Electrical and Electronics Commons^™

Developing Arduino Coding Curriculum, Tyler Brown, Riley Bucheitte, Timothy Kidd

Summer Undergraduate Research Program (SURP) Symposium

No abstract provided.

Analysis And Design Of A Fully Soft Switched Two-Level Dc-Dc Boost Converter For Electric Vehicle Applications, Amin Mirzaei, Mahdi Rezvanyvardom, Ehsan Najafi

Emirates Journal for Engineering Research

In this paper, a fully soft switched two-level DC-DC Boost converter is proposed. The converter is used only one auxiliary cell to create the soft switching conditions for all semiconductor devices. The auxiliary cell contains one auxiliary switch, one resonant capacitor, one resonant inductor and one auxiliary diode. The auxiliary switch creates the soft switching conditions by control of resonant elements. Besides, the auxiliary cell is not located in the main power path and cannot decrease the converter efficiency. It has simple operation modes. Besides, the proposed soft-switched converter is highly efficient while the control circuit is simple and remains …

Experimental Investigation Of The Wind Energy Harvesting Potential Of A Stand-Alone Piezoelectric Strip, Phillip Christopher Scott

Mechanical Engineering ETDs

The purpose of the study was to investigate the feasibility of harvesting wind energy on a small scale in residential areas. The method investigated was the initiation of movement-induced excitation (MIE), a type of aeroelastic flutter, within samples of polyvinylidine fluoride (PVDF), a piezoelectric polymer. Single samples of PVDF were secured in a wind tunnel and sample voltage was measured over a broad range of wind speeds. Power was calculated then via the addition of ohmic resistance matched to the magnitude of the capacitive impedances of the samples. The geometry of the PVDF samples studied was maintained as a simple …

Tunable Compact Thz Devices Based On Graphene And Other 2d Material Metasurfaces, Tianjing Guo

Department of Electrical and Computer Engineering: Dissertations, Theses, and Student Research

Since the isolation of graphene in 2004, a large amount of research has been directed at 2D materials and their applications due to their unique characteristics. Compared with the noble metal plasmons in the visible and near-infrared frequencies, graphene can support surface plasmons in the lower frequencies of terahertz (THz) and midinfrared. Especially, the surface conductivity of graphene can be tuned by either chemical doping or electrostatic gating. As a result, the idea of designing graphene metasurfaces is attractive because of its ultra-broadband response and tunability.

It has been demonstrated theoretically and experimentally that the third-order nonlinearity of graphene at …

Inter-Slice Compression And Reconstruction Of Glioma Magnetic Resonance Imaging (Mri) Data Using Encoder-Decoder Neural Networks, Gavin Michael Karr

Graduate Theses - Electrical and Computer Engineering

Magnetic Resonance Imaging (MRI) scans of patients with brain tumors are an important source of pre-surgical medical information. These three-dimensional image volumes can be represented as a stack of two-dimensional image slices. The objective of this thesis is to compress the size of these image volumes by removing the odd-numbered slices and reconstruct the image volume using an encoder-decoder convolutional neural network. This neural network architecture is based on a modified form of the U-net segmentation network, which has been adjusted to allow for multiple image inputs and to support a network capable of generating new image slices. A novel …

Flexible Capacitive Pressure Sensors And Triboelectric Energy Harvesters Using Laser-Assisted Patterning Process For Flexible Hybrid Electronic Applications, Valliammai Palaniappan

Masters Theses

This work focuses on the design, fabrication and characterization of novel flexible capacitive pressure sensors and triboelectric energy harvesters using laser-assisted patterning process for flexible hybrid electronic applications. Initially, the capacitive pressure sensor was developed by fabricating a set of polydimethylsiloxanes (PDMS) dielectric films with pyramid shaped micro-structures using a laser-assisted patterning process. The pressure sensor consists of two electrodes (top and bottom) that were fabricated by depositing silver (Ag) on flexible polyethylene terephthalate (PET) using additive screen-printing process. Finally, the pressure sensor was assembled by attaching the top and bottom Ag electrodes to the smooth side of pyramid shaped …

Synthesis And Application Of Ceramic Paste For High-Temperature Electronic Packaging, Ardalan Nasiri

Graduate Theses and Dissertations

This dissertation research focused on the synthesis and application of ceramic paste for high-temperature applications. An alumina paste material comprising aluminum dihydric phosphate and alumina powder was developed for high-temperature electronic packaging. Nano aluminum nitride and nano-silica powders were embedded to promote the paste curing process, limit the grain growth, and increase its bond shear strength. The chip-to-substrate bond strength was enhanced and met the MIL-STD requirements for die-attach assembly. Its encapsulation property was improved with fewer cracks compared to similar commercial ceramic encapsulants. The die-attach material and encapsulation properties tested at 500°C showed no defect or additional cracks. Thermal …

Development Of A Reference Design For A Cyber-Physical System, Nicholas Paul Blair

Graduate Theses and Dissertations

The purpose of this thesis is to develop a reference design to assist in the selection of security practices in power electronics design. A prototype will be developed from this reference design for evaluation. This evaluation will include a brief cost/benefit analysis to gauge the efficacy of implementing each layer of security throughout the power electronics design process. This thesis will also describe the obstacles and effectiveness of integrating a Trusted Platform Module (TPM) into a cyber-hardened grid-connected device. The TPM device is a secured crypto processor that assists in generating, storing, and restricting the use of cryptographic keys. The …

Three-Event Energy Detection With Adaptive Threshold For Spectrum Sensing In Cognitive Radio Systems, Alexandru Martian, Mahmood Jalal Ahmad Al Sammarraie, Calin Vladeanu, Dimitrie Popescu

Electrical & Computer Engineering Faculty Publications

Implementation of dynamic spectrum access (DSA) in cognitive radio (CR) systems requires the unlicensed secondary users (SU) to implement spectrum sensing to monitor the activity of the licensed primary users (PU). Energy detection (ED) is one of the most widely used methods for spectrum sensing in CR systems, and in this paper we present a novel ED algorithm with an adaptive sensing threshold. The three-event ED (3EED) algorithm for spectrum sensing is considered for which an accurate approximation of the optimal decision threshold that minimizes the decision error probability (DEP) is found using Newton’s method with forced convergence in one …

The Hybridization Of A Graphene And Silicon Carbide Schottky Optoelectronic Device By The Incorporation Of A Lead Sulfide Quantum Dot Film, Joshua Letton

Theses and Dissertations

The work that follows examines the impact of lead sulfide quantum dots on a native epitaxial graphene (EG) SiC Schottky device, resulting in a hybrid optoelectronic device which presents a possible avenue towards a novel hybrid carbide-based Schottky solar cell. The active (n-type SiC) and contact (graphene) layers for the Schottky junction of the device were grown epitaxially using a novel technique incorporating tetrafluorosilane (TFS) as a precursor gas. The bare EG/SiC device was characterized based on its I-V behavior in dark and under illumination for both forward and reverse bias conditions. The initial characterization demonstrated the expected Schottky diode …

Performance Analysis Of Renewable Energy Resources In Rural Areas: A Case Study Of Solar Energy, Jackson Justo

Tanzania Journal of Engineering and Technology (TJET)

This paper presents an overview of the recent development trends of solar photovoltaic (PV) systems and the performance in the Tanzanian context. The two types of solar power generation that are considered in this paper are: i) solar PV systems and ii) concentrated solar power (CSP). The two are compared in terms of cost of energy and energy storage mechanism. Moreover, the effect of ambient temperature on the solar PV module is analyzed. In addition, a detailed analysis on using solar axis tracking to increase the power generation is also presented. The extent to which the cell surface temperature and …

Modeling And Control Of Solar Pv With Battery Energy Storage For Rural Electrification, Irene Masenge

Tanzania Journal of Engineering and Technology (TJET)

In rural areas where electric power grid network is rarely available, power generation from renewable energy resource such as solar photovoltaic (PV) is mostly accomplished in standalone mode. The standalone solar PV system requires energy storage device to achieve reliable power supply to the end users. This paper presents modelling and coordination control of solar PV with battery energy storage system (BESS) for rural-electrification applications. The proposed control is accomplished via a bidirectional buck-boost converter with the objective of maintaining voltage at the DC bus constant. Simulation results based-on MATLAB/Simulink platform confirms good performance of the proposed system

Multipath Exploitation-Based Indoor Target Localization Model Using Single Marginal Antenna, Joseph Sisala

Tanzania Journal of Engineering and Technology (TJET)

Recently, indoor target localization became an area of interest due to its diverse applications. In indoor target localization, surrounding environment creates multipath components, which can be exploited to aid in localization process. A number of studies have been proposed to employ multipath exploitation in localizing indoor targets. However, their localization errors can still be improved. This study proposed a new localization model based on multipath exploitation techniques by using triangulation method. Ultra-wide band signals were resolved and associated using marginal antenna-based scheme. The estimate of the target location was then obtained using measured round-trip time delays. The location was determined …

Using Of Parametric Nonlinear Lc-Circuits In Stabilized Transducers Of The Number Of Phases, Ivan Mikhaylovich Bedritsky, Kamila Komilovna Jurayeva, Laziz Kholboboyevich Bozorov

Chemical Technology, Control and Management

The use of nonlinear circuits of an autoparametric nature with inductive and capacitive elements for obtaining the necessary phase shifts in single-phase-three-phase converters is considered. The amplitude-phase relations between the stresses of windings located on different rods of a three-core core are obtained. The conditions under which it is possible to stabilize the stresses of the artificial phases of the Converter, as well as the phase shifts between them, are shown.

Statistical Photo-Calibration Of Photo-Detectors For Radiometry Without Calibrated Light Sources Comprising An Arithmetic Unit To Determine A Gain And A Bias From Mean Values And Variance Values, Adrian M. Catarius, Nicholas Yielding, Stephen C. Cain, Michael D. Seal

AFIT Patents

Calibration of a radiometry system uses a readout circuit of a photo-detector to provide first and second measurements collected over first and second integration times, respectively, where the first and second measurements are related to a photonic input to the photo-detector by a gain and a bias. First mean and variance values are computed for a plurality of first measurements. Second mean and variance values are computed for a plurality of second measurements. The gain and bias are determined from the first and second mean values and the first and second variance values without the use of a calibrated source. …

Telemedicine: An Iot Based Remote Healthcare System., Mohammad Abdellatif, Walaa Mohamed

Electrical Engineering

This paper proposes a remote healthcare system which is referred to as Telemedicine. Telemedicine is a platform that establishes a connection be-tween the patient and the doctor. This platform belongs to the internet of medical things (IoMT) by enabling multiple medical sensors to connect to a server either using multiple communication technologies such as Wi-Fi, Bluetooth or GSM technologies. The system collects data from several sensors and sends them using one of the aforementioned technologies using an Arduino Board, while the inter-face is made with matlab and C#. Additionally, a comparative study between the three communications technologies used to connect …

The Design, Testing, And Analysis Of A Constant Jammer For The Bluetooth Low Energy (Ble) Wireless Communication Protocol, Aiku Shintani

Master's Theses

The decreasing cost of web-enabled smart devices utilizing embedded processors, sensors, and wireless communication hardware have created an optimal ecosystem for the Internet of Things (IoT). IEEE802.15.4, IEEE802.11ah, WirelessHART, ZigBee Smart Energy, Bluetooth (BT), and Bluetooth Low Energy (BLE) are amongst the most commonly used wireless standards for IoT systems. Each of these standards has tradeoffs concerning power consumption, range of communication, network formation, security, reliability, and ease of implementation. The most widely used standards for IoT are Bluetooth, BLE, and Zigbee. This paper discusses the vulnerabilities in the implementation of the PHY and link layers of BLE. The link …

Optimization Of Aggregated Ev Power In Residential Communities With Smart Homes, Huangjie Gong, Dan M. Ionel

Power and Energy Institute of Kentucky Faculty Publications

Electric vehicles (EVs) tend to increase peak power for residences in the evening when house owners return home and begin charging. The aggregated EV charging demand can cause a sudden rise in the peak power at the distribution system level, resulting in a “dragon curve” Such phenomenon, combined with the “duck curve” that is caused by high photovoltaic (PV) penetration in residential communities, requires fast ramping rates and expanded capabilities for local distribution transformers and main feeder cables provided by the utility. As a solution, a residential energy storage system (RESS) can store surplus PV generation during midday and use …

Remedying Sound Source Separation Via Azimuth Discrimination And Re-Synthesis, Ruairí De Fréin

Conference papers

Commercially recorded music since the 1950s has been mixed down from many input sound sources to a two- channel reproduction of these sources. The effect of this approach is to assign sources to locations in a stereo field using a pan- position for each source. The Adress algorithm is a popular way of extracting individual music sound sources from a stereo mixture. A drawback of the Adress algorithm is that when time- frequency components in the stereo mixture are shared between two or more sources, calculating the inter-aural intensity scaling parameter for each source for that time-frequency component is challenging. …

Optimized System For On-Route Charging Of Battery Electric Buses And High-Fidelity Modelling And Simulation Of In-Motion Wireless Power Transfer, Yogesh Bappasaheb Jagdale

Masters Theses

Electrifying cars, buses and trucks is an attractive means to reduce energy use and emissions, because it involves minimal restructuring of the transportation network. Transit buses drive fixed routes, minimizing driver range anxiety by properly sizing energy storage system but the major challenge to fully electrifying transit buses, is the amount of energy they consume in a day of driving. To enable a full day of operation, batteries need to be large, which is expensive and heavy. This work utilizes real-world transit bus data fed to a battery electric drive-train model to co-optimize charger locations, charger power levels, and vehicle …