Power and Energy Commons^™

Performance Of The Electro-Oxidation And Electro-Fenton Processes With A Bdd Anode For The Treatment Of Low Contents Of Pharmaceuticals In A Real Water Matrix, Sirs Ignasi, Antonio Garrido Jos, Brillas Enric

Journal of Electrochemistry

Here, we report the performance of electro-oxidation and electro-Fenton with a boron-doped diamond (BDD) anode for the treatment of single and multicomponent solutions containing small amounts of pharmaceutical residues (i.e., 1 mg·L^-1 paracetamol and/or 1 mg·L^-1 salicylic acid) spiked into a real water matrix at pH 3.0. Electro-oxidation was performed in a BDD/Pt cell, whereas electro-Fenton was carried out in a BDD/air-diffusion cell to electrogenerate H₂O₂ at the cathode, always operating at constant current density. It was found that the decay of both pharmaceuticals by electro-oxidation was more rapid in the real water matrix than …

Rooftop Pv Impacts On Fossil Fuel Electricity Generation And Co2 Emissions In The Pacific Northwest, Daniel Albert Weiland

Dissertations and Theses

This thesis estimates the impacts of rooftop photovoltaic (PV) capacity on electricity generation and CO2 emissions in America's Pacific Northwest. The region's demand for electricity is increasing at the same time that it is attempting to reduce its greenhouse gas emissions. The electricity generated by rooftop PV capacity is expected to displace electricity from fossil fueled electricity generators and reduce CO2 emissions, but when and how much? And how can this region maximize and focus the impacts of additional rooftop PV capacity on CO2 emissions? To answer these questions, an hourly urban rooftop PV generation profile for 2009 was created …

Solar Energy Used On Board The Ship And Responding Administration Countermeasures, Xiaoping Zhu

Maritime Safety & Environment Management Dissertations (Dalian)

No abstract provided.

Identification Of Markov Processes Within A Wind Turbine Array Boundary Layer, Matthew Scott Melius

Dissertations and Theses

The Markovianity within a wind turbine array boundary layer is explored for data taken in a wind tunnel containing a model wind turbine array. A stochastic analysis of the data is carried out using Markov chain theory. The data were obtained via hot-wire anemometry thus providing point velocity statistics. The theory of Markovian processes is applied to obtain a statistical description of longitudinal velocity increments inside the turbine wake using conditional probability density functions. It is found that two and three point conditional probability density functions are similar for scale differences larger than the Taylor micro-scale. This result is quantified …

Biofuel From Microalgae – A Review On The Current Status And Future Trends, Rajee Olaganathan, May Zaw Htet, Lim Yan Ling, Sek Hui Yun

Publications

The constant reliance on fossil fuel energy resources is unsustainable, due to both depleting world reserves and increasing green house gas emissions associated with their use and thus there are dynamic research at the global level envisioned at developing alternative renewable and potentially carbon neutral solid, liquid and gaseous biofuels as alternative energy resources. The contemporary knowledge and technology predictions have proved that among the third generation biofuels especially those derived from microalgae are considered the best reasonable alternative energy resource compared to undeniable drawbacks of first and second generation biofuels. Moreover, its efficiency to sequester carbon from the atmosphere …

Electrical Design Considerations And Packaging Of Power Electronic Modules, Shijie Wang

Graduate Theses and Dissertations

A modern power electronic module can save significant energy usage in the power electronic systems by improving their switching efficiencies. One way to improve the efficiency of the power electronic module is to reduce its parasitic circuit elements. The purpose of this thesis is to investigate the mitigation of parasitic circuit elements in power electronic modules. General methods of mitigating parasitic inductances were analyzed by the Q3D Extractor and verified by the time-domain reflectometry (TDR) measurements. In most cases, the TDR measurement results closely matched those predicted by the Q3D Extractor. These methods were applied to design and analyze a …

Resource-Induced Voltage Flicker For Wave Energy Converters – Assessment Tools, Fergus Sharkey, Joe Macenri, Elva Bannon, Michael Conlon, Kevin Gaughan

Articles

For wave energy converters, the input resource has a typical period of 5–20 s depending on the site location and dominant seastates. Wave energy converters generally produce mechanical power twice per wave cycle and therefore depending on the storage available, the electrical power output has half the period of the input resource. These regular power changes induce a voltage change at the point of connection (POC) which is proportional to the amplitude of the power change and at the same frequency. Therefore the coupling of the input resource to the output power of a wave energy converter will cause voltage …

System Design Considerations And The Feasibility Of Passively Compensated, Permanent Magnet, Iron-Core Compulsators To Power Small Railgun Platforms, Collin Taylor Macgregor

Master's Theses

This thesis provides insight into the different aspects of compulsator design for use with railgun systems. Specifically, the design space is explored for passively compensated, permanent magnet iron-core compulsators. Seven design parameters are varied within a compulsator model developed for the Cal Poly Compulsator (CPCPA). The Matlab code for this model is included within the appendix. Efforts were made to compare and validate this compulsator model to published data from existing systems. The compulsator model was found to match closely with discharge pulse length, but resulted in lower values for peak current and projectile velocity by 50% and 30% respectively …

2-Dimensional Personal Motion Energy Harvester For Low Power Electronics, Manuel Gutierrez, Sean Scott, Dimitrios Peroulis

The Summer Undergraduate Research Fellowship (SURF) Symposium

In a lab, it becomes crucial to have a way to monitor that lab workers aren’t exposed to too much radiation. Such a device that detects this should have an energy harvester so that batteries aren’t required. The need for an energy harvester that generates power from a user’s movements in 2 dimensions is needed. This energy harvester is needed to power a radiation monitor. An energy harvester that generates power based off movements in 2 dimensions was developed. The energy harvester was created through a series of prototypes. Each prototype was built from a CAD drawing and a stereolithography …

Solar Data Analysis, Mike C. T. Ray

Dissertations and Theses

The solar industry has grown considerably in the last few years. This larger scale has introduced more problems as well as possibilities. One of those possibilities is analyzing the data coming from the sites that are now being monitored, and using the information to answer a variety of questions.

We have four questions which are of prime importance identified in this thesis:

1. Can data from customers be trusted?

2. Can we use data from existing sites to determine which sites need the most improvement?

3. Can we implement a location-based algorithm to reduce the amount of false positives for …

Quantum Circuit Synthesis Using Group Decomposition And Hilbert Spaces, Michael S. Saraivanov

Dissertations and Theses

The exponential nature of Moore's law has inadvertently created huge data storage complexes that are scattered around the world. Data elements are continuously being searched, processed, erased, combined and transferred to other storage units without much regard to power consumption. The need for faster searches and power efficient data processing is becoming a fundamental requirement. Quantum computing may offer an elegant solution to speed and power through the utilization of the natural laws of quantum mechanics. Therefore, minimal cost quantum circuit implementation methodologies are greatly desired.

This thesis explores the decomposition of group functions and the Walsh spectrum for implementing …

Improving The Efficiency Of P3ht:Icba Organic Solar Cells By Modifying The Photoactive Solution Preparation Step, Matthew Blaine Samson

Electrical & Computer Engineering Theses & Dissertations

Organic solar cells (OSCs) are a promising alternative to conventional silicon solar cells. These organic devices offer the promise of facile low cost large scale solution based processing on lightweight, flexible, plastic substrates. At the present state of the technology, however, OSCs exhibit relatively low power conversion efficiencies. To improve these efficiencies, new materials are constantly being developed.

One such material is the fullerene indene-C₆₀ bisadduct (ICBA). When implemented in a poly(3-hexylthiophene-2, 5-diyl) (P3HT) : ICBA bulk heterojunction solar cell, these devices exhibit open circuit voltages exceeding 0.8 V, a value much higher than the devices made implementing phenyl-C …

Heating Effects Through Harmonic Distortion On Electric Cables In The Built Environment, Kevin O'Connell

Doctoral

Under ideal circumstances, electric power supply voltage and current waveforms should be sinusoidal. However, this is very seldom the case in the built environment, due to the proliferation of non-linear loads. Examples of non-linear loads are those containing switched mode power supplies, reactors and electronic rectifiers/inverters. Common devices such as personal computers, fluorescent lighting, electric motors, variable speed drives, transformers and reactors and virtually all other electronic equipment are examples of non-linear loads. Non-linear loads are the norm in the built environment rather than the exception. Such loads produce complex current and voltage waves and simple spectral analysis of these …

Simulation Of Power Control Of A Wind Turbine Permanent Magnet Synchronous Generator System, Nantao Huang

Master's Theses (2009 -)

This thesis presents a control system for a 2MW direct-drive permanent magnet synchronous generator wind turbine system with the objectives to capture the optimal power from the wind and ensure a maximum efficiency for this system. Moreover, in order to eliminate the electrical speed sensor mounted on the rotor shaft of the PMSG to reduce the system hardware complexity and improve the reliability of the system, a sliding mode observer based PM rotor position and speed sensorless control algorithm is presented here.

The mathematical models for the wind turbine and the permanent magnet synchronous machine are first given in this …

Optimization Of Solar Cell Arrays Using The Fibonacci Search Algorithm, Felicia Tyyan Farrow

Electrical & Computer Engineering Theses & Dissertations

In our energy hungry world, there is a growing demand to develop creative mechanisms to extract, conserve, and use energy from different resources. The use of solar cells to extract and convert solar energy into electrical energy is a growing and popular field of study because solar energy is clean, free, and renewable. One limitation for photovoltaic (PU) or solar technology is its loss in efficiency and availability as a result of shading or partial shading. Shading or partial shading decreases the total capable output power that the PV system can produce because the array is receiving irradiation from the …

Effect Of Ethyl Propionate On Low-Temperature Performance Of Lifepo4-Based Li-Ion Battery, Xiao-Ping Li, Lian-Sheng Hao, Wei-Shan Li, Meng-Qing Xu, Li-Dan Xing

Journal of Electrochemistry

A linear carboxylic, ester ethyl propionate (EP), was used as the co-solvent of carbonates, ethylene carbonate (EC), ethyl-methyl carbonate (EMC) and dimethyl carbonate (DMC), and its effect on low-temperature performance of LiFePO₄-based Li-ion battery was studied by cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS) and galvanostatic charge-discharge test. The application of EP enhances the ionic conductivity of the electrolyte, improves the compatibility of the electrolyte with both LiFePO₄ and graphite materials, and thus improves the low-temperature performance of LiFePO₄-based Li-ion battery. The Li-ion battery using the optimized electrolyte of 1 mol·L^-1 LiPF₆/EC:EMC:DMC:EP …

Multifunctional Corrosion Inhibition Behavior Of Zn-Al Calcined Layered Double Hydroxides For Steel Rebar In Nacl Solution, Xiao-Juan Zhang, Jing-Jing Wang, Shi-Gang Dong, Chang-Jian Lin

Journal of Electrochemistry

The Zn-Al layered double hydroxides (Zn-Al LDHs) and calcined products (Zn-Al CLDHs) were synthesized successfully under a routine air atmosphere. The results showed that both Zn-Al LDHs and Zn-Al CLDHs had obvious flake structures. The corrosion inhibition of Zn-Al CLDHs for steel rebar in NaCl solution was studied by electrochemical techniques. It was found that the corrosion rate of steel rebar decreased significantly after the steel rebar was treated by Zn-Al CLDHs in NaCl solution for 3 h. It was indicated that Zn-Al CLDHs could absorb Cl^- and release OH^- during their reconstruction process, which provided dual protection …

Influences Of The Cinnamic Acid On Zinc Electrodeposition At Glassy-Carbon Electrode, Kai Li, Shen Chen, Shen-Na Liu, Bi-Sang Chen, Heng Lin, Guo-Liang Chen, Qing-Xiang Wang

Journal of Electrochemistry

The influences of cinnamic acid (CIN) on the mechanism of Zn deposition and nucleation kinetics onto glassy-carbon electrode were studied by cyclic voltammetry (CV) and chronoamperometry (CA). The results revealed that the zinc reduction took place via Zn²⁺ + 2e → Zn in the presence of CIN, but the kinetics of zinc deposition was changed and the formation rate of zinc nuclei was accelerated. In the absence of CIN, the mechanism of zinc nucleation followed the 3D-instantaneous diffusion-controlled nucleation, while the 3D-progressive diffusion-controlled nucleation in the presence of CIN. The addition of CIN reduced the nucleation rate, but increased …

Preparation And Characterization Of A Novel Composite Electrolyte Ceria-Sulfate For Intermediate Temperature Solid Oxide Fuel Cells, Ze Tong, Yi-Mei Yin, Jie-Wei Yin, Zi-Feng Ma

Journal of Electrochemistry

A novel composite electrolyte SDC-(Li/Na)₂SO₄ was prepared for intermediate temperature solid oxide fuel cells (ITSOFC). The phase structure and cross-sectional morphology were examined by XRD and SEM, respectively, and the ionic conductivity was investigated by AC impedance in a temperature range of 400 ^oC ~ 700 ^oC in air. It was found that the composite electrolyte was composed of two phases: crystal SDC and amorphous (Li/Na)₂SO₄. The conductivity of the composite electrolyte was significantly larger than that of SDC at intermediate temperatures (550 ^oC ~ 700 ^oC) and increased …

Preparation And Electrochemical Performance Of Hollow Carbon Spheres/Sulfur Composite, Jun Zang, Hang Qian, Er-Man Zeng, Juan-Ni Fu, Ming-Sen Zheng, Quan-Feng Dong

Journal of Electrochemistry

Hollow carbon spheres were prepared by the PMMA template. Hollow carbon spheres/sulfur composite was made from sulfur and hollow carbon spheres as a conducting framework. The results of SEM and TEM showed that sulfur was uniformly filled in both of the shell and hollow core of hollow carbon spheres. The electrochemical performance of hollow carbon spheres/sulfur composite was characterized by the charge/discharge method. The results showed the excellent rate and cycle performance of hollow carbon spheres/sulfur composite. The reversible capacities of hollow carbon spheres/sulfur composite are 1145 mAh·g^-1, 824 mAh·g^-1, 702 mAh·g^-1, 586 mAh·g …