Optics Commons^™

Mode-Locked Laser Based On Large Core Yb3+-Doped Fiber, Fei Jia

Electronic Theses and Dissertations

The thesis reviews principle of laser cavity and gives a general introduction to modelocked laser (MLL). By using Yb3+-doped fiber as gain medium, passive MLL cavity is developed in experiment, aiming to obtain femtosecond pulses with high pump power from 25W to 35W. The gain medium fiber with 65µm core diameter is cleaved with one flat end and another angled. Pump laser with 976nm wavelength is coupled into Yb3+ -doped fiber to excite signal from 1020nm to 1040nm in the core. 9W is threshold for laser setup. After locking all modes, picosecond pulses are output from laser cavity and coupled …

Analysis And Design Of Non-Hermitian Optical Systems, Ali Kazemi Jahromi

Electronic Theses and Dissertations

From a very general perspective, optical devices can be viewed as constructions based on the spatial engineering of the optical index of refraction. Sculpting the real part of the refractive index produces the wide variety of known passive optical devices, such as waveguides, resonators, gratings, among a plethora of other possibilities for managing the transport of light. Less attention has been directed to engineering the imaginary part of the refractive index – that is responsible for optical gain and absorption – in conjunction with the real part of the refractive index. Optical gain is the building block of amplifiers and …

Nonlinear Dynamics In Multimode Optical Fibers, Mohammad Amin Eftekhar

Electronic Theses and Dissertations

Multimode optical fibers have recently reemerged as a viable platform for addressing a number of long-standing issues associated with information bandwidth requirements and power-handling capabilities. The complex nature of heavily multimoded systems can be effectively exploited to observe altogether novel physical effects arising from spatiotemporal and intermodal linear and nonlinear processes. Here, we have studied nonlinear dynamics in multimode optical fibers (MMFs) in both the normal and anomalous dispersion regimes. In the anomalous dispersion regime, the nonlinearity leads to a formation of spatiotemporal 3-D solitons. Unlike in single-mode fibers, these solitons are not unique and their properties can be modified …

Single Mode Wavelength-Tunable Thulium Fiber, Dong Jin Shin

Electronic Theses and Dissertations

Thulium fiber lasers have the broadest emission wavelength bandwidth out of any rare-earth doped fiber lasers. The emission wavelength starts from 1.75μm and ends at around 2.15μm, covering a vast swath of the eye safe wavelength region and intersecting with a large portion of mid-infrared atmospheric transmission window. Also, thulium fiber lasers provide the highest average output power of any other rare-earth doped fiber lasers in these wavelength regimes, making them uniquely suited for applications such as remote sensing. At the moment, high power beam propagation of continuous wave laser through the atmosphere in the mid-infrared range is yet to …

2 Micron Fiber Lasers: Power Scaling Concepts And Limitations, Alex Sincore

Electronic Theses and Dissertations

Thulium- and holmium-doped fiber lasers (TDF and HDF) emitting at 2 micron offer unique benefits and applications compared to common ytterbium-doped 1 micron lasers. This dissertation details the concepts, limitations, design, and performance of four 2 micron fiber laser systems. While these lasers were developed for various end-uses, they also provide further insight into two major power scaling limitations. The first limitation is optical nonlinearities: specifically stimulated Brillouin scattering (SBS) and modulation instability (MI). The second limitation is thermal failure due to inefficient pump conversion. First, a 21.5 W single-frequency, single-mode laser with adjustable output from continuous-wave to nanosecond pulses …

Studies Of Magnetically Induced Faraday Rotation By Polarized Helium-3 Atoms, Joshua Abney

Theses and Dissertations--Physics and Astronomy

Gyromagnetic Faraday rotation offers a new method to probe limits on properties of simple spin systems such as the possible magnetic moment of asymmetric dark matter or as a polarization monitor for polarized targets. Theoretical calculations predict the expected rotations of linearly polarized light due to the magnetization of spin-1/2 particles are close to or beyond the limit of what can currently be measured experimentally (10⁻⁹ rad). So far, this effect has not been verified. Nuclear spin polarized ³He provides an ideal test system due to its simple structure and ability to achieve high nuclear spin polarization via …

Novel Faraday Rotation Effects Observed In Ultra-Thin Iron Garnet Films, Brandon Blasiola

Dissertations, Master's Theses and Master's Reports

Recent work performed by A. Chakravarty and M. Levy showed experimentally a dramatic increase in the specific Faraday Rotation (FR) of the iron garnet Bi_0.8Lu_0.2Gd₂Fe₅O₁₂. A theoretical model, based purely on classical electrodynamics, attempting to explain this behavior was developed by colleagues in Russia that not only confirmed the asymptotic increase in the specific FR at sub-50nm film thicknesses but also suggested that the specific FR should exhibit significant fluctuations at sub-500 nm film thicknesses. The original data points were widespread with steps of 50 nm or more between data …

Self-Processing Photopolymer Materials For Versatile Design And Fabrication Of Holographic Sensors And Interactive Holograms, Dervil Cody, Sabad-E Gul, Tatsiana Mikulchyk, Muhammad Irfan, Anastasia Kharchenko, Kamila Goldyn, Suzanne Martin, Svetlana Mintova, John Cassidy, Izabela Naydenova

Articles

The aim of this paper is to discuss the benefits as well as the limitations of utilizing photopolymer materials in the design of holograms that are responsive to changes in their environment, such as changes in the concentration of a specific substance, temperature, and pressure. Three different case studies are presented, including both surface and volume phase holograms, in order to demonstrate the flexibility in the approach of utilizing holographic photopolymers for the design of sensors and interactive optical devices. First, a functionalized surface relief hologram is demonstrated to operate as an optical sensor for the detection of metal ions …

Theoretical Modeling And Design Of Photonic Structures In Zeolite Nanocomposites For Gas Sensing. Part Ii: Volume Gratings, Dervil Cody, Izabela Naydenova

Articles

The suitability of holographic structures fabricated in zeolite nanoparticle-polymer composite materials for gas sensing applications has been investigated. Theoretical modelling of the sensor response (i.e. change in hologram readout due to a change in refractive index modulation or thickness as a result of gas adsorption) of different sensor designs was carried out using Raman-Nath theory and Kogelnik’s Coupled Wave Theory. The influence of a range of parameters on the sensitivity of holographically-recorded surface and volume photonic structures has been studied, namely hologram geometry, hologram thickness and spatial frequency, reconstruction wavelength, and zeolite nanoparticle refractive index. From this, the optimum fabrication …

Multiscale Imaging Of The Mouse Cortex Using Two-Photon Microscopy And Wide-Field Illumination, Jonathan Richard Bumstead

McKelvey School of Engineering Graduate Student Theses & Dissertations

The mouse brain can be studied over vast spatial scales ranging from microscopic imaging of single neurons to macroscopic measurements of hemodynamics acquired over the majority of the mouse cortex. However, most neuroimaging modalities are limited by a fundamental trade-off between the spatial resolution and the field-of-view (FOV) over which the brain can be imaged, making it difficult to fully understand the functional and structural architecture of the healthy mouse brain and its disruption in disease. My dissertation has focused on developing multiscale optical systems capable of imaging the mouse brain at both microscopic and mesoscopic spatial scales, specifically addressing …

Speckle Effects In Target-In-The-Loop Laser Beam Projection Systems, Mikhail Vorontsov

Electro-Optics and Photonics Faculty Publications

In target-in-the-loop laser beam projection scenarios typical of remote sensing, directed energy, and adaptive optics applications, a transmitted laser beam propagates through an optically inhomogeneous medium toward a target, scatters off the target’s rough surface, and returns back to the transceiver plane. Coherent beam scattering off the randomly rough surface results in strong speckle modulation in the transceiver plane. This speckle modulation has been a long-standing challenge that limits performance of remote sensing, active imaging, and adaptive optics techniques. Using physics-based models of laser beam scattering off a randomly rough surface, we show that received speckle-field spatial and temporal characteristics …

Recursive Non-Local Means Filter For Video Denoising, Redha A. Ali, Russell C. Hardie

Electrical and Computer Engineering Faculty Publications

In this paper, we propose a computationally efficient algorithm for video denoising that exploits temporal and spatial redundancy. The proposed method is based on non-local means (NLM). NLM methods have been applied successfully in various image denoising applications. In the single-frame NLM method, each output pixel is formed as a weighted sum of the center pixels of neighboring patches, within a given search window.

The weights are based on the patch intensity vector distances. The process requires computing vector distances for all of the patches in the search window. Direct extension of this method from 2D to 3D, for video …

Energy From Active Galactic Nuclei And The Effects On Host Spiral Galaxies, Amanda Schilling

Graduate Theses and Dissertations

I have investigated the energy output of active galactic nuclei (AGN) in order to understand how these objects evolve and the impact they may have on host galaxies. First, I looked at a sample of 96 AGN at redshifts $z \sim 2, 3,$ and $4$ which have imaging and thus luminosity measurements in the $griz$ and $JHK$ observed wavebands. For these galaxies, I have co-epochal data across those bands which accounted for variability in AGN luminosity. I used the luminosity measurements in the five bands to construct spectral energy distributions (SED) in the emitted optical-UV bands for each AGN. I …

Generalized Ellipsometry On Complex Nanostructures And Low-Symmetry Materials, Alyssa Mock

Department of Electrical and Computer Engineering: Dissertations, Theses, and Student Research

In this thesis, complex anisotropic materials are investigated and characterized by generalized ellipsometry. In recent years, anisotropic materials have gained considerable interest for novel applications in electronic and optoelectronic devices, mostly due to unique properties that originate from reduced crystal symmetry. Examples include white solid-state lighting devices which have become ubiquitous just recently, and the emergence of high-power, high-voltage electronic transistors and switches in all-electric vehicles. The incorporation of single crystalline material with low crystal symmetry into novel device structures requires reconsideration of existing optical characterization approaches. Here, the generalized ellipsometry concept is extended to include applications for materials with …

Free-Space Measurements Of Dielectrics And Three-Dimensional Periodic Metamaterials, Clifford E. Kintner

Graduate Theses and Dissertations

This thesis presents the free-space measurements of a periodic metamaterial structure. The metamaterial unit cell consists of two dielectric sheets intersecting at 90 degrees. The dielectric is a polyetherimide-based material 0.001” thick. Each sheet has a copper capacitively-loaded loop (CLL) structure on the front and a cut-wire structure on the back. Foam material is used to support the unit cells. The unit cell repeats 40 times in the x-direction, 58 times in the y-direction and 5 times in the z-direction. The sample measures 12” × 12” × 1” in total. We use a free-space broadband system comprised of a pair …

Power-Law Schell-Model Sources, Milo W. Hyde Iv

Faculty Publications

A new type of Schell-model source is developed that has a spectral degree of coherence, or spatial power spectrum, which is described by a power-law function. These power-law sources generally produce cusped, or peaked far-zone spectral density patterns making them potentially useful in directed energy applications. The spectral degrees of coherence, spatial power spectra, and spatial coherence radii for power-law sources are derived and discussed. Two power-law sources are then synthesized in the laboratory using a liquid crystal spatial light modulator. The experimental spectral densities are compared to the corresponding theoretical predictions to serve as a proof of concept.

Application Of Metamaterials To Rf Energy Harvesting And Infrared Photodetection, Clayton M. Fowler

USF Tampa Graduate Theses and Dissertations

Techniques for adapting metamaterials for the improvement of RF energy harvesting and infrared photodetection are demonstrated using experimental and computer simulation methods. Two methods for RF energy harvesting are experimentally demonstrated and supported by computer simulation. In the first method, a metamaterial perfect absorber (MPA) is made into a rectenna capable of harvesting RF energy and delivering power to a load by soldering Schottky diodes onto connected split ring resonator (SRR) structures composing the planar metasurface of the perfect absorber. The metamaterial rectenna is accompanied by a ground plane placed parallel to it, which forms a Fabry-Perot cavity between the …

Analysis Of The Joint Impact Of Atmospheric Turbulence And Refractivity On Laser Beam Propagation, Victor A. Kulikov, Mikhail Vorontsov

Electro-Optics and Photonics Faculty Publications

A laser beam propagation model that accounts for the joint effect of atmospheric turbulence and refractivity is introduced and evaluated through numerical simulations. In the numerical analysis of laser beam propagation, refractive index inhomogeneities along the atmospheric propagation path were represented by a combination of the turbulence-induced random fluctuations described in the framework of classical Kolmogorov turbulence theory and large-scale refractive index variations caused by the presence of an inverse temperature layer. The results demonstrate that an inverse temperature layer located in the vicinity of a laser beam’s propagation path may strongly impact the laser beam statistical characteristics including the …

Electromagnetic Resonant Scattering In Layered Media With Fabrication Errors, Emily Anne Mchenry

LSU Doctoral Dissertations

In certain layered electromagnetic media, one can construct a waveguide that supports a harmonic electromagnetic field at a frequency that is embedded in the continuous spectrum. When the structure is perturbed, this embedded eigenvalue moves into the complex plane and becomes a “complex resonance” frequency. The real and imaginary parts of this complex frequency have physical meaning. They lie behind anomalous scattering behaviors known collectively as “Fano resonance”, and people are interested in tuning them to specific values in optical devices. The mathematics involves spectral theory and analytic perturbation theory and is well understood [16], at least on a theoretical …

The Simulation, Design, And Fabrication Of Optical Filters, John-Michael Juneau

Graduate Theses - Physics and Optical Engineering

The purpose of this thesis is to create a model for designing optical filters and a method for fabricating the designed filters onto a multitude of substrates, as well as to find ways to optimize this process. The substrates that were tested were quartz, glass slides, polycarbonate, and polyethylene terephthalate (PET). This work will account for variations in the deposition process and substrate cleaning method, in order to optimize the performance of the final optical filter. Several different filters were simulated and then fabricated. These filters included 3, 5, and 7-layer Bragg reflectors, 11-layer narrowband filters, and some variations of …