Optics Commons^™

Generating Electromagnetic Schell-Model Sources Using Complex Screens With Spatially Varying Auto- And Cross-Correlation Functions, Milo W. Hyde Iv

Faculty Publications

We present a method to generate any physically realizable electromagnetic Schell-model source. Our technique can be directly implemented on existing vector-beam generators that utilize spatial light modulators for coherence control, beam shaping, and relative phasing. This work significantly extends published research on the subject, where control over the partially coherent source’s cross-spectral density matrix was limited. We begin by presenting the statistical optics theory necessary to derive and implement our method. We then apply our technique, both analytically and in simulation, to produce two electromagnetic Schell-model sources from the literature. We demonstrate control over the full cross-spectral density matrices of …

Laser Irradiation Of Mung Bean (Vigna Radiata L.) At Two Wavelengths For Enhanced Seedling Development, Rayno Vic B. Janayon, Raphael A. Guerrero

Physics Faculty Publications

Two laser sources operating at wavelengths of 632.8 nm (He-Ne) and 488 nm (Ar+

) are used in examining the effects of coherent, low-power, continuous wave exposure on the development of Vigna radiata L. Presowing laser irradiation of seeds leads to an improvement of mung bean seedling characteristics, with increased values of hypocotyl length (an increase of up to 22.5%), root length (an increase of up to 28.8%), and seedling mass (a maximum increase of 29.2%). Measured parameters between seedlings from laser-irradiated seeds and from control samples are statistically different at a level of significance equal to 0.05. For both …

Study Of The Effect Of Magnetic Nanoparticles On The Hologram Recording Capability Of Photopolymer Nanocomposite For Development Of Holographic Sensor/Actuator, Muhammad Irfan, Suzanne Martin, Izabela Naydenova

Conference Papers

Photopolymer nanocomposite materials utilising nanoparticles of varied refractive index are one of the most attractive materials for holography due to their tuneable properties. The preparation of the photopolymer nanocomposites can involve mixing a stable colloidal suspension in the photopolymer solution or printing of the nanoparticle colloidal suspension on top of a dried photopolymer layer. By following the first approach in this study a novel photopolymer nanocomposite material is prepared for holographic recording. It consists of N-isopropylacrylamide (NIPA)-based photopolymer as a host and iron oxide magnetic nanoparticles as nanodopant. The methodology of the photopolymer nanocomposite material preparation is explained in detail. …

Development Of Photopolymer Material With Improved Dynamic Range And Sensitivity, Brian Rogers, Izabela Naydenova, Suzanne Martin

Conference Papers

In this study the effect of the concentration of acrylamide and the influence of different initiators in a photopolymer composition for holographic recording of diffraction gratings is investigated. Light manipulating Holographic Optical Elements (HOEs) have a number of characteristics which can be optimised for different roles. However, at the core of these devices is the refractive index modulation that has been created in the material during recording. Typically higher refractive index modulation will enable greater diffraction efficiency. Solar concentrating HOEs can particularly benefit from material that experiences higher refractive index modulation. For a solar concentrator to have a high acceptance …

Exciton Polaritons In Two-Dimensional Transition Metal Dichalcogenides, Jie Gu

Dissertations, Theses, and Capstone Projects

Strong interaction between photons and excitons in semiconductors results in the formation of half-light half-matter quasiparticles termed exciton-polaritons. Owing to their hybrid character, they inherit the strong interparticle interaction from their excitonic (matter) component via Coulomb interaction while the photonic component lends the small mass (~10⁵ times lighter than free electrons) and long propagation distances. Additionally, exciton-polaritons also carry properties of the host material excitons such as spin and valley polarization and can be probed via the photons that leak out of the cavities since the photon carries all the information owing to conservation laws. Since the first demonstration …

Measuring Length Of Electron Bunches With Optics In Lcls-Ii, Nathan Ahn, Alan Fisher

STAR Program Research Presentations

Since the launch of the LINAC Coherent Light Source (LCLS) in 2009, there have been over 1,000 publications enabling pioneering research across multiple fields. Advances include: harnessing the sun’s light, revealing life’s secrets and aiding drug development, developing future electronics, designing new materials and exploring fusion, customizing chemical reactions, and many more. These discoveries gathered worldwide attention, and now work has begun on a new revolutionary tool, LCLS-II. The LCLS-II will pulse at a million times a second, compared to the 120 pulses from the LCLS. Within the LCLS-II, there are two chicanes, serpentine curves. As the electron beam passes …

Digital Holography Efficiency Experiments For Tactical Applications, Douglas E. Thornton

Theses and Dissertations

Digital holography (DH) uses coherent detection and offers direct access to the complex-optical field to sense and correct image aberrations in low signal-to-noise environments, which is critical for tactical applications. The performance of DH is compared to a similar, well studied deep-turbulence wavefront sensor, the self-referencing interferometer (SRI), with known efficiency losses. Wave optics simulations with deep-turbulence conditions and noise were conducted and the results show that DH outperforms the SRI by 10's of dB due to DH's strong reference. Additionally, efficiency experiments were conducted to investigate DH system losses. The experimental results show that the mixing efficiency (37%) is …

Optical And Collective Properties Of Excitons In 2d Semiconductors, Matthew N. Brunetti

Dissertations, Theses, and Capstone Projects

We study the properties of excitons in 2D semiconductors (2DSC) by numerically solving the Schr\"{o}dinger equation for an interacting electron and hole in the effective mass approximation, then calculating optical properties such as the transition energies, oscillator strengths, and absorption coefficients. Our theoretical approach allows us to consider both direct excitons in monolayer (ML) 2DSC and spatially indirect excitons in heterostructures (HS) consisting of two 2DSC MLs separated by few-layer insulating hexagonal boron nitride (h-BN). In particular, we study indirect excitons in TMDC HS, namely MoS₂, MoSe₂, WS₂, and WSe₂; …

Studying Near-Critical And Super-Critical Fluids In Reduced Gravity, Christian Hawkins, Ana Oprisan, Carole Lecoutre-Chabot, Yves Garrabos, Daniel Beysens

Journal of the South Carolina Academy of Science

Critical and supercritical fluids have a variety of applications, from use as machine lubricants in high pressure or high temperature environments to the manufacturing of materials such as aerogel. The optical properties of fluids undergo rapid changes near the critical point resulting in a rapid increase in turbidity known as critical opalescence. These optical changes can be used to probe the universality of critical behavior. As a fluid approaches the critical point, the compressibility rapidly increases. In a gravitational field, this increase in compressibility leads to near-critical fluids stratifying by phase and density, making it difficult to observe the optical …

Near-Field Effects On Partially Coherent Light Scattered By An Aperture, Milo W. Hyde Iv, Michael J. Havrilla

Faculty Publications

We investigate how the near field affects partially coherent light scattered from an aperture in an opaque screen. Prior work on this subject has focused on the role of surface plasmons, and how they affect spatial coherence is well documented. Here, we consider other near-field effects that might impact spatial coherence. We do this by examining the statistics of the near-zone field scattered from an aperture in a perfect electric conductor plane—a structure that does not support surface plasmons. We derive the near-field statistics (in particular, cross-spectral density functions) by applying electromagnetic equivalence theorems and the Method of Moments. We …

Controlling The Spatial Coherence Of An Optical Source Using A Spatial Filter, Milo W. Hyde Iv

Faculty Publications

This paper presents the theory for controlling the spectral degree of coherence via spatial filtering. Starting with a quasi-homogeneous partially coherent source, the cross-spectral density function of the field at the output of the spatial filter is found by applying Fourier and statistical optics theory. The key relation obtained from this analysis is a closed-form expression for the filter function in terms of the desired output spectral degree of coherence. This theory is verified with Monte Carlo wave-optics simulations of spatial coherence control and beam shaping for potential use in free-space optical communications and directed energy applications. The simulated results …

Tailored Frequency Comb Structures And Their Sensing Applications, James Hendrie

Optical Science and Engineering ETDs

The focus of this dissertation is the development and investigation of nested cavity mode-locked lasers and their resultant tailored frequency combs. A nested cavity is made up of two cavities, known as parents. One parent is a larger, active, 100MHz Ti:Saph oscillator and the other is a smaller, passive, 7GHz Fabry-Perot Etalon (FPE). Unlike standard frequency combs that are continuous, a tailored comb’s teeth are distributed in equally spaced groups where the center of each group corresponds to the resonance of the FPE and the side bands are determined by the resonances of the Ti:Saph. This unique coupling of the …

Polarization Division Multiplexing For Optical Data Communications, Darko Ivanovich

McKelvey School of Engineering Graduate Student Theses & Dissertations

Multiple parallel channels are ubiquitous in optical communications, with spatial division multiplexing (separate physical paths) and wavelength division multiplexing (separate optical wavelengths) being the most common forms. In this research work, we investigate the viability of polarization division multiplexing, the separation of distinct parallel optical communication channels through the polarization properties of light. We investigate polarization division multiplexing based optical communication systems in five distinct parts. In the first part of the work, we define a simulation model of two or more linearly polarized optical signals (at different polarization angles) that are transmitted through a common medium (e.g., air), filtered …

Erratum: "Imaging The Three‐Dimensional Orientation And Rotational Mobility Of Fluorescent Emitters Using The Tri‐Spot Point Spread Function", Oumeng Zhang, Jin Lu, Tianben Ding, Matthew D. Lew

Electrical & Systems Engineering Publications and Presentations

In the original paper, a calibration error exists in the image-formation model used to analyze experimental images taken by our microscope, causing a bias in the orientation measurements in Figs. 2 and 3. The updated measurements are shown in Fig. E1. We have also updated the supplementary material for the original article to discuss the revised PSF model and estimation algorithms (supplementary material 2) and show the revised model and measurements (Figs. S1, S3, S7, S8, and S10–S13).

Microextrusion 3d Printing Of Optical Waveguides And Microheaters, Edidiong Nseowo Udofia

Graduate Theses and Dissertations

The drive for smaller and more compact devices presents several challenges in materials and fabrication strategies. Although photolithography is a well-developed method for creating microdevices, the disparate requirements in fabrication strategies, material choices, equipment and process complexities have limited its applications. Microextrusion printing (μEP) provides a promising alternative for microfabrication. Compared to the traditional techniques, the attractions lie in the wide range of printable material choice, greater design freedom, fewer processing steps, lower cost for customized production, and the plurality of compatible substrates. However, while extrusion-based 3D printing processes have been successfully applied at the macroscale, this seeming simplicity belies …

Development Of A Ground-Based Aerial-Tracking Instrument For Open-Path Spectroscopy To Monitor Atmospheric Constituents, Haden Hodges

Civil Engineering Undergraduate Honors Theses

A ground-based aerial-tracking instrument, known as the Ground Tracker, designed to provide spectral data to quantify greenhouse gases is under development. The Ground Tracker includes an Optical System including a high power rifle scope, video camera, and spectrometer used to locate an active light source from the Emitter, and collect spectral data by utilizing an actuating mirror. The implementation of this instrument could be made low cost by utilizing existing weather balloon infrastructure to allow the Emitter to be placed into the lower stratosphere. The recovery of the emitter will be possible by tracking the GPS coordinates. Weather balloon instrument …

Polarization Properties Of Airy And Ince-Gaussian Laser Beams, Sean Michael Nomoto

Graduate Theses and Dissertations

The description of polarization states of laser light as linear, circular polarization within the paraxial scalar wave approximation is adequate for most applications. However, this description falls short when considering laser light as an electromagnetic wave satisfying Maxwell's equations. An electric field with a constant unit vector for direction of the field and a space dependent complex scalar amplitude in the paraxial wave approximation does not satisfy Maxwell equations which, in general, requires all three Cartesian components of electric and magnetic fields associated for a nonzero laser beam to be nonzero.

Physical observation of passing a linearly polarized laser through …

Rocketry And Observability Predictions For Cubesat, Juliano A. Everett

Publications and Research

Estimating the visibility of Sunlight reflected by the holographic retro-reflector of Cubesat Alpha, and to convert this to star apparent magnitude to learn more about the visibility of these sails through reflected sunlight, to in turn determine if glints of these holograms are visible by terrestrial observers.

Possible Schemes For A Single Photon Switch, Hemlin Swaran Rag

Graduate Theses and Dissertations

I consider the effectiveness of a single control photon to route a target photon using two processes: the first one uses the transient excitation of a two-level system and the second one which uses the permanent population transfer in a three-level Λ-system to route the target photon. In the absence of a single control photon and when the system has additional decay channels, I find ways to optimize the success probability of routing with an increasing number of photons in the control field.

Growth Of Indium Nitride Quantum Dots By Molecular Beam Epitaxy, Steven P. Minor

Graduate Theses and Dissertations

Over the last decade, the evolution of the global consciousness in response to decreasing environmental conditions from global warming and pollution has led to an outcry for finding new alternative/clean methods for harvesting energy and determining ways to minimize energy consumption. III-nitride materials are of interest for optoelectronic and electronic device applications such as high efficiency solar cells, solid state lighting (LEDs), and blue laser (Blu-ray Technology) applications. The wide range of direct band gaps covered by its alloys (0.7eV-6.2eV) best illustrates the versatility of III-nitride materials. This wide range has enabled applications extending from the ultraviolet to the near …