Biomedical Engineering and Bioengineering Commons^™

A Haptic Control System For Functional Electrical Stimulation Of Paraplegic Legs, Mark R. Shaker

Theses

Functional electrical stimulation (FES) is a means by which paraplegic men and women can use their natural legs for walking. In FES the impaired muscles are stimulated with electricity in a proper cycle to cause the legs to move in a walking pattern. It can be greatly beneficial for paraplegics however, current systems are not widely used because they are difficult to control in a useful manner.

The system proposed here uses a haptic interface, one that utilizes the sense of touch, attached to a user’s index and middle fingers. The haptic device allows the wearer to feel with the …

Motor Data Scaling By Respiration Frequencies In Rest, Amit Madhukar Kamble

Theses

Functional Magnetic Resonance Imaging (fMRI) is widely used as a tool to see activations in the different brain regions. Motor data acquired from fMRI scan is accompanied with signal due to hemodynamic changes taking place during the scan. This hemodynamic signal is dominated by parameter alteration in the large vessels of brain. Scaling of task induced BOLD signal with hypercapnic or breathold data is one of the effective methods to minimize the signal due to large vessels. Patient discomfort and compliance has been a major issue with these methods hence in this study we used respiration frequencies in rest data …

Validation Of A Micro-Ct Approach For Characterization Of Murine And Human Bone In Osteogenesis Imperfecta, John Jameson, Brooke Slavens, Robert Molthen, Peter Smith, Gerald F. Harris

Biomedical Engineering Faculty Research and Publications

No abstract provided.

In Vitro Evaluation Of Mechanical Heart Valve Performance Using A Novel Test Chamber In An Automated Mock Circulatory Loop, Antonio Walker

Theses and Dissertations

Valvular heart disease (VHD) continues to have significant effects on many people’s lives, with numbers expected to grow tremendously over the next few years. Individuals suffering from severe valvular heart disease usually require a heart valve transplant in order to restore the native valve’s vital unidirectional flow regulation. Therefore, artificial heart valve (AHV) research is of very high importance. Previous research studies have provided substantial input in the realm of AHV design relative to durability, thrombotic and hemolytic potential, and overall functionality. However, modifications continue to be warranted due to limitations in the accuracy and time efficiency of the in …

A Monocular Marker-Free Gait Measurement System, Jane Courtney, Annraoi M. De Paor

Articles

This paper presents a new, user-friendly, portable motion capture and gait analysis system for capturing and analyzing human gait, designed as a telemedicine tool to monitor remotely the progress of patients through treatment. The system requires minimal user input and simple single-camera filming (which can be acquired from a basic webcam) making it very accessible to nontechnical, nonclinical personnel. This system can allow gait studies to acquire a much larger data set and allow trained gait analysts to focus their skills on the interpretation phase of gait analysis. The design uses a novel motion capture method derived from spatiotemporal segmentation …

Rapid Cell Extraction In Aqueous Two-Phase Microdroplet Systems, Kalpana Vijayakumar, Shelly Gulati, Andrew J. De Mello, Joshua B. Edel

All Faculty Articles - School of Engineering and Computer Science

Distinguishing specific cells is an essential technique in cell research and clinical diagnostics. We report a novel method to passively isolate and extract cells in a microfluidic device. We utilise a droplet-based microfluidic system to generate an aqueous two phase system in which aqueous droplets consist of two phases in the form of a double emulsion. Specifically, we generate PEG droplets that completely encapsulate DEX droplets within a microfluidic channel. Target cells can be introduced directly into the droplets and driven to partition to the more favourable phase, whilst still being contained within the aqueous droplet. Human T lymphoma cells, …

Arterial Waveform Measurement Using A Piezoelectric Sensor, Ruizhi Zhang

Theses and Dissertations

This study aims to develop a new method to monitor peripheral arterial pulse using a PVDF piezoelectric sensor. After comparing different locations of sensor placement, a specific sensor wrap for the finger was developed. Its composition, size, and location make it inexpensive and very convenient to use. In order to monitor the effectiveness of the sensor at producing a reliable pulse waveform, a monitoring system, including the PZT sensor, ECG, pulse-oximeter, respiratory sensor, and accelerometer was setup. Signal analysis from the system helped discover that the PZT waveform is relative to the 1st derivative of the artery pressure wave. Also, …

Development Of Pyrf-Based Genetic System For Targeted Gene Deletion In Clostridium Thermocellum And Creation Of A Pta Mutant, Shital A. Tripathi, Daniel G. Olson, D. Aaron Argyros, Bethany B. Miller, Trisha F. Barrett, Daniel M. Murphy, Jesse D. Mccool, Anne K. Warner, Vineet B. Rajgarhia, Lee R. Lynd, David A. Hogsett, Nicky C. Caiazza

Dartmouth Scholarship

We report development of a genetic system for making targeted gene knockouts in Clostridium thermocellum, a thermophilic anaerobic bacterium that rapidly solubilizes cellulose. A toxic uracil analog, 5-fluoroorotic acid (5-FOA), was used to select for deletion of the pyrF gene. The ΔpyrF strain is a uracil auxotroph that could be restored to a prototroph via ectopic expression of pyrF from a plasmid, providing a positive genetic selection. Furthermore, 5-FOA was used to select against plasmid-expressed pyrF, creating a negative selection for plasmid loss. This technology was used to delete a gene involved in organic acid production, namely pta, which encodes …

The Other Gulf Oil Crisis - In Southwest Asia, Adam Liska

Department of Agricultural and Biological Systems Engineering: Faculty Publications

The oil spill in the Gulf of Mexico is a rude reminder of the risks inherent in an economy dependent upon petroleum. But there's a quieter crisis in the other gulf - the Persian Gulf - that should call Americans' attention to the even more severe consequences of relying upon imported oil. The costs of using the military to protect the transport of oil from the most turbulent part of the world should convince our country's policymakers to increase investments in researching and developing affordable, American-made clean-burning alternative fuels. But, first, we have to understand the real causes, costs and …

Real Time 3-D Tracking Of The High Dose Rate Radiation Source Using A Flat Panel Detector, Aditya Bondal

Theses and Dissertations

A number of QA procedures have been developed for Breast Brachytherapy treatments, yet none guarantee accurate dose delivery or allow conformation of the actual source position leading to errors sometimes going unnoticed. The objective of this study is to track the exact path the HDR source would follow in real time. The exit radiation of the HDR source was used to image a well defined matrix of markers. The images were acquired using FPD and were processed to obtain projection coordinates while an x-ray calibration image was processed to obtain marker coordinates. Each marker along with its projection represents a …

3d Micro-Mr And Micro-Ct Models For Determining In-Vivo Function In The Guinea Pig Knee Model Of Osteoarthritis (Oa), Kristoffer W. Dean

Undergraduate Research Opportunities Program (UROP)

Osteoarthritis (OA) is a debilitating disease that affects an estimated 27 million adults in the United States. OA causes damage to cartilage in the joints resulting in bones that rub together. This creates pain, swelling, loss of motion of the joint, and bone spurs. As the number of adults above 65 grows (an estimated 72 million people by 2030) even more people will be at high risk for OA. It is the most common type of arthritis by far yet very little is known about it including relationships between joint structure and function. In 2004, the NIH created the Osteoarthritis …

Metallic Nanoparticle On Micro Ring Resonator For Bio Optical Detection And Sensing, Ali Haddadpour, Yasha Yi

Publications and Research

We have numerically investigated the unique effects of metallic nanoparticle on the ring resonator, especially multiple Au nanoparticles on the micro ring resonator with the 4-port configuration on chip. For the Au nanoparticle, because it has smaller real refractive index than air and large absorption refractive index, we found that there is a blue shift for the ring resonance wavelength, instead of red shift normally observed for dielectric nanoparticles. The drop port intensity is strongly dependent on both number and size of nanoparticles, while relatively independent on position of nanoparticles. The correlation between the penetration depth of Au and the …

Structural Bioinformatics Based Method For Predicting The Initial Adsorbed Protein Orientation On A Surface, Aby Thyparambil

All Theses

In any molecular simulation of protein-surface interaction, the selection of the initial orientation with which the protein would interact with the surface must be first made and is found to be critical in the determination of the bioactive state of the adsorbed protein. While various molecular simulation methods have been developed to identify the preferred orientation, these methods are generally computationally expensive and time consuming, especially for large molecules thereby motivating the current study.
The computational implementation for identifying a preferred orientation was done in MATLAB¨ and directly addresses the current research problem by assuming the protein to be rigid …

A Spectroscopic Investigation Into The Setting And Mechanical Properties Of Titanium Containing Glass Polyalkenoate Cements, A. W. Wren, A. Kidari, N. M. Cummins, Mark R. Towler

Chemical and Biochemical Engineering Faculty Research & Creative Works

Titanium (Ti) implants are extensively used in a number of biomedical and dental applications. This work introduces Ti into the glass phase of a zinc-based glass polyalkenoate cement (GPC) and investigates changes in handling and mechanical properties considering two molecular weight polyacrylic acids (PAA), E9 and E11. Considering the handling properties, the working time (T_w) increased from 50 s_E9, 32 s_E11 (BT 101, Ti-free) to 169 s_E9, 74 s_E11 with TW-Z (highest Ti content), respectively. The setting time (T_s) increased from 76 s_E9, 47 s_E11 (BT 101) …

St. Jude Medical: An Object-Oriented Software Architecture For Embedded And Real-Time Medical Devices, Atila Amiri

Master's Theses

Medical devices used for surgical or therapeutic purposes require a high degree of safety and effectiveness. Software is critical component of many such medical devices. The software architecture of a system defines organizational structure and the runtime characteristic of the application used to control the operation of the system and provides a set of frameworks that are used to develop that. As such, the design of software architecture is a critical element in achieving the intended functionality, performance, and safety requirements of a medical device. This architecture uses object-oriented design techniques, which model the underlying system as a set of …

Material Modeling And Analysis For The Development Of A Realistic Blast Headform, S. G. M. Hossain

Department of Mechanical and Materials Engineering: Dissertations, Theses, and Student Research

Blast traumatic brain injury (BTBI) has become an important topic of study because of the increase of such incidents, especially due to the recent growth of improvised explosive devices (IEDs). This thesis discusses a project in which laboratory testing of BTBI was made possible by performing blast loading on experimental models simulating the human head. Three versions of experimental models were prepared – one having a simple geometry and the other two having geometry similar to a human head. For developing the head models, three important parts of the head were considered for material modeling and analysis – the skin, …

Development Of Tissue Engineered Test Systems To Study Mammary Cell Interactions In Vitro, Cheryl Cass

All Dissertations

The work described in this dissertation was conducted in the interdisciplinary research environment of the Clemson University Institute for Biological Interfaces of Engineering. A note at the beginning of each chapter acknowledges, as relevant, collaborating doctoral students and reminds the reader where work from each chapter has been presented or published. The overall goal of this work was to develop tissue engineered test system methodologies to allow the study of mammary cell interactions in vitro. The background, as described in Chapter 1, was published in part in Philosophical Transactions of the Royal Society A in 2010. The studies were designed …

Integration Of Microfluidics With Surface Plasmon Resonance, Scott B. Fratzke

Master's Theses

This thesis successfully integrates laminate microfluidic devices with an analytic Surface Plasmon Resonance (SPR) instrument. Integration was accomplished at low-cost using materials such as polydimethylsiloxane (PDMS), Poly(methyl methacrylate) (PMMA), Tygon tubing, and a 3-way stopcock. The main components of this thesis are the design and fabrication of the low-cost, in-house fluidics that can integrate with upstream microfluidics and the validation of the in-house fluidics using the Biosensing Instruments BI-2000 SPR instrument. The low-cost fluidics was designed and fabricated “in-house” using a novel investment casting technique that required the use of laser cutting technology to make a master cast, and candle …

Pre-Swing Deficits In Forward Propulsion, Swing Initiation And Power Generation By Individual Muscles In Hemiparetic Walking, Carrie L. Peterson, Allison Kinney, Steven A. Kautz, Richard R. Neptune

Mechanical and Aerospace Engineering Faculty Publications

Clinical studies of hemiparetic walking have shown pre-swing abnormalities in the paretic leg suggesting that paretic muscle contributions to important biomechanical walking subtasks are different than those of non-disabled individuals. Three-dimensional forward dynamics simulations of two representative hemiparetic subjects with different levels of walking function classified by self-selected walking speed (i.e., limited community=0.4–0.8 m/s and community walkers=>0.8 m/s) and a speed-matched control were generated to quantify individual muscle contributions to forward propulsion, swing initiation and power generation during the pre-swing phase (i.e., double support phase proceeding toe-off). Simulation analyses identified decreased paretic soleus and gastrocnemius contributions to forward propulsion …

Relationships Between Muscle Contributions To Walking Subtasks And Functional Walking Status In Persons With Post-Stroke Hemiparesis, Allison Kinney, Carrie L. Peterson, Steven A. Kautz, Richard R. Neptune

Mechanical and Aerospace Engineering Faculty Publications

Walking speed is commonly used to predict stroke severity and assess functional walking status (i.e., household, limited community and community walking status) post-stroke. The underlying mechanisms that limit walking speed (and functional walking status by extension) need to be understood to improve post-stroke rehabilitation. Previous experimental studies have shown correlations between paretic plantarflexor output during the pre-swing phase and walking speed and suggest that the paretic hip flexors can compensate in some hemiparetic subjects. Modeling and simulation studies of healthy walking have shown that the ankle plantarflexors, soleus (SOL) and gastrocnemius (GAS), and uniarticular hip flexors (IL) are essential contributors …