Electromagnetics and Photonics Commons^™

Improving Kinematic Accuracy Of Soft Wearable Data Gloves By Optimizing Sensor Locations, Donghyun Kim, Sang Wook Lee, Hyung-Soon Park

Electrical and Computer Engineering Faculty Research & Creative Works

Bending sensors enable compact, wearable designs when used for measuring hand configurations in data gloves. While existing data gloves can accurately measure angular displacement of the finger and distal thumb joints, accurate measurement of thumb carpometacarpal (CMC) joint movements remains challenging due to crosstalk between the multi-sensor outputs required to measure the degrees of freedom (DOF). To properly measure CMC-joint configurations, sensor locations that minimize sensor crosstalk must be identified. This paper presents a novel approach to identifying optimal sensor locations. Three-dimensional hand surface data from ten subjects was collected in multiple thumb postures with varied CMC-joint flexion and abduction …

Microfluidically Reconfigurable Frequency-Agile Rf Filters With Wide Frequency Tuning Range And High Power Handling Capability, Timothy Joseph Palomo

USF Tampa Graduate Theses and Dissertations

Radio Frequency (RF) filters are among the key components of today’s multifunctional devices and test equipment. However, the multifuctionality need significantly drives the required filter number and causes large areas to be allocated for filters. To alleviate this issue, over the recent years, reconfigurable filters have been proposed as an attractive alternative. Nevertheless, existing reconfigurable filter technologies demonstrate degraded performances in terms of loss, frequency tunability bandwidth, and power handling capability. This work investigates, for the first time, microfluidic based reconfiguration techniques for implementation of RF bandpass filters. Specifically, microfluidics is shown to provide mechanisms for achieving compact RF bandpass …

Diffractive Propagation And Recovery Of Modulated (Including Chaotic) Electromagnetic Waves Through Uniform Atmosphere And Modified Von Karman Phase Turbulence, Monish Ranjan Chatterjee, Fathi H.A. Mohamed

Electrical and Computer Engineering Faculty Publications

In a parallel approach to recently-used transfer function formalism, a study involving diffraction of modulated electromagnetic (EM) waves through uniform and phase-turbulent atmospheres is reported in this paper. Specifically, the input wave is treated as a modulated optical carrier, represented by use of a sinusoidal phasor with a slowly timevarying envelope. Using phasors and (spatial) Fourier transforms, the complex phasor wave is transmitted across a uniform or turbulent medium using the Kirchhoff-Fresnel integral and the random phase screen.

Some preliminary results are presented comparing non-chaotic and chaotic information transmission through turbulence, outlining possible improvement in performance utilizing the robust features …

Differential Tilt Variance Effects Of Turbulence In Imagery: Comparing Simulation With Theory, Daniel A. Lemaster, Russell C. Hardie, Szymon Gladysz, Matthew D. Howard, Michael Armand Rucci, Matthew E. Trippel, Jonathan D. Power, Barry K. Karch

Electrical and Computer Engineering Faculty Publications

Differential tilt variance is a useful metric for interpreting the distorting effects of turbulence in incoherent imaging systems. In this paper, we compare the theoretical model of differential tilt variance to simulations. Simulation is based on a Monte Carlo wave optics approach with split step propagation. Results show that the simulation closely matches theory. The results also show that care must be taken when selecting a method to estimate tilts.

Large-Area Object Search And Recovery Using Sector-Based Aerial Acousto-Optic Scanning And Reflection Sensing, Monish Ranjan Chatterjee, Salaheddeen G. Bugoffa

Electrical and Computer Engineering Faculty Publications

A sector-based angular scanning system intended to identify and spatially locate relatively small objects scattered over a large terrain is described in this paper. The system is modeled as a planar surface on the horizontal (XY) plane, with an acousto-optic Bragg cell on board an unmanned aerial vehicle (UAV) operating in the XZ plane.

The Bragg cell is excited by a chirped RF signal with a designed frequency ramp. As the scanning beam reflects off the horizontal surface, a detector placed strategically at a suitable altitude (in the analysis shown to be on board the UAV itself) picks up the …

Design Of An Asymmetric Reluctance Machine For A Generator Application, Bryan David Marquet

Open Access Theses

This work compares an Asymmetric Reluctance Machine (ARM) to a Uniform air Gap Reluctance Machine (UGRM) for a generator application. The ARM employs an asymmetric rotor pole to increase machine performance, specifically increasing torque density. A multi-objective optimization is employed to minimize mass and loss subject to design constraints. Two machines are compared in terms of their Pareto-optimal fronts.

Coupled Resonator Based Wireless Power Transfer For Bioelectronics, Henry Mei

Open Access Dissertations

Implantable and wearable bioelectronics provide the ability to monitor and modulate physiological processes. They represent a promising set of technologies that can provide new treatment for patients or new tools for scientific discovery, such as in long-term studies involving small animals. As these technologies advance, two trends are clear, miniaturization and increased sophistication i.e. multiple channels, wireless bi-directional communication, and responsiveness (closed-loop devices). One primary challenge in realizing miniaturized and sophisticated bioelectronics is powering. Integration and development of wireless power transfer (WPT) technology, however, can overcome this challenge.

In this dissertation, I propose the use of coupled resonator WPT for …

Least-Squares Mapping From Kinematic Data To Acoustic Synthesis Parameters For Rehabilitative Acoustic Learning, Xiangyu Zhou

Master's Theses (2009 -)

Thousands of people suffer from dysarthria resulting from neurological injury of the motor component of the motor-speech system, and need to rely on alternative methods to communicate in daily life, such as body language or text-to-speech [1] . However, there are currently very few effective rehabilitative therapies for helping these patients improve their speech. Because of this, research is needed to develop better rehabilitative therapies. One such area of research is the use of involuntary acoustic learning. The Speech and Swallowing lab at Marquette University has an Electromagnetic Articulography (EMA) system to collect kinematic data and a software system called …

Using Phase Screens To Synthesize Electromagnetic Gaussian-Schell Model Sources With Desired Amplitude, Coherence, And Polarization, Christopher K. Kokoczka

Theses and Dissertations

An electromagnetic Gaussian-Schell model (EGSM) source is built with desired coherence, amplitude, and polarization using correlated phase screens based on re- search conducted in Refs. [2, 9]. A new method of amplitude control is presented and tested using spatial light modulators (SLM). A brief review of theory and concepts is discussed followed by methods of how to build an EGSM source, correlated phase screens, and control amplitude using SLM gratings. The experimental set-up is presented which builds EGSM sources that demonstrate desired amplitude, coherence, and polarization. Irradiance correlation, degree of polarization, and Stokes parameters S₀ and S₁ are …

Automated Sunspot Classification And Tracking Using Sdo/Hmi Imagery, Maclane A. Townsend

Theses and Dissertations

Verification of an automated sunspot detection and classification algorithm is conducted utilizing two years of solar imagery from NASA's Solar Dynamics Observatory (SDO) satellite. Automated McIntosh classifications are compared against sunspot reports from the National Oceanic and Atmospheric Administration’s (NOAA) Space Weather Prediction Center (SWPC) using a three-tiered comparison metric. Statistical confidence is demonstrated for algorithm performance and consistency when compared against the SWPC data set, suggesting future applications of the algorithm will perform similarly. A sunspot tracking algorithm is added to the existing code and demonstrates reliable feature tracking for time periods out to four days between consecutive images. …

Utilization Of A Geodesic Sphere And Quadcopter As Two-Way Field Probe For Electro-Magnetic Field Measurements In An Indoor Radar Cross Section Range, Nathan Lett

Theses and Dissertations

Radar Cross Section (RCS) measurements rely heavily on multiple assumptions. Uncertainty in the final measurement is determined based on these assumptions. One source in particular is the non-homogeneous nature of the transmission path between radar test equipment and a target under test. The following research extends prior research. This thesis intends to provide a unique two-way field probe solution for measuring Electro-magnetic (EM) fluctuations in a test volume. In this thesis, the design, development, and demonstration of a geodesic sphere encased quadcopter two-way probe is explained. The Parrot® Bebop Drone quadcopter was used with a 2v frequency divided geodesic sphere …

A New Architecture For Application-Aware Cognitive Multihop Wireless Networks, Trenton Evans, Kossivi Tossou, Feng Ye, Zhihui Shu, Yi Qian, Yaoqing Yang, Hamid Sharif

Electrical and Computer Engineering Faculty Publications

In this article, we propose a new architecture for AC-MWN. Cognitive radio is a technique to adaptively use the spectrum so that the resource can be used more efficiently in a low-cost way. A multihop wireless network can be deployed quickly and flexibly without fixed infrastructure. In our proposed new architecture, we study backbone routing schemes with network cognition, and a routing scheme with network coding and spectrum adaptation. A testbed is implemented to test the proposed schemes for AC-MWN. In addition to basic measurements, we implement a video streaming application based on the proposed AC-MWN architecture using cognitive radios. …

Amorphous Silicon Solar Vivaldi Antenna, Oisin O'Conchubhair, Kansheng Yang, Patrick Mcevoy, Max Ammann

Articles

An ultra-wideband solar Vivaldi antenna is proposed. Cut from amorphous silicon cells, it maintains a peak power at 4.25 V which overcomes a need for lossy power management components. The wireless communications device can yield solar energy or function as a rectenna for dual-source energy harvesting. The solar Vivaldi performs with 0.5 - 2.8 dBi gain from 0.95 - 2.45 GHz and in rectenna mode, it covers three bands for wireless energy scavenging.

A Real-Time Information Based Demand-Side Management System In Smart Grid, Feng Ye, Yi Qian, Rose Qingyang Hu

Electrical and Computer Engineering Faculty Publications

In this paper, we study a real-time information based demand-side management (DSM) system with advanced communication networks in smart grid. DSM can smooth peak-to-average ratio (PAR) of power usage in the grid, which in turn reduces the waste of fuel and the emission of greenhouse gas. We first target to minimize PAR with a centralized scheme. To motivate power suppliers, we further propose another centralized scheme targeting minimum power generation cost. However, customers may not be motivated by a centralized scheme since such a scheme requires total control and privacy from them. A centralized scheme also requires too much real-time …

An Adaptive Security Protocol For A Wireless Sensor‐Based Monitoring Network In Smart Grid Transmission Lines, Xuping Zhang, Feng Ye, Sucheng Fan, Jinghong Guo, Guoliang Xu, Yi Qian

Electrical and Computer Engineering Faculty Publications

In this paper, we propose a new security protocol for a wireless sensor network, which is designed for monitoring long range power transmission lines in smart grid. Part of the monitoring network is composed of optical fiber composite over head ground wire (OPGW), thus it can be secured with conventional security protocol. However, the wireless sensor network between two neighboring OPGW gateways remains vulnerable. Our proposed security protocol focuses on the wireless sensor network part, it provides mutual authentication, data integrity, and data confidentiality for both uplink and downlink transmissions between the sensor nodes and the OPGW gateway. Besides, our …

Development Of A Multi-Objective Evolutionary Algorithm For Strain-Enhanced Quantum Cascade Lasers, Gregory Edward Triplett, David Mueller

Electrical and Computer Engineering Publications

An automated design approach using an evolutionary algorithm for the development of quantum cascade lasers (QCLs) is presented. Our algorithmic approach merges computational intelligence techniques with the physics of device structures, representing a design methodology that reduces experimental effort and costs. The algorithm was developed to produce QCLs with a three-well, diagonal-transition active region and a five-well injector region. Specifically, we applied this technique to AlxGa1􀀀xAs/InyGa1􀀀yAs strained active region designs. The algorithmic approach is a non-dominated sorting method using four aggregate objectives: target wavelength, population inversion via longitudinal-optical (LO) phonon extraction, injector level coupling, and an optical gain metric. Analysis …

A High Performance Ceramic-Polymer Separator For Lithium Batteries, Jitendra Kumar, Padmakar Kichambare, Amarendra K. Rai, Rabi Bhattacharya, Stanley J. Rodrigues, Guru Subramanyam

Electrical and Computer Engineering Faculty Publications

A three-layered (ceramic-polymer-ceramic) hybrid separator was prepared by coating ceramic electrolyte [lithium aluminum germanium phosphate (LAGP)] over both sides of polyethylene (PE) polymer membrane using electron beam physical vapor deposition (EB-PVD) technique. Ionic conductivities of membranes were evaluated after soaking PE and LAGP/PE/LAGP membranes in a 1 Molar (1M) lithium hexafluroarsenate (LiAsF₆) electrolyte in ethylene carbonate (EC), dimethyl carbonate (DMC) and ethylmethyl carbonate (EMC) in volume ratio (1:1:1). Scanning electron microscopy (SEM) and X-ray diffraction (XRD) techniques were employed to evaluate morphology and structure of the separators before and after cycling performance tests to better understand structure-property correlation. …

Ultra–Low Power Straintronic Nanomagnetic Computing With Saw Waves: An Experimental Study Of Saw Induced Magnetization Switching And Properties Of Magnetic Nanostructures, Vimal G. Sampath

Theses and Dissertations

A recent International Technology Roadmap for Semiconductors (ITRS) report (2.0, 2015 edition) has shown that Moore’s law is unlikely to hold beyond 2028. There is a need for alternate devices to replace CMOS based devices, if further miniaturization and high energy efficiency is desired. The goal of this dissertation is to experimentally demonstrate the feasibility of nanomagnetic memory and logic devices that can be clocked with acoustic waves in an extremely energy efficient manner. While clocking nanomagnetic logic by stressing the magnetostrictive layer of a multiferroic logic element with with an electric field applied across the piezoelectric layer is known …

Numerical Calculation Of Spatially Variant Anisotropic Metamaterial, Asad Ullah Hil Gulib

Open Access Theses & Dissertations

3D printing, or additive manufacturing, is rapidly evolving into a mainstream manufacturing technology that is creating new opportunities for electromagnetics and circuits. 3D printing permits circuits to fully utilize the third dimension allowing more functions in the same amount of space and allows the devices to have arbitrary form factors. 3D printing is letting us discover new physics that is not possible in standard 2D circuits and devices. However, evolving electromagnetics and circuits into three dimensions introduces some serious problems like thermal management, interference, and mutual coupling between the components which degrades performance and hurts signal integrity.

Metamaterials are engineered …

Intrinsic Modulation Response Modeling And Analysis For Lithographic Vertical-Cavity Surface-Emitting Lasers, Mingxin Li

Electronic Theses and Dissertations

Vertical-cavity surface-emitting lasers (VCSELs) have been greatly improved and successfully commercialized over the past few decades owing to their ability to provide both mode and current confinement that enables low energy consumption, high efficiency and high modulation speed. However, further improvement of oxide VCSELs is limited by the nature of the oxide aperture because of self-heating, internal strain and difficulties in precise size control. In this dissertation, VCSELs using lithographic approach are demonstrated to overcome the limitations of oxide VCSELs, in which an intra-cavity phase shifting mesa is applied to define the device size and provide optical mode and electrical …