Membrane Science Commons^™

Lipoprotein-Induced Increases In Cholesterol And 7-Ketocholesterol Result In Opposite Molecular-Scale Biophysical Effects On Membrane Structure, Manuela A.A. Ayee, Irena Levitan

Faculty Work Comprehensive List

Under hypercholesterolemic conditions, exposure of cells to lipoproteins results in a subtle membrane increase in the levels of cholesterol and 7-ketocholesterol, as compared to normal conditions. The effect of these physiologically relevant concentration increases on multicomponent bilayer membranes was investigated using coarse-grained molecular dynamics simulations. Significant changes in the structural and dynamic properties of the bilayer membranes resulted from these subtle increases in sterol levels, with both sterol species inducing decreases in the lateral area and inhibiting lateral diffusion to varying extents. Cholesterol and 7-ketocholesterol, however, exhibited opposite effects on lipid packing and orientation. The results from this study indicate …

Phase-Field Modeling Of The Polymer Membrane Formation Process For Micro- And Ultra-Filtration, Michael Rosario Cervellere

Graduate Theses and Dissertations

Porous polymer membrane filters are widely used in separation and filtration process. Micro- and ultra-filtration membranes are commonly used in biopharmaceutical applications such as filtering viruses and separating proteins from a carrier solution. The formation of these membrane filters via phase inversion is a complex and interconnected process where varying casting conditions can have a wide variety of effects on the final membrane morphol- ogy. Tailoring membrane filters for specific performance characteristics is a tedious and time consuming process. The time and length scales of membrane formation make it extremely difficult to experimentally observe membrane formation. Modeling the membrane formation …

Investigation Of Membrane Based Processes For Biomedical Applications, Efecan Pakkaner

Graduate Theses and Dissertations

As substantial developments were achieved in nanotechnology and polymer engineering, especially in the last few decades, the use of membranes and membrane-based procedures was found to be expanding into more and more research and development areas; including biological engineering, life sciences and biomedical engineering. Not only have they been the main focus of meaningful research, but they have also been the main pieces of the solutions to very thorny problems encountered within a wide range of applications from microfluidics to water treatment, thanks to their versatility, cost-effectiveness and biocompatibility, when compared to conventional separation techniques. To celebrate and embrace these …

Surface Modified Polypropylene Membranes For Treating Hydraulic Fracturing Produced Waters By Membrane Distillation, Tharaka Hawpe Gamage

Graduate Theses and Dissertations

Membrane distillation is an emerging technology for treating hydraulic fracturing flowback and produced waters. Suppression of membrane fouling by inorganic and polar and non-polar organic compounds is a challenge. Here polyhydroxyethyl methacrylate, polyacrylic acid, polvinylallyl imidazolium bromide and polyvinylhexyl imidazolium bromide chains have been grafted from the membrane surface. Fouling is initially due to adsorption of organic compounds followed by scale formation. When challenged with produced water, membranes modified with polvinylallyl imidazolium bromide chains provided the greatest resistance to fouling. For EC pretreated produced water and synthetic produced water that contained mainly inorganic species, the flux decline was much less.

Garver Industrial Design Project: Designing A Full-Scale Reverse Osmosis Water Treatment Facility For The City Of Lawton, Oklahoma, Kayliana Warden, Marlando Collins, Sandrina Depaz, Reid Eakin, Reed Leasure, Vera Rodriguez

Chemical Engineering Undergraduate Honors Theses

A groundwater treatment facility was designed for Lawton, Oklahoma to address potential water scarcity due to drought conditions in southwest Oklahoma. The facility will produce five million gallons per day (MGD) of treated water. The plant will have the capacity of treating 4,085 gallons per minute of influent water at an 86% recovery. The water to be treated will come from the Arbuckle-Timbered Hills Aquifer. Studies have been conducted around the aquifer to identify the best well site locations.

A centralized treatment facility using reverse osmosis filtration as the main treatment technology has been designed. To prevent reverse osmosis membrane …

High Temperature Polymer Electrolytes For Hydrogen Fuel Cells And Electrochemical Pumps, Gokul Venugopalan

LSU Doctoral Dissertations

Hydrogen fuel cell and separation technologies such as proton exchange membrane fuel cells (PEMFCs) and electrochemical hydrogen pump (ECHP) offer a profound advantage in the transition to a low-carbon economy. An imperative hitch in hydrogen fuel cells and ECHP technology has been the electrocatalyst poisoning by carbon monoxide (CO) and other contaminants in the reactant mixture. By operating, hydrogen fuel cells and ECHPs at high temperatures (>200 °C), the effect of CO adsorption on the electrocatalyst surface could be curtailed. The high-temperature operation of devices necessitates a proton exchange membrane (PEM) to operate under anhydrous conditions.

In this work, …

Abiotic Sensor For Electrochemical Determination Of Chlorpyrifos In Natural Water Based On The Inhibition Of Silver Nanoparticles Oxidation, Ziad Khalifa, Moustafa Zahran, Magdy Zahran, Magdi Abdelazzem

Chemical Engineering

Chlorpyrifos, organophosphorus pesticide, is a persistent organic pollutant that may cause serious health problems. Herein, a simple, green, and sensitive electrochemical inhibition sensor based on silver nanoparticles (AgNP)-modified glassy carbon (GC) electrode was developed for the determination of chlorpyrifos in natural water for the first time. The chemical reduction technique based on natural reducing and capping agents such as dissolved organic matter (DOM), natural latex (NL) and mucilage was employed for AgNP synthesis. DOM-AgNP, NL-AgNP, and Mucilage-AgNP were immobilized on GC by sticking technique under the same voltammetric and electrolytic conditions. The oxidation behavior of the three modified electrodes was …

Investigating The Performance Of Hydroponic Nutrient Solutions As Potential Draw Solutions For Fertilizer Drawn Forward Osmosis, Mohamed Bassiouny Abu Qersh

Theses and Dissertations

This research project aims at investigating the performance of hydroponic nutrient solutions as draw solutions for desalination using the fertilizer drawn forward osmosis (FDFO) process. Six different lettuce and leafy greens hydroponic nutrient stock solutions were prepared according to the literature and used in this study and tested on a bench-scale forward osmosis unit as draw solutions for the process. The feed solutions for the process was de-ionized water mixed with Sodium Chloride in different concentrations to represent different salinities of brackish groundwater. The draw efficiency of each solution was measured based on water flux, reverse solute flux, water recovery, …

Understanding Absorption, Supersaturation, And Drug Activity In Solution: Working Towards Developing A More Biorelevant Media, Freddy Arce

Theses and Dissertations--Pharmacy

With the looming dominance of poorly water-soluble chemical entities within the pharmaceutical pipeline, the pharmaceutical industry has leaned on the use of supersaturating drug delivery systems (SDDSs) to achieve efficacious concentrations within the gastrointestinal fluids. SDDSs aim to achieve concentrations in solutions greater than the solubility of the lowest energy crystalline form. However, the generation of supersaturated solutions of active pharmaceutical ingredients (APIs) creates a strong crystallization potential, which is undesirable.

In product development, supersaturating products often fail in Phase I and Phase II clinical trials due to poor oral bioavailability and a lack of in vivo efficacy. Pre-clinical testing …

Assessing The Impact Of Block-Selective Homopolymers On The Diffusion Of Payload Through Polymeric Organogels, Ian Coates

Honors Theses

Styrenic polymer gels have received recent attention for their application in transdermal patches due to their unique properties. Previous research in the pharmaceutical industry has identified that polymeric gels, specifically styrenic gels, have the potential to encompass multiple functions of the transdermal delivery patch including controlling mechanical and delivery properties. To tailor styrenic gels either the gel nanostructure or the drug complex can be controlled. Specifically, this thesis investigated the effect of gel nanostructure in an attempt to control the gel diffusivity and mechanical properties. To control gel nanostructure a phase selective styrene homopolymer was used at varying concentrations. It …

Wetting Transition On 3d-Printed Featured Surface, Hannah Pineault

Williams Honors College, Honors Research Projects

The primary objective of this research project was to gain a better understanding of surface characteristics to produce a long-lasting superhydrophobic or superhydrophilic surface. In other words, when will a droplet of water remain on top of a featured surface and when does the transition occur to water filling the grooves of the surface? This research focused on how to best fabricate porous structures that would stay completely dry at all times by preventing the liquid from penetrating. In particular, we followed the behaviors of water droplets placed on top of 3-D printed featured surfaces with various geometries and surface …

Simulation Of Water Loading In Filter Medium, Anthony Mole

Williams Honors College, Honors Research Projects

This research will model fluid flow through a filter plugged with water droplets using FlexPDE software. After simulations are run at various initial conditions, curves will be developed to correlate the permeability of the filter to variables like water droplet distribution and size.

Interactions Of Lignin Dimers With Engineered Surfaces And Model Cell Membranes For Design Of Lignin-Based Materials, Mahsa Moradipour

Theses and Dissertations--Chemical and Materials Engineering

Capitalizing on byproducts of industrial and agricultural economies is among the utmost goals of sustainability. Of particular interest for commercial upgrading is lignin, a phenolic biopolymer found in the cell walls of plants which is the second most abundant biopolymer on Earth after cellulose. Due to its heterogeneous structure, deconstructing lignin to selected small molecules for use as chemicals or advanced materials has been elusive. This work capitalizes on a “bottom up” approach to the synthesis of lignin oligomers of known bond chemistry to better understand their interfacial interactions.

The potential pharmacological mechanism of lignin deconstruction components and their toxicological …

The Effects Of Solution Condition On Virus Filtration Performance, Fnu Namila

Graduate Theses and Dissertations

Virus filtration is an integral part of the downstream purification of mammalian cell culture-derived biotherapeutics to assure the viral safety of the products. Virus filtration membranes remove viruses based on a size-exclusion mechanism. Commercial parvovirus filers possess unique membrane structure and are designed to remove smaller non-enveloped parvoviruses with size 18-26 nm. However, some filters face issues, such as pre-mature fouling, the decline of filtrate flux, and reduction in virus retention. This doctoral dissertation focused on identifying the factors that influence the filtrate flux and the virus retention capability of commercial virus filters. The effects of solution pH and ionic …

Investigation Of Electrospun Nanofibers For Separation Applications, Shu-Ting Chen

Graduate Theses and Dissertations

Electrospun membranes are an attractive alternative to flat sheet membranes as absorbent with numerous advantages like high porosity, large specific surface area and ease of functionalization. This doctoral dissertation focuses on fabricating novel polymeric membrane adsorbents for protein separations and ammonium ion removal. Three distinctly different preparation methods including UV-initiated polymerization, atom transfer radical polymerization, and mixed-matrix formation, have been employed to fabricate the electrospun membranes. Overall, this study aimed to develop electrospun membranes with excellent separation efficiency for application in protein purification and ammonium ion removal.

Chapter 2 details the stepwise development of weak anion exchange membranes and subsequent …

Optimizing Membrane Distillation With Solar Thermal Collectors, Andrew Mason, Ben Shulders, Siamak Nejati

UCARE: Research Products

With rising human populations, the demand for freshwater is an ever-growing problem. One emerging technology to combat this problem is membrane distillation (MD). MD has several advantages for water desalination including 100% rejection of solute (salt, heavy metals, etc.) and mergeability with other affordable energy sources (solar heat, electric resistance, etc.) However, at the moment the specific energy consumption (SEC) of MD is very high due to low water production rates and large energy inputs to heat water. In a solar‐assisted design for MD, the high cost of solar collectors (~$200/m2) inhibits the low cost of water production in comparison …

Alumina Ceramic Membrane Incorporated With Graphene Oxide Frameworks For Protein Recovery, Ishak Noor Fauziyah

Student Works (2020-2029)

Alumina ceramic membrane is undergoing rapid development and innovation for protein recovery process. However, the limitation of this membrane type is membrane fouling due to the deposition and adsorption of proteins on the surface and pore walls of the membranes. It is crucial to minimize membrane fouling by reducing interactions between protein and the membrane surface via surface modification technique. Thus, the main objective of this research is to develop an alumina membrane with enhanced antifouling property for protein recovery process. An alumina dope consisting of 57 wt.% alumina loading was used to fabricate two alumina membrane configurations; which are …

Nanohybrid Membrane Synthesis With Phosphorene Nanoparticles: A Study Of The Addition, Stability And Toxicity, Joyner Eke, Philip Alexander Mills, Jacob Ryan Page, Garrison P. Wright, Olga V. Tsyusko, Isabel C. Escobar

Center of Membrane Sciences Faculty Publications

Phosphorene is a promising candidate as a membrane material additive because of its inherent photocatalytic properties and electrical conductance which can help reduce fouling and improve membrane properties. The main objective of this study was to characterize structural and morphologic changes arising from the addition of phosphorene to polymeric membranes. Here, phosphorene was physically incorporated into a blend of polysulfone (PSf) and sulfonated poly ether ether ketone (SPEEK) doping solution. Protein and dye rejection studies were carried out to determine the permeability and selectivity of the membranes. Since loss of material additives during filtration processes is a challenge, the stability …

Probing Counterion Condensation Phenomena In Nanostructured Thin Film Block Copolymer And Random Copolymer Electrolytes, Qi Lei

LSU Doctoral Dissertations

This dissertation describes advanced metrology and molecular dynamics simulations for quantifying counterion condensation in block copolymer electrolyte thin films. The fraction of condensed counterions (f_c) were quantified in nanostructured block copolymer electrolyte (BCE) and random copolymer electrolyte (RCE) thin films with new and established experimental techniques. The transition between the osmotic-controlled regime and condensation-controlled regime in BCEs and RCEs was identified using solution uptake measurements via a quartz crystal microbalance (QCM) and environmental grazing incidence small-angle x-ray scattering (GI-SAXS). The activity coefficients of ions in thin film were quantified experimentally and these values matched predictions from Manning’s Theory …

Toxicant Disruption Of Immune Defenses Potential Implications For Fetal Membranes And Pregnancy, Sean M. Harris, Erica Boldenow, Steven E. Domino, Rita Loch-Caruso

University Faculty Publications and Creative Works

In addition to providing a physical compartment for gestation, the fetal membranes (FM) are an active immunological barrier that provides defense against pathogenic microorganisms that ascend the gravid reproductive tract. Pathogenic infection of the gestational tissues (FM and placenta) is a leading known cause of preterm birth (PTB). Some environmental toxicants decrease the capacity for organisms to mount an immune defense against pathogens. For example, the immunosuppressive effects of the widespread environmental contaminant trichloroethylene (TCE) are documented for lung infection with Streptococcus zooepidemicus. Group B Streptococcus (GBS; Streptococcus agalactiae) is a bacterial pathogen that is frequently found in the female …