Biomedical Engineering and Bioengineering Commons^™

Biomechanical Comparison Of Lower Limb Unloading Between Common Modalities Of Ankle Foot Orthoses, Andrea Blake Wanamaker

Electronic Theses and Dissertations

Tibial stress fractures and other lower extremity injuries can be treated using an ankle foot orthosis (AFO). AFOs are popular because they allow the patient to ambulate somewhat naturally while reducing weight bearing on the injured limb. Despite their popularity, it is currently unclear how well AFOs reduce lower extremity weight bearing.

The first objective of this investigation was to examine the ability of three commonly used ankle foot orthoses to reduce weight bearing within the lower limb by comparing the ground reaction force measured from a force platform to the force measured from an insole pressure measurement device inside …

Computational Representation Of The Patellofemoral Joint, Abraham Wright

Electronic Theses and Dissertations

Many people suffer from knee pain due to abnormal function of the patellofemoral joint and are not able to enjoy normal activities of daily living. Surgical treatments are available and new methods are being developed by the medical industry. However, computational tools to efficiently evaluate the effects of the intervention on patellofemoral function are lacking.

Therefore, a validated and efficient computational model of the patellofemoral joint was developed. The subject specific finite element model was validated against the patellar kinematics recorded during cadaveric patellofemoral laxity experiments of the natural knee. The development involved a sequential process in which the soft-tissue …

Effect Of Rolling On Viscoelastic Fluids Using A Novel Testing Device, Aswini Mangadu

Dissertations and Theses

The purpose of this research thesis project was to develop a mechanical testing device that could enable us to load articular cartilage with a rolling/sliding motion. This novel device was then used to observe the effect of a rolling motion on the fluid film thickness of different lubricants (motor oil, synovial fluid and Hyaluronic Acid (HA)) to varying loads (1kg, 2,kg, 3kg and 4kg) and speeds (10, 25, 48 and 91 mm/s) applied on the sample fluids for 10 cycles. We were able to examine the effect of different speeds within each load for each of the fluid that was …

A Novel Visual Stimulation Paradigm: Exploiting Individual Primary Visual Cortex Geometry To Boost Steady State Visual Evoked Potentials (Ssvep), Marta Isabel Vanegas Arroyave

Dissertations and Theses

The steady-state visual evoked potential (SSVEP) is an electroencephalographic response to flickering stimuli generated in significant part by activity in primary visual cortex (V1). SSVEP signal-to-noise ratio is generally low for stimuli that are located in the visual periphery, at frequencies higher than 20 Hz, or at low contrast. Because of the typical "cruciform" geometry of V1, large stimuli tend to excite neighboring cortical regions of opposite orientation, likely resulting in electric field cancellation. In Study 1, we explored ways to exploit V1 geometry in order to boost scalp SSVEP amplitude via oscillatory summation, by manipulating flicker-phase offsets among angular …

Finite Element Study Of Transcranial Direct Current Stimulation: Customization Of Models And Montages, Dennis Q. Truong

Dissertations and Theses

Transcranial Direct Current Stimulation (tDCS) is a non-invasive neuromodulation technique that applies low amplitude current via electrodes placed on the scalp. Rather than directly eliciting a neuronal response, tDCS is believed to modulate excitability – encouraging or suppressing activity in regions of the brain depending on the polarity of stimulation. The particular application of tDCS is often determined by the electrode configuration and intensity of stimulation. MRI-derived finite element models have been developed to analyze the effect of these parameters allowing novel electrode configurations to be tested in subject specific models. By creating a subject specific model of an obese …

A Novel Biomaterial Enables Chemotactic Study Of Motile Central Nervous System-Derived Tumor Cells, Tanya Singh

Dissertations and Theses

"The local cell microenvironment plays an important role in maintaining the dynamics of the extracellular matrix (ECM) and the cell-ECM relationship. ECM is a complex network of macromolecules with distinct mechanical and biochemical characteristics [1]. The multifaceted interactions that occur between cells and the ECM are crucial to the regulation of processes that maintain homeostasis. These mechanisms are often deregulated during cancer onset and progression, which cause the ECM to become highly disorganized, alter the cell-matrix interactions, and promote increased hypervascularity and metastasis as these components are indicative of cancer progression. Medulloblastoma (MB) is one of the most common, malignant …

A Novel Resistance Exercise Machine For Use In A Lower Body Negative Pressure Box To Counteract The Effects Of Weightlessness, Christine M. Dailey

Doctoral Dissertations and Master's Theses

Physiological deconditioning is a critical problem in space, especially during long-term missions. Resistance exercise coupled with lower body negative pressure (LBNP) has been shown to be effective in counteracting some of the deconditioning related problems. This thesis describes the development of a compact and effective resistance exercise machine that works within an existing environmentally controlled LBNP Box and is designed to simulate both exercise and sitting, to prevent microgravity-induced deconditioning by simulating physiological and biomechanical features of upright exercise and daily activities. Theoretical calculations are carried out to determine whether kinematics, musculoskeletal loadings, and metabolic rate during supine exercise within …

Biomechanics Of Porcine Renal Artery And The Development Of A Replacment Vessel, Mohamed Gabr

Theses and Dissertations

Mechanical characterization of biological soft tissues is essential in the field of biomedical engineering. In this study several loading experiments have been performed to efficiently characterize the passive mechanical response of both native porcine renal arteries and newly developed tissue constructs. The first aim of these studies is to determine whether there is a difference in mechanical response between the main renal artery and its first branch. After fitting the bi-axial data to a Holzapfel-type constitutive model, the results show that there is no statistical difference between the model parameters for renal artery and the first branch. The only significant …

Theranostic Oxygen Delivery Using Ultrasound And Microbubbles, James J. Kwan, Mehmet Kaya, Mark A. Borden, Paul A. Dayton

Biomedical Engineering and Sciences Faculty Publications

Means to overcome tumor hypoxia have been the subject of clinical investigations since the 1960’s; however these studies have yet to find a treatment which is widely accepted. It has been known for nearly a century that hypoxic cells are more resistant to radiotherapy than aerobic cells, and tumor hypoxia is a major factor leading to the resistance of tumors to radiation treatment as well as several cytotoxic agents. In this manuscript, the application of ultrasound combined with oxygen-carrier microbubbles is demonstrated as a method to locally increase dissolved oxygen. Microbubbles can also be imaged by ultrasound, thus providing the …

Comparison Of 4d Phase-Contrast Mri Flow Measurements To Computational Fluid Dynamics Simulations Of Cerebrospinal Fluid Motion In The Cervical Spine, Theresia Yiallourou, Jan Robert Kroger, Nikolaos Stergiopulos, David Maintz, Bryn A. Martin, Alexander C. Bunck

Mechanical Engineering Faculty Research

Cerebrospinal fluid (CSF) dynamics in the cervical spinal subarachnoid space (SSS) have been thought to be important to help diagnose and assess craniospinal disorders such as Chiari I malformation (CM). In this study we obtained time-resolved three directional velocity encoded phase-contrast MRI (4D PC MRI) in three healthy volunteers and four CM patients and compared the 4D PC MRI measurements to subject-specific 3D computational fluid dynamics (CFD) simulations. The CFD simulations considered the geometry to be rigid-walled and did not include small anatomical structures such as nerve roots, denticulate ligaments and arachnoid trabeculae. Results were compared at nine axial planes …

A Depolymerization Based Model Of Neuron Growth Cone Shape And Motility, Neerajha Nagarajan

Master's Theses

Cell migration is a ubiquitous process underlying critical biological mechanisms like wound healing, cancer metastasis and even neuron growth cone motility. It is a critical process for the living organisms as it ensures proper functioning of the system, for example, crawling fibroblasts endure closure of wounds during wound healing. Here we focus our interest on neuron growth cones, a sensory and motile organelle present at the tip of extending neurites, like the axons, in neurons. These are responsible for neuron pathfinding onto specific targets and synapses, in responses to various guidance cues. Interestingly, the motility of the growth cones is …

Plantar Measurements To Determine Success Of Surgical Correction Of Stage Iib Adult Acquired Flatfoot Deformity, Erika Matheis

Theses and Dissertations

Adult Acquired Flatfoot Deformity (AAFD) is a progressive disease characterized by mechanical degeneration of the soft tissue structure in the arch of the foot that leads to changes in joint alignment. Surgical intervention commonly via tendon transfer and bony osteotomy is used to restore arch architecture, however there is a lack of quantitative assessments that measure the success of the surgical correction in vivo. Using plantar pressures via Tekscan® HR Mat and surveys (SF-36, FAOS), pre-operative and post-operative measures for six participants were defined, analyzed and compared. A paired t-test showed significant lateral shift for percent body weight during walking …

Role Of Epidermal Growth Factor-Triggered Pi3k/Akt Signaling In The Migration Of Medulloblastoma-Derived Cells, Veronica Dudu, Richard A. Able, Jr., Veronica Rotari, Qingjun Kong, Maribel Vazquez

Publications and Research

Medulloblastoma (MB) is the most common brain cancer diagnosed among children. The cellular pathways that regulate MB invasion in response to environmental cues remain incompletely understood. Herein, we examine the migratory response of human MB-derived Daoy cells to different concentration profiles of Epidermal Growth Factor (EGF) using a microfluidic system. Our findings provide the first quantitative evidence that EGF concentration gradients modulate the chemotaxis of MB-derived cells in a dose-dependent manner via the EGF receptor (EGF-R). Data illustrates that higher concentration gradients caused increased number of cells to migrate. In addition, our results show that EGF-induced receptor phosphorylation triggered the …

Voltage Effects On Cells Cultured On Metallic Biomedical Implants, Seyed Morteza Haerihosseini

Biomedical and Chemical Engineering - Dissertations

Electrochemical voltage shifts in metallic biomedical implants occur in-vivo due to a number of processes including mechanically assisted corrosion. Surface potential of biomedical implants and excursions from resting open circuit potential (OCP), which is the voltage they attain while in contact with an electrolyte, can significantly change the interfacial properties of the metallic surfaces and alter the behavior of the surrounding cells, compromising the biocompatibility of metallic implants. Voltages can also be controlled to modulate cell function and fate. To date, the details of the physico-chemical phenomena and the role of different biomaterial parameters involved in the interaction between cells …

Application Of Response Surface Methodology And Central Composite Design For 5p12-Rantes Expression In The Pichia Pastoris System, Frank M. Fabian

Department of Chemical and Biomolecular Engineering: Dissertations, Theses, and Student Research

Pichia pastoris has demonstrated the ability to express high levels of recombinant heterologous proteins. Protein expression is enhanced during fermentation at high cell density. However, the level of expression is mainly regulated by fermentation operation factors. This research is directed to investigate the effect of methanol growth rate, temperature and pH in the expression of the total 5P12-Rantes concentration, expression of active 5P12-Rantes and Specific yield using the response surface methodology and central composite design.

The response surface methodology, RSM, has been used successfully used by Zhang, W. and Ian, M. to optimize the cell density and fermentation process. The …

Induced Elastic Matrix Synthesis Within 3-Dimensional Collagen Constructs, Lavanya Venkataraman

All Dissertations

Elastin, a primary component of elastic arteries, maintains structural stability of the cyclically recoiling artery, and critically regulates vascular cell behavior. Accelerated degradation of elastic matrix, such as that seen in vascular pathologies like abdominal aortic aneurysms (AAA), can therefore severely compromise vessel homeostasis. Tissue engineering and in-situ matrix repair strategies evaluated so far are primarily limited in inducing adult vascular cells to replicate the complex elastic matrix assembly process, and restore lost matrix integrity. Previously, our lab established the elastogenic benefits of concurrent delivery of TGF-β1 and HA-oligomers (together termed elastogenic factors, EFs), within 2D cultures of rat aortic …

Measuring Impedance Of Tissues Using A Microfabricated Microelectrode Array, Ashwini Bhat

Master's Theses

MEASURING IMPEDANCE OF TISSUES USING A MICROFABRICATED MICROELECTRODE ARRAY By Ashwini Bhat

This thesis looks at the possibility of using impedance spectroscopy for differentiating tissue, using a microelectrode array (MEA). The thesis first discusses the background and the motivation for this thesis. It covers the certain basic concepts of the human skin starting from the top epidermis layer all the way to the deep dermis layers of the skin. Then it discusses different types of skin cancer and how they occur, in humans. It also discusses various microfabrication techniques such as oxidation, wet etching, sputtering and photolithography for the creation …

On The Importance Of Modeling Stent Procedure For Predicting Arterial Mechanics, Shijia Zhao, Linxia Gu, Stacey R. Froemming

Department of Mechanical and Materials Engineering: Faculty Publications

The stent-artery interactions have been increasingly studied using the finite element method for better understanding of the biomechanical environment changes on the artery and its implications. However, the deployment of balloon-expandable stents was generally simplified without considering the balloon-stent interactions, the initial crimping process of the stent, its overexpansion routinely used in the clinical practice, or its recoil process. In this work, the stenting procedure was mimicked by incorporating all the above-mentioned simplifications. The impact of various simplifications on the stent-induced arterial stresses was systematically investigated. The plastic strain history of stent and its resulted geometrical variations, as well as …

Implementation Of Magnetic Resonance Elastography For The Investigation Of Traumatic Brain Injuries, Thomas Boulet

Department of Engineering Mechanics: Dissertations, Theses, and Student Research

Magnetic resonance elastography (MRE) is a potentially transformative imaging modality allowing local and non-invasive measurement of biological tissue mechanical properties. It uses a specific phase contrast MR pulse sequence to measure induced vibratory motion in soft material, from which material properties can be estimated. Compared to other imaging techniques, MRE is able to detect tissue pathology at early stages by quantifying the changes in tissue stiffness associated with diseases. In an effort to develop the technique and improve its capabilities, two inversion algorithms were written to evaluate viscoelastic properties from the measured displacements fields. The first one was based on …

Characterization Of Polyacrylonitrile Carbon Fibers, Christian Burke Iversen

Biomedical and Chemical Engineering – Theses

Carbon fiber composites are a widely used, advanced material with exceedingly high strength to weight properties. In this thesis, a literature overview of carbon fiber manufacturing was provided, as well as a thorough analysis of in- house electrospun polyacrylonitrile fiber stabilization and surface modification of the resulting carbon fibers. In the first section, an overview of precursor fiber fabrication is provided, followed by an analysis of stabilization using surface and bulk composition, dimensional analysis, and functional group analysis via FTIR. The second section uses the current stabilization procedure to develop carbon nanofibers. Fibers first underwent a nitric acid oxidation time …