Electronic Devices and Semiconductor Manufacturing Commons^™

Improvement Of 802.11 Protocol On Fully Programmable Wireless Radio, Eunji Lee

Maseeh Summer Undergraduate Research Experience

The growth in the number of connected device usage has led to a rapidly increased data traffic on wireless network and the demand for access to high speed and stable Internet connection is becoming more prominent. However, current off the shelf wireless cards are not programmable or observable across layers of the standard protocol stack, which leads to poor practical performance. Thus, Wireless Open Access Research Platform (WARP), a scalable wireless platform providing programmable functionality at every layer of the network stack, has been used for the real-time implementation and improvement of 802.11 protocol.

An Exploration Of Software Defined Radio And Gnu Radio Companion For Use In Drone-To-Drone Communication, Amanda K. H. Voegtlin

Maseeh Summer Undergraduate Research Experience

In a world that increasingly relies on automation and intelligent robotics, there is a need for drones to expand their independence and adaptability in navigating their environments. One approach to this problem is the use of wireless communication between units in order to coordinate their sensor data and build real-time maps of the environments they are navigating. However, especially indoors, relying on a fixed transmission tower to provide data to the units faces connectivity challenges.

The purpose of this research was to determine the fitness of an on-drone assembly that uses the the NI B200mini software-defined radio board and Gnu …

An Analysis Of Lora Low Power Technology And Its Applications, Gomathy Venkata Krishnan

Maseeh Summer Undergraduate Research Experience

The number of Internet of Things (IoT) devices has exponentially increased in the last decade. With the increase in these devices, there is a necessity to effectively connect and control these devices remotely. Cellular technologies cannot handle this demand since they are not cost effective and easy to deploy. This is where LoRa technology comes handy. LoRa is long-range, low-power, low cost technology that supports internet of things applications. LoRa has many advantages in terms of capacity, mobility, battery lifetime and cost. It uses the unlicensed 915MHz ISM band and can be easily deployed.

This research is focused on setting …

A Comparative Analysis Of Integrated Optical Waveguide Isolators With Magneto-Optic Layers, Reyhane Oztekin

Electrical Engineering Theses and Dissertations

The objective of this study is to theoretically devise an on-chip optical isolator which is monolithically integrated with a semiconductor waveguide layer yielding low loss. The optical properties of iron are modeled for the use of optical waveguide isolators by improving the Brendel-Bormann model. Our model for iron shows excellent fit with the optical data up to 30 electronvolts (eV). The semiconductor optical waveguide isolator with magneto-optic layers based on non-reciprocal loss shift is developed in this study. Fe, Co, and Ni metals as well as cerium-substituted yttrium iron garnet (Ce:YIG) have been used as magneto-optic layers. We have shown …

Cell-Aware Fault Analysis And Test Set Optimization In Digital Integrated Circuits, Fanchen Zhang, Jennifer Dworak

Computer Science and Engineering Theses and Dissertations

Structural tests have many advantages over functional patterns. The fault coverage of structural patterns is generally higher and easier to quantify, well-known algorithms are available to generate them, and they are often a much easier choice for debugging and diagnosis. However, depending on the fault models used, traditional structural patterns can still miss many defects, such as the defects that may occur inside the standard cells, and when chips are placed on a board, they may fail in functional mode even if they pass all structural tests. This can happen even if those same structural tests are applied in-system on …

Voltage-Controlled Deposition Of Nanoparticles For Next Generation Electronic Materials, Subhodip Maulik

LSU Doctoral Dissertations

This work presents both a feasibility study and an investigation into the voltage-controlled spray deposition of different nanoparticles, namely, carbon nanotubes (CNTs), as well as molybdenum disulfide (MoS₂) and tungsten disulfide (WS₂) from the transition metal dichalcogenides (TMDCs) family of materials. The study considers five different types of substrates as per their potential application to next-generation device electronics. The substrates selected for this research were: 1) aluminum as a conducting substrate, 2) silicon as a semiconducting substrate, 3) glass, silicon dioxide (SiO₂), and syndiotactic poly methyl methacrylate (syndiotactic PMMA) as insulating substrates.

Since the …

Increasing The Longevity Of Tungsten Filaments In A Zone Refiner, Byron D. Greenlee

Senior Theses

Zone refining is used for its ability to purify material and grow single crystals. To produce these single crystals, a suspended molten zone, generated by electron bombardment, passes along the polycrystalline stock. During a zone refining run, the filaments that produce the electron bombardment can fail. In this project, the longevity of tungsten filaments in a zone refiner was investigated. A new bombardment geometry was constructed to attempt to increase the longevity of the filaments. The new geometry had a shield machined into it to prevent line-of-sight impurities originating in the molten zone from striking the filaments. It was found …

High Temperature Wide Bandgap Light Emitting Diodes For Harsh Environment Applications, Stephanie Sandoval

Electrical Engineering Undergraduate Honors Theses

The need for high temperature, high power density power modules for applications such as electric vehicles and space exploration has driven the research into wide bandgap LEDs due to their potential operation at elevated temperatures. Wide bandgap LEDs offer an attractive solution due to properties such as high temperature tolerance, strong radiation hardness and good thermal conductivity. In this thesis, the electrical properties of GaN-on-SiC heterojunctions are studied as a precursor to an LED study, and the optical characterization of an InGaN/GaN MQW is reported. The GaN-on-SiC study revealed that these wide bandgap LEDs have linear sensitivity at high temperatures. …

Thermoelectrics And Thermoelectric Devices, Benjamin T. Erck

Senior Theses

The field of thermoelectrics has many applications, and more are found in everyday systems. From its current studies, it is apparent that improving the figure of merit zT (which defines a good thermoelectric material) is important in the effectiveness of power generation. Another important part of thermoelectrics is the duality of these devices. They can both move heat and generate power, depending on their role in the system. In this thesis research, a process was made to test these thermoelectric relationships for a few Peltier devices in order to understand their efficiencies and what systems they can be applied to.

Evaluation Of Terahertz Imaging For Breast Cancer Detection Using Image Morphing, Tanny Andrea Chavez Esparza

Graduate Theses and Dissertations

This thesis proposes the use of a mesh morphing algorithm for the quantitative evaluation of terahertz (THz) images. This work differs from traditional evaluation methods based on qualitative evaluation because it provides a fair and quantitative measurement of the THz imaging system's performance. The objective of the algorithm is to match the alignment, shape, and resolution of the THz and reference pathology images. Therefore, the proposed morphing method provides a pathology reference for a pixel-by-pixel evaluation of the region classification in the THz image. To achieve this, the morphing algorithm aligns the images using the Pearson's correlation coefficient and reshapes …

Glucose Level Estimation Based On Invasive Electrochemical, And Non-Invasive Optical Sensing Methods, Sanghamitra Mandal

Graduate Theses and Dissertations

The purpose of this research is to design and fabricate sensors for glucose detection using inexpensive approaches. My first research approach is the fabrication of an amperometric electrochemical glucose sensor, by exploiting the optical properties of semiconductors and structural properties of nanostructures, to enhance the sensor sensitivity and response time. Enzymatic electrochemical sensors are fabricated using two different mechanisms: (1) the low-temperature hydrothermal synthesis of zinc oxide nanorods, and (2) the rapid metal-assisted chemical etching of silicon (Si) to synthesize Si nanowires. The concept of gold nano-electrode ensembles is then employed to the sensors in order to boost the current …

Vertical Gallium Nitride Schottky Diodes For Power Switching Applications., Sowmya Kolli

Electronic Theses and Dissertations

Gallium nitride (GaN) has enormous potential for use in devices operating at high power, frequency and temperature. Its wide band gap, high critical electric field and favourable carrier properties lead to lower switching losses and conduction losses in power electronic devices. However, most GaN rectifiers reported to date exhibit an ON-resistance (Ron) versus breakdown voltage much below theoretical predictions. Heteroepitaxial growth of GaN on substrates such as SiC, Si, and sapphire suffer from a high density of threading dislocations defects due to the mismatch in lattice constants and thermal expansion coefficients. Vertical devices, in which a bulk GaN substrate is …

Challenges In Flexible Microsystem Manufacturing : Fabrication, Robotic Assembly, Control, And Packaging., Danming Wei

Electronic Theses and Dissertations

Microsystems have been investigated with renewed interest for the last three decades because of the emerging development of microelectromechanical system (MEMS) technology and the advancement of nanotechnology. The applications of microrobots and distributed sensors have the potential to revolutionize micro and nano manufacturing and have other important health applications for drug delivery and minimal invasive surgery. A class of microrobots studied in this thesis, such as the Solid Articulated Four Axis Microrobot (sAFAM) are driven by MEMS actuators, transmissions, and end-effectors realized by 3-Dimensional MEMS assembly. Another class of microrobots studied here, like those competing in the annual IEEE Mobile …

A Novel Design For A Silicon And Cadmium Telluride Tandem Solar Cell., Jacob A Vittitow

Electronic Theses and Dissertations

No abstract provided.

Application Of Modular Multilevel Converters (Mmc) Using Phase-Shifted Pwm And Selective Harmonic Elimination In Distribution Systems, Thouhidul Islam

Graduate Theses and Dissertations

Reducing the size and weight of a power electric system is a prodigious challenge to researchers as the development of the latest technologies emerge in the field of electrical engineering. A similar urge is there to develop a light-weight mobile power substation (MPS) to use in the electric power distribution systems during emergency conditions. This thesis proposes a power electronics based solution using the modular multilevel converter (MMC) topology to design the MPS system. The market-available power semiconductor devices are analyzed and suitable devices are selected to design the system. The phase-shifted pulse width modulation (PS-PWM) and selective harmonic elimination …

Design, Fabrication, And Characterization Of Novel Optoelectronic Devices For Near-Infrared Detection, Ahmad Nusir

Graduate Theses and Dissertations

Investigating semiconductor materials and devices at the nanoscale has become crucial in order to maintain the exponential development in today’s technology. There is a critical need for making devices lower in power consumption and smaller in size. Nanoscale semiconductor materials provide a powerful platform for optoelectronic device engineers. They own interesting properties which include enhanced photoconductivity and size-tunable interband transitions.

In this research, different types of nanostructures were investigated for optoelectronic devices: nanocrystals, nanowires, and thin-films. First, lead selenide nanocrystals with narrow bandgap were synthesized, size-tailored, and functionalized with molecular ligands for the application of uncooled near-infrared photodetectors. The devices …

Design, Fabrication, And Characterization Of All-Inorganic Quantum Dot Light Emitting Diodes, Ramesh Vasan

Graduate Theses and Dissertations

Quantum dot light emitting diodes are investigated as a replacement to the existing organic light emitting diodes that are commonly used for thin film lighting and display applications. In this, all-inorganic quantum dot light emitting diodes with inorganic quantum dot emissive layer and inorganic charge transport layers are designed, fabricated, and characterized. Inorganic materials are more environmentally stable and can handle higher current densities than organic materials. The device consists of CdSe/ZnS alloyed core/shell quantum dots as the emissive layer and metal oxide charge transport layer. The charge transport in these devices is found to occur through resonant energy transfer …

The Eco-Smart Can V2.0, Darack B. Nanto

Appalachian Student Research Forum

I noticed that the workers had the same itinerary when emptying trashcans, meanwhile trashcans needed urgently to be emptied. Traditionally, ETSU maintenance operate on daily routes to pick trash on designated time, regardless the level of the containers. This leads to overflown trashcan in busy areas or during rush hours in certain areas. This overflown trashcan result in an unclean environment for the community and an unpleasant look of our beautiful campus. The time, resources and labor invested in collecting the trash could be saved. Therefore, I decided to use the Internet of Things (IoT) to create a device that …

Crumpling Effects And Specific Absorption Rates Of Flexible Amc Integrated Antennas, Sima Noghanian, Ala Alemaryeen

Electrical Engineering Faculty Publications

This study presents the design of a wearable textile-based monopole antenna integrated with a flexible artificial magnetic conductor (AMC). The proposed design covers the industrial, scientific, and medical 2.45 GHz band. An AMC reflector is utilised to isolate the human body from undesired electromagnetic radiation and to improve the antenna radiation characteristics. A monopole antenna was backed with an AMC reflector and tested in free space and on human body models. The inclusion of an AMC reflector increases the front-to-back ratio and antenna gain in free space. On the human body models, the AMC antenna provides stable performance and a …

Effect Of Molecular Side Groups And Local Nanoenvironment On Photodegradation And Its Reversibility, Nicole Quist, Mark Li, Ryan Tollefsen, Michael Haley, John Anthony, Oksana Ostroverkhova

Chemistry Faculty Publications

Degradation of organic semiconductors in the presence of oxygen is one of the bottlenecks preventing their wide-spread use in optoelectronic devices. The first step towards such degradation in functionalized pentacene (Pn) derivatives is formation of endoperoxide (EPO), which can either revert back to the parent molecule or proceed to molecule decomposition. We present the study of reversibility of EPO formation through probing the photophysical properties of functionalized fluorinated pentacene (Pn-R-F8) derivatives. Experiments are done in solutions and in films both at the single molecule level and in the bulk. In solutions, degradation of optical absorption and its partial recovery after …