Electrical and Electronics Commons^™

One-Pin 32 Khz Low-Power Crystal Oscillator, Aaron Plata-Ruiz

Electrical Engineering

This design is a one-pin, 32 kHz, low-power, crystal oscillator suitable for battery-operated systems. The design is based on a design published by Ali E Zadeh, “A Micropower, Battery-Operated, One-Pin Crystal Oscillator”, but redesigned for standard positive power supply configuration, which is suitable for typical n-well CMOS process.

Solar Powered Backpack, Saagar Sabharwal, Tom Poonsopin

Electrical Engineering

One popular motto in electrical engineering today is “going green.” This project will convert the sun’s energy into reusable energy. The purpose of this senior project is to develop a solar powered backpack that can charge certain portable USB devices for students. Many students walk around campus with an iPod or cell phone, which has surely died or ran low on batteries at least once when needed most. This backpack will allow students to charge their devices “on the go.” When students walk or bike around campus, the solar panels attached to the backpack will allow recharging of their portable …

Rfid Techniques For Passive Electronics, Ryan Behr, David Cobos

Electrical Engineering

No abstract provided.

Smooth Ternary Signaling For Deep-Submicron(Dsm) Buses, Robert Endicott Hanson, Ryan Ian Fullerton

Electrical Engineering

This project demonstrates the error mitigating effects of using a three-level “smooth ternary” signal on a Deep-Submicron(DSM) bus with large inter-wire capacitance. An RC circuit used to simulate and exaggerate (for easier testing) the charging and discharging of the DSM bus. An encoder stage translates binary input data into a three-level signal before sending it to the bus. A decoder stage then translates the three-level signal back to binary that is ideally identical to the original signal. Our results show that the three-level signal has much cleaner transitions than a traditional binary signal. A few glitches that appeared when decoding …

Design And Simulation Of V2g Bidirectional Inverter And Dc-Dc Converter, Allan Agatep, Mason Ung

Electrical Engineering

As plug-in hybrid electric vehicles (PHEV) become more popular, the utility companies are forced to feed the grid more electricity. However, these PHEVs are capable of providing power to the grid when they are parked serving as ancillary systems for grid regulation (V2G). Using a system based on photovoltaic (PV) technology, a design for a bidirectional inverter with LCL filter, and a bidirectional dc-dc with a constant current controller, was constructed using LTspice. Various papers were researched and analyzed to determine applicable designs for components. Simulations show the designs are capable of bidirectional power transfer. ETAP simulations show that delivering …

Variability Of Electroluminescent Displays, Christopher (C.) Michael Shedd, Nathan Ostrout

Graphic Communication

No abstract provided.

Development Of A Cubesat Instrument For Microgravity Particle Damper Performance Analysis, John Trevor Abel

Master's Theses

Spacecraft pointing accuracy and structural longevity requirements often necessitate auxiliary vibration dissipation mechanisms.  However, temperature sensitivity and material degradation limit the effectiveness of traditional damping techniques in space.  Robust particle damping technology offers a potential solution, driving the need for microgravity characterization.   A 1U cubesat satellite presents a low cost, low risk platform for the acquisition of data needed for this evaluation, but severely restricts available mass, volume, power and bandwidth resources.  This paper details the development of an instrument subject to these constraints that is capable of capturing high resolution frequency response measurements of highly nonlinear particle damper dynamics.

Bridgeless Active Power Factor Correction Using A Current Fed Push Pull Converter, Jeramie Seth Bianchi

Master's Theses

ABSTRACT

Bridgeless Active Power Factor Correction

Using a Current Fed Push Pull Converter

Jeramie Seth Bianchi

Switched Mode Power Supplies have become increasingly popular for efficient methods of delivering power to an assortment of electronic devices. This thesis proposes a method of using a current fed push pull converter to provide active power factor correction and rectification in a single stage. While most AC-DC converters utilize a bridge rectifier to convert AC-DC and then perform DC-DC conversion, the proposed circuit will utilize its output diodes to perform rectification, thus eliminating the need for a bridge rectifier. This circuit will also …

Project 308: Augmented Reality Mario Kart, Joseph Abad, David Allender, Joryl Calizo, Ryan Gaspar, Gavin Lee

Computer Engineering

Mario Kart is a popular go-kart racing game developed by Nintendo. The premise of the game is simple: drive a go-kart along a racetrack and reach the finish line before the other players. What makes this game unique, however, is the inclusion of weapons, traps, and other projectiles that a player can use to gain an advantage in the race. We have taken on the challenge of not only recreating this amazing game, but using the art of Augmented Reality to fully immerse the player in the full experience. Rather than play the game on a television screen with a …

Modeling And Analysis Of The Effects Of Pcb Parasitics On Integrated Dc-Dc Converters, Darwin Domingo Fernandez

Master's Theses

Load transients are prevalent in every electronic device including semiconductor memory, card readers, microprocessors, disc drives, piezoelectric devices, and digitally based systems. They are capable of producing voltage stress, introducing noise, and degrading device functionality. In order to avoid damage to the device, a feedback control loop is implemented with system compensation to regulate the output voltage deviations by the converter. Because designing compensation networks can be rather complicated, DC-DC converters with integrated feedback control topologies help minimize design time and complexity of converter compensation at the expense of design flexibility. This thesis widens the limitations of an integrated DC-DC …

Efficient Packet Delivery In Modern Communication Networks, Nan Wang

Dissertations

Modern communication networks are often designed for diverse applications, such as voice, data and video. Packet-switching is often adapted in today’s networks to transmit multiple types of traffic. In packet-switching networks, network performance is directly affected by how the networks handle their packets. This work addresses the packet-handling issues from the following two aspects: Quality of Service (QoS) and network coding.

QoS has been a well-addressed issue in the study of IP-based networks. Generally, nodes in a network need to be informed of the state of each communication link in order to make intelligent decisions to route packets according to …

Optimizing Resource Allocation In Next-Generation Optical Access Networks, Jingjing Zhang

Dissertations

To meet rapidly increasing traffic demands caused by the popularization of Internet and the spouting of bandwidth-demanding applications, Passive Optical Networks (PONs) exploit the potential capacities of optical fibers, and are becoming promising future-proof access network technologies. On the other hand, for a broader coverage area and higher data rate, integrated optical and wireless access is becoming a future trend for wireless access. This thesis investigates three next-generation access networks: Time Division Multiplexing (TDM) PONs, Wavelength Division Multiplexing (WDM) PONs, and WDM Radio-Over-Fiber (RoF) Picocellular networks.

To address resource allocation problems in these three networks, this thesis first investigates respective …

Digital Image Forensics, Fei Long

Theses

Digital image forensics is a relatively new research field that aims to expose the origin and composition of, and the history of processing applied to digital images. Hence, the digital image forensics is expected to be of significant importance to our modern society in which the digital media are getting more and more popular. In this thesis, image tampering detection and classification of double JPEG compression are the two major subjects studied. Since any manipulation applied to digital images changes image statistics, identifying statistical artifacts becomes critically important in image forensics. In this thesis, a few typical forensic techniques have …

Design And Evaluation Of An Adaptable Vector Coprocessor For Multicores, Timothy William Steele

Theses

Future applications for multi-core processor systems will require increased signal processing power along with increased resource utilization and decreased power consumption. Conservative power consumption will be of paramount importance primarily for battery-powered portable multi-core platforms (e.g., advanced cell phones, tablet computers, etc.). This thesis investigates the robustness, efficiency and effectiveness of vector coprocessor sharing policies in multi-core environments. Vector coprocessor sharing is based on an innovative design for a vector lane that forms the building block for the creation of larger vector coprocessors. This innovative lane design contains a floating-point multiply unit, a floating-point add/subtract unit, a miscellaneous function unit, …

Principal Angles And Principal Azimuths Of Frustrated Total Internal Reflection And Optical Tunneling By An Embedded Low-Index Thin Film, R. M.A. Azzam, F. F. Sudradjat

Electrical Engineering Faculty Publications

The condition for obtaining a differential (or ellipsometric) quarter-wave retardation when p- and s-polarized light of wavelength λ experience frustrated total internal reflection (FTIR) and optical tunneling at angles of incidence ϕ≥ the critical angle by a transparent thin film (medium 1) of low refractive index n1 and uniform thickness d, which is embedded in a transparent bulk medium 0 of high refractive index n0 takes the simple form: −tanh2x=tanδptanδs , in whichx=2πn1(d/λ)(N2sin2ϕ−1)1/2 , N=n0/n1 , and δp , δs are 01 interface Fresnel reflection phase shifts for the pand s polarizations. From this condition, the …

Led Device Having Improved Light Output, Ronald S. Cok, Michael E. Miller

AFIT Patents

A thin-film, white-light-emitting diode device includes a reflective, conductive thin-film structure and a semi-transparent, conductive thin-film structure. One or more thin-film layers are formed between the reflective and semi-transparent conductive thin-film structures to form two or more commonly-controlled microcavity structures. The thin-film layers emit white light in response to current provided by the conductive thin-film structure. Each of the two or more commonly-controlled microcavity structures has a different resonant frequency within one or more optical cavities and emits light with a smaller spectral range than the spectral range of the white-light-emitting thin-film layer(s). A combination of light emitted from the …

Passive Matrix Electro-Luminescent Display System, Michael E. Miller, John F. Hamilton Jr., Andrew D. Arnold

AFIT Patents

A passive matrix, electro-luminescent display system has a passive matrix, electro-luminescent display having an orthogonally oriented array of column and row electrodes and an electro-luminescent layer located between the electrodes at the intersection of each column and row electrode forming an individual light-emitting element. Drivers provide separate signals at different times to different groups of row electrodes within the array of row electrodes; wherein the row electrodes of each group simultaneously receive at least two different level signals. A display driver receives and processes the input image signal to provide a presharpened image control signal. Column drivers respond to the …

Examination Of Chaotic Signal Encryption And Recovery For Secure Communication Using Hybrid Acousto-Optic Feedback, Monish Ranjan Chatterjee, Mohammed A. Al-Saedi

Electrical and Computer Engineering Faculty Publications

Generation of chaos from acousto-optic (A-O)Bragg cell modulators with an electronic feedback has been studied for over 3 decades. Since an acousto-optic Bragg cell with zeroth- and first-order feedback exhibits chaotic behavior past the threshold for bistability, such a system was recently examined for possible chaotic encryption of simple messages (such as a low-amplitude sinusoidal signal) applied via the bias input of the sound cell driver. Subsequent recovery of the message signal was carried out via a heterodyne-type strategy employing a locally generated chaotic carrier, with threshold parameters matched to the transmitting Bragg cell.

In this paper, we present numerical …

Elliptical Machine Dc-Dc Converter For The Energy Harvesting From Exercise Machines Project, Greg Hollister

Electrical Engineering

Designing a DC/DC Converter for the Cal Poly Energy Harvesting from Exercise Machines project requires special attention to the unique operating characteristics of the source and the load. An elliptical machine powered by a person exercising comprises the source, while an AC Inverter makes up the load. This project attempts to integrate the two devices with a custom DC/DC Converter in order to ultimately deliver power back into the power grid.

Energy Harvesting From Elliptical Machines Using Four-Switch Buck-Boost Topology, Alvin Jay Hilario

Master's Theses

This thesis presents the topic of using the Four-Switch Buck-Boost topology as a DC-DC converter for the Energy Harvesting from Elliptical Machines Project. The project works toward providing a modular synchronous power generation system. Due to the dynamic and sporadic output voltage and power characteristics of the Precor elliptical machine, the system requires a DC-DC converter as a voltage preregulator. The inherent wide input range, high efficiency, and low parts cost of this converter well suit the application. This paper further discusses other topologies and their shortcomings, as well as characterizes the Precor elliptical machine and Enphase Microinverter for interfacing. …