Electrical and Electronics Commons^™

Size Dependent Melting And Diffusion Of Silicon For Microsystem Applications, Noel Felipe Marquez

Open Access Theses & Dissertations

The size dependent reduced melting point and hydrogen enhanced surface diffusion effect on silicon nanostructures was explored experimentally. SOI and silicon wafers were patterned using nanimprint lithography and dry etching to explore the reduced melting point effect; and patterned with photolithography and dry etching to explore the hydrogen enhanced surface diffusion. The nanotextured samples were annealed in a wide variety of furnaces with nitrogen, forming gas, and argon atmospheres. Nitrogen was found to block the reshaping effect while argon was found to cause extensive pitting damage in the setup used. Micropatterned samples were annealed in a low pressure hydrogen enabled …

Fabrication And Characterization Of Nanocrystalline Yttrium Oxide Thin Films For Electronic Device Applications, Mudavakkat Vikas Haridas

Open Access Theses & Dissertations

This thesis presents the optimization of growth conditions for fabricating nanocrystalline Yttrium Oxide (Y2O3) thin films on silicon and optical grade, high quality quartz substrates in order to study its structural, optical and electrical properties for electronic device applications.

Commercially Y2O3 has proven to be difficult to fabricate at high quality due to its high temperature growth requirements and the need to alter established fabrication methods for electronic devices. A high temperature requirement for high quality poses a problem for research and analysis. This calls upon for an optimization of the growth conditions to facilitate fabrication of thin films for …

Utepcam: A Scalable Wireless Vision Sensor Architecture For Computational, Power And Bandwidth Constrained Scenarios, Ricardo Zepeda

Open Access Theses & Dissertations

UTEPcam is a low cost and power vision sensor node system. UTEPcam is composed of an Atmel atmega32 8-bit microcontroller, a CY7C09099V static RAM chip, an OV6620 CMOS image sensor, a XBEE transceiver and a SD Flash memory card, and four logic gates. UTEPcam's simple yet efficiently architecture enables it to capture video at one frame per second. At its absolute highest, it is estimated that UTEPcam consumes only 1.321 Amps. When in standby, UTEPcam consumes 21 microamps. Furthermore, UTEPcam's program takes up only 1Kbyte of memory space.

UTEPcam's CPU, a simple 8-bit MCU, is unlike most vision sensor node …

Tin Dioxide Memristors On Glass And Plastic Substrates, Oscar Del Real

Open Access Theses & Dissertations

NanoMIL has studied and developed SnO2-based memristors, while the W.M Keck Center has been a research leader in printed silver inks. The focus of this thesis is to take the previous generation of memristors on glass and develop a process for creating memristors on flexible Kapton film for the first time. Moreover, collaborative work between the two UTEP laboratories produced memristors with printed silver top electrode contacts, also for the first time. These approaches may enable inexpensive flexible memory.

Maturation of the process was achieved by understanding important process parameters and subtle differences between glass and Kapton substrates. Moreover, electrical …

Preparation And Characterization Of Iron Oxide And Hydroxide Based Nanomaterials, Guillermo Carbajal Franco

Open Access Theses & Dissertations

Iron (Fe) oxides and hydroxides are common and abundant materials. They exhibit diverse crystal structures, properties and phenomena by virtue of which they find a wide range of scientific and technological applications. Controlled growth and manipulation of the specific structure and electronic behavior to meet the requirements of a given application is a challenging problem in view of many possible phases and composition of the resulting materials. The preparation method and experimental conditions will, therefore, significantly affect the properties and performance of Fe oxides and hydroxides. The goal of the project is to obtain Fe-based oxide/hydroxide catalytic materials and to …

Spatio-Temporal Cardiac Pacing Sites Localization And Time Varying Pericardium Potential Maps Projection Using Ecg Precordial Leads And A Single Moving Dipole Model, Jaime R. De La Cruz

Open Access Theses & Dissertations

A novel non-invasive method for the spatiotemporal localization of the sites of strongest cardiac activity, and for the creation of time varying Pericardium Potential Maps (PPM), with the use of patients' ECG precordial leads, is proposed in this Thesis study. Compared to previous studies, which analyze electrocardiograms in either time domain or spatial domain, the proposed method has the advantage of a simultaneous spatiotemporal electrocardiograph analysis and a 3-D visualization of pericardium potentials maps, as well as, the pericardium surface polarization patterns during the cardiac cycle. The spatial properties added to the electrocardiogram allow for the analysis of specific regions …

Assessment And Evaluation Of Peripheral Neuropathy From Diabetic Mellitus Using Systems Analysis Approach, Oscar Alonso Espino

Open Access Theses & Dissertations

Currently in America 1 out of every 10 residents suffers from diabetes, and this tendency is likely to grow up to "1 of every 3" by the year [6]. Diabetes exhibits several complications. In 2005, the lead cause of stroke and heart disease was diabetes, 68% of the cases [1]. In 2008, 44% of kidney failure was associated with diabetes [1]. 60 to 70 % of cases of diabetes have a mild to severe nervous system damage [1]. Diabetic patients who have developed peripheral neuropathy tend to also develop foot ulceration. In an advanced stage a foot ulcer can lead …

Accelerated Simulation And Testing Of Integrated Circuits Using High Performance Computing Machines, Matthew C. Markulik

Open Access Theses & Dissertations

As Moore's Law continues to hold true and transistor density becomes exponentially larger the need to rely on computer aided design (CAD) simulators has become more relevant and necessary. As we dive into the age of electronic reliance there presents a need to constantly improve methods to reduce time-to-solution for developing technologies. The reliance on CAD simulators for electronic development leaves engineers with an ability to improve the design process by improving these simulators or improving the methods in which these simulators are being utilized. With the advancement of quality fabrication processes and the ability to operate at sub-threshold levels …

Evaluation Methods For Health Monitoring Of Aerospace Structure Rotary Joints, Sergio Armando Navarro

Open Access Theses & Dissertations

In September 2007, the excessive vibrations played a significant role in the station operation since one of the rotary joints, which provides the station electrical energy, presented an anomaly. The replacement of its bearing components and re-lubrication were necessary to reduce the problem. To avoid a new anomaly, the inspection of the rotary joints performance continues by using the accelerometers data. This thesis presents three new approaches to monitor the vibrations at the International Space Station based on Root-Mean-Square, kurtosis, and Approximate Entropy (ApEn). MATLAB functions and codes were necessary to implement the three monitoring techniques results from the provided …

Development Of Load Balancing Algorithm Based On Analysis Of Multi-Core Architecture On Beowulf Cluster, Damian Valles

Open Access Theses & Dissertations

In this work, analysis, and modeling were employed to improve the Linux Scheduler for HPC use. The performance throughput of a single compute-node of the 23 node Beowulf cluster, Virgo 2.0, was analyzed to find bottlenecks and limitations that affected performance in the processing hardware where each compute-node consisted of two quad-core processors with eight gigabytes of memory. The analysis was performed using the High Performance Linpack (HPL) benchmark.

In addition, the processing hardware of the compute-node was modeled using an Instruction per Cycle (IPC) metric that was estimated using linear regression. Modeling data was obtained by using the Tuning …

Automated Detection Of Dust Clouds, Sources, And Direction From Noaa-Avhrr Satellite Imagery, Mohammed Qassim Alkhatib

Open Access Theses & Dissertations

This research is mainly focused on automatically locating dust sources and estimating their transport direction in NOAA-AVHRR images. Applications of AVHRR images may include agricultural assessment, producing maps of large area, and to retrieve various geophysical parameters. The AVHRR simultaneously records five bands of data, in our research, we focused on bands four and five since these wavelengths highlight the absorption and subsequent emission of thermal radiation by the silicate particles in the dust storms.

In this research, we propose a new method to detect dust clouds on satellite images. The approach we propose involves the use of an image …

Conformal Electronics Packaging Through Additive Manufacturing And Micro-Dispensing, Richard I. Olivas

Open Access Theses & Dissertations

Realizing electronic systems that are conformal with curved or complex surfaces is difficult if not impossible with conventional fabrication techniques, which require rigid, two dimensional, printed circuit boards (PCB). Flexible copper based fabrication is widely available commercially providing conformance, but not simultaneously stiffness. As a result, these systems are susceptible to reliability problems if repeatedly bent or stretched. The integration of Additive Manufacturing (AM) combined with Direct Print (DP) micro-dispensing can produce shapes of arbitrary and complex form that also allows for 1) miniature cavities for insetting electronic components and 2) conductive traces for electrical interconnect between components. The fabrication …

Algorithms For Training Large-Scale Linear Programming Support Vector Regression And Classification, Pablo Rivas Perea

Open Access Theses & Dissertations

The main contribution of this dissertation is the development of a method to train a Support Vector Regression (SVR) model for the large-scale case where the number of training samples supersedes the computational resources. The proposed scheme consists of posing the SVR problem entirely as a Linear Programming (LP) problem and on the development of a sequential optimization method based on variables decomposition, constraints decomposition, and the use of primal-dual interior point methods. Experimental results demonstrate that the proposed approach has comparable performance with other SV-based classifiers. Particularly, experiments demonstrate that as the problem size increases, the sparser the solution …

Special Issue On Wireless Sensor And Actuator Networks, Jiming Chen, Karl H. Johanson, Stephan Olariu, Ioannis Ch. Paschalidis, Ivan Stojmenovic

Computer Science Faculty Publications

( First paragraph) WIRELESS Sensor Networks (WSNs), in their various shapes and forms, have greatly facilitated and enhanced the automated, remote, and intelligent monitoring of a large variety of physical systems. These networks consist of a large number of typically small devices, each incorporating sensing, processing, and wireless communications capabilities. Their use has penetrated a plethora of application domains from industrial and building automation, to environmental, wildlife, and health monitoring.

Artificial Neural Network Based Fault Location For Transmission Lines, Suhaas Bhargava Ayyagari

University of Kentucky Master's Theses

This thesis focuses on detecting, classifying and locating faults on electric power transmission lines. Fault detection, fault classification and fault location have been achieved by using artificial neural networks. Feedforward networks have been employed along with backpropagation algorithm for each of the three phases in the Fault location process. Analysis on neural networks with varying number of hidden layers and neurons per hidden layer has been provided to validate the choice of the neural networks in each step. Simulation results have been provided to demonstrate that artificial neural network based methods are efficient in locating faults on transmission lines and …

Lead Silicate Glass Microsphere Resonators With Absorption-Limited Q, Pengfei Wang, Genapathy Murugan, Timothy Lee, Xian Feng, Yuliya Semenova, Qiang Wu, Wei Loh, Gilberto Brambilla, James Wilkinson, Gerald Farrell

Articles

We report the fabrication and characterization of a lead-silicate glass microsphere resonator. We show that at the wavelengths near 1555 nm high Q modes can be efficiently excited from a 109 μm diameter lead-silicate glass microsphere via evanescent coupling using a tapered silica fiber with a waist diameter of 2 μm. Resonances with Q-factors as high as 0.9×10⁷ were observed. This is very close to the theoretical material-limited Q-factor and is the highest Q-factor reported so far from a nonlinear glass microsphere.

On Improving Electrooculogram-Based Computer Mouse Systems: The Accelerometer Trigger, Johnalan Keegan, Edward Burke, James Condron, Eugene Coyle

Conference Papers

Eye tracking is a well-established method of computer control for profoundly paralysed people (Anson et al., 2002). Cameras are commonly used to track eye movements (Morimoto et al., 2005) but one alternative is the bioelectrical signal known as the electrooculogram (EOG). There are some EOG mouse control systems that facilitate the use of GUI applications, but certain actions, which are straightforward using a conventional mouse, remain impossible. Unless the eyes are tracking a target, they move in saccades (jumps), making it impossible to voluntarily trace out smooth trajectories with one's gaze, as would be required to draw a smooth curve. …

A Study On Prospects For The Evolution Of Maritime Traffic Management Systems Taking Into Account E-Navigation, Kwang An

World Maritime University Dissertations

No abstract provided.

Design Concepts Of Terahertz Quantum Cascade Lasers: Proposal For Terahertz Laser Efficiency Improvements, Tillmann Kubis, Saumitra Raj Mehrotra, Gerhard Klimeck

Birck and NCN Publications

Conceptual disadvantages of typical resonant phonon terahertz quantum cascade lasers 􏰎THz-QCLs􏰍 are analyzed. Alternative designs and their combination within a concrete device proposal are discussed to improve the QCL performance. The improvements are 􏰎1􏰍 indirect pumping of the upper laser level, 􏰎2􏰍 diagonal optical transitions, 􏰎3􏰍 complete electron thermalization, and 􏰎4􏰍 materials with low effective electron masses. The nonequilibrium Green’s function method is applied to predict stationary electron transport and optical gain. The proposed THz-QCL shows a higher optical gain, a lower threshold current, and a higher operation temperature. Alloy disorder scattering can worsen the QCL performance.

High Impedance Arc Fault Detection In A Manhole Environment., Thomas Arthur Cooke

Electronic Theses and Dissertations

The scope of this thesis was to develop a prototype high-impedance arc detection system that a utility worker could use as an early warning system while working in a manhole environment. As part of this system sensors and algorithms were developed to increase the sensitivity of detecting an arc while ignoring loads that can give false positive signatures for arcing. The latest technology was used to repeat measurements performed in previous research from decades ago that lacked in sampling speed and amplitude resolution. Several types of arcs were produced and analyzed so to establish a library of various waveform and …