Energy Systems Commons^™

Design And Implementation Of An Optimization Platform For Common Fixed Photovoltaic Systems, Amro Ahmad Zahrawi

Mechanical Engineering Theses

Most household photovoltaic (PV) panels are installed in a fixed arrangement (fixed-type) based on a rule of thumb that comes from experience. The azimuth angle is usually set facing south with a tilt angle equivalent to the location's latitude. However, research shows that this is not the best for all geographical locations and during all hours of the day. Consequently, this brings up the hypothesis that optimizing the PV system's azimuth and tilt angles would ensure that the PV panel produces the most possible output as it is adjusted to face the sun most effectively during peak sunlight hours. This …

Designing A Model Of Solar Photovoltaic Water Pumping System For Off-Grid Localities In Tanzania, Imani Mruma

Tanzania Journal of Engineering and Technology (TJET)

Modeling of photovoltaic (PV) water pumping system for rural water localities is vital especially in these modern days, in Tanzania. This is due to the rise of high number of solar-powered rural water projects constructed lacking appropriate design. The fate result into poor and substandard projects delivering below expectations. Kikombo Solar Water Project situated in Dodoma; Tanzania is one among poorly designed solar project chosen as a case study to validate proposed model. The main problem of Kikombo project is unsatisfactory amount of water from domestic points to satisfy population demand. This matter has been raised by pumping-station attendants and …

Renewable Energy Potential Assessment For Improving Electric Power Availability In Urban Area: A Case Of Msigani Ward In Ubungo Municipal, Tanzania, Respicius Kiiza

Tanzania Journal of Engineering and Technology (TJET)

The demand for electricity in urban areas of the developing countries like Tanzania is increasing rapidly due to factors such as increasing population, expansion of economic activities and industrialization. Msigani ward is one of the fourteen (14) administrative urban wards in Ubungo Municipal, Dar es Salaam, located at latitude 6.8031 oS and longitude 39.1188 oE. Recently, there has been observed increase in power demand in this ward. This in turn has caused a supply deficit that sometimes led to large number of interruptions caused by frequent power outage and load shedding. The total capacity of the national grid is limited …

Mppt Dc-Dc Buck-Boost Converter For Off Grid Hybrid Solar-Wind Battery System In Ikuza Island, Tanzania, Aviti Thadei Mushi

Tanzania Journal of Engineering and Technology (TJET)

Ikuza Island in Kagera-Tanzania faces lack of electricity due to cost challenges of extending the grid by marine cables and other transmission facilities. These makes such endeavour not appealing to the supply authority due to those higher charges. Therefore, this paper undertakes to design hybrid renewable energy sources for the island by specifically focusing on the buck-boost converter for the energy conversion from these renewable resources. The design of the bidirectional buck-boost converter for maximum power point tracking in off-grid hybrid renewable energy systems is multifaceted due to the inhomogeneity nature of the renewable energy sources. The bidirectional buck-boost converter, …

Aquaculture In Hydropower Reservoirs, Racheal Macharia

Tanzania Journal of Engineering and Technology (TJET)

There is an undoubtedly existing relationship between water, energy, and food and their interaction with the natural environment and mankind. Climate change is the talk of the day in global development discussions as it intensifies water shortages, energy, poverty, food shortages, and environmental degradation. Currently, most of the hydropower dams constructed in Africa are majorly built to store water for agricultural purposes, control flooding, and generate electricity. Notable projects include the seven forks hydropower stations located on the Tana River in Kenya; Aswan high dam in Egypt; Grand Renaissance dam in Ethiopia; Kariba dam in Zimbabwe and Akosombo in Ghana. …

Sustainability Matchmaking: Exploration Into Using Excess Renewable Energy To Deliver ‘Free’ Energy To Fuel Poor Homes – A Preliminary Case Study In Ireland, Ciara Ahern, Ronan Oliver

Articles

The aggregated fuel cost of domestic hot water (DHW) generation in Ireland, in 2022, was €529M with associated emissions/load of 1.3MtCO₂/289GWh. The shadow price of carbon monetises the negative impact of emissions, rising with time; DHW generation has an associated shadow carbon cost of €13M in 2022, rising to €42M in 2030 and €335M in 2050.

In 2020, c12%/€441M of wind was curtailed or wasted as inter alia, there was no demand at times of high wind. Meanwhile, a ‘silent crisis’ is occurring in Ireland wherein one-in-two dwellings were considered in fuel poverty in 2022. Households in …

Modeling Of Heat And Mass Transfer In Flat Heat Pipes, Salar Saadatian

LSU Doctoral Dissertations

Phase-change phenomenon is ubiquitous in nature and widely utilized in thermal management of computer chips. Flat heat pipes have been extensively used in thermal management of microelectronic devices. However, existing research mainly concentrates on developing numerical models and lacks a systematic analytical approach to elucidate the working mechanism of flat heat pipes. We consider a horizontal flat heat pipe with an idealized porous wick. The pores in the wick are straight circular capillaries running along and across the wick and are filled with a liquid. The rest of the pipe is filled with its vapor. The mass evaporative rate at …

Heat And Mass Transfer Modeling Of High-Temperature Moving-Bed Thermochemical Reactors, David Korba

Theses and Dissertations

With the global deployment of renewable energy generation at record rates, clean energy is steadily becoming competitive with its fossil-fuel counterparts. However, further expansion is limited by the inherent intermittency of renewable energy sources (solar, wind, wave, etc.), which typically do not match with daily and seasonal variations of global (and local) energy demand. Thermochemical energy storage (TCES) has demonstrated strong potential in being a technological pathway to provide on-demand process heat and handle the intrinsic variations in renewable energy generation and energy demand. TCES works on the premise of excess renewable heat driving an endothermic reduction reaction, in which …

Experimental And Numerical Investigation Of Fluid Flow Behavior Through Fractured Wellbore Cement, Mahya Hatambeigi

Civil Engineering ETDs

Leakage from wellbores has been a major challenge in the energy industry, leading to groundwater contamination, reduced productivity, safety hazards, and increased operating costs. Cemented annulus fractures are a common type of leakage pathway in wellbores that can form due to various physical and chemical conditions. The number of wellbore leaks continues to increase globally, making it imperative to develop a better understanding of the complex mechanisms governing fluid flow through fractured wellbore cement. Understanding the behavior of fluid flow through a leaky cemented annulus is crucial for evaluating the leakage potential and risk assessments in wellbore systems, as well …

Aeroponic System Optimization For Butterhead Lettuce Growth And Future Sustainability Using Flow Blurring Atomization, Taylor J. Johnson

Doctoral Dissertations and Master's Theses

The global population has grown by 6 billion people over the last century and is trending toward 9.7 billion people by the year 2050. Agriculture accounts for 70% of global fresh water usage. Technology must be developed to accommodate the increase of food production demanded by the growing global population and the subsequent increase in water usage. Aeroponic technology is a water-efficient vertical farming technology that can reduce water usage by 90% by suspending plant roots in air within a controlled chamber and supplying atomized droplets of a water-nutrient solution directly to the roots.

This study simultaneously tests six droplet …

Smart Grid In Tanzania: Research Opportunities, Aviti Thadei Mushi

Tanzania Journal of Engineering and Technology (TJET)

reinvigorated its power generation capacity significantly to ensure smooth execution of its industrialization agenda and cope with the fourth industrial revolution. To ensure reliable availability of power to sustain its growing economy, Tanzania embarked on a deliberated measure to forge an energy mix. This deliberate measure encompasses the use of renewable energy technologies such as wind, solar, biomass, wastes, and micro hydro; natural gas; and other energy sources which are locally available including coal and geothermal. To effectively and efficiently manage such a growing power system and make electricity accessible to all for higher levels of industrial investment and services, …

Isolation And Performance Test Of Green Low Dosage Hydrate Inhibitors From Local Materials For Improving Flow Assurance In Oil And Gas Industry, Makungu Madirisha

Tanzania Journal of Engineering and Technology (TJET)

The formation of gas hydrates in oil and gas industry can be minimized or prevented by the use of inhibitors. This paper reports on hemicellulose and modified lignin as low dosage gas hydrate inhibitors (LDGHIs). LDGHIs were isolated from sugarcane bagasse (SCB), plant gum exudates (PGE) of Acacia trees, and coconut coir, and further characterized by Attenuated Total Reflectance - Fourier Transform Infrared (ATR-FTIR) spectrometer, porosimeter and thermogravimetric analyzer (TGA). The PGE and SCB yielded 77.75% and 12.38% of hemicellulose, respectively, while coconut coir yielded 35.59% of lignin which was modified to sodium lignosulfonate (SLS) to improve its solubility in …

Experimental Investigation On Recovery Of Micro Hydropower Dump Load Through Oil Heating System, Joseph H. Kihedu Dr.

Tanzania Journal of Engineering and Technology (TJET)

Micro hydropower power generates electrical energy to meet connected electrical demand, that normally fluctuates causing imbalances. Electronic load controller is then used to balance power system by diverting surplus generated power to the dump load commonly resistive load such as bulk water heater. This study investigated use of oil heating system as a replacement for conventional resistive dump load. In comparison to water, oil has high thermal retention therefore can serve as good thermal media. Dump load range ranged between 17 kW to 78 kW. A 6-kW electrical heater was used for laboratory oil heating system from which heated oil …

Addressing Low Heat Pump Heating System Sales In The Uk, Ben Costelloe

Articles

The replacement of existing fossil fuel boilers with heat pumps is seen as a key measure in the decarbonisation of heating systems and addressing climate change. This policy however, is currently failing in many Western European states, particularly in the UK. The many reasons for this situation are examined. However, the age of UK housing stock and particularly the high number of dwellings built prior to the introduction of building insulation regulations in 1980, are key. To maintain the running cost of air source heat pumps competitive with those of the gas boilers they generally replace the heat pump lift …

A High-Speed Portable Ground Heat Exchanger Model For Use In Various Energy Simulation Software, Ryan Davies, Matt Mitchell, Edwin Lee

Macalester Journal of Physics and Astronomy

A portable component model (PCM) of a ground source heat pump system was developed and used as a test case in the creating of a PCM development framework. By developing this framework, new building energy simulation models will be able to be easily integrated into existing simulation software such as EnergyPlus and the Modelica Buildings Library. Our model uses a time responsive g-function and numerical methods to simulate ground source heat pumps for single time steps as well as long time scales. We validated our model against GHESim and GLHEPro and found that our model agrees with these two standards …

The Modernization Of Large Power Transformer Tanks, Babajide O. Williams

Electronic Theses and Dissertations

Due to the current demands placed on the power grid in terms of climate change, increasing urbanization, and terrorist attacks, the U.S. government in response to these demands, mandated that all the grid components be modernized in order to increase their reliability. As a critical component of the grid, Large Power Transformers (LPTs) play a key role in ensuring sustainable power generation and distribution. A literature search performed in this work and the analysis of data retrieved from the search showed that the tanks of these LPTs are critical to their durability, longevity, and reliability. Therefore, the reliability of LPTs …

Power Thyristor Controller For Speed Control Of Dc Motor, Alejandra Zapata, Morgan Erich Boehme, Abdullah Mohammed Awidah, Payton Robert Chalstrom

Electrical Engineering

In this work, a Power Thyristor Controller for Speed Control of DC Motor has been developed with the purpose of replacing an existing simulation experiment, aiming to effectively implement the principle of learning by doing. The primary objective of the experiment setup is to illustrate the fundamental principles and operational mechanisms underlying the firing angle and controlled bridge rectifier. The new experiment is taking advantage of the existing FCRO4100 Single Phase Firing Board that was donated to the University by ENERPRO. The pre-programmed microcontroller is connected to the thyristor bridge rectifier that’s powered by 24VAC. Additionally, a DC motor will …

Rapid Composter, Shannon Shinozaki, Avin Atencio, Jonathan Fraser, Lukas Kolbl, Russell Occhipinti

Mechanical Engineering

This project was created with the intent of automatically composting equine bio waste to be reused as plant fertilizer. The system consists of four subsystems: power generation and storage, automatic controls, aeration, and structure. Each subsystem may be manufactured independently, then put together. This system will not have access to power outlets, so it was designed to be solar-powered.

A Screening Tool For The Implementation Of Electric And Thermal Energy Storage Systems At Commercial And Industrial Facilities, Mckenna P. Amerson

Theses and Dissertations

The integration of on-site renewable systems with energy storage devices is an important topic in improving energy management for commercial buildings and industrial facilities. Energy storage technologies have the ability to impact the end user’s power reliability while creating measurable energy and cost savings. However, the potential yet remains to increase the application of these systems. To determine the feasibility of renewables and energy storage in commercial and industrial applications, a pre-screening software tool is developed using data-driven algorithms to complete an energy, cost, and carbon savings analysis of storage implementation. A case study of a standalone retail building is …

Atmospheric Carbon Capture: A Review On Current Technologies And Analysis Of Energy Consumption For Various Direct Air Capture (Dac) Systems, Jennifer Perskin

Doctoral Dissertations and Master's Theses

Carbon dioxide (CO₂) capture is a crucial approach to reducing greenhouse gases in the atmosphere to directly combat climate change. Major components of the technology to desublimate CO₂ at cryogenic temperatures are mature and have the potential to be applied to build large Arctic/Antarctic direct-air CO₂ capture plants. Pressure swing adsorption another gas separation technique used in industry today that can be modified for atmospheric carbon capture. The discussion of energy consumption for cryogenic and combined direct air capture systems is explored in this study. The investigation of precompression of atmospheric air for a direct-air capture …