Petroleum Engineering Commons^™

Semantic Model And Updated Screening Criteria For Polymer Flooding, Laila Dao Saleh

Doctoral Dissertations

"Enhanced oil recovery (EOR) processes produce oil that conventional methods leave behind, where interfacial forces, heavy oil viscosity, and reservoir heterogeneity make it difficult to produce. Many EOR methods are available but usually cannot be used at the same time for a candidate reservoir. Therefore, it is important to select the most appropriate EOR process from among the possible techniques. EOR screening criteria have been created using EOR datasets and serve as the first step to compare the suitability of each technique for a specific reservoir. Most of these datasets are based on field data collected from EOR surveys published …

Impact Of Slickwater Fracturing Fluid Compositions On The Petrophysical Properties Of Shale And Tightsand, Yongpeng Sun

Doctoral Dissertations

"A tight reservoir always requires hydraulic fracturing before production to increase production rate. The additives in hydraulic fluids are highly considerable for a successful stimulation. A friction reducer is often used to reduce the flowing friction in the wellbore during hydraulic fracturing. Extensive researches have been conducted to examine the extent it can reduce the fluid friction in tubings; however, no research has been reported on its behavior in a reservoir, which is related to the fracture extension. A breaker is also pumped into the formation to degrade the friction reducer. However, it is not clear that what is the …

Degradable Nanocomposite Preformed Particle Gel For Chemical Enhanced Oil Recovery Applications, Paul Tongwa

Doctoral Dissertations

”This work presents two new materials that can be potentially used in conformance control to increase ultimate oil recovery from mature oilfields.

The first product is a degradable nanocomposite preformed particle gel for enhanced in-depth mobility control. Three different types of degradable nanocomposite preformed particle gels were synthesized. These three nanocomposite hydrogels were made using Laponite XLG, Calcium Montmorillonite, and Sodium Montmorillonite nanomaterials. It was observed that after degradation, Laponite XLG nanocomposite hydrogels had the highest post-degradation viscosity (4437 cp), followed by sodium nanocomposite hydrogels (129 cp), and lastly calcium nanocomposite hydrogels (75.5 cp). Thus, degradable Laponite XLG nanocomposite hydrogels …

Preformed Particle Gel Transport Through Fractures, Hao Zhang

Doctoral Dissertations

"Polymer gel treatment is one of the most cost-effective methods to control water production in mature oil fields. The main objective of gel treatments is to reduce water or gas flow through high-permeability channels or fractures without damaging productive zones. Preformed particle gels (PPGs) have been applied for conformance control because they can overcome some potential drawbacks inherent in an in-situ gelation system.

In this study, lab experiments were performed to quantify PPG propagation through fractures and fracture-like channels by using screen models and open fracture models. The main findings in these experiments can guide the selection of best particle …

Studies Of Influencing Factors For Shale Gas Reservoir Performance, Jiaqi Wang

Masters Theses

"Shale gas resource plays a significant role in energy supply worldwide. For economic production of shale gas, technologies of horizontal well and hydraulic fracturing are used for shale gas reservoirs. Therefore, the productivity of the shale gas reservoirs will be influenced by both reservoir condition, and hydraulic fracture properties.

In this thesis, parameters that will influence shale gas production were classified into two categories: reservoir properties and hydraulic fracture properties. Published shale gas simulation studies were surveyed for determining the typical ranges of those properties. CMG-GEM was employed to finish the reservoir simulation work, and CMG-CMOST was used to complete …

Investigation Of Cased Wellbore Integrity In The Wabamun Area Sequestration Project, Benjamin Lee Weideman

Masters Theses

"Loss of cased wellbore integrity can cause many significant problems, including lost production, aquifer contamination, blowouts, and other environmental damage. The objective of this study is to conduct an analysis of the Wabamun Area Sequestration Project (WASP) to determine if wells in that area are suitable for CO₂ sequestration. This was done by conducting laboratory experiments on the common cement compositions found in the area, simulating the various conditions possible in a wellbore, and by analyzing three case studies from the WASP. The cases include two existing production wells and a proposed injection well specifically designed for CO₂ sequestration. This …

Computational Fluid Dynamics (Cfd) Modeling Of Proppant Transport In A Plug-And-Perf Completion With Different Perforation Phasing, Jinlin Zhang

Masters Theses

"Perf-and-plug is a completion technique commonly used in multistage fracturing. Fracture performance modeling assumes that fluid and proppant distributes uniformly among all perforations along the length of the wellbore in a plug and perf completion Crespo et al. (2012) has conducted a limited proppant flow experiment using a 63 foot stage, and three 0.42 inch, zero phased simulated perforations. His work demonstrates proppant does not distribute evenly, but the work is limited to a single perforation scheme.

In this study, Computational Fluid Dynamics (CFD) software has been used to simulate proppant transport and distribution in a single stage of a …

Data Mining And Statistical Analysis Of Completions In The Canadian Montney Formation, Mustafa Adil Al-Alwani

Masters Theses

"This thesis documents a data-mining study and statistical analysis of well completion methods and their impact on production for more than 3300 horizontal wells in the Canadian Montney resource play.

The statistical software JMP is used to analyze well and production data for both horizontal Montney gas and oil wells, examining production trends with changes in completion parameters, such as the type of completion, fluid volume pumped, proppant load, number of fracture stages and completion costs. The analysis also provides a general understanding of average treatment characteristics, and how completions have changed with time for the Montney play.

Among the …

Data Analysis And Summary For Surfactant-Polymer Flooding Based On Oil Field Projects And Laboratory Data, Pratap D. Chauhan

Masters Theses

"Enhanced oil recovery screening is considered as an important first step towards evaluating a potential EOR technique for a candidate reservoir. A vast amount of research is continuously been conducted in EOR. Therefore, it is imperative to update the screening criteria regularly.

This study involves updating the screening criteria for surfactant polymer flooding for field projects dataset and laboratory dataset. Many of the screening criteria for surfactant-polymer flooding in the literature were achieved on the basis of data collected from the EOR surveys published biennially in Oil & Gas Journals. However, these datasets contain problems like missing data and inconsistent …

Influence Of Erosional Unloading On The State Of Stress For Low Amplitude Single-Layer Buckle Folds - Implications For Tensile Fracture Occurrence, Mengke Li

Masters Theses

"The existence of fractures associated to buckle folds is related to the strain distribution of the fold. The erosional unloading process can amplify the remnant strain in the folded layer. Two-dimensional plane strain Finite Element Analysis (FEA) is used to investigate the influence of the erosional unloading step on both the evolution of the state of stress and the associated failure patterns in low amplitude buckle folds. Sensitivity analyses on different input parameters, including viscosity, shortening ratio, and overburden pressure, are performed. Based on the simulation results, tensile stress can be initiated both in the crest and in the limb …

Evaluation Of Prosper For Modeling Long Lateral Gas Well Productivity In Toe Up, Toe Down, Horizontal Well Geometry, Abdussalam Mahmoud Mohamed

Masters Theses

"Most horizontal wells are not truly horizontal and may be drilled 'toe-up' or 'toe-down' to follow geological formations or in an attempt to keep the well from loading up. Challenges in directional drilling may also lead to horizontal gas wells with undulating wellbore profiles. This wellbore profile creates natural traps for heavy fluids in the lows and light fluid in the highs, which may result in chocked production. Hence, there is an interest in determining the best wellbore trajectory - toe-up, horizontal, or toe-down - for well unloading.

This study evaluates the capability of the well productivity software PROSPER to …

Numerical Simulations For Wellbore Stability And Integrity For Drilling And Completions, Nevan Christopher Himmelberg

Masters Theses

"Conventional wellbore trajectory planning is commonly based on an Andersonian state of stress [SoS] and the optimum well azimuth and inclination for a specific depth can be determined using stereographic projections of the safe mud weight window. In this thesis a new methodology using the complete stress tensor is developed to determine optimal well trajectories for complex in-situ stress scenarios. This study uses a 3D finite element analysis to simulate the SoS based on an integrated 3D MEM. The model yields the complete stress tensor at every location for a planned future well path. Using standard equations to determine the …

Updated Screening Criteria For Steam Flooding Based On Oil Field Projects Data, Mariwan Qadir Hama

Masters Theses

"Enhanced oil recovery (EOR) screening is considered the first step in evaluating potential EOR techniques for candidate reservoirs. Therefore, as new technologies are developed, it is important to update the screening criteria. Many of the screening criteria for steam flooding that have been described in the literature were based on data collected from EOR surveys biennially published in the Oil & Gas Journal. However, these datasets contain some problems, including outliers, missing data, inconsistent data and duplicate data, that could affect the accuracy of the results. Despite the importance of ensuring the quality of a dataset before running analyses, data …

An Analytical Pressure Model To Guide Downhole Sensor Placement For Carbon Dioxide Sequestration Monitoring, Yilin Mao

Masters Theses

"Injecting CO₂ into saline aquifers is currently the most viable approach to mitigate global greenhouse gas effect. Various monitoring techniques are required to achieve 99% accuracy in determining the location of the injected CO₂ plume. Sensor locations are critical to the monitoring quality necessary to meet this requirement but have scarcely been discussed. The pressure profile needs to be modeled accurately at the initial stage of CO₂ injection to guide sensor locations. The objective of this thesis was to develop an analytical solution for CO₂ sequestration based on time and distance. This will guide the locations of downhole pressure sensors …

The Effect Of Using Different Rock Failure Criteria In Wellbore Stability Analysis, Reza Rahimi

Masters Theses

"Determination of the appropriate drilling fluid density by rock failure analysis is an essential step to control wellbore instability. To determine wellbore failure stresses, the rock strength has to be known, an appropriate constitutive model has to be selected, and finally an accurate rock failure criterion must be chosen. Linear-poro elastic modeling of the mechanical wellbore failure is the most common approach to investigate wellbore instability. Numerous failure criteria have been used for the rock failure analysis but there is not any commonly accepted agreement of which failure criteria to use. Rock failure criteria differ in two main characteristics. First, …

Gas Composition Analysis Using Limited Production Data Eagle Ford Case Study, Ryckur K. Shuttler

Honors Capstones

No abstract provided.

The Biological Impact Of Concurrent Exposure To Metallic Nanoparticles And A Static Magnetic Field, Kristen K. Comfort, Elizabeth I. Maurer, Saber M. Hussain

Chemical and Materials Engineering Faculty Publications

The rapid advancement of technology has led to an exponential increase of both nanomaterial and magnetic field utilization in applications spanning a variety of sectors. While extensive work has focused on the impact of these two variables on biological systems independently, the existence of any synergistic effects following concurrent exposure has yet to be investigated. This study sought to ascertain the induced alterations to the stress and proliferation responses of the human adult low calcium, high temperature keratinocyte (HaCaT) cell line by the application of a static magnetic field (approximately 0.5 or 30 mT) in conjunction with either gold or …

Effects Of Enhanced Oil Recovery On Production Engineers, Elm Coulee Field, Bakken Reservoir, Richland County, Montana, Burt J. Todd, Ph.D., John Evans, Leo Heath, David Reichhardt

Petroleum Engineering

This presentation describes research at Montana Tech to improve oil recovery rates in the Elm Coulee Oil Field in the Bakken Reservoir, Richmond County, Montana. The slides display current recovery rate predictions, enhanced oil recovery methods, reservoir model building and history matching strategies. Recommended development strategies include implementing hydrocarbon gas injection operations to improve current oil recovery rates by more than 75%. The impact of increased production on Production Engineers is also described. The Principal Investigators include John Evans, Leo Heath, David Reichhardt and Burt Todd in the Petroleum Engineering Department.

Slab Flattening Trigger For Isotopic Disturbance And Magmatic Flareup In The Southernmost Sierra Nevada Batholith, California, Alan D. Chapman, Jason B. Saleeby, John Eiler

Geosciences and Geological and Petroleum Engineering Faculty Research & Creative Works

The San Emigdio Schist of Southern California permits examination of partial melting and devolatilization processes along a Late Cretaceous shallow subduction zone. Detrital and recrystallized zircon of the structurally highest portions of the schist bracket the depositional age to between ca. 102 and 98 Ma. Zircon oxygen isotope data from both lower-plate schist and upper-plate assemblages of the Sierra Nevada batholith (SNB) reveal a δ18O shift of ̃1.5% between igneous (̃5.5%) and recrystallized (̃7%) domains. These results, taken with previous zircon and whole-rock δ18O measurements, provide evidence for devolatilization and/or partial melting of the schist and fluid ascent through overlying …

Decoupling The Stationary Navier-Stokes-Darcy System With The Beavers-Joseph-Saffman Interface Condition, Yong Cao, Yuchuan Chu, Xiaoming He, Mingzhen Wei

Mathematics and Statistics Faculty Research & Creative Works

This paper proposes a domain decomposition method for the coupled stationary Navier-Stokes and Darcy equations with the Beavers-Joseph-Saffman interface condition in order to improve the efficiency of the finite element method. The physical interface conditions are directly utilized to construct the boundary conditions on the interface and then decouple the Navier-Stokes and Darcy equations. Newton iteration will be used to deal with the nonlinear systems. Numerical results are presented to illustrate the features of the proposed method.