Electromagnetics and Photonics Commons^™

Optimal Design Of A Switched Reluctance Motor With Magnetically Disconnected Rotor Modules Using A Design Of Experiments Differential Evolution Fea-Based Method, Vandana Rallabandi, Jie Wu, Ping Zhou, David G. Dorrell, Dan M. Ionel

Power and Energy Institute of Kentucky Faculty Publications

Switched reluctance (SR) machines are attractive because they present relatively high efficiency and torque density in spite of lacking permanent magnets. This paper focuses on a two-objective optimization of an external rotor SR motor with a stator that has concentrated coils and a rotor with magnetically isolated modules. The objectives are minimum loss and mass, and 11 independent dimensionless geometric variables are considered as inputs that affect them. A combined design of experiments (DOE) and differential evolution (DE) approach is proposed. The DOE methodology is used to reduce the search space by eliminating from consideration input variable values, leading to …

Effects Of Fabrication Errors On The Focusing Performance Of A Sector Metalens, S. S. Stafeev, A. G. Nalimov, Liam O’Faolain, M. V. Kotlyar

Cappa Publications

Using e-beam lithography, a 16-sector spiral metalens was fabricated in an amorphous silicon, capable of converting linearly polarized incident light into an azimuthally polarized optical vortex. When illuminated by a 633-nm linearly polarized laser beam, the metalens generated a near-surface subwavelength focal spot equal to 0.75 of the incident wavelength at full-width of half-maximum intensity. The focusing performance of the spiral metalens was numerically shown to be sensitive to the deviation of the factual microrelief from the calculated height. For the designed microrelief height, a circularly polarized incident beam was focused into a bright ring with a reverse energy flow …

Hyperspectral Imaging For Characterizing Single Plasmonic Nanostructure And Single-Cell Analysis, Nishir Sanatkumar Mehta

LSU Master's Theses

Orientation of plasmonic nanostructures is an important feature in many nanoscale applications such as photovoltaics, catalyst, biosensors DNA interactions, protein detections, hotspot of surface-enhanced Raman spectroscopy (SERS), and fluorescence resonant energy transfer (FRET) experiments. Silver nanocubes with significant spectral signatures between 400-700 nm are observed in this experimental research. Whereas study of single cells will enable the analysis of cell-to-cell variations within a heterogeneous population. These variations are important for further analysis and understanding of disease propagation, drug development, stem cell differentiation, embryos development, and how cells respond to each other and their environment. Adipose-derived mesenchymal stem cells possess the …

Thermal And Mechanical Energy Harvesting Using Lead Sulfide Colloidal Quantum Dots, Taher Ghomian

LSU Doctoral Dissertations

The human body is an abundant source of energy in the form of heat and mechanical movement. The ability to harvest this energy can be useful for supplying low-consumption wearable and implantable devices. Thermoelectric materials are usually used to harvest human body heat for wearable devices; however, thermoelectric generators require temperature gradient across the device to perform appropriately. Since they need to attach to the heat source to absorb the heat, temperature equalization decreases their efficiencies. Moreover, the electrostatic energy harvester, working based on the variable capacitor structure, is the most compatible candidate for harvesting low-frequency-movement of the human body. …

Study Of Physical Layer Security And Teaching Methods In Wireless Communications, Zhijian Xie, Christopher Horne

KSU Proceedings on Cybersecurity Education, Research and Practice

In most wireless channels, the signals propagate in all directions. For the communication between Alice and Bob, an Eavesdropper can receive the signals from both Alice and Bob as far as the Eavesdropper is in the range determined by the transmitting power. Through phased array antenna with beam tracking circuits or cooperative iteration, the signals are confined near the straight line connecting the positions of Alice and Bob, so it will largely reduce the valid placement of an Eavesdropper. Sometimes, this reduction can be prohibitive for Eavesdropper to wiretap the channel since the reduced space can be readily protected. Two …

A Narrow-Wall Complementary-Split-Ring Slotted Waveguide Antenna For High-Power-Microwave Applications, Xuyuan Pan

Electrical and Computer Engineering ETDs

A narrow-band, rugged, complementary-split-ring (CSR) slotted waveguide antenna (SWA) with significant size reduction is presented. The antenna is to be vertically front mounted on a land vehicle, with a horizontally polarized fan-beam radiation pattern. The radiation characteristics of a CSR slot in the narrow-wall of a rectangular waveguide are studied for the first time in this work. Both simulation and experimental results show that the complementary-split-ring slot radiates a linearly polarized wave with a total efficiency and gain close to those of conventional longitudinal slots, while the proposed CSR slots have a maximal outer diameter of 0.23λ₀, much …

Standing-Wave Dielectric Array Antennas, Ayman Althuwayb

Electrical Engineering Theses and Dissertations

Due to the evolutions in wireless communication systems, antenna engineers have been confronting a number of challenges regarding improving the performance of antennas, miniaturizing the size as well as considering the fabrication simplicity. Although dielectric resonator antennas typically suffer from exhibiting low gain, they have been thoroughly under investigating as they are being excellent candidates to be utilized to fulfill contemporary communication systems requirements and specifications, especially at high-frequency ranges. The reason behind this solicitude is because they have several advantageous features, including but not limited to the simplicity of the used excitation mechanism and fabrication easiness.

One of the …

Indirect Imaging Using Heterodyne Remote Digital Holography, Muralidhar Madabhushi Balaji

Electrical Engineering Theses and Dissertations

Conventional line-of-sight imaging techniques rely on detecting light paths bouncing from the object and reaching directly to the detector. Absence of any such direct light paths from object to detector results in a failure to recover any useful information using conventional techniques. The absence of direct light paths from object to detector can be observed in several real-world scenarios such as looking around a corner, imaging through turbid media, imaging through tissue etc.

The focus of this thesis is pertaining to the problem of looking around corners (or) imaging object hidden from line of sight at macroscopic scales. This thesis …

Remote Sensing Using I-Band And S-Band Signals Of Opportunity, Kadir Efecik, Benjamin R. Nold, James L. Garrison

The Summer Undergraduate Research Fellowship (SURF) Symposium

Measurement of soil moisture, especially the root zone soil moisture, is important in agriculture, meteorology, and hydrology. Root zone soil moisture is concerned with the first meter down the soil. Active and passive remote sensing methods used today utilizing L-band(1-2GHz) are physically limited to a sensing depth of about 5 cm or less. To remotely sense the soil moisture in the deeper parts of the soil, the frequency should be lowered. Lower frequencies cannot be used in active spaceborne instruments because of their need for larger antennas, radio frequency interference (RFI), and frequency spectrum allocations. Ground-based passive remote sensing using …

Experimental Evaluation Of A Krypton Propellant Arrangement In A T-100-3 Hall-Effect Thruster, Adam Patel, Javier Cortina Fernandez, Justin Chow, Osvaldo Alejandro Martin, Alexey Shashurin

The Summer Undergraduate Research Fellowship (SURF) Symposium

Stationary Hall thrusters are electric, moderate-specific impulse propulsion systems developed in Russia. These devices manipulate electric and magnetic fields to expel ionized gas (plasma) components, resulting in thrust. The success of Hall-effect engines in USSR satellite-transfer missions quickly sparked western interest in the design. Extensive government and academic study commenced shortly after the dissolution of the Soviet Union, when the technology was made available to the United States. The common SPT-100 model was the primary subject of such studies. Unfortunately, limited literature exists for rare and uncommon Hall thruster models. The T-100-3 stationary plasma thruster suffers from this gap; few …

Spice Based Compact Model For Electrical Switching Of Antiferromagnet, Xe Jin Chan, Jan Kaiser, Pramey Upadhyaya

The Summer Undergraduate Research Fellowship (SURF) Symposium

A simulation framework that can model the behavior of antiferromagnets (AFMs) is essential to building novel high-speed devices. The electrical switching of AFMs allows for high performance memory applications. With new phenomena in spintronics being discovered, there is a need for flexible and expandable models. With that in mind, we developed a model for AFMs which can be used to simulate AFM switching behavior in SPICE. This approach can be modified for adding modules, keeping pace with new developments. The proposed AFM switching model is based on the Landau-Lifshitz-Gilbert equation (LLG). LLG along with an exchange coupling module is implemented …

A High-Efficiency Low Power Rectifier For Wireless Power Transfer, Zachary Loy, Alden Fisher, Brian Vaughn, Dimitrios Peroulis

The Summer Undergraduate Research Fellowship (SURF) Symposium

With the number of implantable devices that utilize electronics increasing, there is an increasing need to find alternative ways of powering them. Currently, surgery is required to replace a battery for these devices; however, with advancements in Wireless Power Transfer (WPT) methods, the need for further surgeries will become negated. This paper explores the ability of WPT as an alternative powering method by investigating rectifier Power Conversion Efficiency (PCE). The rectifier converts high frequency waves to Direct Current (DC) energy that can provide usable power to devices requiring electrical power. It is targeted for low power applications centered around a …

Imaging Characterization Of Current Generating Lipid-Protein Membranes, Joel D. Kamwa

Microelectronics-Photonics Student Works

Imaging Characterization of Current Generating Lipid-protein Membranes

High Dynamic Range Optical Devices And Applications., Elijah Robert Jensen

Electronic Theses and Dissertations

Much of what we know about fundamental physical law and the universe derives from observations and measurements using optical methods. The passive use of the electromagnetic spectrum can be the best way of studying physical phenomenon in general with minimal disturbance of the system in the process. While for many applications ambient visible light is sufficient, light outside of the visible range may convey more information. The signals of interest are also often a small fraction of the background, and their changes occur on time scales so quickly that they are visually imperceptible. This thesis reports techniques and technologies developed …

Room Temperature Operation Of Quantum Cascade Lasers Monolithically Integrated Onto A Lattice-Mismatched Substrate, Rowel Go

Electronic Theses and Dissertations

Quantum Cascade Lasers (QCLs) are semiconductor devices that, currently, have been observed to emit radiation from ~ 2.6 μm to 250 μm (1 to 100 terahertz range of frequencies.) They have established themselves as the laser of choice for spectroscopic gas sensing in the mid-wavelength infrared (3-8 μm) and long-wavelength infrared (8-15 μm) region. In the 4-12 μm wavelength region, the highest performing QCL devices, in terms of wall-plug efficiency and continuous wave operation, are indium phosphide (InP) based. The ultimate goal is to incorporate this InP-based QCL technology to silicon (Si) substrate since most opto-electronics are Si-based. The main …

Hybrid Perovskite Characterization And Device Applications., Kasun Fernando

Electronic Theses and Dissertations

Hybrid perovskites are a group of materials that has shown a great impact in the field of scientific research in the past decade due to the efficiency gain within a short period of time. Hot casting is one technique that has been producing high efficient and stable solar cells. Electrical transportation of lateral device structure by such film is explored to understand basic properties and predict possible device applications using it. Under dark, memristive ability of the film was explored using various experiments. Unique uni-polar memristor ability was observed. Using the experimental results, a model is hypothesized using the concepts …

High-Sn-Content Gesn Alloy Towards Room-Temperature Mid Infrared Laser, Wei Dou

Graduate Theses and Dissertations

Si photonics is a rapidly expanding technology that integrates photonic circuits onto a Si substrate. The integration of Si electronics and photonics has been a successful technology for a wide range of applications. Group-IV alloy GeSn has drawn great attentions as a complementary metal–oxide–semiconductor compatible optoelectronic material for Si photonics. The devices based on GeSn alloy could be monolithically integrated into well-established and high-yield Si integrated circuits, which is favorable for chip-scale Si photonics featuring smaller size, lower cost, and higher reliability.

The relaxed GeSn with high material quality and high Sn composition is highly desirable to cover mid-infrared wavelength. …

Opto-Thermal Characterization Of Plasmon And Coupled Lattice Resonances In 2-D Metamaterial Arrays, Vinith Bejugam

Graduate Theses and Dissertations

Growing population and climate change inevitably requires longstanding dependency on sustainable sources of energy that are conducive to ecological balance, economies of scale and reduction of waste heat. Plasmonic-photonic systems are at the forefront of offering a promising path towards efficient light harvesting for enhanced optoelectronics, sensing, and chemical separations. Two-dimensional (2-D) metamaterial arrays of plasmonic nanoparticles arranged in polymer lattices developed herein support thermoplasmonic heating at off-resonances (near infrared, NIR) in addition to regular plasmonic resonances (visible), which extends their applicability compared to random dispersions. Especially, thermal responses of 2-D arrays at coupled lattice resonance (CLR) wavelengths were comparable …

Pulse Sharpening Circuit For Explosive Emission Cathode Driver, Nicholas D. Kallas

Electrical and Computer Engineering ETDs

Explosive field emission cathodes (EEC), used for the generation of relativistic electron beams, require short rise-time high-voltage pulses in order to minimize the extraction of off-energy electrons. To this end, a rise-time sharpening circuit has been developed at the Los Alamos National Laboratory (LANL). The circuit consists of a 7 nF water-filled peaking capacitor with an integrated self-breakdown switch designed to operate up to -300 kV. This unit is intended to reduce the rise-time of a 4-stage Type-E PFN Marx Generator that will be used to study operational characteristics of velvet cathodes. Simulations of the peaking circuit show a reduction …

Microwave Characterization Of Printable Dielectric Inks Using Additive Manufacturing Methods, Seth York

USF Tampa Graduate Theses and Dissertations

Two methods of dielectric characterization are presented that offer quick and cost-effective solutions for screening complex dielectric material properties. Through Direct-Print Additive Manufacturing (DPAM) methods, a dielectric material of choice is dispensed into a capacitor structure and characterized through 1-port s-parameter measurements. The presented methods use fixtures that are modeled and validated through simulation then implemented in practice. Advanced simulations are performed to gain insights which are used to optimize the dielectric characterization performance of the fixtures. Additional investigations are performed which investigate the durability of the fixture and material within by exposing the combination to rough environmental conditions for …