Electrical and Electronics Commons^™

Scalable Cognitive Radio Network Testbed In Real Time, Kevin Z. Yu

Master's Theses

Modern society places an increasingly high demand on data transmission. Much of that data transmission takes place through communication over the frequency spectrum. The channels on the spectrum are limited resources. Researchers realize that at certain times of day some channels are overloaded, while others are not being fully utilized. A spectrum management system may be beneficial to remedy this efficiency issue. One of the proposed systems, Cognitive Radio Network (CRN), has progressed over the years thanks to studies on a wide range of subjects, including geolocation, data throughput rate, and channel handoff selection algorithm, which provide fundamental support for …

Zero Voltage Switching Hybrid Voltage Divider Converter, Timothy Jeong

Master's Theses

This project proposes a new hybrid voltage divider DC-DC converter that utilizes switching capacitors and inductors to produce zero voltage switching (ZVS) at the turn on state of its switches. By achieving ZVS, the switching losses are significantly reduced; thus, increasing the overall efficiency of the converter at various loads. The goal for this thesis is to perform analysis of the operation of the converter, derive equations for sizing the main components, and demonstrate its functionality through computer simulation and hardware prototype. Results of the simulation and hardware testing show that the proposed converter produces the desired output voltage while …

Power Line Coupling Power Supply Design, Janine Gian Christii C. Darato, Jeni K. Kawate, Nicholas A. Marta

Electrical Engineering

In this project, a power supply was designed for a startup company, Perch Sensing, to detect wildfires with the use of distributed sensors across power lines. The purpose of the power supply is to provide 15W of power to a microcontroller, which controls the sensor nodes. The power supply hangs from power lines and draws energy by inductively coupling to these lines. Our design starts with a current transformer that steps down the current from the power line, which is fed into a shunting mechanism as a safety precaution when the load is absent, then to the power supply itself. …

Buck Converter With Voltage Foldback Protection, Fabian Aaron Enriquez, Pedro Rincon Rosales

Electrical Engineering

In this work, we implemented the idea of current foldback protection onto a buck converter. Current foldback protection essentially helps reduce the power dissipation which may be caused by a short circuit or overload scenario. To achieve the goal of this project, we used a combination of comparators, operational amplifiers and MOSFETs to create a current foldback sub controller. This controller would then serve as a feedback device between the output of the converter and the main controller to detect if a fault condition has occurred. Following the design, we performed simulation of the current foldback controller using PSpice and …

Tractor Hacking, Jin Huang, Kyle B. Kesler

Electrical Engineering

Tractor hacking arose from tractor owners' desire for full control over the tractors they purchase. Tractor manufacturers set strict security on the electrical components of their tractors, making it difficult for tractor owners to diagnose and monitor their tractors on their own. The UltraBlue Tractor Hacking project is a solution to this problem, allowing tractor owners to perform diagnostics and monitor the equipment they purchased without having to go through dealerships. From talking to farmers, we found that they valued a diagnostic tool that allows for clearing and resetting Diagnostic Trouble Codes (DTCs), viewing diagnostic data pertaining to a specific …

Portable Ventilator, Bradley C. Weeks, Jack W. Brewer, Sanders Sanabria

Electrical Engineering

The current COVID-19 pandemic has heavily impacted the healthcare system in the United States and elsewhere. The need for patients to have access to a hospital with a ventilator along with a shortage of ventilators for recovery and at-home care as a result of minimal hospital vacancy for patients has been greatly stressed. The presented problem is both an unmet demand and supply of portable and effective ventilators. Existing ventilators have many shortcomings that should be addressed: size, weight, cost, and complexity of current ventilators confines users to stay in a medical facility whilst being monitored by professionals. This both …

Feasibility Study Of Radio Frequency Microelectromechanical Filters For Space Operation, Karanvir Singh

Theses and Dissertations

Piezoelectric contour mode resonator technology has the unique advantage of combining low motional resistance with the ability to define multiple frequencies on the same substrate. Contour mode resonators can be mechanically coupled together to form robust band-pass filters for the next generation of GPS satellites with extreme size reduction compared to electrically coupled filters. Piezoelectric zinc oxide (ZnO) contour mode resonators have the potential for monolithic integration with current ZnO transistor further reducing size, power consumption, and cost of filter modules. Barium strontium titanate (BST) contour mode resonators have incredible frequency tunability due to the fundamental nature of the thin …

Survey And Design Of Microwave Low-Noise Amplifiers, Omri Yaari, Pavin Virdee

Electrical Engineering

This project is a contest entry in the Wide In-band Receiver area of the 2020 International Microwave Symposium, 5G Low Noise Amplifier Competition [1]. The project includes RF transistor selection, single, two-stage, and cascode models, and RF parameter optimization to maximize the IMS Competition figure of merit along with a supplemental figure of merit [2]. 5G technologies (used in cellphones, IoT, etc.), first introduced in 2018, are on the rise in current society. Fifth generation hardware requires extended capabilities in comparison to 4G (5-20MHz bandwidth EU: 0.6-2.6GHz), including the newly allocated sub 6GHz frequency bands (EU: 3.4-3.8GHz) and wider bandwidth …

Led-Based Solar Simulator, Jonathan E. Honrada

Electrical Engineering

Solar simulators are great laboratory tools that help users conduct tests with solar cells indoors. Conventional solar simulators typically use xenon arc bulbs as a light source, which can have considerable disadvantages. Recent projects have sought to design and implement LED-based solar simulators, as they are more power-efficient, inexpensive, and durable.

Based on these advantages, the goal of this project is to create an LED-based solar simulator that can replicate the characteristics of solar light, but also be tunable with controls. This broadens the testing capabilities of the device, allowing users to conduct tests with more narrow spectrums of light …

Design And Characterization Of Standard Cell Library Using Finfets, Phanindra Datta Sadhu

Master's Theses

The processors and digital circuits designed today contain billions of transistors on a small piece of silicon. As devices are becoming smaller, slimmer, faster, and more efficient, the transistors also have to keep up with the demands and needs of the daily user. Unfortunately, the CMOS technology has reached its limit and cannot be used to scale down due to the transistor's breakdown caused by short channel effects. An alternative solution to this is the FinFET transistor technology, where the gate of the transistor is a three dimensional fin that surrounds the transistor and prevents the breakdown caused by scaling …

Development Of A Portable Low-Moisture Food Pasteurization Device Using Rf Heating, Eric Jason Ohata

Master's Theses

Bacterial presence in low-moisture foods such as flour, cereals, baby formula, and spices, have become a concern due to sanitizing challenges. The food industry currently focuses on wet food sanitation as opposed to low-moisture foods because of bacteria’s inability to reproduce in low water activity media. Traditionally, food processing RF heating pasteurizes in mass quantities while an equivalent consumer device does not exist the market today. A consumer product would help eliminate food waste by providing an easy way to sanitize food and extend shelf life. The Portable Food Pasteurization (PFP) project is an interdisciplinary project involving the Electrical Engineering, …

Bibliometric Review On Iot Based System For Remote Downloading On Microcontroller, Arundhati Bandopadhyaya Ms., Diya Dodwad Ms., Diviyanshi Gupta Ms., Surya Koyyana Mr., Parag Narkhede Mr., Shripad Deshpande Mr.

Library Philosophy and Practice (e-journal)

Working with sensors has become an area of expertise within the domain of electronic engineering. On a day to day basis, thousands of sensors are put to use around us, for instance, in smoke alarms, speedometers, motors, computers, radiators etc. to accumulate sensor data, cables that connect the sensors to the bottom station after which the information is worked on. But cabling is often expensive especially when handling large scale industrial applications ^[5]. For an equivalent reason, low-cost wireless networks came into the picture recently and are in high demand. A research paper we found during our review of …

Optical Engineering Of Iii-Nitride Nanowire Light-Emitting Diodes And Applications, Ha Quoc Thang Bui

Dissertations

Applications of III-nitride nanowires are intensively explored in different emerging technologies including light-emitting diodes (LEDs), laser diodes, photodiodes, biosensors, and solar cells. The synthesis of the III-nitride nanowires by molecular beam epitaxy (MBE) is investigated with significant achievements. III-nitride nanowires can be grown on dissimilar substrates i.e., silicon with nearly dislocation free due to the effective strain relaxation. III-nitride nanowires, therefore, are perfectly suited for high performance light emitters for cost-effective fabrication of the advanced photonic-electronic integrated platforms. This dissertation addresses the design, fabrication, and characterization of III-nitride nanowire full-color micro-LED (µLED) on silicon substrates for µLED display technologies, high-efficient …

Selective Neural Stimulation By Leveraging Electrophysiological Diversity And Using Alternative Stimulus Waveforms, Bemin Ghobreal

Dissertations

Efforts on finding the principle mechanism for selective neural stimulation have concentrated on segregating the neurons based on their size and other geometric factors. However, neuronal subtypes found in different parts of the nervous system also differ in their electrophysiological properties. The primary objective of this study is to investigate the feasibility of selective activation of neurons by leveraging the diversity seen in passive and active membrane properties.

Using both a local membrane model and an axon model based on the CRRSS, the diversity of electrophysiological properties is simulated by varying four model parameters (membrane leakage-Gleak and capacitance-Cm, temperature coefficient-Ktemp, …

Intelligent And Secure Fog-Aided Internet Of Drones, Jingjing Yao

Dissertations

Internet of drones (IoD), which utilize drones as Internet of Things (IoT) devices, deploys several drones in the air to collect ground information and send them to the IoD gateway for further processing. Computing tasks are usually offloaded to the cloud data center for intensive processing. However, many IoD applications require real-time processing and event response (e.g., disaster response and virtual reality applications). Hence, data processing by the remote cloud may not satisfy the strict latency requirement. Fog computing attaches fog nodes, which are equipped with computing, storage and networking resources, to IoD gateways to assume a substantial amount of …

Modeling And Analysis Of Intracellular Signaling Networks And Cellular Decisions, Mustafa Ozen

Dissertations

Developing molecular network analysis methods is important due to their applications on complex biological systems such as target discovery, development of drugs, discovering drug effects, and finding treatments for many complex diseases, e.g., cancer, autoimmune, and mental disorders. An example of analysis techniques is the fault diagnosis analysis, in which the purpose is to quantify how much vulnerable the entire network is to dysfunction of one or multiple molecules. Such analysis can be done after proper network models are implemented, trained, and tested against the experimental data. In this dissertation, a Boolean modeling framework is implemented and methods to train …

Bibliometric Analysis On Dynamic Target Tracking By Mobile Robot, Gaurav Atha Mr., Siddhant Chaturvedi Mr., Atishraj Desai Mr., Dhrumil Desai Mr., Shripad V. Deshpande Mr.

Library Philosophy and Practice (e-journal)

The survey and bibliometric research on dynamic target tracking by a mobile robot are discussed in this paper. The primary goal of this bibliometric analysis is to comprehend and analyze the scope of the literature in the field of mobile robots for obstacle avoidance, path planning and target tracking using Robot Operating System (ROS). The ROS contains various tools for data analysis, incorporates multiple robots and their sensors, and supports devices interaction for target seeking and localization in mobile robots. This detailed review was performed on various research publications about the mapping of the unknown field/environment by the ROS based …

Boot-Loading Microcontroller Through Serial Port, Siddharth Sameer, Jayshree Ashok Pande

Library Philosophy and Practice (e-journal)

Modern-day automobiles have several Electronic Control Units (ECUs) integrated into them so naturally, compared to the older cars, their complexity is too high, and this trend of increasing complexity in the cars of the future will continue to increase. Consequently, with the increase in the software part in the vehicles, there is always the risk of a potential bug. Whenever a software bug is found, a recall process is required to update the software. The modern ECU update technology is achieved through the interaction of information between the remote server and the end equipment of the vehicle. Therefore, due to …

An Lpc Pole Processing Method For Enhancing The Identification Of Dominant Spectral Features, Jin Xu, Mark Davis, Ruairí De Fréin

Articles

This paper proposes a new time-resolved spectral analysis method based on a modification to the linear predictive coding (LPC) method for enhancing the identification of the dominant frequencies of a signal. The method described here is based on a z-plane analysis of the LPC poles. These poles are used to produce a series of reduced order filter transfer functions which can accurately identify and estimate the frequency of the dominant spectral features. The standard LPC method has been shown to suffer from a sensitivity to noise and its performance is dependent on the filter order. The proposed method can …

Fault Modeling And Test Vector Generation For Asic Devices Exposed To Space Single Event Environment, Ahmed Mohamed

Theses and Dissertations

This work aims at providing a concise automated flow to predict the effect of Single Event Transients (SETs) on ASIC chips by developing a method to characterize the circuit susceptibility to SET pulses propagation and then generation of the required input vectors that sensitize the victim paths. A new enhanced method for SET electrical propagation modeling is proposed and compared to a previously published analytical model. The method was applied on different standard cells libraries built over XFAB Xh018 technology and verified for accuracy against simulations. The new method showed enhancement in accuracy compared with previous work in literature. Industrial …