Electrical and Computer Engineering Commons^™

Characterization Of An Inductively Coupled Plasma Produced In Argon At 13.56 Mhz., Lim Ai Nuan

Student Works (2010-2019)

The electrical and plasma characteristics of radio frequency (13.56 MHz) inductively coupled argon plasma (RF ICP) were studied in this project. On the electrical breakdown properties, the breakdown voltage has a general appearance of Paschen’s curve and the minimum is achieved at 0.1 mbar. After ignition, two modes of discharge exist, namely, the E mode at low RF power and H mode at high RF power. Mode transition that occurs is accompanied by abrupt changes in both electrical and plasma characteristics. Hysteresis is observed in the mode transitions and has a minimum at 0.1 mbar. The resistance reflected into the …

Performance Analysis Of Srcp Image Based Sound Source Detection Algorithms, Praveen Reddy Nalavolu

University of Kentucky Master's Theses

Steered Response Power based algorithms are widely used for finding sound source location using microphone array systems. SRCP-PHAT is one such algorithm that has a robust performance under noisy and reverberant conditions. The algorithm creates a likelihood function over the field of view. This thesis employs image processing methods on SRCP-PHAT images, to exploit the difference in power levels and pixel patterns to discriminate between sound source and background pixels. Hough Transform based ellipse detection is used to identify the sound source locations by finding the centers of elliptical edge pixel regions typical of source patterns. Monte Carlo simulations of …

Testing Program For Kysat‐1, Jason Robert Bratcher

University of Kentucky Master's Theses

Years of success in the aerospace industry has taught Kentucky Space several lessons. This thesis will summarize the accomplishments in an attempt to formulate a well-defined program for designing and testing small spacecraft in an environment with strict financial restraints. The motivation for producing this well-defined platform for testing small spacecraft arose when Kentucky Space became the liaison between NASA and its customers for the NanoRacks and CubeLab module program. Having a solid program for testing small spacecraft will allow future student programs to easily set standards for experiment payloads. Also by discussing obstacles for smaller programs such as restraints …

Verilog Design And Fpga Prototype Of A Nanocontroller System, Akshay Vummannagari

University of Kentucky Master's Theses

Many new fabrication technologies, from nanotechnology and MEMS to printed organic semiconductors, center on constructing arrays of large numbers of sensors, actuators, or other devices on a single substrate. The utility of such an array could be greatly enhanced if each device could be managed by a programmable controller and all of these controllers could coordinate their actions as a massively-parallel computer. Kentucky Architecture nanocontroller array with very low per controller circuit complexity can provide efficient control of nanotechnology devices.

This thesis provides a detailed description of the control hierarchy of a digital system needed to build "nanocontrollers" suitable for …

Issues Related To The Numerical Implementation Of A Sparse Method For The Solution Of Volume Integral Equations At Low Frequencies, Kiran Arcot

University of Kentucky Master's Theses

Computational electromagnetic modeling involves generating system matrices by discretizing integral equations and solving the resulting system of linear equations. Many methods of solving the system of linear equations exist and one such method is the factorization of the matrix using the so called local-global solution (LOGOS) modes. Computer codes to perform the discretization of the integral equations, filling of the matrix, and the subsequent LOGOS factorization have previously been developed by others. However, these codes are limited to complex double precision arithmetic only.

This thesis extends and expands the existing computer by creating a more general implementation that is able …

A Novel Message Routing Layer For The Communication Management Of Distributed Embedded Systems, Darren Jacob Brown

University of Kentucky Master's Theses

Fault tolerant and distributed embedded systems are research areas that have the interest of such entities as NASA, the Department of Defense, and various other government agencies, corporations, and universities. Taking a system and designing it to work in the presence of faults is appealing to these entities as it inherently increases the reliability of the deployed system. There are a few different fault tolerant techniques that can be implemented in a system design to handle faults as they occur. One such technique is the reconfiguration of a portion of the system to a redundant resource. This is a difficult …

Audio Scene Segementation Using A Microphone Array And Auditory Features, Harikrishnan Unnikrishnan

University of Kentucky Master's Theses

Auditory stream denotes the abstract effect a source creates in the mind of the listener. An auditory scene consists of many streams, which the listener uses to analyze and understand the environment. Computer analyses that attempt to mimic human analysis of a scene must first perform Audio Scene Segmentation (ASS). ASS find applications in surveillance, automatic speech recognition and human computer interfaces. Microphone arrays can be employed for extracting streams corresponding to spatially separated sources. However, when a source moves to a new location during a period of silence, such a system loses track of the source. This results in …

Accelerated Aging Of Mwcnt Filled Electrically Conductive Adhesives, Ashwanth Reddy Vangala

University of Kentucky Master's Theses

Electrically conductive adhesives (ECA) are discussed and studied with everincreasing interest as an environmentally friendly alternative to solder interconnection in microelectronics circuit packaging. They are used to attach surface mount devices (SMD), Integrated Circuits (IC) and Flip chips in electronic assembly. The use of ECAs brings some benefits like flexibility, mild processing conditions and process simplicity. Multi walled carbon nanotubes (MWCNT) are used instead of metal fillers because of their novel properties such as light weight, high aspect ratio, corrosion resistant, reduced processing temperature, lead free, good electrical conduction and mechanical strength.

The purpose of the present work is to …

Genetic Algorithm Controlled Common Subexpression Elimination For Spill-Free Register Allocation, Shashi Deepa Arcot

University of Kentucky Master's Theses

As code complexity increases, maxlive increases. This is especially true in the case of the Kentucky If-Then-Else architecture proposed for Nanocontrollers. To achieve low circuit complexity, computations are decomposed to bit-level operations, thus generating large blocks of code with complex dependence structures. Additionally, the Nanocontroller architecture allows for only a small number of single bit registers and no extra memory.

The assumption of an infinite number of registers made during code generation becomes a huge problem during register allocation because the small number of registers and no additional memory. The large basic blocks mean that maxlive almost always exceeds the …

Comparison Of Stabilization Methods For Fixed-Speed Wind Generator Systems, Mohammod Ali, Bin Wu

Faculty Publications

Static Synchronous Compensator (STATCOM), Pitch control system, Braking Resistor (BR), and Superconducting Magnetic Energy Storage (SMES) have recently been reported as stabilization methods for fixed-speed wind generator systems. although the individual technologies are well documented, a comparative study of these systems has not been reported so far. This paper aims to fill in the gap, and provides a comprehensive analysis of these stabilization methods for fixed-speed wind generator systems. The analysis is performed in terms of transient stability enhancement, controller complexity, and cost. a novel feature of this work is that the transient stability analysis of wind generator system is …

High Frequency Vco And Frequency Divider In Vlsi 90nm Technology, Paesol Veerakitti

Browse all Theses and Dissertations

A Voltage Controlled Oscillator (VCO) is essentially a tunable frequency generator. A VCO is used as a part in PLL system which is a system that generates a stable oscillating signal. As the digital electronic industry demands an ever increasing performance in speed, VCO's are required to create higher frequency signals. However, the phase noise performance of a VCO decreases as the operating frequency gets higher. The LC VCO is developed in this thesis to be used in with a tunable frequency divider as a part of a PLL system. The LC VCO structure design takes the advantage of a …

Interface Polarization Coupling In Piezoelectric-Semiconductor Ferroelectric Heterostructures, Venkata M. Voora, Tino Hofmann, M. Brandt, M. Lorenz, M. Grundmann, N. Ashkenov, H. Schmidt, Natale J. Ianno, Mathias Schubert

Department of Electrical and Computer Engineering: Faculty Publications

We present a dielectric continuum model approach for studying the electrical polarization properties of interface polarization coupled BaTiO₃, BaTiO₃-ZnO, and ZnO-BaTiO₃-ZnO thin-film structures consisting of several hundred nanometer thick layers. Our model augments the effects of electric field driven switchable polarization and depletion layer formation with spontaneous interface polarization coupling. Wurtzite-structure (piezoelectric) n-type ZnO and perovskite-structure (ferroelectric) highly insulating BaTiO₃ layers were prepared and investigated. The coupling between the nonswitchable spontaneous polarization of ZnO and the electrically switchable spontaneous polarization of BaTiO₃ causes strong asymmetric polarization hysteresis behavior. The n-type ZnO reveals …

Protein Adsorption On And Swelling Of Polyelectrolyte Brushes: A Simultaneous Ellipsometry-Quartz Crystal Microbalance Study, Eva Bittrich, Keith B. Rodenhausen Jr., Klaus-Jochen Eichhorn, Tino Hofmann, Mathias Schubert, Manfred Stamm, Petra Uhlmann

Department of Electrical and Computer Engineering: Faculty Publications

With a coupled spectroscopic ellipsometry-quartz crystal microbalance with dissipation (QCM-D) experimental setup, quantitative information can be obtained about the amount of buffer components (water molecules and ions) coupled to a poly(acrylic acid) (PAA) brush surface in swelling and protein adsorption processes. PAA Guiselin brushes with more than one anchoring point per single polymer chain were prepared. For the swollen brushes a high amount of buffer was found to be coupled to the brush-solution interface in addition to the content of buffer inside the brush layer. Upon adsorption of bovine serum albumin the further incorporation of buffer molecules into the protein-brush …

The Manifestation Of Stopping Sets And Absorbing Sets As Deviations On The Computation Trees Of Ldpc Codes, Eric T. Psota, Lance C. Perez

Department of Electrical and Computer Engineering: Faculty Publications

The error mechanisms of iterative message-passing decoders for low-density parity-check codes are studied. A tutorial review is given of the various graphical structures, including trapping sets, stopping sets, and absorbing sets that are frequently used to characterize the errors observed in simulations of iterative decoding of low-density parity-check codes. The connections between trapping sets and deviations on computation trees are explored in depth using the notion of problematic trapping sets in order to bridge the experimental and analytic approaches to these error mechanisms. A new iterative algorithm for finding low-weight problematic trapping sets is presented and shown to be capable …

The Design And Manufacture Of A Light Emitting Diode Package For General Lighting, Michael S. Krist

Master's Theses

Lighting technologies have evolved over the years to become higher quality, more efficient sources of light. LEDs are poised to become the market standard for general lighting because they are the most power efficient form of lighting and do not contain hazardous materials. Unfortunately, LEDs pose unique problems because advanced thermal management is required to remove the high heat fluxes generated by such relatively small devices. These problems have already been overcome with complex packaging and exotic materials, but high costs are preventing this technology from displacing current lighting technologies.

The purpose of this study is to develop a low-cost …

Quantification Of Channel Performance And Development And Characterization Of Small Magnetic Field Probes, Surbhi Mittal

Masters Theses

"This thesis presents a new approach to quantifying channel performance using a transmitter waveform and dispersion penalty (TWDP) with frequency domain S-parameter data. Initially TWDP was defined to characterize the performance of a transmitter in optical links. More recently its use has been extended to include the quantification of channel performance, especially in high-speed copper links. This project focused mainly on channel characterization. Instead of using the time-domain oscilloscope measurements involved in the original approach, it proposes a new method that relies on frequency-domain S-parameter data obtained either from measurements or simulations. It included a parametric study of TWDP with …

Control And Design Considerations In Electric-Drive Vehicles, Shweta Neglur

Masters Theses

"Electric-drive vehicles have been identified as one of the promising technologies of the future. Electric-drive vehicles including fuel cell, hybrid electric, and plug-in hybrid electric vehicles have the potential to improve the fuel economy and reduce gas emissions when compared to conventional vehicles. One of the important challenges in the advancement of the electric-drive vehicles is to develop a control strategy which meets the power requirements of the vehicles. The control strategy is an algorithm designed to command the battery and the internal combustion engine of the vehicle for specific power demands. In this thesis, load follower and thermostat control …

Modeling And Analysis Of High-Speed Sources And Serial Links For Signal Integrity, Siming Pan

Masters Theses

"As the computer and electronics industry moves towards higher data rates, signal integrity and electromagnetic interference (EMI) problems always present challenges for designers for high-speed data communication systems. To characterize the entire link path between transmitters and receivers, accurate models for sources, passive link path (such as traces, vias, connectors, etc), and terminations should be built before simulations either in frequency or time domain. Due to the imperfection of model, data corrections are preferred before time-domain simulations to ensure stability. Moreover, data obtained from models should be compared with measurement results to judge the level of agreement for validations. This …

Time-Domain Thru-Reflect-Line (Trl) Calibration Error Assessment And Its Mitigation And Modeling Of Multilayer Printed Circuit Boards (Pcb) With Complex Area Fills, Vysakh Sivarajan

Masters Theses

"Part 1 for this thesis is on the error assessment of a time-domain (t-TRL) calibration technique. Application of the "Thru-Reflect-Line" (TRL) calibration to time-domain measurements of S-parameters (t-TRL) can be used for the characterization of the printed circuit boards (PCBs). However, t-TRL calibrated results still have deviations from the reference frequency-domain vector network analyzer (VNA) calibrated results. There are two main sources of errors in the t-TRL calibration. They are random errors, such as an additive noise and jitter, and systematic errors associated with cables, connectors, and port mismatches. This work addresses these two types of errors by proper selection …

Freeform Reflector Design With Extended Sources, Florian Fournier

Electronic Theses and Dissertations

Reflector design stemmed from the need to shape the light emitted by candles or lamps. Over 2,000 years ago people realized that a mirror shaped as a parabola can concentrate light, and thus significantly boosts its intensity, to the point where objects can be set afire. Nowadays many applications require an accurate control of light, such as automotive headlights, streetlights, projection displays, and medical illuminators. In all cases light emitted from a light source can be shaped into a desired target distribution with a reflective surface. Design methods for systems with rotational and translational symmetry were devised in the 1930s. …