Power and Energy Commons^™

Triple-Junction Solar Cells : In Parallel., Levi C Mays

Electronic Theses and Dissertations

This paper looks into the current inefficiency of solar cells and attempts a few alternative solar cell structures in order to provide a more effective source of renewable energy. Currently, multi-junction solar cells are being developed to capture the sun’s light more efficiently. One of the ideas in this paper is to add a window to see if the addition of such a layer into a junction will increase the voltage while maintaining nearly the same current output. Central to this paper is the rearranging of the conducting layers of the multi-junction cell so that the junctions can be connected …

Residential Electricity Management And Protection System, Ejimonu Kosisochukwu Gabriel

Journal of International Technology and Information Management

The Residential Electricity Monitoring System is an electricity meter connected to the Internet to provide real time data on the power system in your home. The REMS is designed to replace the distribution board allowing it to conduct a series of tests on the quality of the electricity supply to your home/facility and, within your home detect basic wiring faults and allow owners and service providers to identify potential problems with the electrical systems.

The electrical monitoring system finally puts proper electrical control into the hands of the home owner by providing him with the ability to control power distribution …

Swarm Behavior To Mitigate Rebound In Air Conditioning Demand Response Events, Jason Yasuto Kuwada

Boise State University Theses and Dissertations

Thermostatically Controlled Loads (TCLs) have shown great potential for Demand Response (DR) events. However, it has been commonly seen that DR events using TCLs may cause demand rebound, especially in homogeneous populations. To further explore the potential for DR events, as well as the negative effects, a stability and resilience analysis were performed on multiple populations and verified with agent based modeling simulations.

At the core of this study is an added thermostat criterion created from the combination of a proportional gain and the average compressor operating state of neighboring TCLs. Where DR events in TCLs are commonly controlled by …

Beneficial Reuse Of Industrial Co2 Emissions Using A Microalgae Photobioreactor: Waste Heat Utilization Assessment, Daniel T. Mohler, Michael H. Wilson, Zhen Fan, John G. Groppo, Mark Crocker

Center for Applied Energy Research Faculty and Staff Publications

Microalgae are a potential means of recycling CO₂ from industrial point sources. With this in mind, a novel photobioreactor (PBR) was designed and deployed at a coal-fired power plant. To ascertain the feasibility of using waste heat from the power plant to heat algae cultures during cold periods, two heat transfer models were constructed to quantify PBR cooling times. The first, which was based on tabulated data, material properties and the physical orientation of the PBR tubes, yielded a range of heat transfer coefficients of 19–64 W m⁻² K⁻¹ for the PBR at wind speeds of 1–10 …

Forecasting In Blockchain-Based Local Energy Markets, Michael Kostmann, Wolfgang Karl Hardle

Sim Kee Boon Institute for Financial Economics

Increasingly volatile and distributed energy production challenges traditional mechanisms to manage grid loads and price energy. Local energy markets (LEMs) may be a response to those challenges as they can balance energy production and consumption locally and may lower energy costs for consumers. Blockchain-based LEMs provide a decentralized market to local energy consumer and prosumers. They implement a market mechanism in the form of a smart contract without the need for a central authority coordinating the market. Recently proposed blockchain-based LEMs use auction designs to match future demand and supply. Thus, such blockchain-based LEMs rely on accurate short-term forecasts of …

Energy Transformation And Conservation Investigation, Mike Jackson, Holly Haney

High School Lesson Plans

Students will use a thermoelectric generator module to analyze the relationship between thermal and electrical energies. Using data collection sensors and analysis software, students will investigate the relationship between the temperature gradient across a thermoelectric generator module and the resulting electrical potential. Students will then use their data and analysis to solve problems relating to waste thermal energy in electrical systems and communicate their work to their peers and teacher.

Co-Optimization Approach To Post-Storm Recovery For Interdependent Power And Transportation Systems, Yinyin Ge, Lili Du, Hongzing Ye

Electrical and Computer Engineering Faculty Publications

The power and transportation systems are urban interdependent critical infrastructures (CIs). During the post-disaster restoration process, transportation mobility and power restoration process are interdependent, and their functionalities significantly affect other well-beings of other urban CIs. Therefore, to enhance the resilience of urban CIs, successful recovery strategies should promote CI function cooperatively and synergistically to distribute goods and services efficiently. This paper develops an integrative framework that addresses the challenges of enhancing the recovery efficiency of urban power and transportation systems in short-term recovery period. Specifically, the post-storm recovery process is considered as a scheduling problem under the constraints representing crew …

The Comparative Analysis Of The Performances Of Four And Six Pole Pairs Permanent Magnet Synchronous Generator, Ra Msuya

Tanzania Journal of Engineering and Technology (TJET)

Wind power applications using multi-poles permanent magnet generators have become very attractive especially in small ratings. Low-speed multi-pole PM generators are maintenance-free and may be used in different climate conditions. Most of the low speed wind turbine generators presented is permanent magnet machines, which have advantages of high efficiency and reliability since there is no need of external excitation and conductor losses are removed from the rotor. From the study two types of PM AC generator are designed with 6 pole pairs and the other one with 4 pole pairs. These generators were designed and analysed using Maxwell software. The …

Electrocatalytic Nanomaterials For Reduction Of Hydrogen Peroxide As Potential Radioprotectors, Rui-Hong Jia, Jin-Xuan Zhang, Xiao-Dong Zhang, Mei-Xian Li

Journal of Electrochemistry

Nanomaterials have shown many potential application prospects in the biomedical field, such as medical imaging, drug delivery and biosensing due to their unique physical and chemical properties. In this review we focus on nanomaterials that have shown not only abilities of radiation protection, but also good electrocatalytic activities toward reduction reactions of hydrogen peroxide and oxygen. We discuss the abilities of radiation protection of these nanomaterials that are ascribed to their enzyme-like activities because their catalytic properties provide an effective pathway for scavenging free radicals in vivo via rapid reactions with reactive oxygen species. We also provide insights into electrocatalytic …

Improving Power Network Resilience Against Threats, Hamzeh Davarikia

LSU Doctoral Dissertations

The work reported in this dissertation aims at developing a practical tool for utility transmission planners to improve the power network resilience against high-impact, low-frequency events (HILF). Such events rarely happen, but when occurred are catastrophic. In this dissertation, we studied the impact of HILF from the static and dynamic point of view and proposed the planning strategy to lower the devastating effect of the HILF.

In the static analysis, we consider the steady-state situation of the power grids and plan to protect the grid’s components, i.e., generators, buses, and transmission lines, to maximize preserving demand in a disastrous situation. …

Smart Charging Strategies For Electric Vehicle Charging Stations, Zeinab Moghaddam

Theses: Doctorates and Masters

Although the concept of transportation electrification holds enormous prospects in addressing the global environmental pollution problem, consumer concerns over the limited availability of charging stations and long charging/waiting times are major contributors to the slow uptake of plug-in electric vehicles (PEVs) in many countries. To address the consumer concerns, many countries have undertaken projects to deploy a network of both fast and slow charging stations, commonly known as electric vehicle charging networks.

While a large electric vehicle charging network will certainly be helpful in addressing PEV owners' concerns, the full potential of this network cannot be realised without the implementation …

Analyzing The Efficiency Of Horizontal Photovoltaic Cells In Various Climate Regions, Parker A. Hines, Torrey J. Wagner, Clay M. Koschnick, Steven J. Schuldt

Faculty Publications

This research presents the development of linear regression models to predict horizontal photovoltaic power output. We collected a dataset from 14 global Department of Defense (DoD) installations over a timeframe of one year using an experimental apparatus, resulting in 24,179 usable data points. We developed a linear model to predict power output, which incorporated site-specific weather and geographical characteristics, along with Köppen-Geiger climate classifications in order to determine the effect of adding climate to the model. After performing a Wald test between the full model and a reduced model without Köppen-Geiger climate variables, it was determined that including Köppen-Geiger climate …

Aggregation Of Electric Water Heaters For Peak Shifting And Frequency Response Services, Thomas Leighton Clarke

Dissertations and Theses

The increased penetration of renewable energy sources poses new challenges for grid stability. The stochastic and uncontrollable generation of solar and wind power cannot be adjusted to match the load profile, and the transition away from traditional synchronous generators is reducing the grid capacity to arrest and recover from frequency disturbances.

Additionally, the distributed nature of many renewable energy sources makes centralized control of generation more complicated. The traditional power system paradigm balances the supply and demand of electricity on the grid by regulating generation. As this becomes more difficult, one alternative is to adjust the load instead. This is …

Smart Management Strategies Of Utility-Scale Energy Storage Systems In Power Networks, Choton Kanti Das

Theses: Doctorates and Masters

Power systems are presently experiencing a period of rapid change driven by various interrelated issues, e.g., integration of renewables, demand management, power congestion, power quality requirements, and frequency regulation. Although the deployment of Energy Storage Systems (ESSs) has been shown to provide effective solutions to many of these issues, misplacement or non-optimal sizing of these systems can adversely affect network performance. This present research has revealed some novel working strategies for optimal allocation and sizing of utility-scale ESSs to address some important issues of power networks at both distribution and transmission levels. The optimization strategies employed for ESS placement and …

Weight Controlled Electric Skateboard, Zachary Barram, Carson Bertozzi, Vishnu Dodballapur

Computer Engineering

Technology and the way that humans interact is becoming more vital and omnipresent with every passing day. However, human interface device designers suffer from the increasingly popular “designed for me or people like me” syndrome. This design philosophy inherently limits accessibility and usability of technology to those like the designer. This places severe limits of usability to those who are not fully able as well as leaves non-traditional human interface devices unexplored. This project set out to explore a previously uncharted human interface device, on an electric skateboard, and compare it send user experience with industry leading human interface devices.

Gold Tree Solar Farm - Machine Learning To Predict Solar Power Generation, Jonathon T. Scott

Computer Science and Software Engineering

Solar energy causes a strain on the electrical grid because of the uncontrollable nature of the factors that affect power generation. Utilities are often required to balance solar generation facilities to meet consumer demand, which often includes the costly process of activating/deactivating a fossil fuel facility. Therefore, there is considerable interest in increasing the accuracy and the granularity of solar power generation predictions in order to reduce the cost of grid management. This project aims to evaluate how sky imaging technology may contribute to the accuracy of those predictions.

Heat: Hydraulic And Electric Animation Team, Tyler J. Couvrette, Michael J. Cain, Sara T. Novell, Dexter K. Yanagisawa

Mechanical Engineering

Each New Years’ Day, the Cal Poly Rose Float presents a flower-covered float to the world at the Tournament of Roses parade. This floral display, paired with moving mechanical animations, shows off Cal Poly to the world. This project strove to keep Cal Poly on the cutting edge of technology both in parade floats, and in engineering, by creating a completely electric-powered animation system.

To accomplish this, a group of students set out to make the fully electric animation system that can power both the hydraulic and electric mechanisms on the Float. This was accomplished through months of planning and …

Smart Dc Wall Outlet Design With Improved Load Voltage Detection, Patrick Donovon Granieri

Master's Theses

A standard home in the United States has access to the 120V AC power grid for use with home appliances. Many electronics used at home are powered by a DC power supply, which loses energy in the conversion from AC power. The DC House project avoids any conversion between AC and DC by storing energy in batteries as DC power and supplying it directly to DC appliances. While AC systems feature a standardized output voltage, no such standard exists for DC systems. The Smart DC Wall Outlet solves this by automatically adjusting its output voltage to meet any required DC …

Waved: A Coreless Axial Flux Pm Motor For Drive Systems With Constant Power Operation, Narges Taran, Vandana Rallabandi, Dan M. Ionel

Power and Energy Institute of Kentucky Faculty Publications

In this paper, a two-phase coreless AFPM machine with wave winding, 2-stators, and 3-rotors for traction applications is studied. A highly general optimization method, employing 3D FEA as the computational engine is employed. Number of poles in addition to other geometrical variables are included as independent optimization variables. A method for extending the speed range by rotating one of the stator discs with respect to the other at constant power operation is proposed. An inverter configuration including Si and wide band gap devices is proposed to be employed in conjunction with the machine under study. The study includes a comparison …

Modeling And Control Of A Multiport Converter Based Ev Charging Station With Pv And Battery, Yibin Zhang, Jiangbiao He, Dan M. Ionel

Power and Energy Institute of Kentucky Faculty Publications

As an environmental friendly vehicle, the increasing number of electrical vehicles (EVs) leads to a pressing need of widely distributed charging stations, especially due to the limited on-board battery capacity. However, fast charging stations, especially super-fast charging stations may stress power grid with potential overload at peaking time, sudden power gap and voltage sag. This paper discusses the detailed modeling of a multiport converter based EV charging station integrated with PV power generation, and battery energy storage system, by using ANSYS TwinBuilder. In this paper, the control scheme and combination of PV power generation, EV charging station, and battery energy …