Power and Energy Commons^™

A Country-Level Primary-Final-Useful (Cl-Pfu) Energy And Exergy Database: Overview Of Its Construction And 1971–2020 World-Level Efficiency Results, Paul E. Brockway, Matthew Kuperus Heun, Zeke Marshall, Emmanuel Aramendia, Paul Steenwyk, Thomas Relph, Michelle Widjanarko, Jeonghoo (James) Kim, Anjana Sainju, Julian Irtube

University Faculty Publications and Creative Works

Societal exergy analysis examines the flows of energy and exergy through societies, from primary (e.g. oil) to final (e.g. gasoline) to useful (e.g. propulsion) energy stages. By extending the study of energy to the useful stage, new insights into the under-represented role of energy in economic growth have been made. However, currently (a) country coverage is patchy and incomplete, (b) available data are based on varying methods and assumptions including efficiencies based on economic rather than engineering data, and (c) datasets are constructed using piecemeal computational approaches. To address these gaps, we construct a country-level primary-final-useful (CL-PFU) energy and exergy …

Incremental Quantities Based Permissive Overreaching Transfer Trip Scheme For Protecting Inverter-Based Renewable Resources, Osama Zangoti

Electronic Theses and Dissertations

The power generation landscape evolves, with the increase of inverter-based resources (IBRs) such as solar photovoltaics and wind turbines, providing sustainable and clean energy sources. The shift towards IBRs mitigates climate change, creating considerable challenges to traditional power system protection due to their low fault current. Conventional protection schemes are designed around the internal dynamic of synchronous generators where they can supply an elevated fault current. This thesis explores a protection scheme designed to enhance the security of IBRs. The incremental characteristics of voltage and current coupled with the Permissive Overreaching Transfer Trip scheme (POTT) provide a remarkable ability to …

Harmonic Flow Modeling And Analysis Of A Green Hybrid Ac/Dc Seaport Power System, Krishan Kaushal Ram, Taufik, Helen Yu, Siddharth Vyas

Master's Theses

This thesis aims to design and develop a model for a proposed Green Seaport power system and perform harmonic analysis. The model was developed using MATLAB Simulink and tests were performed by dividing the system into several Battery Energy Storage System (BESS) operating modes such as simultaneous charging and discharging, simultaneous charging, and simultaneous discharging. For each mode, BESS state of charge and other factors such as solar irradiance for the PV system, load levels and power factor were varied to observe the impact on system’s voltage Total Harmonic Distortion (THD) level and current Total Demand Distortion (TDD). 62 separate …

Battery Energy Storage System, Alec C. Maclean, Kaylen H. Schwartz, Kyle A. Begley

Electrical Engineering

The project is a continuation of part 1 of the “Reliability Measurement for Grid-Connected Solar System” project. The goal is to continue where the previous design failed. This project will configure an ITECH IT-6000C and Tabuchi Battery Energy Storage System (BESS) to the small-scale microgrid at the Cal Poly, San Luis Obispo EE Department. Initially, a system was designed to connect an ITECH IT-M3633 as a PV solar source emulator to the Tabuchi BESS within a grid-connected microgrid system in Room 20-102 at Cal Poly. A Photovoltaic Thevenin equivalent model was developed for the ITECH IT-M3633, but this setup failed …

Advancing Embedded Iot Architectures For Space And Terrestrial Applications, Wuwei Douglas Liu, Nicolas Jesus Alvarez, Eric Huang

Electrical Engineering

Radio transceivers play a pivotal role in establishing communication networks, particularly in regions where existing infrastructures are unstable or compromised due to natural disasters or conflicts. By utilizing LoRa (Long Range) communication technology, OWL Integrations develops radio transceivers to establish mesh networks to communicate with one another during disasters. This project team continues development of a second generation OWL board, classified as Quacker Advanced Development (QuAD), with a focus on transitioning to a new microcontroller and integrating GNSS libraries and drivers. An ulterior objective involved R&D for a space application of the board.

Ross Dam Micro Hydropower Project, Ryan Pospichal, Wilson Szeto

Electrical Engineering

In 2020, Utica Water and Power Authority (UWPA) commissioned the development and installation of a micro hydropower system for Ross Dam in northern California. The micro-hydro system was intended to serve as a reliable source of renewable energy to power on-site equipment for monitoring the Ross Reservoir. Despite its innovative approach, the system encountered operational shortcomings, including frequent mechanical failures, rapid wear, and an inability to adapt to variable flow rates. To address these challenges, UWPA has commissioned interdisciplinary teams of Mechanical Engineering (ME) and Electrical Engineering (EE) students to redesign the micro hydropower system. The ME team was entrusted …

X-Band Wireless Power Transfer System Using A Focused Array Lens, Jason Alexander Kunz, Tyler S. Bury, Oscar Damian Gonzalez, Jaime Garcia

Electrical Engineering

Wireless power beaming from space and energy harvesting were once stories of science fiction, until now. Wireless power transmission (WPT) is a field continually in development to provide energy in situations where energy transfer through wires is impractical or unfeasible. This engineering discipline abandons the use of wire technology for the energy transfer between the power source and a distant device. While various forms of WPT exist, our project focuses on transmission through means of radio frequency (RF), utilizing electromagnetic waves to power devices. Furthermore, WPT technology primarily assists in the elimination of a physical connection between devices, and it …

Design Of High Efficiency Doherty Power Amplifier, Kobi G. Kelly, Severin Pindell

Electrical Engineering

The project includes design and fabrication of a high efficiency power amplifier for a student design competition held at International Microwave Symposium (IMS) 2023. Efficient power amplifiers are critical for base station communication requiring efficient use of available power. The final design optimizes power added efficiency (PAE) and linearity. The amplifier will operate at 2.45 GHz. Competitive PAE above 50%, and C/I above 30 dB is achieved by leveraging a Doherty class amplifier using accurate discrete CGH4006P transistor models to simulate an efficient and linear design. Unique design features include optimal transistor bias point selection and power split ratios between …

A 4-Switch Buck-Boost Dc/Dc Converter For Electric Vehicle Applications, Andrew Hudak, Ashley Schiller

Electrical Engineering

In this project, we develop a four switch buck-boost DC/DC converter that is to be integrated into a microgrid-inspired power distribution architecture for electric vehicles. The overall architecture includes DC/DC and DC/AC converters for bi-directional energy transfer between the DC and AC ports along with a communications port to control each energy interface. There is also the onboard battery and the internal combustion engine power exchange being done with DC/DC converters and AC/DC inverters to connect to the centralized DC bus. Hardware prototypes using an Arduino and Raspberry Pi for the 500 W DC/DC and DC/AC converters have been previously …

2024 Marine Energy Collegiate Competition, Nora Riedinger, Miles Mikkelsen, Brendan Stratford, Derek Tom, Zach Kwast, Harmon Yanikian-Sutton, Kennedy Urcelay, Tori Thomas, Brady Caron

Mechanical Engineering

PolyWave Energy is the second team from California Polytechnic University at San Luis Obispo to compete in the Marine Energy Collegiate Competition. PolyWave Energy consists of Mechanical Engineering, Electrical Engineering, and Business Administration students who have worked together from September 2023 to May 2024 on designing, building, and testing a marine power device to serve a selected market.

In response to the escalating concerns surrounding carbon emissions, climate change, and the depletion of fossil fuels, California Polytechnic State University’s Polywave Energy team has developed a sustainable and reliable energy source for Autonomous Underwater Vehicle (AUV) charging. Through extensive research of …

Design And Analysis Of A New Buck-Boost Converter With A Low-Side Switch, Abdullah Awidah

Master's Theses

This work explores the design, simulation, construction, and analysis of a novel Non-isolated DC-DC Buck-Boost converter which has the advantage of incorporating a low-side switch compared to the traditional buck-boost which requires a high-side switch. This allows the use of a low-side driver which further simplifies the design and operation of the converter. The proposed Buck-Boost converter was constructed to provide -24 V output from an input range of 12V-18V with 15V nominal input at 10W maximum output power utilizing 500kHz switching frequency. Findings from simulations and hardware tests verify that the converter effectively provides the desired -24 V output …

A Hybrid Computer To Solve The Selective Harmonic Minimization Problem In Single-Phase Inverters, Dillon Nguyen

Master's Theses

Power electronics possess forms of non-ideality due to the nonlinearity present in physical switches. These switches are driven with pulse width modulation (PWM), which properly down-converts or up-converts based on converter topology. When these switches turn on or off, they introduce the main proponent of efficiency loss: harmonics. This becomes a nonlinear optimization problem with many converters. The solution proposed in this thesis is an analog/digital hybrid computer that utilizes the speed of analog computation and the accuracy of digital computing together. A Plexim RT Box provides the programmability needed for algorithms, while the analog circuit provides low-power, high-speed computation …

Design Of A Dynamic, Reconfigurable, Self-Balancing Battery Pack, Alexander Hallett Neiman

Master's Theses

This thesis details the design and testing of a reconfigurable battery array. Reconfigurable battery arrays, specifically for mobile applications, have the potential to reduce or eliminate use of auxiliary charging, balancing, and inverter systems. Design work included a bidirectional solid state switch and a cell-to-cell bidirectional current-limiting power converter. While the overall efficiency, size, and cost of the battery pack was not competitive with existing options, it demonstrated cell-to-cell balancing and native four-level square wave AC inverter output with an array of only two cells. This demonstrates viability of the concept as well as reveals important requirements and safety features …

Electrical Design For Moringa Leaf Dryer, Jake Weiss

Construction Management

The objective of this project is to provide a methodology to the electrical scope of mechanical leaf dryers. This dryer was particularly designed for an off-grid farm in New Longoro, Ghana in which resources and materials are limited. The electrical system must be designed so that it works with motors, variable frequency drives, worm gears, and other materials that could be sourced in Ghana. The system should also draw minimal power so that remaining photovoltaic energy could be utilized on the farm. The system should be simplistic and repeatable for other farmers to utilize. By using both a numerical analysis …

Decentralized Control Of Renewable Generation Systems, Milad Shojaee

Dissertations

As the global community struggles with the escalating challenges of climate change and environmental degradation, the transition to renewable energy sources has emerged as a paramount solution. Harnessing energy from renewable sources such as solar, wind, and hydro power not only alleviates the adverse effects of conventional fossil fuel energy sources, but also establishes a foundation for a sustainable and resilient future. Microgrids have been utilized as a feasible platform to integrate renewable energy sources into the electrical power generation networks. They include one or more generation units connected to nearby users, and are able to operate in both grid-connected …

Graph-Based Modeling And Optimization Of Wpt Systems For Evs, Matthew J. Hansen, Greg Droge, Abhilash Kamineni

Electrical and Computer Engineering Student Research

A model of a system of wireless power transfer (WPT) pads is developed, where each WPT pad is modeled as a node and the coupling between pads is modeled as graph edges. This modeling approach is generalized to admit primary, secondary, and booster coils, where power can flow among the pads and a pad can fill multiple roles. An excitation in one pad induces voltage and current in all neighboring pads, causing each pad to act as both a booster coil and either a transmitter or a receiver. Power flow through the entire system can be modeled with the graph …

Estimation Of Useful-Stage Energy Returns On Investment For Fossil Fuels And Implications For Renewable Energy Systems, Emmanuel Aramendia, Paul E. Brockway, Peter G. Taylor, Jonathan B. Norman, Matthew K. Heun, Zeke Marshal;

University Faculty Publications and Creative Works

The net energy implications of the energy transition have so far been analysed at best at the final energy stage. Here we argue that expanding the analysis to the useful stage is crucial. We estimate fossil fuelsʼ useful-stage energy returns on investment (EROIs) over the period 1971–2020, globally and nationally, and disaggregate EROIs by end use. We find that fossil fuelsʼ useful-stage EROIs (~3.5:1) are considerably lower than at the final stage (~8.5:1), due to low final-to-useful efficiencies. Further, we estimate the final-stage EROI for which electricity-yielding renewable energy would deliver the same net useful energy as fossil fuels (EROI …

An Integrated Resource Planning Proposal For Tucson Electric Power, Valeria Bernal

Master's Projects and Capstones

An integrated resource plan (IRP) is crucial for utilities to determine the most cost-efficient energy resources while considering system reliability, environmental impact, and regulatory requirements. VitalsparK developed an IRP for Tucson Electric Power (TEP) to transition its current 70% thermal and 30% renewable energy portfolio, emitting 740 grams of CO2 per kWh, toward carbon neutrality by 2050. The proposed plan involves retiring existing infrastructure, adding 8 GW of renewable and storage capacity, and incorporating 2.5 GW of net-zero natural gas power plants. VitalsparK presented two scenarios: the Reference (REF) Case, which focuses on the least-cost portfolio to meet demand through …

Residential Ders In Service-Oriented Load Participation: Enhancing Grid Flexibility, Zhongkai Zeng

Dissertations and Theses

Amidst concerns about power consumption during peak periods and potential grid instability, the role of Distributed Energy Resource (DER) aggregation comes into consideration. Smart electric water heaters with remote capabilities and energy storage offer load reduction capabilities that can help maintain grid stability and manage residential energy consumption. DERs address challenges posed by stochastic renewable energy generation and fossil fuel power plant emissions, playing a contributing role in load shifting and enhancing grid flexibility by participating in energy management programs.

However, high unenrollment rates in demand response programs, notably programs that use direct load control, persist due to customer dissatisfaction. …

Engineering Composite Gridlines For Improved Solar Module Reliability, Andre Chavez

Electrical and Computer Engineering ETDs

Renewable energy sources, such as solar power, are rapidly expanding worldwide to meet increased energy demands. However, these sources are exposed to challenging environmental stressors, such as extreme wind, heavy snow loads, and hailstorms that can cause irreversible damage to the crystalline semiconductor solar cells. Today, single crystalline silicon solar cells dominate the market, and our work is focused on improving their reliability against environmental stressors. One of the main degradation mechanisms caused by environmental stressors is cell cracks. These microcracks can go virtually undetected and lead to reduced power output from solar modules over time. To solve this engineering …