Electrical and Electronics Commons^™

Modified Fractional Order Sliding Mode Control For Speed Control Of Permanent Magnet Synchronous Motor, Fardila Mohd Zaihidee

Student Works (2020-2029)

In recent years, energy saving research activities have focused on electric motors and their systems since they are the main consumer of electricity in the industrial sector. Permanent magnet synchronous motor is known as a high-efficiency motor and slowly replacing induction motors in the industries. For speed control of PMSM, the sliding mode controller (SMC) has been widely used due to its robustness, high accuracy, and simplicity. The main disadvantage of the SMC method is the chattering phenomenon, which should be reduced or eliminated without compromising the controller’s robustness. Fractional order sliding mode speed control (FOSMC) of PMSM is proposed …

Optimal Distribution System Reconfiguration Incorporating Distributed Generation Based On Simplified Network Approach, Mohammad Al Samman

Student Works (2020-2029)

Network Reconfiguration (NR) and Distributed Generation (DG) are well-accepted strategies to minimize power loss and voltage deviation in the Electrical Distribution Network (EDN). Since the NR problem contains a huge combinational search space, most researchers applied meta-heuristic methods to attain optimal NR solution. However, meta-heuristic methods do not always guarantee optimal solution and furthermore they consume huge processing time. This occurs mainly due to (1) random solution’s initialization and (2) the verification of solution in each iteration to fulfill the operation constraints during the optimization process. Besides, solving the NR problem simultaneously with DG placement and sizing increases the computational …

Optimized Transconductance Designs To Enhance The Linearity Performance Of Rf Front-End Receiver Circuits In 130 Nm Cmos Technology, Nandini Vitee

Student Works (2020-2029)

Highly linear front-end circuits are greatly desired for wireless receivers to improve the dynamic range. However, intermodulation distortions caused by the non-linear transconductor current limits the linearity of the front-end receiver circuit in CMOS technologies. In addition to the inherent nonlinear effect, the downscaling of CMOS further exacerbates the linearity of the circuit due to lower voltage headroom and high-field mobility. Thus, it is essential to develop effective circuit techniques that can aid linearity enhancement without jeopardizing other preferred performances such as low noise, high conversion gain, and low-power consumption. In this thesis, two different high linear transconductors are presented …

Schottky And Poole-Frenkel Conduction Mechanisms In Zron/Sic System, Lusus Vanessa

Student Works (2020-2029)

In this work, the conduction mechanisms of Schottky Emission (SE) and Poole–Frenkel (PF) Emission for the ZrON/SiC system with a temperature range between 400 oC to 900 oC were analyzed. Understanding of the conduction charge mechanisms will help to estimate leakage characteristics of the ZrON/SiC system. Based on the J-E plot measured at different temperatures for 15 minutes, the obtained r2 was ranged between 0.90–0.98, which confirmed the data obtained complied with the standard SE model. Furthermore, the data plotted from the Effective Barrier Height Extracted from the SE plot showed the highest values of

Fabrication And Application Of Flexible Sensors, Tallis Huther Da Costa

LSU Doctoral Dissertations

A transfer printing method was developed to transfer carbon nanotubes (CNTs) from polyethylene terephthalate (PET) film to poly(dimethyl siloxane) (PDMS) polymer. Carbon nanotubes are composed of carbon atoms arranged in a honeycomb lattice structure, which are electrically conducting. When embedded in a nonconducting polymer, carbon nanotubes impart electrical conductivity to the nanocomposite, thus forming a nanocomposite that has potential applications in highly sensitive strain and pressure sensors. Several printing methods have been studied to deposit carbon nanotubes onto PDMS, including inkjet printing. Inkjet printing is a desirable deposition method since it is low-cost, simple, and allows the processing of aqueous-based …

Live Media Production: Multicast Optimization And Visibility For Clos Fabric In Media Data Centers, Ammar Latif

Dissertations

Media production data centers are undergoing a major architectural shift to introduce digitization concepts to media creation and media processing workflows. Content companies such as NBC Universal, CBS/Viacom and Disney are modernizing their workflows to take advantage of the flexibility of IP and virtualization.

In these new environments, multicast is utilized to provide point-to-multi-point communications. In order to build point-to-multi-point trees, Multicast has an established set of control protocols such as IGMP and PIM. The existing multicast protocols do not optimize multicast tree formation for maximizing network throughput which lead to decreased fabric utilization and decreased total number of admitted …

Energy And Performance-Optimized Scheduling Of Tasks In Distributed Cloud And Edge Computing Systems, Haitao Yuan

Dissertations

Infrastructure resources in distributed cloud data centers (CDCs) are shared by heterogeneous applications in a high-performance and cost-effective way. Edge computing has emerged as a new paradigm to provide access to computing capacities in end devices. Yet it suffers from such problems as load imbalance, long scheduling time, and limited power of its edge nodes. Therefore, intelligent task scheduling in CDCs and edge nodes is critically important to construct energy-efficient cloud and edge computing systems. Current approaches cannot smartly minimize the total cost of CDCs, maximize their profit and improve quality of service (QoS) of tasks because of aperiodic arrival …

Error Correction For Asynchronous Communication And Probabilistic Burst Deletion Channels, Chen Yi

Dissertations

Short-range wireless communication with low-power small-size sensors has been broadly applied in many areas such as in environmental observation, and biomedical and health care monitoring. However, such applications require a wireless sensor operating in "always-on" mode, which increases the power consumption of sensors significantly. Asynchronous communication is an emerging low-power approach for these applications because it provides a larger potential of significant power savings for recording sparse continuous-time signals, a smaller hardware footprint, and a lower circuit complexity compared to Nyquist-based synchronous signal processing.

In this dissertation, the classical Nyquist-based synchronous signal sampling is replaced by asynchronous sampling strategies, i.e., …

Numerical Study Of Paraffin Wax Melting In A Cavity With A Gradient Of Hot Wall Inclination, Agus Dwi Korawan

Makara Journal of Technology

The melting of a phase change material (PCM) in a cavity with a gradient of hot wall inclination was simulated numerically using five models, namely, Model-A, Model-B, Model-C, Model-D, and Model-E with gradients of −2, −4, ∞, 4, and 2, respectively. The PCM was paraffin wax, which was melted using an enthalpy porosity technique with a pressure-based method. Model-A was found to be the best model. For the completion of the melting process, the models were assigned with the liquid fraction of 1. Model-A required the shortest time, followed by Model-B, Model-C, Model-E, and Model-D, respectively. Compared with Model-C, Model-A …

Fault-Tolerant Capability Of Star Connected Symmetrical Six-Phase Induction Machine With Single And Two Isolated Neutrals, Wan Noraishah Wan Abdul Munim

Student Works (2020-2029)

Traditionally, electrical machines have been designed to operate with single- or three phase power supplies. In the early stage of power electronics development, three-phase machine suffers problems such as high torque ripple due to low order harmonics during six-step switching and limited current handling capacity of the power switches. This has motivated the use of multiphase machines which is capable of mitigating the aforementioned issues. The revival of multiphase machine research is mainly motivated by the need for more reliable drive systems. The vector space decomposition (VSD) model is used for a healthy multiphase machine as the basis for control …

Cooperative Spectrum Sensing Using Maximum A Posteriori As A Detection Technique For Dynamic Spectrum Access Networks, Mohammad Abdellatif, Ahmed Tohamy, Usama Sayed Mohamed, Taha A. Khalaf, Mohamed Abdelraheem

Electrical Engineering

Over the past few years, dynamic spectrum access has been gaining an increasing attention as a solution to the spectrum scarcity problem. In this paper, a primary user detection technique based on Maximum A Posteriori estimation is proposed for dynamic spectrum access networks. In the proposed technique, a set of secondary users acting as sensing nodes send their individual decisions about the existence of the primary user to a central fusion center. The fusion center uses the received data to form a codeword then, applies the maximum a posteriori estimation rule to make a final decision regarding the presence of …

Engineering And Technology For The Better Good Of Society, Pit-Oer, Huixin Wu, Raymond Lam, Dimitrios Stroumbakis

Open Educational Resources

Understanding the importance of New America's commitment to strengthening the outcomes of non-profits and the public sector. We at QCC's Engineering Technology (ET) Department are dedicated to contributing to the nationwide efforts underway by Universities to establish Public-Interest-in-Technology curriculums. Technology impacts our every day lives like never before and it is time to augment the technologists' and engineers' education with curriculum components to enhance their ability to serve the good of society by:

• Teaching students to leverage 3D printing, Open Source Coding, Project Management and Engineering Ethics for the good of society.
• Exposing ET students to put into practice the …

Convex Relaxations For Particle-Gradient Flow With Applications In Super-Resolution Single-Molecule Localization Microscopy, Hesam Mazidisharfabadi

McKelvey School of Engineering Graduate Student Theses & Dissertations

Single-molecule localization microscopy (SMLM) techniques have become advanced bioanalytical tools by quantifying the positions and orientations of molecules in space and time at the nanoscale. With the noisy and heterogeneous nature of SMLM datasets in mind, we discuss leveraging particle-gradient flow 1) for quantifying the accuracy of localization algorithms with and without ground truth and 2) as a basis for novel, model-driven localization algorithms with empirically robust performance. Using experimental data, we demonstrate that overlapping images of molecules, a typical consequence of densely packed biological structures, cause biases in position estimates and reconstruction artifacts. To minimize such biases, we develop …

Structural Organization And Chemical Activity Revealed By New Developments In Single-Molecule Fluorescence And Orientation Imaging, Tianben Ding

McKelvey School of Engineering Graduate Student Theses & Dissertations

Single-molecule (SM) fluorescence and its localization are important and versatile tools for understanding and quantifying dynamical nanoscale behavior of nanoparticles and biological systems. By actively controlling the concentration of fluorescent molecules and precisely localizing individual single molecules, it is possible to overcome the classical diffraction limit and achieve 'super-resolution' with image resolution on the order of 10 nanometers.

Single molecules also can be considered as nanoscale sensors since their fluorescence changes in response to their local nanoenvironment. This dissertation discusses extending this SM approach to resolve heterogeneity and dynamics of nanoscale materials and biophysical structures by using positions and orientations …

Brave New World - Connectivity, Rhonda S. Binda

Open Educational Resources

The trifecta of globalization, urbanization and digitization have created new opportunities and challenges across our nation, cities, boroughs and urban centers. Cities are in a unique position at the center of commerce and technology becoming hubs for innovation and practical application of emerging technology. In this rapidly changing 24/7 digitized world, city governments worldwide are leveraging innovation and technology to become more effective, efficient, transparent and to be able to better plan for and anticipate the needs of its citizens, businesses and community organizations. This class will provide the framework for how cities and communities can become smarter and more …

A Brief Bibliometric Survey On Circularly Polarized Antennas For Mobile Communication, Aniket Gunjal, Abhaya Pal Singh

Library Philosophy and Practice (e-journal)

This paper presents a database review on “Circularly Polarized Antennas for Mobile Communication” as it is the emerging technique used by mobile service provider because of having benefits over other types of antennas available.The polarization purity is now the major issue. In some cases due to cross polarization issue the antenna signal is cancelled at receiver side.So, it is necessary to have circularly polarized antenna to avoid this polarization issue because of change in phase of signal. The change in phase of signal is due to striking of wave on the obstacles and it slightly tilted from its direction causes …

A 2.56 Gbps Serial Wireline Transceiver That Supports An Auxiliary Channel And A Hybrid Line Driver To Compensate Large Channel Loss, Xiaoran Wang

Electrical Engineering Theses and Dissertations

Serial transceiver links are widely used for high-speed point-to-point communications. This dissertation describes two transceiver link designs for two different applications.

In serial wireline communications, security is an increasingly important factor to concern. Securing an information processing system at the application and system software layers is regarded as a necessary but incomplete defense against the cyber security threats. In this dissertation, an asynchronous serial transceiver that is capable of transmitting and receiving an auxiliary data stream concurrently with the primary data stream is described. The transceiver instantiates the auxiliary data stream by modulating the phase of the primary data without …

Model-Based And Data-Driven Situational Awareness For Distribution System Monitoring And Control, Ying Zhang

Electrical Engineering Theses and Dissertations

Electric power systems are undergoing a dramatic change. The penetration of distributed energy resources (DERs) such as wind turbine generators and photovoltaic panels is turning a traditional power system into the active distribution network. Power system situational awareness, which provides critical information for system monitoring and control, is being challenged by multiple sources of uncertainties such as random meter errors, stochastic power output of DERs, and imprecise network parameters. On the other hand, cyber-physical power system operation is vulnerable to cyberattacks against effective state estimation, such as false data injection attacks (FDIAs). To construct next-generation smart grids, this dissertation develops …

Negative-Triangularity Configuration On East: Analysis Of Engineering Limitations On Superconducting, D-Shaped, Target-Diverted Plasmas, David A. Weldon

Graduate Theses - Electrical and Computer Engineering

Thermonuclear fusion is so named because of the high temperature that the majority of the fuel must maintain such that nuclei can overcome the electrostatic force, fuse, and produce energy. However, the ions and electrons (plasma) are so hot that any material used to confine them would be destroyed. To achieve confinement while maintaining the 50,000,000 K temperature needed for self-sustaining fusion, magnetic confinement is needed. As of 2019, the tokamak is the leading candidate for a practical fusion reactor. In recent years, tokamak research has repeatedly shown that the edge magneto-hydrodynamic stability is critical for handling the power to …

Learning Deep Architectures For Power Systems Operation And Analysis, Mahdi Khodayar

Electrical Engineering Theses and Dissertations

With the rapid increase in size and computational complexities of power systems, the need for powerful computational models to capture strong patterns from energy datasets is emerged. In this thesis, we provide a comprehensive review on recent advances in deep neural architectures that lead to significant improvements in classification and regression problems in the area of power engineering. Furthermore, we introduce our novel deep learning methodologies proposed for a large variety of applications in this area. First, we present the interval deep probabilistic modeling for wind speed forecasting. Incorporating the Rough Set Theory into deep neural networks, we create an …