Space Vehicles Commons^™

Conceptual Design Of A Reusable Mars Aircraft, Bryce L. Horvath

Mechanical & Aerospace Engineering Theses & Dissertations

This study assumes that the launch vehicles and precision Mars entry descent and landing systems, required for eventual crewed missions to the surface, have been developed, motivating the rapid build-up of a fixed surface base to enable extended human stays. During the time interval between the first successful placement of a heavy (between 20 and 80 metric ton) payload and completion of the baseline human-rated Mars outpost, it will be possible to utilize this large payload delivery capability to accelerate robotic exploration of the surface from the fixed base location.

One element of such an expanded robotic exploration program will …

Feasibility Of Cubesat Formation Flight Using Rotation To Achieve Differential Drag, Skyler M. Shuford

Aerospace Engineering

This paper presents the results of a study conducted to understand the feasibility of CubeSat formation flight. The mechanism for separation and formation studied was differential drag, achieved by rotating the CubeSats to give them different cross-sectional areas. Intuitively, lower altitude orbits provide much higher separation effects. Although the most influential orbital effects occur with maximum and minimum cross-sectional areas, an attitude-controlled and a tumbling CubeSat may provide enough differential drag to meet separation requirements of a mission. Formation flight is possible, but due to the non-linearity of the system, gain scheduling may be the most effective method of long …

Volume Averaged Modeling Of The Oxidation Of Porous Carbon Fiber Material, Alexandre Martin

Mechanical Engineering Faculty Publications

Charring ablators remain the premium choice for space exploration missions that involve atmospheric re-entry. This type of ablative material is composed of a carbon matrix, usually made of fibers, which is then impregnated with a resin. During re-entry, the high heat flux produced by convective heating causes the material to chemically react. First, the resin pyrolyzes, and is vaporized into a gas that travels through the material, and is eventually ejected at the surface. Then, as the temperature rises, the surface of the porous matrix recess through ablative processes. For re-entry conditions typical of space exploration missions, this is mainly …

Assessment For Completion Of Cp7 Integration With Revision 6 Avionics, Daniel Jennings

Electrical Engineering

he purpose of this project is the continuation of the CP7 CubeSat project, analysis for integration with new Avionics Systems, and to leave behind instruction for future work for completion of the satellite. CP7 is a satellite in development to support a mechanical and electrical system to experiment on particle damping in micro-gravity. The completion of this satellite needs to be prioritized more than it has been by the PolySat team to honor our work with Northrop Grumman, who have been supportive and helpful throughout the process. This work seeks to aid in the completion of this satellite, so that …

A Generic Decision Making Framework For Autonomous Systems, Connor Lange

Master's Theses

With the rising popularity of small satellites, such as CubeSats, many smaller institutions previously incapable of developing and deploying a spacecraft have starting to do so. Institutions with a history of space flight, such as NASA JPL, have begun to put projects on CubeSats that would normally fly on much larger satellites. As a result, the institutions with space flight heritage have begun to port spacecraft software that was previously designed for much larger and more complex satellites to the CubeSat platform. Unfortunately for universities, who are the majority of all institutions devel- oping CubeSats, these ported systems are too …

Feasibility Of Microsatellite Active Debris Removal Systems, Karsten J. James

Master's Theses

Space debris has become an increasingly hazardous obstacle to continued spaceflight operations. In an effort to mitigate this problem an investigation of the feasibility of a microsatellite active debris removal system was conducted. Through proposing a novel concept of operation, utilizing a grapple-and-tug system architecture, and by analyzing each resultant mission phase in the frame of a representative example, it was found that microsatellite scale systems are capable of fulfilling the active debris removal mission. Analysis of rendezvous, docking, control and deorbit mission requirements determined that the design of a grapple-and-tug system will be driven by sizing of the propellant …

Rocket Fuel Pressurization, Sean Green, Joe Marcinkowski, Andrew Nahab

Mechanical Engineering

No abstract provided.

Design, Fabrication, And Testing Of An Emr Based Orbital Debris Impact Testing Platform, Jeffrey J. Maniglia Jr.

Master's Theses

This paper describes the changes made from Cal Poly’s initial railgun system, the Mk. 1 railgun, to the Mk. 1.1 system, as well as the design, fabrication, and testing of a newer and larger Mk. 2 railgun system. The Mk. 1.1 system is developed as a more efficient alteration of the original Mk. 1 system, but is found to be defective due to hardware deficiencies and failure, as well as unforeseen efficiency losses. A Mk. 2 system is developed and built around donated hardware from the Naval Postgraduate School. The Mk. 2 system strove to implement an efficient, augmented, electromagnetic …

Characterization Of The Effects Of A Sun-Synchronous Orbit Slot Architecture On The Earth's Orbital Debris Environment, Connor David Noyes

Master's Theses

Low Earth orbit represents a valuable limited natural resource. Of particular interest are sun-synchronous orbits; it is estimated that approximately 44% of low Earth satellites are sun-synchronous. A previously developed sun-synchronous orbit slot architecture is considered. An in-depth analysis of the relative motion between satellites and their corresponding slots is performed. The long-term evolution of Earth's orbital environment is modeled by a set of coupled ordinary differential equations. A metric for quantifying the benefit, if any, of implementing a sun-synchronous architecture is developed. The results indicate that the proposed slot architecture would reduce the frequency of collisions between satellites in …

Smaller Spacecraft For Education And Space Research, Robert J. Twiggs

Robert "Bob" Twiggs STEM Education Collection

A PowerPoint presentation created by Professor Bob Twiggs titled "Smaller spacecraft for education and space research" from May 14, 2013.

Investigation Of A Lagrangian-Point Propellant Depot Rendezvous Approach For An Interplanetary Mission To Mars, Joshua W. Ehrlich

Doctoral Dissertations and Master's Theses

This thesis investigates the feasibility of a refueling station for a beyond Earth orbit (BEO) mission. The propellant depot is located at the L₂ -Lagrangian point within the Earth-Moon system. This investigation determines if a refueling mission will reduce propulsive energy requirements necessary for Earth departure of a BEO-vehicle to achieve an interplanetary transfer to Mars. Furthermore, this research presents a trade study which identifies approximate total requirements for a direct and rendezvous mission to Mars as well as the necessary fuel masses to complete each approach. This analysis provides conclusive information in determining the benefits in utilizing a …

Orbital Debris Removal Technologies: A Hybrid Electrodynamic Tether And Ion Beam Shepherd Satellite Design For Fuel Efficient Contactless Debris Removal, JöRn Mumme

Doctoral Dissertations and Master's Theses

Space debris poses a serious threat to humanities efforts at space exploration as well as the expanding uses for earth-orbiting satellites. This thesis investigates the proposed technologies for the debris's removal both large and small. Focus is applied to the large debris removal technologies since the small size category is dominated by the ORION laser system. Furthermore, the large debris objects pose the most destructive threat upon impact to satellites. Electrodynamic tethers (EDT) as well as their control strategies, ion-beam shepherds (IBS), and tradition thruster methods are investigated for effectiveness and feasibility. Hybrid combinations of these technologies are investigated in …

Comm-Components Of Link Equation, Robert J. Twiggs

Robert "Bob" Twiggs STEM Education Collection

A PowerPoint Presentation created by Professor Bob Twiggs on "Comm-Components of Link Equation" from April 10, 2013.

Pilots For Space Tourism, Robert A. Goehlich, Jay K. Anderson, Nathan N. Harrold, Joseph A. Bemis, Mike T. Nettleingham, Joshua M. Cobin, Bradley R. Zimmerman, Ben L. Avni, Michael D. Gonyea, Nicholas Y. Ilchena

Applied Aerospace Science

This article sheds light on the key player needed for any space tourism adventure: the pilot who flies the spacecraft. The paper addresses the potential benefits of including a pilot at the controls when designing a space tourism spacecraft. It examines the basic qualifications and advanced skills required of space tourism pilots and discusses key training requirements for selected pilots and space pilots’ pay and benefits. In addition, the research concludes that, just as the pioneers of passenger transport in aviation entertained and captured the interest of their passengers, the space pilot should have the skills of a tour guide.

Syllabus For Space Systems Engineering 120: Satellites And Space Systems I (Spring 2013), Robert J. Twiggs

Robert "Bob" Twiggs STEM Education Collection

Professor Bob Twiggs' 2013 spring syllabus for Space Systems Engineering 120: Satellites and Space Systems I.

.

Communications: Moving Data, Robert J. Twiggs

Robert "Bob" Twiggs STEM Education Collection

A PowerPoint Presentation created by Professor Bob Twiggs on "Communications: Moving Data" from March 24, 2013.

Comm-Using Decibels, Robert J. Twiggs

Robert "Bob" Twiggs STEM Education Collection

A PowerPoint Presentation created by Professor Bob Twiggs on "Comm-Using Decibels" from March 14, 2014.

Ad-Hoc Regional Coverage Constellations Of Cubesats Using Secondary Launches, Guy G. Zohar

Master's Theses

As development of CubeSat based architectures increase, methods of deploying constellations of CubeSats are required to increase functionality of future systems. Given their low cost and quickly increasing launch opportunities, large numbers of CubeSats can easily be developed and deployed in orbit. However, as secondary payloads, CubeSats are severely limited in their options for deployment into appropriate constellation geometries.

This thesis examines the current methods for deploying cubes and proposes new and efficient geometries using secondary launch opportunities. Due to the current deployment hardware architecture, only the use of different launch opportunities, deployment direction, and deployment timing for individual cubes …

Work Ethics For Sse-122: Satellites & Space Systems (Spring 2013), Robert J. Twiggs

Robert "Bob" Twiggs STEM Education Collection

PowerPoint presentation by Professor Bob Twiggs on work ethics for SSE-122: Satellites & Space Systems for the spring 2013 semester, created on February 28, 2013.

Vtt Technical Research Centre Of Finland, Vtt Technical Research Centre

Robert "Bob" Twiggs STEM Education Collection

A PowerPoint Presentation titled "VTT Technical Research Centre of Finland" from February 14, 2013.

Smaller Spacecraft For Flying Large Clusters Of Biological Space Experiments, Robert J. Twiggs

Robert "Bob" Twiggs STEM Education Collection

A PowerPoint presentation created by Professor Bob Twiggs titled "Smaller spacecraft for flying large clusters of biological space experiments" from February 5, 2013.

Would I Survive In Space?, Robert J. Twiggs

Robert "Bob" Twiggs STEM Education Collection

A PowerPoint presentation created by Professor Bob Twiggs titled "Would I survive in Space?" from February 4, 2013.

Spacecraft Payloads, Robert J. Twiggs

Robert "Bob" Twiggs STEM Education Collection

A PowerPoint Presentation created by Professor Bob Twiggs on "Spacecraft Payloads" on January 5, 2013.

Systems Engineering, Robert J. Twiggs

Robert "Bob" Twiggs STEM Education Collection

A PowerPoint Presentation created by Professor Bob Twiggs on "System Engineering" on January 5, 2013.

Akin's Laws Of Spacecraft Design, Robert J. Twiggs

Robert "Bob" Twiggs STEM Education Collection

A document use in class by Professor Bob Twiggs titled "Akin's Law of Spacecraft Design" from January 5, 2013.

Modeling Of Chemical Nonequilibrium Effects In A Charring Ablator, Alexandre Martin

Mechanical Engineering Faculty Publications

Charring ablators remain the premium choice for space exploration missions that involve atmospheric re-entry. These type of ablative material are composed of a carbon matrix, usually made of fibers, which is then impregnated with a resin. During re-entry, the high heat flux produced by convective heating causes the material to chemically react. First, the resin pyrolyzes, and is vaporized into a gas that travels through the material, and is eventually ejected at the surface. Since the composition of the gas at the surface greatly affects the heat flux, and therefore the surface temperature, it is thus important to be able …

Bio-Inspired Cooperative Optimal Trajectory Planning For Autonomous Vehicles, Charles Remeikas

Electronic Theses and Dissertations

With the recent trend for systems to be more and more autonomous, there is a growing need for cooperative trajectory planning. Applications that can be considered as cooperative systems such as surveying, formation flight, and traffic control need a method that can rapidly produce trajectories while considering all of the constraints on the system. Currently most of the existing methods to handle cooperative control are based around either simple dynamics and/or on the assumption that all vehicles have homogeneous properties. In reality, typical autonomous systems will have heterogeneous, nonlinear dynamics while also being subject to extreme constraints on certain state …

Vision-Based Sensing And Optimal Control For Low-Cost And Small Satellite Platforms, Bradley Sease

Electronic Theses and Dissertations

Current trends in spacecraft are leading to smaller, more inexpensive options whenever possible. This shift has been primarily pursued for the opportunity to open a new frontier for technologies with a small financial obligation. Limited power, processing, pointing, and communication capabilities are all common issues which must be considered when miniaturizing systems and implementing low-cost components. This thesis addresses some of these concerns by applying two methods, in attitude estimation and control. Additionally, these methods are not restricted to only small, inexpensive satellites, but offer a benefit to large-scale spacecraft as well. First, star cameras are examined for the tendency …

Mission Analysis For Pico-Scale Satellite Based Dust Detection In Low Earth Orbits, Jacob Belli

Electronic Theses and Dissertations

A conceptual dust detection mission, KnightSat III, using pico-scale satellites is analyzed. The purpose of the proposed KnightSat III mission is to aid in the determination of the size, mass, distribution, and number of dust particles in low earth orbits through a low cost and flexible satellite or a formation of satellites equipped with a new dust detector. The analysis of a single satellite mission with an on-board dust detector is described; though this analysis can easily be extended to a formation of pico-scale satellites. Many design aspects of the mission are discussed, including orbit analysis, power management, attitude determination …

Heteroclinic And Homoclinic Connections Between The Sun-Earth Triangular Points And Quasi-Satellite Orbits For Solar Observations, Pedro J. Llanos, Gerald R. Hintz, Martin W. Lo, James K. Miller

Publications

Investigation of new orbit geometries exhibits a very attractive behavior for a spacecraft to monitor space weather coming from the Sun. Several orbit transfer mechanisms are analyzed as potential alternatives to monitor solar activity such as a sub-solar orbit or quasi-satellite orbit and short and long heteroclinic and homoclinic connections between the triangular points L4 and L5 and the collinear point L3 of the CRTBP (circular restricted three-body problem) in the Sun-Earth system. These trajectories could serve as channels through where material can be transported from L5 to L3 by performing small maneuvers at the departure of the Trojan orbit. …