Materials Chemistry Commons^™

Applications Of Ellipsometry In The Investigations Of Electrode-Solution Interface, Jing-Lei Lei, Liang-Liu Wu, Ling-Jie Li, Sheng-Mao Wu, Sheng-Tao Zhang

Journal of Electrochemistry

Ellipsometry is an optical technique with high-sensitivity to quantitatively obtain surface/interface properties such as thickness andrefractive index by analyzing the changes in polarized light reflected from the surface/interface. Its noncontacting and nondestructivenature makes it possible to acquire thein situreal-time information of the change at the surface/interface. Therefore, ellipsometry has been used widely in the electrochemical investigations. In this paper, based on the brief introduction of the measurementprinciple of ellipsometry, the current progress and the future trends of ellipsometry in electrochemistry arediscussed. The applications of ellipsometry in the fields of conversion and storage of electrochemical energy, electrochemistry ofmaterials science,electroanalysisand bioelectrochemistry are …

Oxygen Reduction Reaction On Glycin Modified Pt(111) Electrode, Ming-Fang Li, Jing Kang, Ling-Wen Liao, Yan-Xia Chen, Shen Ye

Journal of Electrochemistry

O

xygen reduction reaction (ORR) on glycin (NH₂CH₂COOH) modified Pt(111) electrode has been investigated using hanging meniscus rotating disk electrode system (HMRD) in 0.05 mol•L^-1 H₂SO₄ and 0.1 mol•L^-1 HClO₄ solutions, respectively. Cyclic voltammograms of the glycin modified Pt (111) electrode measured in 0.05 mol•L^-1 H₂SO₄ solution similar to that of CN^- modified Pt(111) electrodes, demonstrating that sulfate adsorption is strongly inhibited at the glycin modified Pt(111). From the polarization curve of ORR recorded in 0.05 mol•L^-1 H₂SO₄ solution, it is …

Porous Electrodes With High Pt Utilization Obtained By Ion-Exchange/Electrodeposition, Si-Guo Chen, Wei Ding, Xue-Qiang Qi, Li Li, Zi-Hua Deng, Zi-Dong Wei

Journal of Electrochemistry

We report a novel method based on ion-exchange/electrodeposition (IEE) for constructing high Pt utilization porous electrodes. The electrode prepared using IEE was assessed by linear sweep voltammetry (LSV), scanning electron microscopy (SEM), transmission electron microscopy (TEM) and single cell test. The preliminary results show that the undesired ion-exchange between Pt anion and surface functional group in carbon black can be eliminated through the electrode preparation process, and every Pt particle prepared by IEE is expected to be deposited on the three-phase reaction zone and thus can be fully utilized in fuel cell reactions. The Pt particle size, shape and distribution …

Effect Of Ti/Pbo2 Electrodes Doped With Different Elements On Electrocatalytic Oxidation Characteristics Of Phenol, Xiao-Lei Liu, Yuan-Yuan Dan, Hai-Yan Lu, Hai-Bo Lin, Ming-Li Ouyang, Chuan-Jun Yun

Journal of Electrochemistry

Three types of electrodes, namely, Ti/PbO₂, F-doped PbO₂ (Ti/PbO₂-F) and nano-Co₃O₄-doped PbO₂ (Ti/PbO₂+Nano-Co₃O₄) electrodes, were prepared by electro-deposition method on the Ti substrate with the interlayer of SnO₂-Sb₂O₅. X-ray diffraction (XRD) and scanning electron microscopy (SEM) were used to study the compositions, structures and film morphologies of the electrodes. Electrocatalytic oxidation characteristics to phenol on the prepared electrodes were investigated by electrochemical method. The experimental results showed that compared with the Ti/PbO₂ electrode, the potentials of oxygen …

A Dft Calculation Screening Of Pt-Based Bimetallic Catalysts For Oxygen Reduction, Li-Hui Ou, Sheng-Li Chen

Journal of Electrochemistry

Developing Pt-lean catalysts for oxygen reduction reaction (ORR) is the key for large-scale application of proton exchange membrane fuel cell (PEMFC). In this paper, we have proposed a multiple-descriptor strategy for screening efficient and durable ORR alloy catalysts of low Pt content. We argue that an ideal Pt-based bimetallic alloy catalyst for ORR should possess simultaneously negative alloy formation energy, negative surface segregation energy of Pt and a lower oxygen binding ability than pure Pt. By performing detailed DFT calculations on the thermodynamics, surface chemistry and electronic properties of various Pt-M alloys (M refers to non-precious transition metals in the …

Sodium Carbonate Catalyzed Photoelectrochemical Water Splitting Over Tio2 Nanotubes Photoanode, De-Sheng Kong, Jing Wang, Xue-Di Zhang, Xi Zhao, Chao Wang, Yuan-Yuan Feng, Wen-Juan Li

Journal of Electrochemistry

Surface recombination of the photogenerated electron-hole pairs at semiconductor/electrolyte interface is one of the most essential reasons responsible for lowering photoconversion efficiency (Φ) of light to chemical energy for photoelectrochemical (PEC) water splitting reaction. In this paper, the catalytic effect of sodium carbonate on the oxygen evolution reaction (OER) over TiO₂ nanotubes photoanode during PEC water splitting was investigated by performing photocurrent and ac impedance measurements. It was demonstrated that the addiction of 1 mmol•L^-1 Na₂CO₃ in 0.5 mol•L^-1 NaClO₄ electrolyte can effectively improve the charge transfer properties for the photogenerated holes across …

Piezoelectric Microfiber Composite Actuators For Morphing Wings, Timothy Usher, Kenneth R. Ulibarri, Gilberto S. Camargo

Physics Faculty Publications

Morphing wing technologies provide expanded functionality in piloted and robotic aircraft, extending particular vehicle mission parameters as well as increasing the role of aviation in both military and civilian applications. However, realizing control surfaces that do not void the benefits of morphing wings presents challenges that can be addressed with microfiber composite actuators (MFCs). We present two approaches for realizing control surfaces. In one approach, flap-like structures are formed by bonding MFCs to each side of a metal substrate. In the other approach, MFCs are bonded directly to the wing. Counter intuitively, the flap approach resulted in larger voltage actuation …

Metastable Nanostructured Metallized Fluoropolymer Composites For Energetics, Hannah A. Miller, Bradley S. Kusel, Seth T. Danielson, James W. Neat, Eryn K. Avjian, Scott N. Pierson, Stephen M. Budy, David W. Ball, Scott T. Iacono, Sharon C. Kettwich

Chemistry Faculty Publications

Fluoropolymers have long served as potent oxidizers for metal-based pyrolant designs for the preparation of energetic materials. Commercial perfluoropolyethers (PFPEs), specifically known as Fomblins®, are well-known to undergo accelerated thermal degradation in the presence of native metals and Lewis acids producing energetically favorable metal fluoride species. This study employs the use of PFPEs to coat nano-aluminum (n-Al) and under optimized stoichiometric formulations, harness optimized energy output. The PFPEs serve as ideal oxidizers of n-Al because they are non-volatile, viscous liquids that coat the particles thereby maximizing surface interactions. The n-Al/PFPE blended combination is required to interface with an epoxy-based matrix …

Excitation Of Radiative Polaritons By Polarized Broadband Infrared Radiation In Thin Oxide Films Deposited By Atomic Layer Deposition, Anita J. Vincent-Johnson, Andrew E. Masters, Xiaofeng Hu, Giovanna Scarel

Department of Physics and Astronomy - Faculty Scholarship

This work contributes to the understanding of infrared radiation interaction with matter and its absorption for energy harvesting purposes. By exciting radiative polaritons in thin oxide filmswith polarized infrared radiation, a further evidence is collected that a link exists between radiative polaritons and the heat recovery mechanism hypothesized in previous research. In the voltage transient occurring when the infrared radiation is turned on, the observed time necessary to reach the maximum voltage and the voltage intensity versus angle of incidence exhibit a mismatch when generated by polarized and nonpolarized infrared radiation. The existence of collective charge oscillation modes in the …

Diffusion Of Vitamin B12 Across A Mesoporous Metal Organic Framework, Veronica Valencia

Undergraduate Journal of Mathematical Modeling: One + Two

We measure the rate of uptake and the rate of release of a Vitamin B12 solution (dissolved in water) at 2 different temperatures (room temperature and 37°C) by the mesoporous metal organic framework TbMOF-100 at 1-hour intervals using a spectrophotometer. Using the Beer-Lambert law, we calculate the concentration of the stock solution based on the absorbance values obtained with the spectrophotometer. These values allow for the quantification of the initial rate of uptake and the rate of uptake at a random incubation time of the Vitamin B12 by the TbMOF-100. We also calculate the value of the coefficient of diffusion …

Polymers And Cement?, Randee Newsom

Natural Sciences Student Research Presentations

Identifies the improvements made to modern cement by adding polymers. This is a project for the Natural Sciences Poster Session at Parkland College.

Multi-Dimentional Use Of Mri For Optimizing Reactions In Industries, Vyanti Sagram

Natural Sciences Student Research Presentations

MRI Imaging has been used for many years and in a wide variety of industries. Recently. another application of MRI has been discovered by chemists. This research in MRI, a major step toward bridging the gap between laboratory studies and industrial catalysts, could help improve the design and environmental impact of catalytic reactors. This is a project for the Natural Sciences Poster Session at Parkland College.

Preparation Of Phosphonoterephthalic Acids Via Palladium-Catalyzed Coupling Of Aromatic Iodoesters, Nathaniel Ivan, Vladimir Benin, Alexander Morgan

Chemistry Faculty Publications

The current article reports in detail the preparation of two phosphonoterephthalic acids: 2-phosphonoterephthalic acid (1) and 2,5-diphosphonoterephthalic acid (2). Efficient, scalable syntheses have been developed for both compounds based on Pd-catalyzed coupling reactions of iodinated terephthalate esters. Phosphonoterephthalic acids are potentially useful as flame-retardant additives or as monomers for the construction of acid-pendant polymer chains.

A Highly Efficient Tio2-Xcx Nano-Heterojunction Photocatalyst For Visible-Light Induced Antibacterial Applications, Vinodkumar Etacheri, Michael Seery, Stephen Hinder, Georg Michlits, Suresh Pillai

Articles

Visible-light-induced antibacterial activity of carbon-doped anatase-brookite titania nano-heterojunction photocatalysts are reported for the first time. These heterostructures were prepared using a novel low temperature (100 °C) non-hydrothermal low power microwave (300 W) assisted method. Formation of interband C 2p states was found to be responsible for the band gap narrowing of the carbon doped heterojunctions. The most active photocatalyst obtained after 60 minutes of microwave irradiation exhibits a 2-fold higher visible-light induced photocatalytic activity in contrast to the standard commercial photocatalyst Evonik-Degussa P-25. Staphylococcus aureus inactivation rate constant for carbon-doped nano-heterojunctions and the standard photocatalyst was 0.0023 and -0.0081 min …

Effects Of Retarder On Cement, Reuben James

A with Honors Projects

Applying chemical analysis gained from taking a chemistry class, the author reflects on his summer employment at a chemical plant where he tested the effect of tartaric acid had on one of the company's products, Redline Speed Crete.

The Mechanism Of Photo-Hydrosilylation On Silicon And Porous Silicon Surfaces, Kurt W. Kolasinski

Chemistry Faculty Publications

No abstract provided.

Reaction Between Polyol-Esters And Phosphate Esters In The Presence Of Metal Carbides, David W. Johnson, Carolyn Iacullo, John E. Hils

Chemistry Faculty Publications

The reaction of metal carbides with polyol esters found in aerospace lubricants and phosphate esters commonly used as additives was investigated. Carbides were of particular interest since modern materials under consideration at high temperature bearings have surfaces that are primarily metal carbides. Vanadium and chromium carbide were found to react with the ester and phosphate ester by a transesterification reaction, producing an alkyl phosphate which is less stable than the aromatic phosphate esters. In the process, the metal carbide is converted to the metal phosphate and metal polyphosphate, evidenced by the infrared and Raman spectra of the solid residue and …

Synthesis And Modification Of Octafluoro[2.2]Paracyclophane (Parylene Af4), Craig Hicks, Brendan Duffy, Gráinne Hargaden

Articles

Parylenes are a class of organic compounds which have gained significant attention due to their application as coatings in areas such as medical devices and electronics. This review highlights the development of synthetic pathways to Octafluoro[2.2]Paracyclophane, commonly referred to as parylene AF4. Methods which have been used to functionalise AF4 are also presented.

Optimization Of The Optical And Electrochemical Properties Of Donor-Acceptor Copolymers Through Functional Group And Side Chain Modification, Mark J. Seger

Theses and Dissertations--Chemistry

Donor-acceptor copolymers have received a great deal of attention for application as organic semiconductors, in particular as the active layers in low-cost consumer electronics. The functional groups grafted to the polymer backbones generally dictate the molecular orbital energies of the final materials as well as aid in self-assembly. Additionally, the side chains attached to these functional groups not only dictate the solubility of the final materials, but also their morphological characteristics. The bulk of the research presented in this dissertation focuses on the synthesis and structure-property relationships of polymers containing novel acceptor motifs. Chapter 2 focuses on the synthesis of …

Properties And Structures Of Li-N Based Hydrogen Storage Materials, Junqing Zhang

Dissertations, Master's Theses and Master's Reports - Open

Traditional transportation fuel, petroleum, is limited and nonrenewable, and it also causes pollutions. Hydrogen is considered one of the best alternative fuels for transportation. The key issue for using hydrogen as fuel for transportation is hydrogen storage. Lithium nitride (Li3N) is an important material which can be used for hydrogen storage. The decompositions of lithium amide (LiNH2) and lithium imide (Li2NH) are important steps for hydrogen storage in Li3N. The effect of anions (e.g. Cl-) on the decomposition of LiNH2 has never been studied. Li3N can react with LiBr to form lithium nitride bromide Li13N4Br which has been proposed as …