Energy Systems Commons^™

Solar Chimney Power Plants: A Mini Review, Ahmed Reda, Waseem Salah, Ahmed Suwailem, Shehab Eldin Ahmed, Omar Lasheen, Amira Elkodama, Moustafa R. Shousha, Amr Ismaiel, Anas A. Rahman

Future Engineering Journal

The main investigations of a novel solar thermal application known as SCPP are summarized in this paper. It is a method of producing electricity from solar energy that relies on the fact that air rises when it is heated. An adequate position within a tall chimney can be utilized to position a turbine to turn it, creating an updraft that can be used to generate power. This system's specifications, design, construction, and use are all covered in the paper along with experimental and analytical research related to it. It also emphasizes the development and execution of SCPP programs.

Low-Cost, Low-Weight Test Rig Design For A Laboratory-Scale Twin Rotor Wind Turbine, Ahmed Ayoub, Ahmed Elzeedy, Mahmoud Elkordy, Eslam Ayad, Mohamed Waleed, Amira Elkodama, Amr Ismaiel

Future Engineering Journal

Multi-Rotor Wind Turbine (MRWT) has been proven advantageous over Single-Rotor Wind Turbine (SRWT) in many aspects. In order to study the performance of MRWT over SRWT, this work presents a low-cost and low-weight design for a test rig for laboratory-scale wind turbine configurations. The configurations under study are a single-rotor, and a twin-rotor of the same size with a diameter of 30 cm. Aerodynamic loads have been calculated using the Blade Element Momentum (BEM) method, then the loads were used for stress analysis over the test rig proposed. The test rig is designed on Solidworks and the aerodynamic and inertial …

Changing Climates And Extreme Weather For Minnesota, Patrick A. Tebbe

Mechanical and Civil Engineering Department Publications

Climate change is impacting the design, prediction, and operation of HVAC systems for the built environment, and will continue to do so for the foreseeable future. This presentation reviews climate predictions for the upper Midwest and how they will affect the HVAC industry. Topics such as changing design conditions, extreme weather impact, and increased electrification will be addressed.

Injustice Within Renewable Energy Life Cycles: Can Irena Offer A Solution?, G. Webster Ross

IdeaFest: Interdisciplinary Journal of Creative Works and Research from Cal Poly Humboldt

This paper explores case studies of green colonialism, supply chain injustices, and poor e-waste management within renewable energy life cycles, and investigates how the International Renewable Energy Agency (IRENA) may be the best suited organization to address and mitigate these issues on a global scale. While renewable energy technology is often heralded as the key to a sustainable future, the life cycle of these technologies is riddled with human rights violations and other injustices. To begin with, many of the minerals required for assembling the hardware are mined in unregulated environments, resulting in several injustices such as health and safety …

Removal Of Selenium And Heavy Metals From Coal Combustion Residuals Wastewater Using Surface Modified Iron Based Media, Madan Tandukar, Alex Korff, Andrew Vincent, Chris Hardin

World of Coal Ash Proceedings

No abstract provided.

Machine Learning Approach For Classifying Power Outage In Secondary Electric Distribution Network, Stephan Mgaya, Hellen Maziku

Tanzania Journal of Engineering and Technology (TJET)

Power outage is the problem that hinders social and economic development especially for developing countries like Tanzania. Frequent power outages damage electric equipment, and negatively affect the industrial production process. Power outages cannot be completely eradicated due to uncontrolled cause like natural calamities but technical challenges can be managed and hence reducing power outages. The existing manual methods used to locate power outage like customer calls is inefficient and time consuming. On the other hand, modern method like the Advanced Metering Infrastructure (AMI) still faces a challenge in effectively classifying power line outage due to the nature of imbalanced datasets. …

Carbon Capture, Utilization, And Storage, University Of North Dakota. Energy And Environmental Research Center

EERC Brochures and Fact Sheets

Fact sheet about carbon capture, utilization, and storage (CCUS) and the Energy & Environmental Research Center’s CCUS capabilities. Includes information on the Plains CO₂ Reduction (PCOR) Partnership initiative, Brine Extraction and Storage Test (BEST), Carbon Storage Assurance Facility Enterprise (CarbonSAFE), Red Trail Energy Carbon Capture and Storage, a feed study at Coal Creek Station, Bell Creek and Cedar Creek anticline projects, and Partnership for CO₂ Capture (PCO₂C). [This item is an outdated or superseded version and retained for historical purposes only. It may no longer reflect current information, policies, or practices.]

Renewable Energy Microgrids To Improve Electrification Rate In Democratic Republic Of Congo: Case Of Hydro, Municipal Waste And Solar, Ngondo Otshwe Josue, Aviti Thadei Mushi

Tanzania Journal of Engineering and Technology (TJET)

Worldwide, it is imperative for citizens to have access to electricity. This applies to Congolese--rural and urban dwellers, and if possible, it should be guaranteed by government’s laws and policies. Howev er, the rural and urban areas of Democratic Republic of Congo (DRC) suffer majorly from lack of access to electricity. The major reasons are the high costs associated with connection to the national central grid and production insufficiency. Therefore, one feasible approach to electrify these areas is to use microgrids. This technolo gy is decent and viable option for energy revolution since it incorpo rates energy storage systems, distributed …

Assessment Of Energy Efficiency In Beverage Industry, Mahamudu H. Mtebwa

Tanzania Journal of Engineering and Technology (TJET)

The brewery industry has a significant contribution to the national income. However, it is also associated with energy intensive processes and pollution. In this work, the energy efficiency assessment of the largest brewery in Tanzania i.e., Tanzania Breweries Limited has been conducted. Energy consumption analysis was conducted according to IEEE SA 739 1995. Important parameters used to assess brewery energy efficiency were boiler efficiency and losses, equipment energy productivity as well as load factor. It was found that the main energy consumers are packaging (54.63%), brewing (29.30%) and utilities (15.17%). More importantly, it was found that about 68% of the …

An Experimental Approach Towards Pv-Based Solar System Sizing For An Engineering Laboratory, Muyideen O. Lawal

Tanzania Journal of Engineering and Technology (TJET)

This study aims at providing an experimental sizing procedure for a rooftop PV-based solar power system for an engineering laboratory. This was achieved by monitoring the peak power and energy delivered by an installed 20W solar panel into an 18 Ah battery. Knowledge of the average daily peak power and energy was used to determine the percentage rated capacity available for use and the sun hour. A load consumption comparison was also carried out with and without the connection of a load to inverter. In addition to this, the monitoring of the no-load consumption of the inverter was carried out. …

Viability Analysis Of Ubungo Ii Gas Power Plant Efficiency Improvement Using Co-Generation System, Aviti Thadei Mushi

Tanzania Journal of Engineering and Technology (TJET)

The power utility, Tanzania Electric Supply Company Limited (TANESCO) is faced with challenges of supplying adequate power to the ever-increasing demand. To this end, this paper explores the installed Ubungo Gas Power Plant (UGP II) located in Dar es Salaam to find means of utilizing it in co-generation method. The study embarked on detailed modelling of the system and run simulations which indicated that the co-generation can result to power generation efficiency increase between 10.42 to 50.92%. It is recommended to change the UGP II to exploit this co-generation method. Further, the study could be improved by including more parameters …

Structural Dynamics Of Awt-27 Wind Turbine Blade, Amr Ismaiel

Future Engineering Journal

Wind energy is one of the world’s current leading renewable energy resources. One of the major aspects of studying wind turbines is the structural dynamics for the turbine structure including blades and support structure. In the current work, the blades of the Advanced Wind Turbine (AWT-27) are investigated in a dynamic approach. Different wind fields have been generated for the study to provide different Design Load Conditions (DLCs). Three laminar wind velocities of 5 m/s, 12 m/s, and 17 m/s were simulated. Turbulent wind flow fields have also been generated at the three standard classes A, B and C of …

Solid Thermal Storage As An Energy Storage Device In Insulated Solar Electric Cookers: Thermal Modeling And Experiment, Michael Antonio Fernandez

Physics

The use of solid thermal storage (STS) as an energy storage device in insulated solar electric cookers (ISEC) was explored using a thermal simulation before retrofitting an existing cooker without energy storage and testing it under several conditions. STS sizing, material selection, and geometry were examined from both theoretical and practical perspectives and re-examined following experimental results. Characterization of the system’s thermal interfaces and methods to improve their thermal conductivities were investigated resulting in several performance enhancements to the system.

Sunsation’S Solar Powered Picnic Table, Michelle M. Barnett, Christopher Barber, Casey Durham, David Mason

Mechanical Engineering

Team SunSation is an interdisciplinary senior design project group that was tasked with developing a semi-permanent seating area for Cal Poly's electrical engineering courtyard. The EE courtyard is populated with plastic folding tables and chairs that are slowly falling apart. Dale Dolan, the head of the EE department, requested that a table design be developed that incorporates the use of solar panels. The addition of the solar panels to the table would help promote clean renewable energy as well as provide shade to those sitting in the courtyard.

The solution that SunSation arrived at is broken up into mechanical/structural, electrical, …

Mmteg Heatsink Design, Peyton Nienaber, Kadin Feldis, Alec Savoye, Jack Waeschle

Mechanical Engineering

In this document, Cal Poly Senior Design Team F16 presents a summary of its work developing a suitable heatsink for Gas Technology Institute’s Methane Mitigation Thermoelectric Generator. After several months of iterating between experimental testing and simulated heat transfer, a suitable prototype was selected for use in further refining simulation parameters. This was called the structural prototype and it allowed Team F16 to confirm several remaining unknowns relating to component thermal conductivity. All documentation of this process can be found in Preliminary, Critical, and Interim Design Review documents (PDR, CDR, IDR), included in this report. Having a realistic model …

Baker/Koob Final Report: Solar Solution For Mini Mars Rover, Jonathan Cederquist, Cole Korchek, Derick Louie, Michaella Ochotorena, Collin Petersen

Mechanical Engineering

This project focused on designing, building, and testing a functional prototype of a collapsible solar array on the mini Mars rover being developed by client and sponsor, Mr. Rich Murray. Although many previous collapsible solar arrays have been deployed for space missions, the previous solar-powered Mars rovers only deployed their arrays once upon landing. This solar array will be able to collapse and deploy multiple times to allow for greater rover mobility and stability when the rover is not charging. This system is critical to the success of the rover project because it provides power without which the rover cannot …

Ecological Risk Assessment For Coal Combustion Residuals And Herrington Lake Adjacent To The Kentucky Utilities E.W. Brown Generating Station, Mary Sorensen, Alex Smith, Mark Nielsen

World of Coal Ash Proceedings

No abstract provided.

Epri Research On Groundwater-Surface Water Interactions Near Coal Combustion Product Sites, Bruce Hensel, Jeff Thomas, Tim Towey, Anthony Aufdenkampe

World of Coal Ash Proceedings

No abstract provided.

Cqa - A Common Sense Approach At Becoming The Mvp On Your Next Project, James Price, Michael Fisher, John Metcalf

World of Coal Ash Proceedings

No abstract provided.

Challenges & Pragmatic Solutions For The Design And Construction Of A 300-Acre Ccr Landfill Located In The Southwestern Us - A Case Study, Andy Lucas, Jason Pokorny

World of Coal Ash Proceedings

No abstract provided.