Electromagnetics and Photonics Commons^™

Development Of Breast Tissue Phantoms For Enhanced Terahertz Imaging Utilizing Microdiamond And Nano-Onion Particles, Alec Walter

Electrical Engineering Undergraduate Honors Theses

This thesis presents the work performed to develop tissue phantoms and a contrast agent that will be used in future research of terahertz time-domain imaging of breast tumor margins. Since an excised breast tumor can contain healthy fibrous and fatty tissues along with invasive ductal carcinoma (IDC), three phantom materials were developed. Solid phantom materials were made by using TX151 to solidify water in order to tune the refractive index and absorption coefficient of the fibrous tissue phantom and IDC phantom to the properties of freshly excised breast tissue. Various amounts of olive oil were added to the water prior …

Identity-Based Schemes For A Secured Big Data And Cloud Ict Framework In Smart Grid System, Feng Ye, Yi Qian, Rose Qingyang Hu

Electrical and Computer Engineering Faculty Publications

Smart grid is an intelligent cyber physical system (CPS). The CPS generates a massive amount of data for efficient grid operation. In this paper, a big data-driven, cloud-based information and communication technology (ICT) framework for smart grid CPS is proposed. The proposed ICT framework deploys hybrid cloud servers to enhance scalability and reliability of smart grid communication infrastructure. Because the data in the ICT framework contains much privacy of customers and important data for automated controlling, the security of data transmission must be ensured. In order to secure the communications over the Internet in the system, identity-based schemes are proposed …

Interactive Physics And Characteristics Of Photons And Photoelectrons In Hyperbranched Zinc Oxide Nanostructures, Garrett Edward Torix

Graduate Theses and Dissertations

As is commonly known, the world is full of technological wonders, where a multitude of electronic devices and instruments continuously help push the boundaries of scientific knowledge and discovery. These new devices and instruments of science must be utilized at peak efficiency in order to benefit humanity with the most advanced scientific knowledge. In order to attain this level of efficiency, the materials which make up these electronics, or possibly more important, the fundamental characteristics of these materials, must be fully understood. The following research attempted to uncover the properties and characteristics of a selected family of materials. Herein, zinc …

Integrated Circuit Design For Hybrid Optoelectronic Interconnects, Kehan Zhu

Boise State University Theses and Dissertations

This dissertation focuses on high-speed circuit design for the integration of hybrid optoelectronic interconnects. It bridges the gap between electronic circuit design and optical device design by seamlessly incorporating the compact Verilog-A model for optical components into the SPICE-like simulation environment, such as the Cadence design tool.

Optical components fabricated in the IME 130nm SOI CMOS process are characterized. Corresponding compact Verilog-A models for Mach-Zehnder modulator (MZM) device are developed. With this approach, electro-optical co-design and hybrid simulation are made possible.

The developed optical models are used for analyzing the system-level specifications of an MZM based optoelectronic transceiver link. Link …

Dual Role Of Sb Ions As Electron Traps And Hole Traps In Photorefractive Sn2P2S6 Crystals, Brant E. Kananen, Eric M. Golden, Sergey A. Basun, D. R. Evans, A. A. Grabar, I. M. Stoika, John W. Mcclory, Nancy C. Giles, Larry E. Halliburton

Faculty Publications

Doping photorefractive single crystals of Sn₂P₂S₆ with antimony introduces both electron and hole traps. In as-grown crystals, Sb³⁺ (5s²) ions replace Sn²⁺ ions. These Sb³⁺ ions are either isolated (with no nearby perturbing defects) or they have a charge-compensating Sn²⁺ vacancy at a nearest-neighbor Sn site. When illuminated with 633 nm laser light, isolated Sb³⁺ ions trap electrons and become Sb²⁺ (5s²5p¹) ions. In contrast, Sb³⁺ ions with an adjacent Sn vacancy trap holes during illumination. The hole is primarily …

Investigation Of The Optical Properties Of Pbse/Pbx Nanocrystals For Photodetector Applications, Haley Ann Morris

Graduate Theses and Dissertations

Lead selenide and lead selenide/lead sulfide core/shell nanocrystals were investigated for use in near infrared photodetectors. A colloidal synthesis method was used for both the core and core/shell configurations. The lead sulfide shell was examined in order to mitigate oxidation of the nanoparticle surface. Absorbance and photoluminescence spectra were measured at room temperature and 77 K, respectively. Transmission electron microscopy images were also obtained to confirm crystallography and size. Bulk lead selenide was simulated in WIEN2k utilizing the linear-augmented plane wave method of solving density functional theory to better understand the electronic structure of PbSe. The crystal structure, electron density, …

Design, Fabrication And Measurement Of A Plasmonic Enhanced Terahertz Photoconductive Antenna, Nathan Matthias Burford

Graduate Theses and Dissertations

Generation of broadband terahertz (THz) pulses from ultrafast photoconductive antennas (PCAs) is an attractive method for THz spectroscopy and imaging. This provides a wide frequency bandwidth (0.1-4 THz) as well as the straightforward recovery of both the magnitude and phase of the transmitted and/or reflected signals. The achieved output THz power is low, approximately a few microwatts. This is due to the poor conversion of the femtosecond laser used as the optical pump to useable current inside the antenna semiconducting material. The majority of THz power comes from the photocarriers generated within ~ 100 nm distance from the antenna electrodes. …

Photoluminescence Studies Of Amorphous Boron Carbide And Tungsten Diselenide Thin Films, David M. Allendorfer

Department of Electrical and Computer Engineering: Dissertations, Theses, and Student Research

For many years scientists and engineers have been researching semi-conducting materials for use in a broad array of electronic devices. With the growing demand for faster, smaller and more efficient electronics, new materials must be characterized and their properties quantified. The focus of this thesis is to develop a system to measure photoluminescence in opto-electronic materials. Photoluminescence measurements are important because it can give researchers valuable information about a material’s band structure. This thesis begins by presenting the carrier recombination mechanisms and how they apply to photoluminescence. A system was developed to measure photoluminescence spectroscopy. This system was tested with …

Vector Magneto-Optical Generalized Ellipsometry For Determining Magneto-Optical Properties Of Thin Films, Chad Briley

Department of Electrical and Computer Engineering: Dissertations, Theses, and Student Research

Modern growth techniques allow for highly complex nano scale thin films to be created. These new films possess highly anisotropic properties structurally, optically, and magnetically that are significantly different from that of their bulk counterparts and must be accurately characterized in order to optimize desired properties for applications in next generation devices. Current magnetometry techniques focus on high symmetry characterization, namely in and out of the sample plane, and therefore do not possess the capabilities to fully explore these anisotropic properties without complicated setups and multiple sample manipulations. The author describes a setup that combines generalized ellipsometry with an octu-pole …

Frequency Tunable Antennas And Surface Microwave Imaging System Using Microfluidic Reconfiguration Techniques, Abhishek Dey

USF Tampa Graduate Theses and Dissertations

Reconfigurable radio frequency (RF) devices are attractive for miniaturization of wireless components and systems by handling functionality of multiple distinct devices. Existing reconfiguration techniques rely on device loadings with semiconductor diodes, ferrite/ferroelectric materials, and microelectromechanical system (MEMS) switches and capacitors. However, it is well-recognized that these techniques cannot fully address important system metrics such as high efficiency, wide frequency tuning range, high power handling capability and cost. Therefore, novel alternative techniques are highly desirable to advance the state of the art in reconfigurable RF devices. The aim of this dissertation is to investigate the novel concept of microfluidically loaded reconfigurability …

Rain Attenuation Effects On Signal Propagation At W/V-Band Frequencies, Nadine Daoud

Electrical and Computer Engineering ETDs

The current frequency spectrum congestion in space is begging for the exploration and utilization of a new range of frequencies. The W/V-band Terrestrial Link Experiment (WTLE) project run jointly by AFRL, NASA and the University of New Mexico, focuses on using higher frequencies for satellite communications, more precisely, at 72 GHz and 84 GHz.

In this thesis, the rain effect on the propagating signal is studied. First, instantaneous comparisons between the experiment and two different models, the ITU-R and the Siva-Mello, is presented. Second, the WTLE link was analyzed statistically over a period of approximately 10 months, and the ITU-R …

Electromagnetic Forcing As A Damping Method For Combustion Instabilities, Bradley Henderson, Gabriel Xu

Von Braun Symposium Student Posters

No abstract provided.

Thermoelectric Magnetohydrodynamic Effects In Solidification Processes, Andrew Kao, Koulis Pericleous, Peter Lee, Biao Cai, Jianrong Gao

The 8th International Conference on Physical and Numerical Simulation of Materials Processing

No abstract provided.

Negative Index In Chiral Metamaterials Under Conductive Loss And First-Order Material Dispersion Using Lorentzian, Condon And Drude Models, Monish Ranjan Chatterjee, Tarig A. Algadey

Electrical and Computer Engineering Faculty Publications

Emergence of negative index (NIM) in chiral materials with conductive loss using standard dispersive models is reported. Positive and negative phase and group indices are realized as expected for NIM behavior for sidebands with opposite polarities.

Anisoplanatic Electromagnetic Image Propagation Through Narrow Or Extended Phase Turbulence Using Altitude-Dependent Structure Parameter, Monish Ranjan Chatterjee, Ali Mohamed

Electrical and Computer Engineering Faculty Publications

The effects of turbulence on anisoplanatic imaging are often modeled through the use of a sequence of phase screens distributed along the optical path. We implement the split-step wave algorithm to examine turbulence-corrupted images.

Pattern Reconfigurable Back-To-Back Microstrip Patch Antenna, Kansheng Yang, Xiulong Bao, Patrick Mcevoy, Max Ammann

Articles

A back-to- back microstrip patch antenna with a switchable pattern is proposed for WLAN applications. The patch elements, printed on FR-4 substrates with a common ground plane, are switched with a single-pole double-throw PIN diode circuit. Switching the feed selects either of two identical radiation patterns in the opposing hemispheres for spatial diversity that would benefit a distributed network.

Optimization Of The Bowtie Gap Geometry For A Maximum Electric Field Enhancement, Tsenguun Byambadorj

Master's Theses (2009 -)

Optimization of the geometry of a metallic bowtie gap at radio frequency is presented in this thesis. Since the design and fabrication of a plasmonic device (nanogap) at nanoscale is challenging, the results of this study can be used to estimate the best design parameters for nanogap structure. The geometry of the bowtie gap including gap size, tip width, metal thickness, and tip angle are investigated at macroscale to find the maximum electric field enhancement across the gap. This thesis focuses on the simulation portion of a work that consists of experimental and simulation platforms. The simulation platform is created …

Analysis Of Interference Between Electromagnetic Articulography And Electroglottograph Systems, Kelly Vonderhaar

Master's Theses (2009 -)

Electromagnetic Articulography (EMA) has become an integral tool for researchers and clinicians who seek to characterize speech kinematics. The position and orientation of the articulators – which include the jaw, lips, and tongue – are recorded by attaching sensors to the articulators and tracking the movement of the sensors through an electromagnetic field. This has been used by researchers and clinicians to better understand dysarthria and synthesize speech, among other applications. Another speech tool, electroglottography (EGG), is used to analyze the movement of the vocal folds during speech production. This is achieved by measuring the time variation of the contact …

Absolute Positioning Using The Earth's Magnetic Anomaly Field, Aaron J. Canciani

Theses and Dissertations

Achieving worldwide alternatives to GPS is a challenging engineering problem. Current GPS alternatives often suffer from limitations such as where and when the systems can operate. Navigation using the Earth's magnetic anomaly field, which is globally available at all times, shows promise to overcome many of these limitations. We present a navigation filter which uses the Earth's magnetic anomaly field as a navigation signal to aid an inertial navigation system (INS) in an aircraft. The filter utilizes highly-accurate optically pumped cesium (OPC) magnetometers to make scalar measurements of the Earth's magnetic field and compare them to a map using a …

Photonicstd-2d: Modeling Light Scattering In Periodic Multilayer Photonic Structures, Alexey Bondarev, Shaimaa Azzam, Zhaxylyk Kudyshev, Alexander V. Kildishev

The Summer Undergraduate Research Fellowship (SURF) Symposium

Efficient modeling of electromagnetic processes in optical and plasmonic metamaterials is important for enabling new and exciting ways to manipulate light for advanced applications. In this work, we put together a tool for numerical simulation of propagation of normally incident light through a nanostructured multilayer composite material. The user builds a unit cell of a given material layer-by-layer starting from a substrate up to a superstrate, splitting each layer further into segments. The segments are defined by width and material -- dielectric, metal or active medium. Simulations are performed with the finite difference time domain (FDTD) method. A database of …