Chemical Engineering Commons^™

Simulating Fluid Flow And Gas Expansion In The Marine Riser Using Computational Fluid Dynamics (Cfd) Software, Ross Teichman

Honors Capstones

No abstract provided.

Development Of A Thiol-Acrylate-Based Hydrogel For Tumor Spheroid Generation In A Microfluidic Device, Wayne Joseph Wortmann Iii

Honors Capstones

No abstract provided.

Nonlinear Model Predictive Control For A Managed Pressure Drilling With High-Fidelity Drilling Simulators, Junho Park

Theses and Dissertations

The world's energy demand has been rapidly increasing and is projected to continue growing for at least the next two decades. With increasing global energy demand and competition from renewable energy, the oil and gas industry is striving for more efficient petroleum production. Many technical breakthroughs have enabled the drilling industry to expand the exploration to more difficult drilling such as deepwater drilling and multilateral directional drilling. For example, managed pressure drilling (MPD) offers ceaseless operation with multiple manipulated variables (MV) and wired drill pipe (WDP) provides two-way, high-speed measurements from bottom hole and along-string sensors. These technologies have maximum …

Absorption Of Carbon Dioxide Via Single And Blends Of Aqueous Amine Solutions And Nanofluids In Gasliquid Hollow Fiber Membrane Contactor, Zia Ur Rehman Said Rehman

Chemical and Petroleum Engineering Theses

In this work, CO₂ gas was absorbed from a gas mixture (20 vol.% CO₂ + 80 vol.% N₂) in a custom made Polyvinylidene fluoride (PVDF) hollow fiber membrane contactors by using a variety of single and blends of aqueous amine solutions and nanofluids. An ultrasonic dispersion method was used to prepare nanofluids where SiO₂ nanoparticles and carbon nanotubes (CNTs) were dispersed in deionized (DI) water without adding any surfactant. The prepared solvents were fed into the tube side of the membrane module, whereas the gas mixture was passed through the shell side. CO₂ absorption experiments were carried out using four …

Simulation And Experiments To Understand The Manufacturing Process, Microstructure And Transport Properties Of Porous Electrodes, Mohammad Mehdi Forouzan

Theses and Dissertations

Battery technology is a great candidate for energy storage applications. The need for high-performance and cost-effective batteries has motivated researchers to put much effort into improving battery performance. In this work, we attempt to understand the elements that affect the microstructure and performance of two battery systems. The first part of this work focuses on the investigation of transport and structural properties of porous electrodes in an alkaline electrolyte. A DC polarization method was deployed for tortuosity measurements. An apparatus was designed to flow specified current through and measure the voltage drop over the porous electrodes. Using a modified Ohm's …

Structural And Photoluminescence Properties Of Zno Thin Films Deposited By Ultrasonic Spray Pyrolysis, Iwan Sugihartono, Erfan Handoko, Vivi Fauzia, Artoto Arkundato, Lara Permata Sari

Makara Journal of Technology

Zinc oxide (ZnO) thin films on a silicon (Si) (111) substrate were grown herein using ultrasonic spray pyrolysis at 450 °C with different Zn concentrations. The ZnO thin films had X-ray diffraction patterns of a polycrystalline hexagonal wurtzite structure. The (002) and (101) peak intensities changed under different Zn concentrations. Furthermore, according to Scherer's and Stokes–Wilson equations, the crystallite size and the internal strain of the ZnO thin films in the (002) and (101) peaks changed with the Zn concentration. Optically, the photoluminescence spectra indicated that the ratio of the UV/GB emission of the ZnO thin films was the highest …

Development Of A Novel Bioactive Glass Suitable For Osteosarcoma-Related Bone Grafts, Alireza Rahimnejad Yazdi, Lawrence Torkan, Stephen D. Waldman, Mark R. Towler

Chemical and Biochemical Engineering Faculty Research & Creative Works

In this study, zinc borate-based glasses with increasing gallium content (0, 2.5, 5, 10, and 15 wt % Ga) were synthesized and their effect on the viability and proliferation of preosteoblasts and osteosarcoma cancer cells were investigated. Methyl thiazolyl tetrazolium (MTT) cell viability assays using glass degradation extracts revealed that the extracts from glasses with lower Ga contents could enhance the viability of preosteoblasts, while extracts from the glass composition with 15 wt % Ga caused statistically significant reduction of their viability. MTT cell viability assays using the extracts and osteosarcoma cells showed that only extracts from the glass composition …

An Exploratory Study Of Sukuk Utilisation For Transportation Infrastructure Development In Indonesia, Fiona Lamari, Ayomi Dita Rarasati, Meilia Evita

Makara Journal of Technology

Investment in infrastructure is one of the principal drivers of the growth of the economy. For that reason, the Indonesian government has proposed an investment budget in the railway and sea and air transport sectors over the next 10 years. In order to overcome the burden of direct outflows and for the future, a study was conducted to lay down the framework of Shariah-compliant payments for the development of infrastructure in Indonesia in the transport sector. This paper aims to explore the opportunity and implementation of sukuk utilisation to develop transportation infrastructure. Secondary data study and interviews were selected for …

Experimental And Modeling Of Co2 Removal From Gas Mixtures Using Membrane Contractors Packed With Glass Beads., Farah O.S. Abuhatab

Chemical and Petroleum Engineering Theses

Natural gas is one of the major natural resources in UAE which carries significant amounts of acid gases. For the purpose of utilizing or liquefying, the gas must be pre-treated by separating the major non-hydrocarbon gases, namely C0₂. Typical C0₂ separation processes involve separation using sorbents or solvent, cryogenic or membrane. Among these processes, the chemical absorption considered to be the most effective process to remove C0₂. However, this process carries several drawbacks such as flooding, foaming, entraining, channeling, and most importantly high capital and operating costs.

An integrated unit called gas absorption membrane (GAM) …

Integrated Stratigraphic Controls For Flow Simulation Of The Wall Creek Member Of Frontier Formation: Western Powder River Basin, Wyoming, Tuan Le

Graduate Theses & Non-Theses

The Frontier Formation in the Powder River Basin has been re-discovered for oil and gas potential with the development of long horizontal wells and multi-stage hydraulic fracturing. Over the last decade, the Upper Cretaceous Wall Creek Member (WCM) of the Frontier Formation has proven to be a successful hydrocarbon-producing target, yet a full understanding of the flow behavior in this complex stratigraphic unit has not been fully achieved.

The fluid and rock properties have uncertainty and are not well defined due to the low permeability rocks. This study aims to describe the fluid flow behaviors of these features and create …

Seismic Response Analysis Along The Coastal Area Of Bengkulu During The September 2007 Earthquake, Lindung Zalbuin Mase

Makara Journal of Technology

A strong earthquake of 8.4 Mw occurred at the Sumatra Subduction Zone in September 12, 2007. The area that underwent the impact of the earthquake was located along the coastal area of the Bengkulu Province. A seismic ground response study was then performed with reference to the event. Several site investigations, including standard penetration test and shear wave velocity tests, were conducted to understand the subsoil condition. The data were used to analyze a ground response during the earthquake. The amplification factor of each site was obtained, and a comparison of the spectral accelerations was performed. The results showed that …

Coax-Fed Dipole-Type Applicator For Hepatic Cancer Rf Ablation, Basari Basari, Aditya Rakhmadi, Kazuyuki Saito

Makara Journal of Technology

Cancer is the third leading cause of mortality in the world and is one of the most difficult diseases to detect and cure. This fact motivates us to investigate a treatment method by using radiofrequency (RF) ablation. RF ablation therapy kills cancer cells by electromagnetically heating them up. The treatment uses an applicator that is inserted into the body to heat the cells. The cancer cells are exposed to a temperature of more than 60 °C in short duration (a few seconds to a few minutes), thereby causing cell destruction locally. To ensure effective treatment, a minimally invasive method is …

Economic Analysis Of Reactive Distillation In The Production Of Tert-Amyl Methyl Ether (Tame), Clayton Brandenburg

Senior Theses

Aspen HYSYS was used to make two flowsheets, one with plug flow reactors and distillation columns and another with a reactive distillation column, to see which flowsheet was better at producing tert-amyl methyl ether (TAME) and which one was more economically feasible. The goal was to produce 15,000 metric tons of TAME per year by reacting a naptha stream with methanol. It was found that both flowsheets were capable of producing the desired amounts of TAME and with product purities around 100%. The conversions of the reactive distillation was 93.93%, significantly higher than the 72.48% and 76.98% in the base …

The Effect Of Incorporating Different Concentrations Of Chlorhexidine Digluconate On The Degree Of Conversion Of An Experimental Adhesive Resin, Lamiaa Mahmoud Moharam, Haidy Nabil Salem, Hanaa Mahmoud Elgamily

Chemical and Biochemical Engineering Faculty Research & Creative Works

Background: The aim of this study was to evaluate the effect of chlorhexidine digluconate incorporation on the degree of conversion of an experimental adhesive resin. Material and methods: The experimental resin was prepared from 70 wt.% bisphenol A glycerolate dimethacrylate, 30 wt.% hydroxyethyl methacrylate, silanized SiO₂ nanofillers, 0.5% of camphorquinone and ethyl 4-dimethylaminebenzoate (binary photo-initiator system). Five chlorhexidine digluconate concentrations (0, 0.5, 1, 2 and 4 wt%) were then incorporated into the experimental resin. Thirty Potassium Bromide pellets were prepared then divided into six groups (n=5/group), representing the tested adhesive resins (Single Bond 2, 0, 0.5, 1, 2 and …

Modeling And Validation Of Local Electrowinning Electrode Current Density Using Two Phase Flow And Nernst-Planck Equations, Joshua M. Werner, W. Zeng, M. L. Free, Z. Zhang, J. Cho

Mining Engineering Faculty Publications

In this work we demonstrate the validity of a multi-physics model using COMSOL to predict the local current density distribution at the cathode of a copper electrowinning test cell. Important developments utilizing Euler-Euler bubbly flow with coupled Nernst-Planck transport equations allow additional insights into deposit characteristics and topographies.

Pore-Scale Analysis Of Interfacial Instabilities And Impact Of Heterogeneity On Relative Permeability By Lattice Boltzmann Method, Zhipeng Zhu

LSU Master's Theses

Interfacial instabilities occur often during immiscible fluid flow through porous media and their understanding is essential for waterflooding operations or other oil recovery processes. Although many studies including experimental and numerical have been done to reproduce and analyze the interfacial instabilities in porous median, there is still significant knowledge gap in fundamental understanding of these flow instabilities at the pore-scale. In order to better understand the interfacial instabilities phenomenon, the pore-scale simulations are performed. In this study, Lattice Boltzmann Method is used to simulate two different types of interfacial instabilities: viscous fingering and capillary fingering in irregular sphere packs by …

Definite Indefiniteness Of "Molecular Weight" As A Claim Term For Polymer-Related Patents, Ping-Hsun Chen

The Journal of Business, Entrepreneurship & the Law

The molecular weight of a polymer is not just a number for a single molecule. In fact, molecular weight measurement is based on a large volume of molecules of the same polymer. Due to the non-uniformity of molecular weights, there are several methods to measure an “average molecular weight” of a polymer. Unfortunately, the Federal Circuit in Teva Pharms. USA, Inc. v. Sandoz, Inc., 789 F.3d 1335 (Fed. Cir. 2015), held that the term “molecular weight” in several polymer claims was indefinite, because the term could mean either peak average molecular weight, number average molecular weight, or weight average molecular …

Magnetic Gradient Drilling, Garrett Lowry Nielsen

LSU Master's Theses

The drilling industry has always had difficulties with staying within the mud weight window. The problems associated with failure to stay within the mud weight window include uncontrolled influxes and wellbore collapse on the low pressure side of the window, and fluid losses and wellbore damage on the high pressure side of the window. When the risk for getting outside of this mud window becomes too great, casing must be set in order to isolate formations from each other. If too many strings of casing are set, or if the damage from getting out of the mud weight window is …

Promoter Effects On Iron-Based, Sba-15 Supported Ultra-High Temperature Fischer- Tropsch Catalysts, David P. Weber

USF Tampa Graduate Theses and Dissertations

Promoter effects on SBA-15 supported iron Fischer-Tropsch catalysts were investigated for their potential to improve high temperature catalyst performance. FTS catalysts promoted by manganese (0.15%-1.4%), copper (0.15%-1%), and potassium (0.5%-3%), with all percentages stated on the basis of mass percentage of final catalysts, were prepared and tested at 430°C and ambient pressure in a fixed bed reactor. Manganese showed the ability to promote the FT reaction, increasing both the CO conversion and the average chain length of hydrocarbon products. Compared to the unpromoted catalyst composed only of iron supported on SBA-15, 1.4%Mn (mass) promotion of 15% (mass) iron on SBA-15 …

Systems And Methods For Endotoxin Removal From Fluids, Sutapa Barua

Chemical and Biochemical Engineering Faculty Research & Creative Works

Systems and methods are provided for the removal of endotoxins from fluids. The methods can include the use of polymeric nanoparticles for binding endotoxins present in a fluid. The polymeric nanoparticles can be associated with a support member. The polymeric nanoparticles can have an endotoxin removal capacity of at least 1×10⁹ endotoxin units per gram of polymeric nanoparticle (EU/g) and/or a removal efficacy per unit surface area of the polymeric nanoparticles of at least 1×10⁶ EU/cm².