Mechanical Engineering Commons^™

Developing A System For Blind Acoustic Source Localization And Separation, Raghavendra Kulkarni

Wayne State University Theses

This dissertation presents innovate methodologies for locating, extracting, and separating multiple incoherent sound sources in three-dimensional (3D) space; and applications of the time reversal (TR) algorithm to pinpoint the hyper active neural activities inside the brain auditory structure that are correlated to the tinnitus pathology. Specifically, an acoustic modeling based method is developed for locating arbitrary and incoherent sound sources in 3D space in real time by using a minimal number of microphones, and the Point Source Separation (PSS) method is developed for extracting target signals from directly measured mixed signals. Combining these two approaches leads to a novel technology …

Ion Current Signal Detection During Cold Starting And Idling Operation In A Diesel Engine, Sanket Anil Gujarathi

Wayne State University Theses

Cold starting of diesel engines is characterized by inherent problems such as long cranking periods and combustion instability leading to an increase in fuel consumption and the emission of high concentrations of hydrocarbons which appear as white smoke. Accordingly, a signal indicative of combustion during cold starting and idling operation is important for combustion and emission control. The ion current signal has been considered for the feedback control of both gasoline and diesel engines. However, the ion current signal produced from the combustion of the heterogeneous charge in diesel engines is weaker compared to that produced from the combustion of …

Characteristics Of Cold Start Of A Diesel Engine Using Jp8 And Ulsd Fuels, Madhushankar Palanisamy

Wayne State University Theses

This study involves the cold start testing of ULSD and JP8 fuels on the 6 cylinder 7.2 liter turbocharged diesel engine at various ambient temperatures as low as 0oF for JP8 fuel and 10oF for ULSD fuel. Cycle by cycle analysis of the cold start transient data, along with the effects of variation in ambient temperature on the engine cranking speed and in cylinder motoring pressure were analyzed and presented. It was found that the reduction in ambient temperature resulted in prolonged cranking periods along with the longer time taken to reach idling speed as well as increased combustion instability. …

System Dynamics Modeling Of Hybrid Renewable Energy Systems And Combined Heating And Power Generator, Krishna R. Reddi, Weilin Li, Bochao Wang, Young B. Moon

Mechanical and Aerospace Engineering - All Scholarship

The role of energy in the present world is critical in terms of both economical development and environmental impact. Renewable energy sources are considered essential in addressing these challenges. As a result, a growing number of organisations have been adopting hybrid renewable energy system (HRES) to reduce their environmental impact and sometimes take advantage of various incentives. When a HRES is being planned, the ability to model a HRES can provide an organisation with numerous benefits including the capability of optimising sub-systems, predicting performances and carrying out sensitivity analysis. In this paper, we present a comprehensive system dynamics model of …

A New Class Of Solid Oxide Metal-Air Redox Batteries For Advanced Stationary Energy Storage, Xuan Zhao

Theses and Dissertations

Cost-effective and large-scale energy storage technologies are a key enabler of grid modernization. Among energy storage technologies currently being researched, developed and deployed, rechargeable batteries are unique and important that can offer a myriad of advantages over the conventional large scale siting- and geography- constrained pumped-hydro and compressed-air energy storage systems. However, current rechargeable batteries still need many breakthroughs in material optimization and system design to become commercially viable for stationary energy storage.

This PhD research project investigates the energy storage characteristics of a new class of rechargeable solid oxide metal-air redox batteries (SOMARBs) that combines a regenerative solid oxide …

Electrokinetic Mixing And Separation In Microfluidic Systems, Fang Yang

Theses and Dissertations

Electrokinetics involves the study of liquid or particle motion under the action of an electric field; it includes electroosmosis, electrophoresis, dielectrophoresis, and electrowetting, etc. The applications of electrokinetics in the development of microfluidic devices have been widely attractive in the past decade. Electrokinetic devices generally require no external mechanical moving parts and can be made portable by replacing the power supply by small battery. Therefore, electrokinetic based microfluidic systems can serve as a viable tool in creating a lab-on-a-chip (LOC) for use in biological and chemical assays. Here we present our works of electrokenitic based mixing and separation in microfluidics …

Welding Parameters, Distortion And Mechanical Properties Of Aa7075 Lap Joints In Ssfsw, Hejun Yu

Theses and Dissertations

Friction Stir Welding (FSW), first invented by The Welding Institute of UK (TWI) in 1991, is a solid state welding process which was initially applied to welding Aluminum Alloy. FSW has wide application in industrial sectors. Stationary shoulder friction stir welding (SSFSW) was first developed to weld low thermal conductivity Ti-based alloys, which are hard to weld using conventional friction stir welding. Previous literatures showed SSFSW can produce uniform temperature distribution through thickness during the welding process. Since SSFSW is still under study phase, its advantages and disadvantages are not yet well defined. It is important to study the characteristics …

Toward Sophisticated Controls Of Two-Phase Transport At Micro/Nano-Scale, Fanghao Yang

Theses and Dissertations

Through the use of latent heat evaporating, flow boiling in microchannels offers new opportunities to enable high efficient heat and mass transport for a wide range of emerging applications such as high power electric/electronic/optical cooling, compact heat exchangers and reactors. However, flow boiling in microchannels is hampered by several severe constraints such as bubble confinement (e.g., slug flow), viscosity and surface tension force-dominated flows, which result in unpredictable flow pattern transitions and tend to induce severe flow boiling instabilities (i.e. low-frequency and large magnitude flows) and suppress evaporation and convection.

In this dissertation, three novel micro/nanoscale thermo-fluidic control methodologies were …

Positive Matrix Factorization Of Pm2.5 - Eliminating The Effects Of Gas/Particle Partitioning Of Semivolatile Organic Compounds, Mingjie Xie, Kelley Barsanti, Michael P. Hannigan, Steven J. Dutton, Sverre Vedal

Civil and Environmental Engineering Faculty Publications and Presentations

Gas-phase concentrations of semi-volatile organic compounds (SVOCs) were calculated from gas/particle (G/P) partitioning theory using their measured particle-phase concentrations. The particle-phase data were obtained from an existing filter measurement campaign (27 January 2003-2 October 2005) as a part of the Denver Aerosol Sources and Health (DASH) study, including 970 observations of 71 SVOCs (Xie et al., 2013). In each compound class of SVOCs, the lighter species (e.g. docosane in n-alkanes, fluoranthene in PAHs) had higher total concentrations (gas + particle phase) and lower particle-phase fractions. The total SVOC concentrations were analyzed using positive matrix factorization (PMF). Then the results were …

Nebraska Summary: S952 New Holland T5.95, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …

Nebraska Summary: S953 New Holland T5.105, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …

Nebraska Summary: S954 New Holland T5.115, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …

Nebraska Summary: S947 New Holland T4.105, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …

Nebraska Summary: S946 New Holland T4.95, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …

Nebraska Summary: S930 John Deere 6125r, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …

Nebraska Summary: S928 John Deere 6105r, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …

Nebraska Summary: S926 Challenger Mt535d, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …

Nebraska Summary: S921 Challenger Mt495d, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …

Nebraska Summary: S922 Massey Ferguson 7615, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …

Nebraska Summary: S919 Challenger Mt475d, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …