Energy Systems Commons^™

Test 2012: Case Ih Farmall 55a, Nebraska Tractor Test Lab

Nebraska Tractor Tests

ABOUT THE TEST REPORT AND USE OF THE DATA The test data contained in this report are a tabulation of the results of a series of tests. Due to the restricted format of these pages, only a limited amount of data and not all of the tractor specifications are included. The full OECD report contains usually about 30 pages of data and specifications. The test data were obtained for each tractor under similar conditions and therefore, provide a means of comparison of performance based on a limited set of reported data. EXPLANATION OF THE TEST PROCEDURES Purpose The purpose of …

Toward A Zero Energy Home: Applying Swiss Building Practices/Attitudes To U.S. Residential Construction, Daphene C. Koch, William Hutzel, Jason M. Kutch, Eric A. Holt

School of Engineering Technology Faculty Publications

This project evaluated typical U.S. and Swiss homes to identify construction practices that are most energy efficient and have economic payback. A net zero energy home (ZEH) produces as much energy as is consumed in it over time. Students in a College o f Technology in a Midwest Indiana State University and a technical University in Switzerland resulted in developing models of homes that combined U.S. and Swiss standards. The project was completed in two phases: during the first phase o f this project, construction costs, energy use, and economic payback was calculated for six homes that were designed using …

Optical Cell For Combinatorial In Situ Raman Spectroscopic Measurements Of Hydrogen Storage Materials At High Pressures And Temperatures, Jason R. Hattrick-Simpers, Wilbur S. Hurst, Sesha S. Srinivasan, James E. Maslar

Faculty Publications

An optical cell is described for high-throughput backscattering Raman spectroscopic measurements of hydrogen storagematerials at pressures up to 10 MPa and temperatures up to 823 K. High throughput is obtained by employing a 60 mm diameter × 9 mm thick sapphire window, with a corresponding 50 mm diameter unobstructed optical aperture. To reproducibly seal this relatively large window to the cell body at elevated temperatures and pressures, a gold o-ring is employed. The sample holder-to-window distance is adjustable, making this cell design compatible with optical measurement systems incorporating lenses of significantly different focal lengths, e.g., microscope objectives and single element …

Mechanical Characterization Of Polymer Electrolyte Membrane With Optical Methods, Xinyu Huang, Luis Alva, Jay Neutzler

Faculty Publications

Mechanical properties of polymer electrolyte membrane have important implications in the endurance of many electrochemical energy conversion devices [1]. Mechanical experiments are effective method to reveal discrete damage developed in the membrane by quantifying the change of mechanical strength and toughness. Regular strain measurement methods are overly intrusive to the thin and relatively fragile polymer electrolyte membrane; hence optical-based minimal invasive stress/strain measurement methods are studied.

Phase Change Materials As A Thermal Storage Device For Passive Houses, Kevin Ryan Campbell

Dissertations and Theses

This study describes a simulation-based approach for informing the incorporation of Phase Change Materials (PCMs) in buildings designed to the "Passive House" standard. PCMs provide a minimally invasive method of adding thermal mass to a building, thus mitigating overheating events. Phase change transition temperature, quantity, and location of PCM were all considered while incrementally adding PCM to Passive House simulation models in multiple climate zones across the United States. Whole building energy simulations were performed using EnergyPlus from the US Department of Energy. A prototypical Passive House with a 1500 Watt electric heater and no mechanical cooling was modeled. The …

A Feasibility Study Of Model-Based Natural Ventilation Control In A Midrise Student Dormitory Building, Steven James Gross

Dissertations and Theses

Past research has shown that natural ventilation can be used to satisfy upwards of 98% of the yearly cooling demand when utilized in the appropriate climate zone. Yet widespread implementation of natural ventilation has been limited in practice. This delay in market adoption is mainly due to lack of effective and reliable control. Historically, control of natural ventilation was left to the occupant (i.e. they are responsible for opening and closing their windows) because occupants are more readily satisfied when given control of the indoor environment. This strategy has been shown to be effective during summer months, but can lead …

Performance Of Four Near Zero Energy Homes: Lessons Learned, Florida Solar Energy Center, Carlos Colon

FSEC Energy Research Center®

While the idea of a zero or near zero energy home is well understood, the actual performance of the structure can be different than expected. High performance homes necessitate increasingly complex envelope, HVAC, water heating, and appliance systems, and successful designs rely on proper function and feedback from those systems to achieve low-energy goals. This paper presents measured data on four near zero energy homes located in Florida that are a part of the U.S. DOE Building America program. The monitored data are compared to both a benchmark model and the prototype computer simulations. By examining the submetered energy data, …

Florida Weatherization Training - Quarterly Report (October 2010-December 2010), Florida Solar Energy Center, Neil Moyer

FSEC Energy Research Center®

The weatherization training for the State of Florida Dept of Community Affairs continues at the Florida Solar Energy Center's Training Facility. Progress for the sixth three months of the contract included a five day classroom training on October 18-22 (17 students) and in-field evaluations (16 students).

2010 Fall Engr333 Project Final Report, 2010 Fall Engr333

ENGR 333

Calvin College dorms have a chronic issue with wasting energy. The dorms have little insulation, high infiltration rates, and are heated by low efficiency boilers. These existing characteristics combine for a larger required heating load and increased energy usage. The excess heat, due to poor temperature control, is often vented out through the windows whenever students deem necessary. This project will attempt to reduce wasted energy and efficiently distribute heat as needed.

The Thermal Systems Design class of 2010 was challenged with retrofitting the Bolt-Heyns-Timmer (BHT) dorm to decrease energy consumption and improve efficiency. The class was presented with the …

Optimization Design Of Electrodes For Anode-Supported Solid Oxide Fuel Cells Via Genetic Algorithm, Junxiang Shi, Xingjian Xue

Faculty Publications

Porous electrode is the critical component of solid-oxide fuel cells (SOFCs) and provides a functional material backbone for multi-physicochemical processes. Model based electrode designs could significantly improve SOFC performance. This task is usually performed via parameter studies for simple case and assumed property distributions for graded electrodes. When nonlinearly coupled multiparameters of electrodes are considered, it could be very difficult for the model based parameter study method to effectively and systematically search the design space. In this research, the optimization approach with a genetic algorithm is demonstrated for this purpose. An anode-supported proton conducting SOFC integrated with a fuel supply …

The Effects Of Roof Solar Absorptance On Building Energy Performance In A Variety Of U.S. Climate Zones, Zachary Eubanks

Mechanical Engineering Undergraduate Honors Theses

The solar absorptance of a roof surface directly affects the solar heat gain through the roof. It has been shown that buildings in hot climates benefit from roofs with low absorptance. Cold and moderate climates have received less attention in previous studies. This paper simulates the effects on annual energy use, carbon dioxide emission, and utility cost of varying the solar absorptance of warehouse and small office building roofs in a wide variety of U.S. climate zones using EnergyPlus software and the DOE Commercial Building Benchmark Models. Results show that the optimum absorptance not only depends on the climate zone, …

Agenda: 2010 World Energy Justice Conference: Emerging Solutions For The Energy Poor: Technological, Entrepreneurial And Institutional Challenges, University Of Colorado Boulder. Center For Energy & Environmental Security, Colorado Journal Of International Environmental Law And Policy

2010 World Energy Justice Conference (November 5)

This conference is a sequel to the 2009 World Energy Justice Conference (WEJC 2009) which began examining ways of mainstreaming safe, clean, and efficient energy for the world's Energy Poor (EP). The EP number two and a half billion people living on less than $1-2 a day who have no access to modern energy services. WEJC 2010 more fully develops these themes. WEJC 2010 will explore how the next round of global warming meetings in Cancun could design new flexibility mechanisms that give credits, for example, for the reduction of black carbon by the adoption of cookstoves, and embrace small …

Modeling And Numerical Investigation Of Hot Gas Defrost On A Finned Tube Evaporator Using Computational Fluid Dynamics, Oai The Ha

Master's Theses

Defrosting in the refrigeration industry is used to remove the frost layer accumulated on the evaporators after a period of running time. It is one way to improve the energy efficiency of refrigeration systems. There are many studies about the defrosting process but none of them use computational fluid dynamics (CFD) simulation. The purpose of this thesis is (1) to develop a defrost model using the commercial CFD solver FLUENT to simulate numerically the melting of frost coupled with the heat and mass transfer taking place during defrosting, and (2) to investigate the thermal response of the evaporator and the …

Building America Industrialized Housing Partnership Case Studies - 2010, Florida Solar Energy Center, Janet Mcilvaine

FSEC Energy Research Center®

This document is a compilation of 14 separate case studies of home builders who have adopted Building America principles of high performance as standard construction. This work was compiled by the Building America Industrialized Housing Partnership (www.baihp.org ) for the U.S. Department of Energy to serve as a model for other housing providers. BAIHP is led by the Florida Solar Energy Center of the University of Central Florida.

Florida Weatherization Training - Quarterly Report (July 2010 - September 2010), Florida Solar Energy Center, Neil Moyer

FSEC Energy Research Center®

The weatherization training for the State of Florida Dept of Community Affairs continues at the Florida Solar Energy Center's Training Facility. Progress for the fifth three months of the contract included minor course refinement of presentation materials and handouts as the result of the June 2010 updates to the P & G . Four 1-day IR classes were completed (45 students).

Opportunities For Energy Conservation And Improved Comfort From Wind Washing Retrofits In Two-Story Homes - Part Ii, Florida Solar Energy Center, Charles Withers, Jr.

FSEC Energy Research Center®

Wind washing is a general term referring to diminished thermal control caused by air movement partially or completely bypassing the thermal barrier. The primary focus of this paper relates to a specific type of wind washing where wind can push attic air into the floor cavity between first and second stories of the home through ineffective (or missing) air barriers separating attic space from the floor cavity. A second type of wind washing studied in this project involves insulation batts on knee walls where space between the batts and the wall board allow air movement against the gypsum wall board. …

Opportunities For Energy Conservation And Improved Comfort From Wind Washing Retrofits In Two-Story Homes - Part I, Florida Solar Energy Center, Charles Withers, Jr.

FSEC Energy Research Center®

Wind washing is a general term referring to diminished thermal control caused by air movement over or through a thermal barrier. The primary focus of this paper is towards a specific type of wind washing where wind can push attic air into the floor cavity between first and second stories of the home through ineffective (or missing) air barriers separating attic space from the floor cavity. A second type of wind washing studied in this project involved insulation batts on knee walls where space between the batts and the wall board allowed air movement against the gypsum wall board. During …

Affiliate Steps Toward Building Energy Star Homes, Florida Solar Energy Center, Janet Mcilvaine

FSEC Energy Research Center®

To certify a home as an Energy Star, a builder works with a RESNET certified home energy rater to evaluate the home with respect to criteria required by the Energy Star program. The following steps will help Habitat affiliates navigate the path toward building Energy Star homes.

Pilot Evaluation Of Energy Savings And Persistence From Residential Energy Demand Feedback Devices In A Hot Climate, Florida Solar Energy Center, Danny Parker

FSEC Energy Research Center®

According to past studies, providing instantaneous feedback on household electrical demand has shown the promise to typically reduce energy consumption by 5-10%. This paper briefly reviews past research and describes a two year pilot evaluation of a low cost residential energy feedback system installed in twenty case study homes in Florida. Although not a statistical sample (the participants were self-selected and interested in reducing energy use), the study showed an average 7% reduction in energy use from feedback homes in the second year of monitoring after controlling for weather-related influences. However, a follow-up evaluation done three years later found little …

2010 Fall Engr333 Project Assignment, Matthew K. Heun

ENGR 333

The Fall 2010 ENGR333 project focused on heating and air-conditioning in campus dormitories, which are notoriously leaky and inefficient.

I asked the students “What would it take to retrofit the Bolt-Heyns-Timmer (BHT) dormitory heating and air-conditioning systems in a manner that achieves LEED certification?”

Customer

The customer for this project was Calvin’s VP for finance Henry DeVries.