Aerospace Engineering Commons^™

Active Control Of Shocks And Sonic Boom Ground Signal, Bedri Yagiz

Mechanical & Aerospace Engineering Theses & Dissertations

The manipulation of a flow field to obtain a desired change is a much heightened subject. Active flow control has been the subject of the major research areas in fluid mechanics for the past two decades. It offers new solutions for mitigation of shock strength, sonic boom alleviation, drag minimization, reducing blade-vortex interaction noise in helicopters, stall control and the performance maximization of existing designs to meet the increasing requirements of the aircraft industries. Despite the wide variety of the potential applications of active flow control, the majority of studies have been performed at subsonic speeds. The active flow control …

Solution Approximation For Atmospheric Flight Dynamics Using Volterra Theory, Ashraf Mohammed Kandeel Omran

Mechanical & Aerospace Engineering Theses & Dissertations

This dissertation introduces a set of novel approaches in order to facilitate and enrich Volterra theory as a nonlinear approximation technique for constructing mathematical solutions from the governing relationships describing aircraft dynamic behavior. These approaches reconnect Volterra theory and flight mechanics research, which has not been addressed in the technical literature for over twenty years. Volterra theory is known to be viable in modeling weak nonlinearities, but is not particularly well suited for directly describing high performance aircraft dynamics. In order to overcome these obstacles and restrictions of Volterra theory, the global Piecewise Volterra Approach has been developed. This new …

Management Of A University Satellite Program With Focus On A Refrigerant-Based Propulsion System, Shawn W. Miller

Masters Theses

"The Missouri University of Science and Technology Satellite (M-SAT) design team has established a satellite program to develop a pair of satellites to perform an autonomous formation flight mission. The resulting configuration was assembled for the Air Force Research Lab University Nanosat Program. This document, written by the Program Manager and former member of the Propulsion subsystem, is a description of the management process used by the team to develop a satellite configuration. Included in the document is a discussion of team organization, techniques for managing a program, and lessons learned during the 2007 to 2008 timeframe. The managing techniques …

Black Carbon Over Mexico: The Effect Of Atmospheric Transport On Mixing State, Mass Absorption Cross-Section, And Bc/Co Ratios, R. Subramanian, G. L. Kok, D. Baumgardner, A. Clarke, Y. Shinozuka, T. L. Campos, C. G. Heizer, B. B. Stephens, B. De Foy, Paul B. Voss, R. A. Zaveri

Engineering: Faculty Publications

A single particle soot photometer (SP2) was operated on the NCAR C-130 during the MIRAGE campaign (part of MILAGRO), sampling black carbon (BC) over Mexico. The highest BC concentrations were measured over Mexico City (sometimes as much as 2μg/m3) and over hillfires to the south of the city. The age of plumes outside of Mexico City was determined using a combination of HYSPLIT trajectories, WRF-FLEXPART modeling and CMET balloon tracks. As expected, older, diluted air masses had lower BC concentrations. A comparison of carbon monoxide (CO) and BC suggests a CO background of around 65 ppbv, and a background-corrected BC/COnet …

Studies Of Dynamic Crack Propagation And Crack Branching With Peridynamics, Youn Doh Ha, Florin Bobaru

Department of Engineering Mechanics: Faculty Publications

In this paper we discuss the peridynamic analysis of dynamic crack branching in brittle materials and show results of convergence studies under uniform grid refinement (m-convergence) and under decreasing the peridynamic horizon (δ-convergence). Comparisons with experimentally obtained values are made for the crack-tip propagation speed with three different peridynamic horizons.We also analyze the influence of the particular shape of themicro-modulus function and of different materials (Duran 50 glass and soda-lime glass) on the crack propagation behavior. We show that the peridynamic solution for this problem captures all the main features, observed experimentally, of dynamic crack propagation and branching, as well …

Real-Time On-Board Object Tracking For Cooperative Flight Control, Ajay Kumar Mandava, Emma Regentova, Henry Selvaraj

Electrical & Computer Engineering Faculty Research

One of possible cooperative Situations for flights could be a scenario when the decision on a new path is taken by A Certain fleet member, who is called the leader. The update on the new path is Transmitted to the fleet members via communication That can be noisy. An optical sensor can be used as a back-up for re-estimating the path parameters based on visual information. For A Certain topology, the issue can be solved by continuous tracking of the leader of the fleet in the video sequence and re-adjusting parameters of the flight, accordingly. To solve such a problem …

Development Of A Micro-Catbed For Miniature Thrusters, Chance Paul Garcia

Open Access Theses & Dissertations

The goal of this work is to develop a micro catalytic bed for miniature thrusters. A test bed was constructed for experimental testing to characterize several parts of the micro catalytic bed. The reactant fluid studied is 90% Hydrogen Peroxide (H2O2) by weight. Three different cross sectional area designs were tested to determine decomposition efficiency, temperature reaction propensity, optimum flow rate, and temperature distribution across each bed. The products of decomposition were condensed to measure the oxygen released from decomposition. The results will be used to develop the basis for a micro catalytic bed design to implement into future miniature …

An Investigation On Pulsing Performance Of Mn Class Bi-Propellant Thrusters, Carlos Francisco Gomez

Open Access Theses & Dissertations

With the advancement of technology and machining methods, considerable attention has been focused in manufacturing micro thrusters for micro spacecraft applications (Yetter et al, 2003). Micro propulsion systems are currently being investigated for Miniature Kill Vehicles (MKV) and Micro Satellite Systems (MSS) with an emphasis in reducing weight and cost but without affecting performance. Reducing the weight seems practical when reducing the size of the propulsion system, but problems are encountered with system design.

In addition, propulsion requirements strongly influence choice in propellant and complexity. A thorough understanding of stabilizing thrust levels and the ability to control the propulsion system …

Processing Of Zrb2-Zrc-Zrxsiy Ceramic By Reactive Metal Penetration, Nischel B. Maheswaraiah

Open Access Theses & Dissertations

The processing of ZrB2-ZrC-ZrxSiy composite by reactive metal penetration was investigated as a successor to the ZrB2-SiC composites for hypersonic vehicles application, which cannot be used for extended time at temperatures greater than 1600C due to formation of SiO and CO gases. Zirconium (Zr), zirconium disilicide (ZrSi2), and boron carbide (B4C) were reacted in graphite crucibles for 60, 120, 180, and 240 minutes. Microscopy and x-ray diffraction (XRD) deduced the formation of a heterogeneous microstructure of ZrB2-ZrC-ZrxSiy precipitates surrounded by a solidified Zr-Si melt. Unreacted boron carbide was observed in samples held at 1860C for 60 minutes and 120 minutes, …

Microstructure Investigation Of Al-Rich Titanium Aluminum Alloys, David Pham

Open Access Theses & Dissertations

The microstructures of Ti-Al alloys with 70-80 wt% Al were investigated. Aluminum wire (99.999%) and TiH₂ powder (99.7%) were used to produce the sample compositions inside a vertical tube furnace at 1600^oC in an Ar atmosphere. Argon is purified through a dehumidification and deoxidation system. Magnesium perchlorate Mg(ClO₄)₂ acts as a desiccant and titanium sponge pulls oxygen from the Ar in furnaces operating at 800^oC and 750^oC. X-ray diffraction and an optical microscope are used to identify phases and compositions

Thrust Measurement Of Dielectric Barrier Discharge Plasma Actuators And Power Requirements For Aerodynamic Control, Joseph William Ferry

Masters Theses

"Plasma-based aerodynamic actuators are of interest to researchers because they do not require moving control surfaces or a source of pressurized air to modify a flow field. Dielectric barrier discharge (DBD) plasma actuators have the added advantages of simple installation and low power consumption.

DBD plasma actuators are AC devices. This work measured actuator power consumption and thrust production for driving frequencies between 1 and 18 kHz, and for driving voltages of 6 and 9 kV peak to peak. The actuator consumed between 3 and 22 W of power and produced thrust levels between 0.05 and 0.2 mN per meter …

A Numerical Investigation Of Flowfield Modification In High-Speed Airbreathing Inlets Using Energy Deposition, Matthew Flynn Rohweder

Masters Theses

"Energy deposition in front of dual-mode ram/scramjet engines is numerically investigated utilizing two-dimensional CFD for its potential to modify inlet/isolator flow-fields for engine start/unstart control and for its general potential for generating large-scale flow-field modification in such flows. A simplified (high Mach number) constant-area duct geometry is initially defined in order to test the feasibility of the concept; the results from this initial investigation demonstrates possible beneficial effects of depositing energy upstream of a thermally choked duct in terms of causing massive changes in flow patterns, including the reestablishment of supersonic flow throughout the duct. This study is followed by …

Integration And Test Of A Refrigerant-Based Cold-Gas Propulsion System For Small Satellites, Ryan Alan Pahl

Masters Theses

"Due to the launch safety constraints placed on university-built small satellites, designing a low-cost propulsion system to meet mission requirements presents a significant challenge to aspiring student engineers. The Missouri University of Science and Technology is currently developing a low-cost, two-phase propulsion system using the refrigerant R-134a as the propellant that can be stored at low pressures while still providing sufficient performance to meet mission goals. The purpose of this study is to present the testing results of a refrigerant-based cold gas system utilizing R-134a as a saturated liquid propellant and the ability to design this system to be portable …

Quantification Of Uncertainty In Aerodynamic Heating Of A Reentry Vehicle Due To Uncertain Wall And Freestream Conditions, Benjamin R. Bettis

Masters Theses

"The primary focus of this study is to demonstrate an efficient approach for uncertainty quantification of surface heat flux to the spherical non-ablating heatshield of a generic reentry vehicle due to epistemic and aleatory uncertainties that may exist in various parameters used in the numerical solution of hypersonic, viscous, laminar blunt-body flows with thermo-chemical non-equilibrium. Two main uncertainty sources were treated in the computational fluid dynamics (CFD) simulations: (1) aleatory uncertainty in the freestream velocity and (2) epistemic uncertainty in the recombination efficiency for a partially catalytic wall boundary condition. The Second-Order Probability utilizing a stochastic response surface obtained with …

Analysis Of The Theta-D Filter As Applied To Hit-To-Kill Interceptors And Satellite Orbit Determination, Michael W. Dancer

Masters Theses

"When designing feedback control systems, there is often a need for estimation methods that provide system information that is not readily available via sensors placed within the system. In many cases a sensor that measures a particular system state either does not exist or is prohibitively expensive. In addition, all realistic systems contain some degree of nonlinearity. This thesis focuses on two such cases: missile guidance with bearings-only measurements and GPS satellite orbit determination. In each case, a new nonlinear filter, the [theta]-D method, is used and evaluated for its performance in providing the necessary estimation. To aid the filter …

Direct Numerical Simulation Of Hypersonic Turbulent Boundary Layers. Part 2. Effect Of Wall Temperature, L. (Lian) Duan, I. Beekman, M. P. Martín

Mechanical and Aerospace Engineering Faculty Research & Creative Works

In this paper, we perform direct numerical simulation (DNS) of turbulent boundary layers at Mach 5 with the ratio of wall-to-edge temperature T w/T ℘ from 1.0 to 5.4 (Cases M5T1 to M5T5). The influence of wall cooling on Morkovin's scaling, Walz's equation, the standard and modified strong Reynolds analogies, turbulent kinetic energy budgets, compressibility effects and near-wall coherent structures is assessed. We find that many of the scaling relations used to express adiabatic compressible boundary-layer statistics in terms of incompressible boundary layers also hold for non-adiabatic cases. Compressibility effects are enhanced by wall cooling but remain insignificant, and the …

Influence Of Interactions Between Turbulence And Radiation On Transmissivities In Hypersonic Turbulent Boundary Layers, A. M. Feldick, L. (Lian) Duan, M. F. Modest, M. P. Martín, D. A. Levin

Mechanical and Aerospace Engineering Faculty Research & Creative Works

In the current paper, a high-fidelity large eddy simulation solver is coupled to our modified line-by-line radiative transport equation solver to study the effects of absorption turbulence-radiation interations in a hypersonic turbulent boundary layer, representative of the Orion CEV entering Earth's atmosphere, at peak heating condition. The turbulent and radiation fields represent extreme conditions typical of Orion, as the simulated boundary layer represents the region of high turbulence coupled to region of highest incident radiation. A simplification in the calculation of molecular spectra with a single temperature property database in allows for tractable calculation of spectral properties. A comparison of …

Direct Detection Of No Produced By High-Temperature Surface-Catalyzed Atom Recombination, Dušan A. Pejaković, Jochen Marschall, Lian Duan, Maria P. Martin

Mechanical and Aerospace Engineering Faculty Research & Creative Works

The surface-catalytic recombination of oxygen and nitrogen atoms to form nitric oxide was confirmed by the direct detection of product NO molecules, using single-photon laser-induced fluorescence spectroscopy. Experiments were performed from room temperature to 1200 K in a quartz diffusion-tube sidearm reactor enclosed in a high temperature tube furnace. Atomic nitrogen was generated using a microwave discharge, and atomic oxygen was produced via the rapid gas-phase titration reaction N + NO → O + N2. The use of isotopically labeled titration gases 15N16O and 15N18O allowed for the unambiguous identification of nitric oxide produced by the O + N surface …

Direct Numerical Simulation Of Hypersonic Turbulent Boundary Layers With Varying Freestream Mach Number, L. (Lian) Duan, I. Beekman, M. P. Mart́In

Mechanical and Aerospace Engineering Faculty Research & Creative Works

In this paper, the effects of freestream Mach number on the statistics and large-scale structures in compressible turbulent boundary layers are investigated using direct numerical simulations (DNS). DNS of turbulent boundary layers with nominal freestream Mach number ranging from 3 to 8 are performed. The validity of Morkovin's scaling, strong Reynolds analogy, and Walz's equation are assessed. We find that many of the scaling relations used to express compressible boundary layer statistics in terms of incompressible boundary layers still hold for the range of freestream Mach number considered. Compressibility effects are enhanced with increasing freestream Mach number but remain insignificant, …

Constrained Optimal Orbit Design For Earth Observation, Sharon D. Vtipil

Mechanical & Aerospace Engineering Theses & Dissertations

The purpose of this dissertation is to demonstrate use requirements for a satellite observation mission can be used to determine a constrained optimal orbit based on observation site requirements, observation condition restraints, and sensor characteristics. The typical Earth observation satellite is first designed according to an appropriate orbit; then the observation requirements are used to develop a target schedule. The new design process outlines the development of the appropriate orbit by incorporating user requirements at the forefront of mission planning, not after an orbit has been selected. This research shows how to map the user requirements into constraints for the …