Civil Engineering Commons^™

Fitness For Service (Ffs) And Fatigue Assessment For Shell Distorted Steel Storage Tank Based On Api 579-1/Asme Ffs-1, Wira Herucakra Sr. Structure Engineer, Luh Putri Adyani, Ic Farid Hadi Prasetyo, Alviani Rahma Rizkhita

Journal of Materials Exploration and Findings

A shell distortion was occurred due to incorrect in the welding procedure during construction of a new built above ground steel storage tank. The assessment level 1 then performed referred to original construction code of API Standard 650 was performed, the roundness data of tank plate was obtained through to laser scanning survey, and the result on assessment level 1 known that the minimum radius of measured point is exceeding the radius tolerance. This unacceptable condition of assessment level 1 requires to be performed the higher level of assessment. A fitness for service assessment level 3 for tank 1000 KL …

Development Of 485 Mpa Class High Strength Low Alloy Steel For Power Plant Infrastructures, Agung Baskoro, Rini Riastuti

Journal of Materials Exploration and Findings

Currently, Indonesia is progressing to build 35,000 MW of power plants, which will increase the demand for materials, especially steel. One of these power plants is fossil fuel-based, which generates not only electricity but also flue gas containing sulfur that may cause corrosion to power plant infrastructure such as chimney or boiler areas. In addition, apart from being resistant to corrosion in sulfuric and hydrochloric acid conditions, the steel used in power plant infrastructure must also have good strength, toughness, and weldability. Therefore, the present paper describes about steel development for power plant applications that has not only corrosion resistance …

Effect Of Waste Covid-19 Masks On Compaction Characteristics Of Silty-Clay Soil, Sydney K. Lawson

Honors College Theses

The present study aims to explore the effect of adding shredded waste Covid-19 masks to silty-clay soil on the soil’s compaction characteristics for beneficial use in embankment, the subgrade of roadways, or backfill. This was accomplished by using two different types of masks: blue surgical masks and KN95 masks. Both mask types were hand shredded into half-inch sections using safety-scissors. The maximum dry density (MDD) and optimum moisture content (OMC) are the two most important compaction characteristics, and they were determined by the Standard Proctor Compaction Test (ASTM D698 / AASHTO T99). The change of both the MDD and OMC …

Physical And Stochiometric Controls On Nutrient Uptake And Ecosystem Respiration In Contrasting Sites, Jancoba K. Dorley

Civil Engineering ETDs

Meteorological, hydrological, and biogeochemical processes naturally control stream ecosystems. These processes define the frequency and distribution of precipitation and the supply and demand of solutes and particles to support aquatic food chains through space and time. Studies have also found that stream ecosystems are also controlled by anthropogenic activities, which occur on a much shorter timescale. These anthropogenic activities affect stream ecosystems' structure and function from local to planetary changes to the environment. It is essential for scientists and engineers to understand the relationships between naturally occurring processes and those created by human activities for a better interpretation of stream …

Investigation Into The Effect Of Mixture Composition On Setting Time Of Magnesium Phosphate Cement, Autumn Broglen

Civil Engineering Undergraduate Honors Theses

Magnesium phosphate cement (MPC) is a cementitious material that is formed through an acid-base reaction between magnesia and phosphate. This reaction occurs rapidly, making MPC an appealing choice for rapid repair applications. The purpose of this project is to investigate the impact of different proportions of class F fly ash, set retarder consisting of a mixture of boric acid and dextrose, magnesium to phosphate ratio, and water/cement ratio on the initial setting time of MPC paste. Different mixtures of MPC paste were developed to vary the proportions of each constituent, and setting time of each mixture was determined using the …

Effect Of Swirl Ratio On Simulated Vortech Chamber Vortex Parameters, Samuel Kolar

Civil Engineering Undergraduate Honors Theses

A numerical simulator can use computational fluid dynamics (CFD) to model an experimental tornado-simulating chamber at Texas Tech University (known as VorTECH). Previous studies evaluating this particular CFD model have produced results that compare the touchdown swirl ratio (S_TD), core radius (r_c), maximum tangential velocity at touchdown (V_tmax @ S_TD), and height of the maximum tangential velocity (z_c) reasonably well with experimental data from the VorTECH facility. The effects of swirl ratio beyond S_TD on important vortex parameters including r_c, V_tmax, z …

Development And Evaluation Of An Arsenic Transport Model For The Maurice River Watershed, Christina Eddleman

All Theses

For many Superfund sites across the United States, arsenic is one of the most common contaminants of concern that must be cleaned up to protect human and environmental health. Past research and health studies have documented the harmful effects of inorganic arsenic on humans and the environment but selecting an appropriate remediation plan depends on several site-specific factors at each Superfund site. To assist in determining an appropriate remediation plan, sediment and contaminant transport models have been used to simulate the transport of arsenic and other contaminants of concern at contaminated sites to, e.g., make relative comparisons of the efficacy …

Analytical And Experimental Studies To Support Codification Of Lightweight Grout For Masonry Design, Cooper Banks

All Theses

Lightweight (LW) aggregates have many potential benefits in masonry construction including minimizing mass, improving thermal performance, and reducing the potential for shrinkage cracking via internal curing. The current masonry design standard, TMS 402/602-22, permits lightweight aggregate in the production of concrete masonry units (CMU), but there has been insufficient testing of masonry assemblies to permit designing with LW grout. Shrestha et al. characterized LW grouts bond to reinforcement, shear strength, tension and shear pullout behavior of anchors and proposed possible reduction factors for design. Hiner characterized the flexural bond strength LW grouted masonry assemblies and proposed possible reduction factors for …

Quantifying Hurricane Effects On Housing: Evaluating Damage, Loss, And Shelter Demands Using Historical And Simulated Storm Tracks, Adish Deep Shakya

All Theses

This research introduces an advanced framework which employs parametric wind field models for peak wind speeds, and building fragility curves, loss functions, and demographic data to estimate for estimating housing damage and loss. The uninhabitable units immediate displaced households, short-term and long-term shelter need households are determined. with a particular focus on those eligible for FEMA assistance. The framework's validity is reinforced by a high correlation in the analysis of recent hurricane events between estimated numbers of displaced households and actual FEMA aid recipients, where FEMA aids about 20-60% of the predicted long-term displaced households. A novel application of the …

Engineering Sustainable Bridge Deck Rehabilitation: Evaluating Mechanical And Electro-Chemical Properties Of Rapid-Set Patching Materials And Their Influence On Repair Durability, James Roberts

All Theses

As the state of the US infrastructure continues to deteriorate over time, a prominent issue especially in the field of reinforced concrete structures has been the ability to properly rehabilitate and extend the design service life of these structures. A majority of our existing reinforced concrete bridges were built in the construction boom during the 60’s, 70’s and 80’s, and were originally designed with a service life of approximately 50 years, thus showing that many structures are close to or have already exceeded their intended service life. Additionally, with a poor history of government infrastructure funding, it is seen to …

Building Services Engineering May/June 2024

Building Services Engineering

No abstract provided.

Detection Of Deficiencies And Data Analysis Of Bridge Members With Deep Convolutional Neural Networks, Bennett Jackson

Department of Civil and Environmental Engineering: Dissertations, Theses, and Student Research

Concrete cracks and structural steel corrosion are two of the most common defects in bridges. Quantifying and classifying these defects provide bridge inspectors and engineers with valuable data for assessing deterioration levels. However, the bridge inspection process is typically a subjective, time intensive, and tedious task, as defects can be overlooked or in locations not easily accessible. Previous studies have investigated deep learning-based inspection methods, implementing popular models such as Mask R-CNN and U-Net. The architectures of these models offer certain advantages depending on the required task. This thesis aims to evaluate and compare Mask R-CNN and U-Net regarding their …

Breakaway Luminaire Pole Research, Jacob Conway

Department of Civil and Environmental Engineering: Dissertations, Theses, and Student Research

This document reports the efforts conducted to determine critical parameters and configurations for Manual for Assessing Safety Hardware 2016 (MASH) Test Level 3 (TL-3) compliant breakaway luminaire poles supported by slip bases, including identifying pole configurations with the potential to meet MASH TL-3 as well as recommending critical configurations for full-scale crash testing. A thorough literature review was conducted which included survey results collected from Midwest Pooled Fund state departments of transportation (DOTs), standard plans from state DOT’s, and past luminaire pole testing.

Numerical LS-DYNA models were developed for luminaire poles with 4-bolt slip base utilized by the Utah Department …

Using Genetic Algorithm And Geographic Information System For Equity-Driven Transportation Planning And Analysis, Emiliano Del Rio Reyes

Open Access Theses & Dissertations

Efforts to address equitable access in public transit planning have gained momentum, spurred by incentives for Metropolitan Planning Organizations (MPOs) and State Departments of Transportation (DOTs). However, traditional strategies often fall short of meeting the needs of disadvantaged communities, particularly in underserved areas. This study presents a pioneering methodology leveraging Genetic Algorithms (GA) and Geographic Information Systems (GIS) to optimize bus stop placement, aiming to enhance equitable access in public transit systems. Focusing on Route 16 of Sun Metro in El Paso, Texasâ??a critical feeder route linking the Westside Transit Center to Upper Valley neighborhoodsâ??the research commences with a comprehensive …

Routing Opportunities For Commercial Crossings Between El Paso And Juarez, Marek Musil

Open Access Theses & Dissertations

This thesis explores the topic of commercial movements between the El Paso and Ciudad Juarez road networks and the implications of the possible changes in their routing. This area houses several ports of entry, which present one of the busiest commercial and personal border crossings in the whole nation. The primary focus was to evaluate the recently proposed reconstruction scenario of removing trucks from the Bridge of the Americas and study the impacts on the flows throughout the other ports. The chosen tool to support the analysis is a mesoscopic simulation software called DynusT, which is capable of modeling the …

Smart Public Transportation And Mobility Hub Design In El Paso, Jiri Vojtisek

Open Access Theses & Dissertations

This thesis explores the potential of a Smart Public Transportation concept and mobility hub design as tools to mitigate the growing trend of transportation issues, such as traffic congestion, reliance on privately owned vehicles, or unattractive public transportation. Consequently, residentsâ?? lives are negatively affected by excessive noise, air pollution, and travel delays, leading to increased safety risks, lost productivity, and a lower quality of life. Considering these challenges, the study begins by analyzing the current state of public transportation in El Paso. Next, it introduces a toolkit from the Smart City concept, followed by case studies of best practices of …

Hydrological Model Of The Diyala River Watershed In Iraq Using Soil Water Assessment Tool, Ahmed Sagban Khudier, Ahmed Naseh Ahmed Hamdan

Al-Bahir Journal for Engineering and Pure Sciences

The motivation of the present study is to study and address the limitations imposed on hydrological models and the spatial and temporal distribution of streamflow in the Watershed Diyala River (WDR) from January 1996 to April 2023, which has an area of 25652 km2, which is considered an important source of water for central and southern Iraq, to enable decision-makers to make a future management plan for streamflow. To achieve this motivation, the SWAT model was used and fed by input data such as a Digital elevation model with a 30 m resolution, a soil map, the land use and …

A Review Of Electrically Conductive Cement Concrete Pavement For Sustainable Snow-Removal And Deicing: Road Safety In Cold Regions, Mohammad Anis, Mohamed Abdel-Raheem

Civil Engineering Faculty Publications and Presentations

Within cold U.S. regions, winter storms can cause interruptions in transportation networks, affecting transportation entities’ revenue streams. Conventional snow-removal methods on roadways efficiently remove snow and ice, yet their adverse environmental impacts further make winter maintenance more challenging. In response to these concerns, electrically conductive cement concrete (ECCC) pavement has become an effective alternative for deicing and snow melting on road surfaces. ECCC utilizes the Joule heating principles to effectively melt snow and ice by incorporating conductive elements into conventional concrete. This paper comprehensively reviews the current literature on ECCC pavement. Previous studies have diligently explored various aspects of ECCC …

Adventure Course - Hocking Hills Retreat Center, Donavan Yelle, Valerie Froylan, Nathaniel Nargang, Samantha Paterson

Scholar Week 2016 - present

Hocking Hills Retreat Center located in Logan, Ohio tasked a senior engineering design group with the creation of a high and low ropes adventure course. The goal of this course is to increase the number of visitors to the retreat center. The course was designed to feature a kid’s area; a teamwork section; and beginner, intermediate, and expert courses. All course elements range from ten to thirty feet in elevation to allow for a variety of difficulty levels. The course has been modeled using both AutoCAD and Revit software. Additionally, structural analysis was performed to ensure the safety and strength …

Aisc Structural Steel Bridge Competition, Isaac Baker, Michael Byrne, Andrew Coble, Holden Devore

Scholar Week 2016 - present

The American Institute of Steel Construction (AISC) hosts an annual competition in which students compete to design and fabricate a structural steel bridge. This year, four senior civil engineering majors are representing Olivet Nazarene University (ONU) to fulfill their capstone project requirement for the engineering department. The purpose of this project is to develop relationships between students and professionals while acquiring critical thinking skills. Through sponsor engagement, ONU’s team has developed a 3 ft-wide bridge that spans 20 ft and successfully holds up to 2,500 lbs of live load and 50 lbs of lateral load. The steel bridge is fabricated …