Energy Systems Commons^™

2010 Fall Engr333 Project Final Report, 2010 Fall Engr333

ENGR 333

Calvin College dorms have a chronic issue with wasting energy. The dorms have little insulation, high infiltration rates, and are heated by low efficiency boilers. These existing characteristics combine for a larger required heating load and increased energy usage. The excess heat, due to poor temperature control, is often vented out through the windows whenever students deem necessary. This project will attempt to reduce wasted energy and efficiently distribute heat as needed.

The Thermal Systems Design class of 2010 was challenged with retrofitting the Bolt-Heyns-Timmer (BHT) dorm to decrease energy consumption and improve efficiency. The class was presented with the …

Optimization Design Of Electrodes For Anode-Supported Solid Oxide Fuel Cells Via Genetic Algorithm, Junxiang Shi, Xingjian Xue

Faculty Publications

Porous electrode is the critical component of solid-oxide fuel cells (SOFCs) and provides a functional material backbone for multi-physicochemical processes. Model based electrode designs could significantly improve SOFC performance. This task is usually performed via parameter studies for simple case and assumed property distributions for graded electrodes. When nonlinearly coupled multiparameters of electrodes are considered, it could be very difficult for the model based parameter study method to effectively and systematically search the design space. In this research, the optimization approach with a genetic algorithm is demonstrated for this purpose. An anode-supported proton conducting SOFC integrated with a fuel supply …

The Effects Of Roof Solar Absorptance On Building Energy Performance In A Variety Of U.S. Climate Zones, Zachary Eubanks

Mechanical Engineering Undergraduate Honors Theses

The solar absorptance of a roof surface directly affects the solar heat gain through the roof. It has been shown that buildings in hot climates benefit from roofs with low absorptance. Cold and moderate climates have received less attention in previous studies. This paper simulates the effects on annual energy use, carbon dioxide emission, and utility cost of varying the solar absorptance of warehouse and small office building roofs in a wide variety of U.S. climate zones using EnergyPlus software and the DOE Commercial Building Benchmark Models. Results show that the optimum absorptance not only depends on the climate zone, …

Agenda: 2010 World Energy Justice Conference: Emerging Solutions For The Energy Poor: Technological, Entrepreneurial And Institutional Challenges, University Of Colorado Boulder. Center For Energy & Environmental Security, Colorado Journal Of International Environmental Law And Policy

2010 World Energy Justice Conference (November 5)

This conference is a sequel to the 2009 World Energy Justice Conference (WEJC 2009) which began examining ways of mainstreaming safe, clean, and efficient energy for the world's Energy Poor (EP). The EP number two and a half billion people living on less than $1-2 a day who have no access to modern energy services. WEJC 2010 more fully develops these themes. WEJC 2010 will explore how the next round of global warming meetings in Cancun could design new flexibility mechanisms that give credits, for example, for the reduction of black carbon by the adoption of cookstoves, and embrace small …

Modeling And Numerical Investigation Of Hot Gas Defrost On A Finned Tube Evaporator Using Computational Fluid Dynamics, Oai The Ha

Master's Theses

Defrosting in the refrigeration industry is used to remove the frost layer accumulated on the evaporators after a period of running time. It is one way to improve the energy efficiency of refrigeration systems. There are many studies about the defrosting process but none of them use computational fluid dynamics (CFD) simulation. The purpose of this thesis is (1) to develop a defrost model using the commercial CFD solver FLUENT to simulate numerically the melting of frost coupled with the heat and mass transfer taking place during defrosting, and (2) to investigate the thermal response of the evaporator and the …

Building America Industrialized Housing Partnership Case Studies - 2010, Florida Solar Energy Center, Janet Mcilvaine

FSEC Energy Research Center®

This document is a compilation of 14 separate case studies of home builders who have adopted Building America principles of high performance as standard construction. This work was compiled by the Building America Industrialized Housing Partnership (www.baihp.org ) for the U.S. Department of Energy to serve as a model for other housing providers. BAIHP is led by the Florida Solar Energy Center of the University of Central Florida.

Florida Weatherization Training - Quarterly Report (July 2010 - September 2010), Florida Solar Energy Center, Neil Moyer

FSEC Energy Research Center®

The weatherization training for the State of Florida Dept of Community Affairs continues at the Florida Solar Energy Center's Training Facility. Progress for the fifth three months of the contract included minor course refinement of presentation materials and handouts as the result of the June 2010 updates to the P & G . Four 1-day IR classes were completed (45 students).

Opportunities For Energy Conservation And Improved Comfort From Wind Washing Retrofits In Two-Story Homes - Part I, Florida Solar Energy Center, Charles Withers, Jr.

FSEC Energy Research Center®

Wind washing is a general term referring to diminished thermal control caused by air movement over or through a thermal barrier. The primary focus of this paper is towards a specific type of wind washing where wind can push attic air into the floor cavity between first and second stories of the home through ineffective (or missing) air barriers separating attic space from the floor cavity. A second type of wind washing studied in this project involved insulation batts on knee walls where space between the batts and the wall board allowed air movement against the gypsum wall board. During …

Opportunities For Energy Conservation And Improved Comfort From Wind Washing Retrofits In Two-Story Homes - Part Ii, Florida Solar Energy Center, Charles Withers, Jr.

FSEC Energy Research Center®

Wind washing is a general term referring to diminished thermal control caused by air movement partially or completely bypassing the thermal barrier. The primary focus of this paper relates to a specific type of wind washing where wind can push attic air into the floor cavity between first and second stories of the home through ineffective (or missing) air barriers separating attic space from the floor cavity. A second type of wind washing studied in this project involves insulation batts on knee walls where space between the batts and the wall board allow air movement against the gypsum wall board. …

Affiliate Steps Toward Building Energy Star Homes, Florida Solar Energy Center, Janet Mcilvaine

FSEC Energy Research Center®

To certify a home as an Energy Star, a builder works with a RESNET certified home energy rater to evaluate the home with respect to criteria required by the Energy Star program. The following steps will help Habitat affiliates navigate the path toward building Energy Star homes.

Pilot Evaluation Of Energy Savings And Persistence From Residential Energy Demand Feedback Devices In A Hot Climate, Florida Solar Energy Center, Danny Parker

FSEC Energy Research Center®

According to past studies, providing instantaneous feedback on household electrical demand has shown the promise to typically reduce energy consumption by 5-10%. This paper briefly reviews past research and describes a two year pilot evaluation of a low cost residential energy feedback system installed in twenty case study homes in Florida. Although not a statistical sample (the participants were self-selected and interested in reducing energy use), the study showed an average 7% reduction in energy use from feedback homes in the second year of monitoring after controlling for weather-related influences. However, a follow-up evaluation done three years later found little …

2010 Fall Engr333 Project Assignment, Matthew K. Heun

ENGR 333

The Fall 2010 ENGR333 project focused on heating and air-conditioning in campus dormitories, which are notoriously leaky and inefficient.

I asked the students “What would it take to retrofit the Bolt-Heyns-Timmer (BHT) dormitory heating and air-conditioning systems in a manner that achieves LEED certification?”

Customer

The customer for this project was Calvin’s VP for finance Henry DeVries.

Exploring Cost-Effective, High Performance Residential Retrofits For Affordable Housing In The Hot Humid Climate, Florida Solar Energy Center, Janet Mcilvaine

FSEC Energy Research Center®

In 2009, a Department of Energy Building America team led by the Florida Solar Energy Center began working with partners to find cost-effective paths for improving the energy performance of existing homes in the hot humid climate. A test-in energy audit and energy use modeling of the partner's proposed renovation package was performed for 41 affordable and middle income foreclosed homes in Florida and Alabama. HERS1 Indices ranged from 92 to 184 with modeled energy savings ranging from 3% to 50% (average of 26%). Analyses and recommendations were discussed with partners to encourage more efficient retrofits, highlight health and safety …

Evaluation Of Bias Issues Within Regression-Based Inverse Modeling Methods Against Climate And Building Characteristics Using Synthetic Data, Florida Solar Energy Center, Jamie Cummings

FSEC Energy Research Center®

Typically, a model of the energy use of a building is created using the building's characteristics and climate information for its location. However, models of existing homes can be created using monitored energy and climactic data in a process called inverse modeling. Such a technique has potential for those seeking to evaluate the savings a home before and after a retrofit (Meier, Busch, & Conner, 1988).Several programs use an inverse modeling technique to model a home's energy use based on total home energy use, heating and cooling energy use, and indoor/outdoor temperature data from a home (Kissock, Haberl, & Claridge, …

Development Of Pilot Plant For Bio-Ethanol Processing, Emrod Elisante

Tanzania Journal of Engineering and Technology (TJET)

The paper outlines achievements obtained in developing a pilot bio-ethanol plant at the Department of Chemical and Mining Engineering (CME), University of Dar es Salaam. The pilot plant consists of: 30 L inoculums tank; 1,700 L fermenter; 1,500 L/day distillation column; and ancillary equipment. The prototype is a platform intended to be used for technology demonstration and research by graduate and undergraduate students studying the production of bio-ethanol using traditional and non-traditional raw materials like coffee mash, cashew fruit, and sisal inulin. The equipment has been developed using locally available engineering resources and the distillation column with 18 sieve tray …

Computer Simulation Of A Biomass Gasification-Solid Oxide Fuel Cell Power System Using Aspen Plus, Wayne Doherty, Anthony Reynolds, David Kennedy

Articles

The operation and performance of a solid oxide fuel cell (SOFC) stack on biomass syn-gas from a biomass gasification combined heat and power (CHP) plant is investigated. The objective of this work is to develop a model of a biomass-SOFC system capable of predicting performance under diverse operating conditions. The tubular SOFC technology is selected. The SOFC stack model, equilibrium type based on Gibbs free energy minimisation, is developed using Aspen Plus. The model performs heat and mass balances and considers ohmic, activation and concentration losses for the voltage calculation. The model is validated against data available in the literature …

Investigation Into The Possible Benefits Of A Refrigeration Based Intercooling System, Ronan Kierans, Jim Mcgovern

Conference Papers

This paper describes findings from analysis and simulation in relation to the possible benefits of applying refrigeration based intercooling to the engine of a modern passenger car or haulage vehicle. Initial theoretical analysis showed that, depending on the engine specifications and the boost pressure level of the turbo/supercharger, the power improvement could range from 15–30% and there would be a similar improvement in torque. This meant a smaller engine could be used to do the work of a larger engine. The power required to run the refrigeration system, the space required and the charge air pressure drop due to its …

Side-By-Side Testing Of Water Heating Systems Results From 2009-2010 Testing, Florida Solar Energy Center, Carlos Colon

FSEC Energy Research Center®

The Hot Water System (HWS) Laboratory test facility at the Florida Solar Energy Center (FSEC) in Cocoa, FL was used for testing seven differing types of residential water heating systems. The HWS building provides unconditioned housing (similar to a garage in Florida) for one reference electric 50-gallon heater, three solar thermal electric assisted systems, one electric tankless system, one reference 40-gallon natural gas (NG) and tankless gas system. The performance of all seven systems has been compared in a side-by-side test configuration over a full year period. Simultaneous hot water draws take place for all hot water heating systems on …

Thermodynamic Optimisation Of The Otto / Stirling Combined Cycle, Barry Cullen, Michel Feidt, Jim Mcgovern, Stoian Petrescu

Conference Papers

Combined cycle systems are an established method for increasing primary energy efficiency of power generation systems. Some ongoing research is concerned with investigating the novel combined cycle system involving the Otto and Stirling thermodynamic cycles. The Otto cycle is to act as the topping cycle, with the Stirling cycle acting to recover heat from the exhaust for the purpose of additional power generation. The present work investigates the thermodynamic optimisation of the combined cycle system for the case of the engines operating under two imposed parametric constraints: 1) imposed heat addition to the Otto cycle, and 2) imposed maximum cycle …

Simulation Of A Tubular Solid Oxide Fuel Cell Stack Operating On Biomass Syngas Using Aspen Plus, Wayne Doherty, Anthony Reynolds, David Kennedy

Articles

A tubular solid oxide fuel cell (SOFC) stack was modelled and its operation on biomass syn-gas was investigated. The objective of this work was to develop a computer simulation model of a biomass gasification-SOFC (BG-SOFC) system capable of predicting performance under various operating conditions and using diverse fuels. The stack was modelled using Aspen Plus and considers ohmic, activation and concentration losses. It was validated against published data for operation on natural gas. Operating parameters such as fuel and air utilisation factor U_f and U_a, current density j and steam to carbon ratio STCR were varied and …