Mechanical Engineering Commons^™

Synthesis Of Graphene Nanomaterials And Their Application In Electrochemical Energy Storage, Guoping Xiong

Open Access Dissertations

The need to store and use energy on diverse scales in a modern technological society necessitates the design of large and small energy systems, among which electrical energy storage systems such as batteries and capacitors have attracted much interest in the past several decades. Supercapacitors, also known as ultracapacitors, or electrochemical capacitors, with fast power delivery and long cycle life are complementing or even replacing batteries in many applications. The rapid development of miniaturized electronic devices has led to a growing need for rechargeable micro-power sources with high performance. Among different sources, electrochemical micro-capacitors or micro-supercapacitors provide higher power density …

Propagation Of Sound In The Vicinity Of Rigid Porous Interfaces, Hongdan Tao

Open Access Dissertations

Propagation of sound in the vicinity of rigid porous interfaces is investigated systematically to facilitate the acoustical characterization of sound absorption materials for noise reduction applications. Various rigid porous interfaces are considered: (1) a semi-infinite porous layer; (2) a porous hard-backed surface; and (3) a porous impedance-backed layer. A closed-form solution and numerical methods are derived with respect to each rigid porous interface condition.

A modified saddle-point method is exploited to investigate the sound field emanating from a monopole source above and below a rigid porous interface. The solutions can be expressed in a form that resembles the classical Weyl-Van …

Mechanisms Of Microstructure Formation Under The Influence Of Ultrasonic Vibrations, Milan Rakita

Open Access Dissertations

Positive effects of ultrasound on crystallization have been known for almost 90 years. Application of ultrasound has been very successful in many industries, most notably in chemistry, creating a new branch of science - sonochemistry. However, ultrasonication has not found wide commercial application in the solidification processing. The reason for that is the complexity of underlying phenomena and the lack of predicting models which correlate processing parameters with the properties of a product. The purpose of this study is to give some contribution toward better understanding of mechanisms that lead to changes in the solidifying microstructure. It has been found …

An Experimental Investigation Of Wind Turbine Aerodynamic Interaction, Brandon Lee Ennis

Open Access Dissertations

Wind turbines have become a viable component in the overall energy makeup of the United States due to improved economics where energy prices have risen and production costs dropped. For a fixed cost, the effectiveness of a wind turbine financially is highly related to its performance. Considering the size of current wind farms, a minor performance improvement will result in large additional sums of revenue. A problem that has received attention with wind farms is that while the fixed costs of the development do get spread out further to reduce the installed cost of each wind turbine, the wind turbines …

Electric Machine Differential For Vehicle Traction Control And Stability Control, Sandun Shivantha Kuruppu

Open Access Dissertations

Evolving requirements in energy efficiency and tightening regulations for reliable electric drivetrains drive the advancement of the hybrid electric (HEV) and full electric vehicle (EV) technology. Different configurations of EV and HEV architectures are evaluated for their performance. The future technology is trending towards utilizing distinctive properties in electric machines to not only to improve efficiency but also to realize advanced road adhesion controls and vehicle stability controls. Electric machine differential (EMD) is such a concept under current investigation for applications in the near future. Reliability of a power train is critical. Therefore, sophisticated fault detection schemes are essential in …

Near-Field Pressure Distributions To Enhance Sound Transmission Into Multi-Layer Materials, Andrew Martin Jessop

Open Access Dissertations

The large impedance difference between air and most solids prevents significant energy transfer from incident acoustic waves across the air-material interface. Refraction also plays a role in preventing acoustic transmission, as the wave speed difference between air and solid materials results in an increase of the resulting propagation angles, creating near-field pressure distributions in the solid material. By utilizing evanescent pressure distributions, which decay normal to the usual direction of propagation and are represented as plane waves propagating with complex angles, energy propagation through the interface can be increased in the subsonic region of wave propagation: i.e., where waves typically …

Hybrid And Smart Topologically Interlocking Materials, Somesh Khandelwal

Open Access Dissertations

This thesis explores the mechanical properties of a new class of multifunctional architectured materials, Topologically Interlocking Materials (TIMs). These materials are created as an assembly of unit elements arranged in an interlocking pattern such that the load transfer between unit elements occurs by contact only. In the absence of adhesive interaction, the tensile component of the load is carried by complementary tensile elements in the form of external constraints or integrated filaments. By virtue of the bottom up design used in creating these materials, their mechanical properties are influenced by a number of controllable parameters including shape, confinement force, scale, …

Multiscale Simulation Of Thermocline Energy Storage For Concentrating Solar Power, Scott Michael Flueckiger

Open Access Dissertations

Concentrating solar power (CSP) is a renewable and demonstrated technology for large-scale power generation but requires multiple engineering advancements to achieve grid parity with conventional fossil fuels. Part of this advancement includes novel and inexpensive thermal energy systems to decouple daily power production from intermittent solar collection. Dual-media thermocline tanks, composed of molten salt and solid rock filler, offer low-cost storage capability but the concept has experienced limited deployment in CSP plants due to unresolved concerns about long-term thermal and structural stability. The main objective of the present work is to advance the understanding of thermocline storage design and operation …

Graphene Decorated Substrates And Their Interfacial Characteristics, Anurag Kumar

Open Access Dissertations

Carbon nanotubes and graphene have been extensively studied for their excellent properties. As research on carbon expands, two major issues face the scientific community: (i) Expanding the scale of synthesis and (ii) Integration of different carbon structures for improved functionality. While significant advancements have been made in large-scale synthesis, room for improvement remains. As the scale of production increases, issues such as time, cost and energy that may otherwise not be very significant, begin to play greater roles. Thus, in order to effectively transition from laboratory prototypes to industrial products, a synthesis method that can address these issues is strongly …

Subgrid Scale Modeling For Large Eddy Simulation Of Buoyant Turbulent Flows, Niranjan Shrinivas Ghaisas

Open Access Dissertations

Buoyancy effects due to small density differences commonly exist in turbulent fluid flows occurring in nature and in engineering applications. The large eddy simulation (LES) technique, which is being increasingly used for simulating buoyant turbulent flows, requires accurate modeling of the subgrid sclae (SGS) momentum and buoyancy fluxes. This thesis presents a series of LES and direct numerical simulation (DNS) studies towards a priori and a posteriori evaluation of existing SGS models, and development of new SGS models for the buoyancy flux. This thesis also presents the application of LES, in elucidating qualitative physical features and accurate measures of important …

Solution To Certain Problems In The Failure Of Composite Structures, Jonathan Goodsell

Open Access Dissertations

The present work contains the solution of two problems in composite structures. In the first, an approximate elasticity solution for prediction of the displacement, stress and strain fields within the m-layer, symmetric and balanced angle-ply composite laminate of finite-width subjected anticlastic bending deformation is developed. The solution is shown to recover classical laminated plate theory predictions at interior regions of the laminate and thereby illustrates the boundary layer character of this interlaminar phenomenon. The results exhibit the anticipated response in congruence with the solutions for uniform axial extension and uniform temperature change, where divergence of the interlaminar shearing stress is …

Numerical Techniques For The Noninvasive Assessment Of Material Properties And Stresses In Soft Biomaterials, Kent David Butz

Open Access Dissertations

The noninvasive measurement of finite displacements and strains in biomaterials by magnetic resonance imaging (MRI) may be shown to enable mathematical estimates of stress distributions and material properties within structures of the body such as articular cartilage or the intervertebral disc. Such methods will allow for non-contact and patient-specific modeling in a manner not currently possible with traditional mechanical testing or finite element techniques. Therefore, the objective of this thesis was to develop computational methods incorporating imaging-based measures of deformation, composition, and local microstructure to permit nondestructive analysis of a range of complex biomechanical systems.

Finite strain-based models were developed …

A Novel Multiblock Immersed Boundary Method Enabling High Order Large Eddy Simulation Of Pathological And Medical Device Hemodynamics, Anupindi Kameswararao

Open Access Dissertations

Computational fluid dynamics (CFD) simulations are becoming a reliable tool in understanding disease progression, investigating blood flow patterns and evaluating medical device performance such as stent grafts and mechanical heart valves. Previous studies indicate the presence of highly disturbed, transitional and mildly turbulent flow in healthy and pathological arteries. Accurate simulation of the transitional flow requires high order numerics together with a scale resolving turbulence model such as large eddy simulation (LES). This in turn limits one to use a structured fluid flow solver on which complex, branching arterial domains that are typical in the human blood circulatory system could …

On The Uniqueness And Sensitivity Of Indentation Testing Of Isotropic Materials, J. K. Phadikar, T. A. Bogetti, Anette M. Karlsson

Mechanical Engineering Faculty Publications

Instrumented indentation is a popular technique to extract the material properties of small scale structures. The uniqueness and sensitivity to experimental errors determine the practical usefulness of such experiments. Here, a method to identify test techniques that minimizes sensitivity to experimental erros is in indentation experiments developed. The methods are based on considering “shape functions,” which are sets of functions that describe the force–displacement relationship obtained during the indentation test. The concept of condition number is used to investigate the relative reliability of various possible dual indentation techniques. Interestingly, it was found that many dual indentation techniques can be as …

Theory Of Constraints Project Management In A Manufacturing Environment, Shihching Kraft

Mechanical & Aerospace Engineering Theses & Dissertations

The following thesis covers the concepts of Theory of Constraints (TOC) Project Management. Introduced by Eliyahu M. Goldratt in I 984, TOC is a management philosophy that focuses on the use of critical chain project management to prioritize everyday tasks in a company. In TOC Project Management, there is always at least one resource constraint that limits the speed at which projects are completed. TOC management philosophy also recognizes that most projects in the manufacturing industry face unknown schedule delays that could cause projects to be completed late or over the planned budget. During project plan creation, plans are developed …

Design And Implementation Of Software For Technological Forecasting And Modeling Technological Obsolescence, Gershom Kwaku Obeng

Mechanical & Aerospace Engineering Theses & Dissertations

In a world that is highly infused with technology, it is important that an organization knows how many resources such as manpower, equipment, and funding are needed at what time so that the organization does not suffer unnecessary risks. It is also important to know when to replace equipment. After examining different methods of forecasting, it was determined that manipulation of growth curves was the best way to determine the likelihood of device failure at a specific time. An approach in engineering economics was used to estimate the cost due to the failure of various devices or groups of devices. …

Probabilistic Modeling Of Erroneous Human Response To In-Vehicle Route Guidance Systems: A Domain Decomposition-Based Algorithm, Abdullah Al Farooq

Computational Modeling & Simulation Engineering Theses & Dissertations

Drivers are generally assumed to follow the shortest route to their destinations prescribed by in-vehicle route navigation systems without mistake. However, it is not uncommon that drivers make mistakes when there are complex intersections along the route to miss turns. Such mistakes would result in following a longer route than the optimal one. In this thesis, research has been conducted to analyze the effects of the number of intersections in the shortest routes of different O-D (origin-destination) pairs. While different formulations can be employed to describe such "driving with error" model, a Domain Decomposition (DD) partitioning algorithm has been developed …

Effects Of Bit Type On Maximum Torque And Axial Force Using Manual Screwdrivers, Mark Hickok

Master's Theses (2009 -)

The screwdriver is a tool that has been among the most widely used hand tools for decades and continues to be used in the workplace to perform a variety of fastening tasks. Advancements in fastener technology have been complemented by the development of new types of screwdriver bits. While designs may vary, so do the force application requirements placed on the tool user. The primary objective of this experiment is to analyze the relationship between user torque and screwdriver bit design. A further objective is to utilize the results to develop an effort metric by which bits of different designs …

An Investigation Of Phase-Change Effects During Rapid Compression Machine Experiments, Colin Banyon

Master's Theses (2009 -)

Rapid compression machines (RCMs) are well characterized laboratory scale devices capable of achieving internal combustion (IC) engine relevant thermodynamic environments. These machines are often used to collect ignition delay times as targets for gas-phase chemical kinetic fuel autoigntion models. Modern RCMs utilize creviced piston(s) to improve charge homogeneity and allow for an adequate validation of detailed chemistry mechanisms against experiments using computationally efficient, homogeneous reactor models (HRMs). Conventionally, experiments are preformed by introducing a premixed gas of fuel + oxidizer + diluent into the machine, which is compressed volumetrically via a piston. Experiments investigating low-vapor pressure fuels (e.g. diesels, biodiesels, …

Micro-Scale Dielectric Spectroscopy Of Biological Cells, Arindam Ghosh

Mechanical & Aerospace Engineering Theses & Dissertations

In recent years microfluidics has become one of the most commonly used tools to investigate cellular biology and to provide a platform for novel biomedical devices. Electrical Impedance Spectroscopy (EIS) was formulated as a non-invasive and label-fi.ee method to investigate the dielectric and the structural properties of materials. Since the early 20th century, EIS and Dielectric Spectroscopy have been applied to measure the dielectric properties of biological cells and tissues. Information about the cell membrane, cytoplasm and the nucleus can be extracted by dielectric spectroscopy. This thesis focuses on the applicability of the analytical models, in particular the Maxwell-Wagner Interfacial …