Optics Commons^™

Suppression Of Raman Soliton Self-Frequency Shift In Photonic Cystal Fibers With Tellurite Subwavelength Core, Shua Wei, Jinhui Yuan, Chongxiu Yu, Sha Li, Boyuan Jin, Xiaoming Hu, Gerald Farrell, Qiang Wu

Articles

A new nonlinear evolution equation including the vector nature of the electromagnetic field and the frequency variation of the mode profile is derived. A kind of new nonlinearity is demonstrated. Its magnitude is strongly dependent on the waveguide geometrical parameters, which will lead to a suppression of the Raman soliton self-frequency shift in a photonic crystal fiber with a tellurite subwavelength core. Our results can be supported by the detailed numerical simulations

Photonic Crystal Fiber Half-Taper Probe Based Refractometer, Pengfei Wang, Ming Ding, Lin Bo, Chunying Guan, Yuliya Semenova, Weimin Sun, Libo Yuan, Gilberto Brambilla, Gerald Farrell

Articles

A compact singlemode - photonic crystal fibre - singlemode fibre tip (SPST) refractive index sensor is demonstrated in this paper. A CO₂ laser cleaving technique is utilsed to provide a clean-cut fibre tip which is then coated by a layer of gold to increase reflection. An average sensitivity of 39.1 nm/RIU and a resolvable index change of 2.56×10^-4 are obtained experimentally with a ~3.2 µm diameter SPST. The temperature dependence of this fiber optic sensor probe is presented. The proposed SPST refractometer is also significantly less sensitive to temperature and an experimental demonstration of this reduced sensitivity is …

Microwave Assisted Reconstruction Of Optical Interferograms For Distributed Fiber Optics Sensing & Characterization Of Pcb Dielectric Properties Using Two Striplines On The Same Board, Lei Hua

Masters Theses

"A new concept, the microwave-assisted reconstruction of an optical interferogram for distributed sensing, was developed to resolve both the position and reflectivity of each sensor along an optical fiber. This approach involves sending a microwave-modulated optical signal through cascaded fiber optic interferometers. The optical spectrum of each sensor can be reconstructed by sweeping the optical wavelength and detecting the modulation signal. A series of cascaded fiber optic extrinsic Fabry-Perot interferometric sensors was used to prove the concept. The microwave-reconstructed interferogram matched well with those recorded individually from a traditional optical spectrometer. The application of distributed strain measurement was also investigated. …

Investigation Of The Sensitivity To Humidity Of An Acrylamide-Based Photopolymer Containing N-Phenylglycine As A Photoinitiator, Tatsiana Mikulchyk, Suzanne Martin, Izabela Naydenova

Articles

Sensitivity of holographic recording materials to the relative humidity (RH) of the environment often restricts their use in fabrication of holographic optical elements and other applications. It is important to develop materials with little or no sensitivity to humidity. In this paper the humidity response of transmission gratings recorded in an acrylamide-based photopolymer containing N-phenylglycine (NPG) as a photoinitiator is studied at RH = 20 – 90 %. The hologram is found to be completely insensitive to humidity at RH below 70 % and its diffraction efficiency remains constant. A decrease in diffraction efficiency is observed at RH = 80 …

Holographic Sensors: Three-Dimensional Analyte-Sensitive Nanostructures And Their Applications, Ali K. Yetisen, Izabela Naydenova, Fernando Da Cruz Vasconcellos, Jeffrey Blyth, Christopher R. R. Lowe

Articles

Holographic sensors are analytical devices that systematically diffract narrow-band light in the ultraviolet to near-infrared range for application in the detection and quantification of analytes and/or physical parameters. They can be functionalized with analyte-responsive materials to construct highly sensitive optical sensors for use in testing, where a visual readout, fast turnaround time, and reversibility are needed. Holography allows fabrication of disposable sensors that are lightweight for miniaturization and multiplexing purposes.3 Holographic sensors offer three capabilities on a single analytical device: (i) label-free analyte-responsive polymer, (ii) real-time, reversible quantification of the external stimuli, and (iii) three-dimensional visual image display.

Optical And Hybrid Imaging And Processing For Big Data Problems, Khan Iftekharuddin, Abdul A. S. Awwal, S. Susan Young, Ghaleb M. Abdulla

Electrical & Computer Engineering Faculty Publications

(First paragraph) The scientific community has been dealing with big data for a long time. Due to advancement in sensing, networking, and storage technology, other domains such as business, health, and social media followed. Data are considered the gold of the 21st century and are being collected, stored, and analyzed at a rapid pace. The amount of data being collected creates a compelling case for investing in hardware and software research to support generating even more data from new sensors and with better quality. It also creates a compelling case for investing in research and development of new hardware and …

Forcing Mutual Coherence In Diode Laser Stacks, Jonathan R. Wurtz

Honors Theses and Capstones

This paper will discuss both theoretical and experimental attempts to improve the spatial beam quality of diode laser stacks using an external optical system. An overview and derivation of the mathematics of both the optical system and diode lasers will be discussed. The experimental setup will be presented, as well as the fundamental theoretical and experimental results that suggest the external optical system used for this thesis fails to improve the beam quality of a diode laser stack.

Ionizing Radiation Detection Using Microstructured Optical Fiber, Stanton Dehaven

Electrical & Computer Engineering Theses & Dissertations

Ionizing radiation detecting microstructured optical fibers are fabricated, modeled and experimentally measured for X-ray detection in the 10-40 keV energy range. These fibers operate by containing a scintillator material which emits visible light when exposed to ionizing radiation. An X-ray source characterized with a CdTe spectrometer is used to quantify the X-ray detection efficiency of the fibers. The solid state CdTe detector is considered 100% efficient in this energy range. A liquid filled microstructured optical fiber (MOF) is presented where numerical analysis and experimental observation leads to a geometric theory of photon transmission using total internal reflection. The model relates …

An Investigation Of Electro-Optical 1/F Noise Reduction In An Open-Path Tunable Diode Laser Spectrometer, Samira Adnan Mahdi

Theses and Dissertations

A mobile spectrometer system has been designed to scan the near-surface atmosphere for ammonia gas over a wide range of distances (10 m to 1 Km). Since the system is designed for space applications, it needs to be small, light weight, and low power, which dictates the use of relatively low frequency measurement scans. The spectrometer uses a diode laser, which is subject to a large of electro-optical 1/f noise component at these low frequencies. In this work, digital signal processing techniques are developed to reduce the effects of 1/f noise in gas measurements. A Double Fast Fourier Transform-Based Filter …

Direct Coupling Of Photonic Modes And Surface Plasmon Polaritons Observed In 2-Photon Peem, Robert Campbell Word, Joseph Fitzgerald, Rolf Könenkamp

Physics Faculty Publications and Presentations

We report the direct microscopic observation of optical energy transfer from guided photonic modes in an indium tin oxide (ITO) thin film to surface plasmon polaritons (SPP) at the surfaces of a single crystalline gold platelet. The photonic and SPP modes appear as an interference pattern in the photoelectron emission yield across the surface of the specimen. We explore the momentum match between the photonic and SPP modes in terms of simple waveguide theory and the three-layer slab model for bound SPP modes of thin metal films. We show that because the gold is thin (30- 40 nm), two SPP …

Temperatures In The Mid-Latitude Mesosphere During Sudden Stratospheric Warmings As Determined From Rayleigh Lidar Data, Leda Sox, Vincent B. Wickwar, Chad Fish, Joshua P. Herron

Graduate Student Posters

Sudden Stratospheric Warmings (SSWs) are major disturbances in the polar region of the winter hemisphere that cause major changes in stratospheric temperature and circulation. SSWs are characterized by a temperature increase of tens of degrees Kelvin, averaged over 60°-90° latitude, and a weakening of the polar vortex that persists for the order of a week at the 10 hPa level (roughly 32 km) [Labitzke and Naujokat, 2000]. The polar vortices are cyclones centered on both of the Earth’s poles that are present from the mid-troposphere to the lower stratosphere. Eastward zonal winds define the strong polar vortices in the winter. …

Infrared Skin Damage Thresholds From 1319-Nm Continous-Wave Laser Exposures, Jeffrey W. Oliver, Revecca Vincelette, Gary Noojin, Clifton D. Clark, Corey Harbert, Kurt J. Schuster, Aurora D. Schingledecker, Semih S. Kumru, Justin Maughan, Naomi Kitzis, Gavin D. Buffington, David J. Stolarski, Robert J. Thomas

Physics Faculty Publications

A series of experiments were conducted in vivo using Yucatan miniature pigs (Sus scrofa domestica) to determine thermal damage thresholds to the skin from 1319-nm continuous-wave Nd:YAG laser irradiation. Experiments employed exposure durations of 0.25, 1.0, 2.5, and 10 s and beam diameters of ∼0.6 and 1 cm. Thermal imagery data provided a time-dependent surface temperature response from the laser. A damage endpoint of fifty percent probability of a minimally visible effect was used to determine threshold for damage at 1 and 24 h postexposure. Predicted thermal response and damage thresholds are compared with a numerical model of opticalthermal interaction. …

Analysis Of Polarimetric Synthetic Aperture Radar And Passive Visible Light Polarimetric Imaging Data Fusion For Remote Sensing Applications, Sanjit Maitra

Theses

The recent launch of spaceborne (TerraSAR-X, RADARSAT-2, ALOS-PALSAR, RISAT) and airborne (SIRC, AIRSAR, UAVSAR, PISAR) polarimetric radar sensors, with capability of imaging through day and night in almost all weather conditions, has made polarimetric synthetic aperture radar (PolSAR) image interpretation and analysis an active area of research. PolSAR image classification is sensitive to object orientation and scattering properties. In recent years, significant work has been done in many areas including agriculture, forestry, oceanography, geology, terrain analysis. Visible light passive polarimetric imaging has also emerged as a powerful tool in remote sensing for enhanced information extraction. The intensity image provides information …

Stimulated Raman Scattering In Micro Sphere Resonators, Ruoyu Zhang

All Theses

Micro sphere resonators that hold optical whisper gallery modes (WGMs) provide an innovative option for implementing micro optical resonators. The unique properties of the micro sphere resonator make it capable to introduce resonance for various optical phenomenon, like stimulated Raman scattering (SRS), in micron scale.

This thesis illustrates the characteristics of micro sphere resonators and demonstrates the resonance-enhanced SRS in micro sphere resonators with reduce threshold power. Both theoretical and experimental results are presented. Coupling model for WGM is derived in transfer matrix method. Simulation analyses for mode pattern of WGMs are solved based on mathematic model and finite element …

Design And Fabrication Of An Infrared Optical Pyrometer Asic As A Diagnostic For Shock Physics Experiments, Jared Gordon

UNLV Theses, Dissertations, Professional Papers, and Capstones

Optical pyrometry is the sensing of thermal radiation emitted from an object using a photoconductive device to convert photons into electrons, and is an important diagnostic tool in shock physics experiments. Data obtained from an optical pyrometer can be used to generate a blackbody curve of the material prior to and after being shocked by a high speed projectile. The sensing element consists of an InGaAs photodiode array, biasing circuitry, and multiple transimpedance amplifiers to boost the weak photocurrent from the noisy dark current into a signal that can eventually be digitized. Once the circuit elements have been defined, more …

Steady-State Switching And Dispersion/Absorption Spectroscopy Of Multistate Atoms Inside An Optical Ring Cavity, Jiteng Sheng

Graduate Theses and Dissertations

This thesis mainly focuses on the experimental investigations of electromagnetically induced transparency (EIT) related phenomena in various systems involving multilevel atoms inside an optical ring cavity. Semiclassical methods, e.g. density-matrix equations, are used through out this thesis to simulate the experimental results. First, the cavity transmission spectrum can be significantly modified when multilevel atoms are placed inside an optical ring cavity. Such coupled atom-cavity systems are well explained by the intracavity dispersion/absorption properties. Specifically, three-level lambda-type, four-level N-type and double-lambda-type atoms inside an optical ring cavity are investigated by examining their cavity transmission spectra. Second, optical multistability (OM) has been …

Physics-Based Surface Energy Model Optimization For Water Bodies In Cold Climates Using Visible And Calibrated Thermal Infrared Imagery, May V. Casterline

Theses

When tasked with accurately modeling a water body in a cold climate environment, the complexity of the system being simulated and the numerous parameters affecting the observable outcome pose an arduous task for any modeling effort. The task is increasingly complicated when the body of water is serving as a cooling pond for a power plant and can become partially frozen. The introduction of a heat effluent into the water creates a highly dynamic system whose physical state is not only reactionary to the surrounding environmental conditions, but the industrial facility's operating parameters as well. Both calibrated thermal and visible …

Molecular Fluorescence In The Vicinity Of A Charged Metallic Nanoparticle, H. Y. Chung, P. T. Leung, D. P. Tsai

Physics Faculty Publications and Presentations

The modified fluorescence properties of a molecule in the vicinity of a metallic nanoparticle are further studied accounting for the possible existence of extraneous charges on the particle surface. This is achieved via a generalization of the previous theory of Bohren and Hunt for light scattering from a charged sphere, with the results applied to the calculation of the various decay rates and fluorescence yield of the admolecule. Numerical results show that while charge effects will in general blue-shift all the plasmonic resonances of the metal particle, both the quantum yield and the fluorescence yield can be increased at emission …

Characterization Of Planar Wave Guides By Angle-Dependent Excitation Of Guided Modes, Edward D. Lunde

Physics

In this project a high resolution rotation stage was used to measure the angle of coupling of light into planar waveguide modes. Control of the stage and acquisition of light intensity data was done using the commercially available programming environment, MATLAB. Reliable, repeatable excitation of modes was done using prism coupling. We also investigated coupling using a surface grating on the waveguide.

Global Fossil Energy Markets And Climate Change Mitigation: An Analysis With Remind, Nico Bauer, Ioanna Mouratiadou, Gunnar Luderer, Lavinia Baumstark, Robert J. Brecha, Ottmar Edenhofer, Elmar Kriegler

Physics Faculty Publications

We analyze the dynamics of global fossil resource markets under different assumptions for the supply of fossil fuel resources, development pathways for energy demand, and climate policy settings. Resource markets, in particular the oil market, are characterized by a large discrepancy between costs of resource extraction and commodity prices on international markets. We explain this observation in terms of (a) the intertemporal scarcity rent, (b) regional price differentials arising from trade and transport costs, (c) heterogeneity and inertia in the extraction sector. These effects are captured by the REMIND model. We use the model to explore economic effects of changes …