Electrical and Computer Engineering Commons^™

Utepcam: A Scalable Wireless Vision Sensor Architecture For Computational, Power And Bandwidth Constrained Scenarios, Ricardo Zepeda

Open Access Theses & Dissertations

UTEPcam is a low cost and power vision sensor node system. UTEPcam is composed of an Atmel atmega32 8-bit microcontroller, a CY7C09099V static RAM chip, an OV6620 CMOS image sensor, a XBEE transceiver and a SD Flash memory card, and four logic gates. UTEPcam's simple yet efficiently architecture enables it to capture video at one frame per second. At its absolute highest, it is estimated that UTEPcam consumes only 1.321 Amps. When in standby, UTEPcam consumes 21 microamps. Furthermore, UTEPcam's program takes up only 1Kbyte of memory space.

UTEPcam's CPU, a simple 8-bit MCU, is unlike most vision sensor node …

Tin Dioxide Memristors On Glass And Plastic Substrates, Oscar Del Real

Open Access Theses & Dissertations

NanoMIL has studied and developed SnO2-based memristors, while the W.M Keck Center has been a research leader in printed silver inks. The focus of this thesis is to take the previous generation of memristors on glass and develop a process for creating memristors on flexible Kapton film for the first time. Moreover, collaborative work between the two UTEP laboratories produced memristors with printed silver top electrode contacts, also for the first time. These approaches may enable inexpensive flexible memory.

Maturation of the process was achieved by understanding important process parameters and subtle differences between glass and Kapton substrates. Moreover, electrical …

Impulse Oscillometric Features And Parsimonious Respiratory Models Track Small Airway Function In Hispanic And Anglo Children, Erika Guadalupe Meraz Tena

Open Access Theses & Dissertations

Asthma is an inflammatory condition of the peripheral (small) airways resulting in airway hyper-reactivity and, among other symptoms, airflow obstruction. It is the most prevalent chronic respiratory disease in children. Reliable and patient-friendly instruments and methods are required to help pulmonologists accurately detect asthma and Small Airway Impairment (SAI) with acceptable clinical accuracy, specificity and sensitivity. Impulse Oscillometry System (IOS) based on the Forced Oscillation Technique (FOT) has been successfully used to measure lung function in children with a high degree of sensitivity and specificity to SAI and Asthma. IOS is a patient-friendly lung function to measure the mechanical impedance …

Preparation And Characterization Of Iron Oxide And Hydroxide Based Nanomaterials, Guillermo Carbajal Franco

Open Access Theses & Dissertations

Iron (Fe) oxides and hydroxides are common and abundant materials. They exhibit diverse crystal structures, properties and phenomena by virtue of which they find a wide range of scientific and technological applications. Controlled growth and manipulation of the specific structure and electronic behavior to meet the requirements of a given application is a challenging problem in view of many possible phases and composition of the resulting materials. The preparation method and experimental conditions will, therefore, significantly affect the properties and performance of Fe oxides and hydroxides. The goal of the project is to obtain Fe-based oxide/hydroxide catalytic materials and to …

Spatio-Temporal Cardiac Pacing Sites Localization And Time Varying Pericardium Potential Maps Projection Using Ecg Precordial Leads And A Single Moving Dipole Model, Jaime R. De La Cruz

Open Access Theses & Dissertations

A novel non-invasive method for the spatiotemporal localization of the sites of strongest cardiac activity, and for the creation of time varying Pericardium Potential Maps (PPM), with the use of patients' ECG precordial leads, is proposed in this Thesis study. Compared to previous studies, which analyze electrocardiograms in either time domain or spatial domain, the proposed method has the advantage of a simultaneous spatiotemporal electrocardiograph analysis and a 3-D visualization of pericardium potentials maps, as well as, the pericardium surface polarization patterns during the cardiac cycle. The spatial properties added to the electrocardiogram allow for the analysis of specific regions …

Assessment And Evaluation Of Peripheral Neuropathy From Diabetic Mellitus Using Systems Analysis Approach, Oscar Alonso Espino

Open Access Theses & Dissertations

Currently in America 1 out of every 10 residents suffers from diabetes, and this tendency is likely to grow up to "1 of every 3" by the year [6]. Diabetes exhibits several complications. In 2005, the lead cause of stroke and heart disease was diabetes, 68% of the cases [1]. In 2008, 44% of kidney failure was associated with diabetes [1]. 60 to 70 % of cases of diabetes have a mild to severe nervous system damage [1]. Diabetic patients who have developed peripheral neuropathy tend to also develop foot ulceration. In an advanced stage a foot ulcer can lead …

Accelerated Simulation And Testing Of Integrated Circuits Using High Performance Computing Machines, Matthew C. Markulik

Open Access Theses & Dissertations

As Moore's Law continues to hold true and transistor density becomes exponentially larger the need to rely on computer aided design (CAD) simulators has become more relevant and necessary. As we dive into the age of electronic reliance there presents a need to constantly improve methods to reduce time-to-solution for developing technologies. The reliance on CAD simulators for electronic development leaves engineers with an ability to improve the design process by improving these simulators or improving the methods in which these simulators are being utilized. With the advancement of quality fabrication processes and the ability to operate at sub-threshold levels …

Development Of Load Balancing Algorithm Based On Analysis Of Multi-Core Architecture On Beowulf Cluster, Damian Valles

Open Access Theses & Dissertations

In this work, analysis, and modeling were employed to improve the Linux Scheduler for HPC use. The performance throughput of a single compute-node of the 23 node Beowulf cluster, Virgo 2.0, was analyzed to find bottlenecks and limitations that affected performance in the processing hardware where each compute-node consisted of two quad-core processors with eight gigabytes of memory. The analysis was performed using the High Performance Linpack (HPL) benchmark.

In addition, the processing hardware of the compute-node was modeled using an Instruction per Cycle (IPC) metric that was estimated using linear regression. Modeling data was obtained by using the Tuning …

Automated Detection Of Dust Clouds, Sources, And Direction From Noaa-Avhrr Satellite Imagery, Mohammed Qassim Alkhatib

Open Access Theses & Dissertations

This research is mainly focused on automatically locating dust sources and estimating their transport direction in NOAA-AVHRR images. Applications of AVHRR images may include agricultural assessment, producing maps of large area, and to retrieve various geophysical parameters. The AVHRR simultaneously records five bands of data, in our research, we focused on bands four and five since these wavelengths highlight the absorption and subsequent emission of thermal radiation by the silicate particles in the dust storms.

In this research, we propose a new method to detect dust clouds on satellite images. The approach we propose involves the use of an image …

Bioprinting Oxygen Releasing Microparticles For Improved Cell Tissue Viability, Daniel Reyna

Open Access Theses & Dissertations

A major challenge in regenerative medicine/tissue engineering is the difficulty of providing adequate oxygen to all cells within implanted engineered tissues before full vascularization is achieved. To overcome this limitation, a variety of oxygen-releasing particles have been developed to improve cell and tissue survival. However, most of these particles are used in random mixtures within scaffolding materials, which usually leads to an uneven distribution of oxygen in bioengineered tissues. An ideal oxygen supply requires a precise depositing control of oxygen-releasing particles in scaffolds. Cell bioprinting is a novel tissue fabrication approach, in which the bio-printer can be programmed to deposit …

Atrial Fibrillation Signal Analysis, Raja Sarath Chandra Prasad Vaizurs

USF Tampa Graduate Theses and Dissertations

Atrial fibrillation (AF) is the most common type of cardiac arrhythmia encountered in clinical practice and is associated with an increased mortality and morbidity. Identification of the sources of AF has been a goal of researchers for over 20 years. Current treatment procedures such as Cardio version, Radio Frequency Ablation, and multiple drugs have reduced the incidence of AF. Nevertheless, the success rate of these treatments is only 35-40% of the AF patients as they have limited effect in maintaining the patient in normal sinus rhythm. The problem stems from the fact that there are no methods developed to analyze …

Fabrication And Characterization Of Electrospun Cactus Mucilage Nanofibers, Yanay Pais

USF Tampa Graduate Theses and Dissertations

This work seeks to fabricate, optimize, and characterize nanofibers of cactus Opuntia ficus-indica mucilage and Poly (vinyl alcohol) (PVA) by electrospinning. Mucilage is a neutral mixture of sugars produced by cactus and PVA is a non-toxic, water-soluble, synthetic polymer, which is widely used as a co-spinning agent for polymers. Mucilage was extracted from the cactus pad and prepared for electrospinning by mixing with acetic acid. Two types of PVA were used differentiating in high and low molecular weights. Concentrations of PVA were varied to find an adequate threshold for fiber formation. Changing the ratio of PVA to cactus mucilage produced …

Molybdenum Nitride Films In The Back Contact Structure Of Flexible Substrate Cdte Solar Cells, Vasudha Guntur

USF Tampa Graduate Theses and Dissertations

CdTe solar cells in the superstrate configuration have achieved record efficiencies of 16% but those in the substrate configuration have reached efficiencies of only 7.8%. A major reason for the lower efficiency of substrate CdTe solar cells is the poor back contact. In this work, CdTe solar cells of the substrate configuration have been fabricated on flexible metallic substrates. For this type of devices, impurity diffusion out of stainless-steel substrates due to high temperature processing can be a cause for poor cell performance. It is necessary to investigate ways of improving the back contact by trying to mitigate the above …

Fabrication And Characterization Of Novel 2sss Cigs Thin Film Solar Cells For Large-Scale Manufacturing, Keshavanand Jayadevan

USF Tampa Graduate Theses and Dissertations

A novel 2SSS (2 Step Solid Selenization) CIGS (Cu, In, Ga, Se) thin film solar cell recipe was developed which can be a replacement to the conventional co-deposition process usually employed for large-scale manufacturing. The co-deposition procedure is faced with multiple problems such as selenium incorporation, effective gallium incorporation in the absorber. It is a 2-step proprietary procedure with better control over growth mechanisms and material utilization for the absorber layer for the CIGS thin film solar cells. It makes use of solid selenium source as preferred by manufacturers. Each step of the 2-step procedure was dealt with separately for …

Resource Allocation Methodologies With Fractional Reuse Partitioning In Cellular Networks, Hazar Aki

USF Tampa Graduate Theses and Dissertations

Conventional cellular systems have not taken full advantage of fractional frequency reuse and adaptive allocation due to the fixed cluster size and uniformed channel assignment procedures. This problem may cause more fatal consequences considering the cutting-edge 4G standards which have higher data rate requirements such as 3GPP-LTE and IEEE 802.16m (WiMAX). In this thesis, three different partitioning schemes for adaptive clustering with fractional frequency reuse were proposed and investigated. An overlaid cellular clustering scheme which uses adaptive fractional frequency reuse factors would provide a better end-user experience by exploiting the high level of signal to interference ratio (SIR). The proposed …

Integrating Multiple Clusters For Compute-Intensive Applications, Zhifeng Yun

LSU Doctoral Dissertations

Multicluster grids provide one promising solution to satisfying the growing computational demands of compute-intensive applications. However, it is challenging to seamlessly integrate all participating clusters in different domains into a single virtual computational platform. In order to fully utilize the capabilities of multicluster grids, computer scientists need to deal with the issue of joining together participating autonomic systems practically and efficiently to execute grid-enabled applications. Driven by several compute-intensive applications, this theses develops a multicluster grid management toolkit called Pelecanus to bridge the gap between user's needs and the system's heterogeneity. Application scientists will be able to conduct very large-scale …

The Application Of Discontinuous Galkerin Finite Element Time-Domain Method In The Design, Simulation And Analysis Of Modern Radio Frequency Systems, Bo Zhao

University of Kentucky Doctoral Dissertations

The discontinuous Galerkin finite element time-domain (DGFETD) method has been successfully applied to the solution of the coupled curl Maxwell’s equations. In this dissertation, important extensions to the DGFETD method are provided, including the ability to model lumped circuit elements and the ability to model thin-wire structures within a discrete DGFETD solution. To this end, a hybrid DGFETD/SPICE formulation is proposed for high-frequency circuit simulation, and a hybrid DGFETD/Thin-wire formulation is proposed for modeling thin-wire structures within a three-dimensional problem space. To aid in the efficient modeling of open-region structures, a Complex Frequency Shifted-Perfectly Matched Layer (CFS-PML) absorbing medium is …

Enhancements To The Modified Composite Pattern Method Of Structured Light 3d Capture, Charles Joseph Casey

University of Kentucky Doctoral Dissertations

The use of structured light illumination techniques for three-dimensional data acquisition is, in many cases, limited to stationary subjects due to the multiple pattern projections needed for depth analysis. Traditional Composite Pattern (CP) multiplexing utilizes sinusoidal modulation of individual projection patterns to allow numerous patterns to be combined into a single image. However, due to demodulation artifacts, it is often difficult to accurately recover the subject surface contour information. On the other hand, if one were to project an image consisting of many thin, identical stripes onto the surface, one could, by isolating each stripe center, recreate a very accurate …

Miniature Embedded Module For Prognostic Health Monitoring (Phm) Of Electronic Systems, Liam Moore

Theses

Sensing systems for reliability prognostics are used extensively in life- and mission- critical electronics systems. They allow monitoring of reliability stresses in real time and scheduling of preventative maintenance before system failure. However, reliability prognostics systems are, in general, large and expensive and cannot be used in lower cost, small sized or portable products.

This thesis presents a sensing module for reliability prognostics which is only 1cm in volume and uses only commercial off-the-shelf components. In its 1cm package, the module combines all the necessary elements to act as an embedded prognostic sensor system for multi axial strain, vibration, humidity …

Protection Of Embedded Systems For Applications Involving High Loading Rate Mechanical Forces, Amjad Alsakarneh

Theses

This thesis describes the development of a methodology to optimise the dimensions and mechanical properties of force-absorbing layers surrounding miniaturised embedded electronic modules subject to high mechanical compressive/impact forces and vibration. While much has been published on the mechanical protection of electronic systems in larger scale applications, where traditional mechanical shock absorbers and springs can be used to protect the electronics, little has been published on the mechanical protection of miniature electronic modules embedded in smart structures and materials where traditional methods of mechanical protection are not feasible. The generalised system concept used in this thesis is of module encapsulation …