR, lies at the outermost point on the proposed transportation route and consequently faces the highest CO₂ compression and transportation costs. In order to minimize the cost of CO₂ sequestration, it is desirable to find a storage site within the state. The Lamotte sandstone is identified as a suitable sequestration aquifer formation in Missouri with acceptable permeability, porosity, extension, rock strength and water salinity. Using the finite …

Comparison Of Class Ii Injection Well Area Of Review Requirements With Area Of Evaluation For Hydraulically Fractured Wells, Yashesh Jitendra Panchal

Masters Theses

"Since 2010 the US Environmental Protection Agency (EPA) has been proposing plans to study, and has now initiated research regarding the potential impact of hydraulic fracturing processes on drinking water sources. Their work refers to an 'Area of Evaluation' around a hydraulically fractured well, inferring that the wells immediately around hydraulic fractured wells should be studied, to evaluate the conditions of these wells and their potential to contaminate overlying USDWs. Class II injection wells must have a minimum 1/4 mile radius area of review to determine the condition of wells surrounding the proposed injection well. All wells within this AOR …

Establishing Well Operability Limits For Frac Pack Sandface Well Completions Using A Screen Erosion Model And Well Completion Score Card, Rickey Hendrix

Doctoral Dissertations

"Completion quality has a direct impact upon the maximum production rate at which a frac pack well should be operated. Best practices for frac pack well completions ensure the highest possible quality for the well completion. A novel frac pack well completion score card was developed based on best practices for frac pack well completions identified through consultation with industry experts. The score card systematically combines and assesses completions data readily available standard completion reports. The outcome of the score card process is a numerical completion quality rating, which combines all well design and frac pack operations information.

The completion …

Minimizing Formation Damage For Preformed Particle Gels Treatment In Mature Reservoirs, Mahmoud Omran Elsharafi

Doctoral Dissertations

"This research studied the effect of preformed particle gels (PPGs) on unswept, low-permeable zones/areas. The objective was to find methods that minimized the damage caused by PPGs on unswept, low-permeable zones/areas, thus improving PPG treatment efficiency. These results can help to identify of the best PPG types, particle sizes, and brine concentrations for specific reservoirs and treatments. This study used sandstone core samples with various degrees of permeability. Two types of particle gels, a strong Daqing gel (DQ) and a weak Liquiblock™ 40k gel (40K), were used, each with a different strength.

This research included two stages. Firstly, both a …

Gas And Water Flow Through Nanoscale Porous Media, Songyuan Liu

Masters Theses

"This work provides a lab experiment to describe the fluid diffusion in nanoscale porous media. By using ideal ceramic membranes which have uniform pore size in nanoscale and homogeneous pore distribution instead of shale or tight sandstone which have various pore sizes and complicated pore distribution and structure, a better understanding of fluid flow through nanoscale porous media could be gained.

Core flooding test were conducted by injecting nitrogen and water separately to describe gas and liquid flow in nanoscale porous media. With all the other factors known or controlled, pressure and flow rate were measured to calculate permeability. By …

Computational Fluid Dynamics Flow Comparison Between Openhole Sleeve And Plug-And-Perf Completion In A Hydraulic Fractured Horizontal Well, Viriyah Theppornprapakorn

Masters Theses

"Multi-stage hydraulic fracture completions in horizontal wells have facilitated economic development of natural gas from unconventional and tight gas reservoirs.Industry has relied on two horizontal multi-stage completion technologies: cemented and perforated liner or Plug-and-perf method and Openhole Sleeve Multi-stage method. Each method has its own advantages and disadvantages. However, one of the most important questions is which method yields better gas production? Computation fluid dynamics (CFD) is a powerful tool for solving complex fluid flow problems. In well completion design, CFD plays a significant role aiding the completion engineers on making decision on well completion methods. In this study, a …

Pvt Study Of Selected Uae Reservoir Fluids, Rashid Sher Mohammad

Theses

Phase behavior modeling in crude oil includes prediction of thermodynamic properties (such as saturation pressure, density, viscosity, thermal conductivity, etc.) for the vapor and liquid phases. The aim of phase behavior modeling is to establish the accuracy and reliability of the developed equation of state model to predict various other fluid phase behavior properties at high pressure and temperature conditions.

In the first part of this work, a new and reliable phase behavior apparatus designed in Brazil was used for the two-stage recombination process and phase behavior measurements. The recombination of the surface sample fluids (first-stage separator gas and stock-tank …

Optimization Of Co2 Wag Processes In A Selected Carbonate Reservoir: Laboratory Study, Mohamed Elwy Abdalla Amin

Theses

Miscible gas flooding using carbon dioxide is currently investigated as a possible EOR process for a number of United Arab Emirates (UAE) reservoirs. The major factors affecting the implementation of CO₂ floods are the availability of CO₂ at economic prices and the net utilization ratio of CO₂ per barrel of additional oil recovered.Minimizing net utilization requires controlling the high mobility ratio which causes lower sweep. To control the mobility ratio, the Water-Alternating CO₂-gas (WAG) technique is proposed.

The objective of this work is to experimentally assess the recovery of oil with CO₂ injection in …

Supercritical Co2 Extraction Of Oil From Henna Flower: Experimental, Mathematical Modeling, And Antioxidant Activity, Bushra Saeed Mohammed Dohai

Theses

Henna is a plant that has been used traditionally for coloring nail, skin, and hair, and as medicinal plant. The supercritical fluid technology offers a considerable promise as extraction media due to its advantages over other conventional extraction techniques. The extraction of volatile components from flowers of henna was studied using supercritical carbon dioxide at temperatures and pressures ranging from 35 to 55°C and 80 to 120 bar, respectively. A maximum extraction yield of 31 % from 2g of henna flowers was obtained at 45 °C and 120 bar. The composition of the extracts was investigated by gas chromatography technique. …

Carbon Nanotubes Grown On Glass Fiber As A Strain Sensor For Real Time Structural Health Monitoring, Matthew Boehle, Qiong Jiang, Lingchuan Li, Alexandre Lagounov, Khalid Lafdi

Chemical and Materials Engineering Faculty Publications

In order to more effectively monitor the health of composite structures, a fuzzy fiber sensor has been developed. The fuzzy fiber is a bundle of glass fibers with carbon nanotubes or nanofibers (CNTs or CNFs) grown on the surface. The nanotube coating makes the fiber bundle conductive while the small conductive path increases sensitivity. The fuzzy fiber sensor can replace conventional metal foil strain gauges in composite applications. The electrical response of the sensor is monitored in real time to measure strain, vibration, cracking and delamination. Continuous monitoring provides instant notification of any problems. Implementation of this sensor network in …

Investigation Of Wellbore Stability In A North Sea Field Development, Steven Austin Hilgedick

Doctoral Dissertations

"Planning drilling operations is key to the development of oil and natural gas fields. As part of well design, wellbore stability and pore pressure analysis are main factors in determining the safe operating window for selecting mud density. The motivation for this research was to conduct wellbore stability based on exploration wells as basis for planning new offshore field developments with deviated and horizontal wells. A second objective was to investigate the use of a probabilistic approach to wellbore stability, and compare it to the conventional deterministic methods, in order to evaluate the value of including a probabilistic approach to …

Experimental Investigations In Co2 Sequestration And Shale Caprock Integrity, Abiola Olukola Olabode

LSU Master's Theses

More than sixty percent (60%) of conventional hydrocarbon reservoirs which are potential CO2 repositories are sealed by tight shale caprock. The geochemical reactivity of shale caprock during CO2 diffusive transport needs to be included in the reservoir characterization of potential CO2 sequestration sites as slow reactive transport processes can either strengthen or degrade seal integrity over the long term. Several simulation results had predicted that influx-induced mineral dissolution/precipitation reactions within shale caprocks can continuously reduce micro-fracture networks, while pressure and effective-stress transformation first rapidly increase then progressively constrict them. This experimental work applied specific analytical techniques in investigating changes in …

Risk Of Well Integrity Failure Due Sustained Casing Pressure, Koray Kinik

LSU Master's Theses

Sustained casing pressure (SCP) is considered a well integrity problem. The approach of this study is to look at SCP as environmental risk due hydrocarbon release. Currently, the risk is qualified by the value of surface pressure (Pcsg) that may cause failure of casing head. However, the resulting rate of gas emission to the atmosphere is not considered. Also not considered is a possibility of breaching the casing shoe due transmission of Pcsg downhole. The objective of this study is to develop methods for maximum possible air emission rates (MER) and risk of subsurface well integrity failure due SCP. Mathematical …

Experimental Study Of The Effect Of Drilling Fluid Contamination On The Integrity Of Cement-Formation Interface, Nnamdi Charles Agbasimalo

LSU Master's Theses

Well cementing is one of the key processes performed during drilling and completion of wells. The main objective of primary cementing is to provide zonal isolation. Failure of cement to provide zonal isolation can lead to contamination of fresh water aquifers, sustained casing pressure, or blowout. For effective cementing, the cement slurry should completely displace the drilling fluid. In practice, this is hard to achieve and some mud is left in the wellbore where it contaminates the cement after cement placement.

This study investigates the effect of mud contamination of cement on the integrity of cement-formation interface. Flow-through experiments were …

Simulations Of The Primary Cement Placement In Annular Geometries During Well Completion Using Computational Fluid Dynamics (Cfd), Muhammad Zulqarnain

LSU Master's Theses

Effective zonal isolation during primary cementing is only possible when drilling mud in the annulus is completely displaced with cement, while the spacers aid in this process. During the displacement process the rheological properties of fluids used and the operating conditions control the motion of different fluids interfaces; desired stable interfacial displacement leads to piston like motion. Computational Fluid Dynamics (CFD) tool with the Volume-of-Fluid (VOF) has been validated against experimental and used to conduct numerical experiments in a virtual well model consisting of 50 ft vertical section of 8.765" x 12.5" annulus having initially mud and this mud is …

Measurement Of Interfacial Tension In Hydrocarbon/Water/Dispersant Systems At Deepwater Conditions, Mohamed Abdelrahim

LSU Master's Theses

The events of the Deepwater Horizon oil spill in the Gulf of Mexico were associated with great water depths that made it difficult to understand the behavior of the spilled oil as it came in contact with the seawater. The remedial subsea application of chemical dispersants draws interest to evaluate the interfacial interactions between the oil and water at such great water depths. Most importantly, a quantification of the interfacial tension (IFT) between the spilled oil and seawater at deepwater conditions can provide insight into the effectiveness of the chemical dispersion of spilled oil. In this study, Macondo crude oil …

A Review Of Offshore Blowouts And Spills To Determine Desirable Capabilities Of A Subsea Capping Stack, Louise Matilde Smith

LSU Master's Theses

The events surrounding the Deepwater Horizon disaster have changed the face of deepwater operations. In order to continue drilling in the Gulf of Mexico, the regulatory body, the Bureau of Safety and Environmental Enforcement (BSEE), has required that applications to conduct work in the Gulf of Mexico (GOM) include a plan to stop, capture, or contain any uncontrolled release of fluids. The capping and containment systems built and implemented by BP during the event are an excellent starting point for minimizing pollution from deepwater subsea blowouts, but the system has limitations. The industry recognizes these limits but is currently focused …

An Experimental And Theoretical Critique Of Flow Model Accuracy, Shannon Ray Chollett

LSU Master's Theses

In today’s exploration and production environment it is required that engineers must collect and use vast amounts of data for flow model construction and calibra- tion, as well as reservoir estimation and optimization. With modern technology, the data volume can be overwhelming. It is necessary that data monitoring and calibration are highly efficient. It is also essential that physical and mathematical models can be tested in repeatable, inexpensive experiments. The experiments described in this thesis will develop and perform verification of algorithms and can generate prior geomodels, collect and process seismic refraction data, collect and process production data, and calibrate …